Having problems with your Cars & Trucks ?

Replaced disc breaks in front and new calipers now just catchi on driver side bleed passenger side and very little preasure not enouph to grasp discs

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Then you have a restricted rubber hose

If you bleed the system first, before any other work was
performed & knew when parts get replaced, that could
been avoided

Have to bleed all 4 corners correctly,no pumping
& need a helper to do so
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replaced disc breaks in front and new calipers now just catchi on driver side bleed passenger side and very little preasure not enouph to grasp discs

Then you have a restricted rubber hose If you bleed the system first, before any other work wasperformed & knew when parts get replaced, that could been avoidedHave to bleed all 4 corners correctly,no pumping& need ... Cars & Trucks

I have a 2000 Toyota Tundra V8 4 wheel drive. I just replace new rotor,caliper(old and rusted), and brake pads( front left/right wheel). 1) My friend and I bleed the brake line. I pumped the brake pedal 3 to 4 times till hard. We started from the driver side first, rear passenger side, rear passenger side, and than front passenger side. We did this process twice. The brake is still spongy? 2) When we drive the Tundra and press on the brake we feel a little vibration on the driver side brake?

... 2000 Toyota Tundra

I am having a hard time replacing the brake cylinder on the passenger's side. The 2 little pistons or pins do not want to line up w/ there said notches in the brake system. They tend to bow out when the 2 screws in the back along w/the brake line and bleed nut are attached. The seal keeps popping off when the pressure in cylinder is built up. Please help

Keep the bleeder open when installing the wheel cylinder until it is in and the shoes are on. Sometimes the pistons will want to pop out on their own with no hydraulic pressure just because of the way the internal seals are. You'll have to push them ... 1996 Dodge Ram 1500 Club Cab

2001 Camaro. Problems with the power windows going out sometimes. The passenger side seems to be ok. The driver side seems to stop then after a few minutes will work again but not long enough to raise the window completly. Today i experienced both windows and the radio shut down completly. After a few minutes the were back on, although the drivers side window still goes up a little then I have to wait and put it up little by little as it will allow me. Thanks, I need every answer I can get

Are you repeat this question? The answer have in other POST, HERE. ... Chevrolet Camaro

Driver side power window stopped working 2000 nissan maxima. My 2 rear windows work fine But my passenger side goes down fine but it wont go up without reaching over and pulling on it a little from the drivers side. however the passenger side will works fine intermittedly. Trying to save money by knowing what the problem is so I can purchase the part myself But im not sure. Is it the motors One gone and the other one on its way out???

... 2000 Nissan Maxima

The climate control system is not working right on my 2000 grand cherokee. The drivers side will not put out hot air but the passenger side will. The drivers side gets a little warmer at times but is mostly cooler air blowing out. I turned on the ac just to try something different and then the passengers side did not want to put out cold air even on its coldest setting.

The grand cherokees have a tendancy fot the control doors inside the heater box. they do make a update kit on ebay. most of the require removing dash but some have instructions to cut hole in heater box and replace doors from there.check ebay for ble ... 2000 Jeep Cherokee

What fuse controls the passenger side window on my 2003 eurovan? bought the van used and the owners manual was not with the vehicle. the cheapest owners manual i found for sell was $59....trying to get out a little cheaper than that. The window is up and does not work from the passenger side control or the drivers side control thinking it is just a fuse but was unable to find a bad one with my multimeter. could be a limit switch i guess please help

I would call a dealer and ask them, they might help ypu. ... 2003 Volkswagen Eurovan

Power window slow to go up and down on passenger's side front today. It stopped half way up on the 4th try, then I have to wait a second then it goes up a little more. I have to keep doing this until it's all the way up. I hear clicking from both switches on the driver side and passenger side. Is this the window motor or switch problem?

I had the same problem with my car...it was the motor starting to wear out---it would be easiest to get one from a pick and pull or a recycling lot and just switch them out...in the meantime, pull up on the window as you press the lift button and it ... 2002 Toyota Highlander

AC I have a 1999 Pontiac Grand Prix. When I turn on the ac my engine making so much noise like clik,clik,clik and air is not cold. Noise is coming from passenger side ( around belts). It just blows warm air. Actually air is on passenger side is little bit colder then driver side. I don't know why. Thank you so much for ur time. Jacob

Is the compressor turning on an off quickly ?Could be a low pressure switch or problem with the ac clutch. ... 1999 Pontiac Grand Prix

Do I remove the entire cover or the little door thats atached to this cover on the passenger side? There are 3 brake lights that were recommended to replace. Driver side and passenger side plus the third brake light. I take it as the light in the middle of the door hatch? James

Lamp, Rear Hi-Mount\015\012 \015\012Lamp Assembly\015\012Removal\015\012\015\012Disconnect the battery ground cable (14301) .\015\012\015\012Raise the liftgate. ... 1995 Ford Aspire

The abs light came on about a week ago. nothing was going on utill i went to stop one day and it felt like it was trying to grab but couldnt. i just had new balljoints and tie rod ends put on both sides. and a roder on the passenger side. i had it looked at and a piston in the calaper on the front passenger side was sticking so i had it fixed and bleed the brakes but it is still doing it. when you go to stop it stops like nothing is wrong until the end of your stop and then it acts like it cant

You could possibly have a bad abs module. ... 1999 Oldsmobile Bravada

I bought a new master cylinder and tried to bleed the brakes, but two of them would not bleed while the other two bled just fine. the drivers side front and the passengers side rear would not bleed. Any ideas

Yes, you have to pre bleed the M/C. After market parts stores sell a kit that allows you to bleed it easily....It is difficult to get air to go downhill.\012\012after prebleeding M/C, do not let it run dry while bleeding the brakes. ... 1991 Buick Park Avenue

No brakes/pressure So after changing nearly everything (front rotors and pads, rear rotors and pads, both rear calipers, and master cylinder) and then bleeding the system three times starting from rear passenger side to rear driver and then front passenger and then front driver. Then also bleeding master cylinder and abs unit twice still have no brake pressure when car is on. Also makes a hissing sound like air escaping when pushing pedal. Anybody have any ideas

Got the same problem replaced everything but the abs pump and power brake booster, have you found what is the problem yet? Any suggestions... ... 2006 Scion tC

Changed front brakes on 08 aspen and now the brakes will not engage. I have bleed the passenger side, but can not get the driver side to bleed. What do i do

... 2008 Chrysler Aspen

I have a 1997 toyota camry and lately the sunroof has been leaking on the passenger side. when I look on the roof the sunroof is pushed down and when I try to push it flush with the roof it falls, I have been holing it in closed position with a water bottle keeping it level. It still seems to be damp with water on the passenger side felt by the door. Recently I had a new windshield put it and that was when i started to notice the little leak.

... 1997 Toyota Camry

I have installed new brake lines on the a 2000 GMC Safari. I am unable to power bleed front drivers side. I may have mixed up the lines. There are 5 lines on the anti lock under the front seat 2 on the bottom are coming from the master cylinder 3 on top are far passenger is drivers front middle is passenger front and drivers side is rear axle.

You need to bleed the brakes at each wheel. You can use a tube and jar filled with brake fluid and run the tube from the line to the jar to push the air out by pressing the pedal and when you let off it sucks fluid back in, instead of air. The auto ... 2000 GMC Safari

There is very little heat on the passenger side when the automatic control setting is set so the heat is supposed to "blow" on the floor. The passengers feet are cold. The driver's side is marginal also. Heat seems OK when set to "blow" from the vents justunder the dash

Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Try and check if the heater core is plugged. Find\015\012the 2 coolant lines going to the heater core. ... 2007 Ford Edge SEL Plus

Oil leak passenger side 300 turbo sedan, some on front passenger side wheel. Never lost oil pressure, but dipstick showed very little oil in crankcase on immediate after-run check. Have not started engine since, to be cautious. What could it be?

Add about 2.5-quarts of new engine oil to the engine.\015\012Remove the passenger-side wheel, and support the car on jack-stands.\015\012Start the engine and look for oil leak.\015\012Chances are leaks are coming from failed oil-pan ... 1985 Mercedes-Benz 300

Passenger side mirrior broken away from car--Oldsmobile Alero '03 I backed up into a mailbox on the side of the road and it broke the side mirror's plastic attachment away from the car. It is hanging on the side of the car now. It is still attached by a little bit on the bottom and by the eletrical wires. The eletrical wires still work, as I can still move the mirrior from inside the car. I'm wondering what I should do? Can I fix it myself? If so, what would need to be done and what tool

If your insurance were to cover that, you wouldn't ask a \015\012stranger on the internet,call the insurance agent\015\012\015\012You can remove the inner door panel and replace\015\012the mirror yourself,maybe,if you have aut ... 2003 Oldsmobile Alero

I'm replacing half shafts on 94 mazda 626 w/auto trans. Front end is off ground and supported. After removing drivers side axle shaft, I replaced it with a new one and while installing it turned it a little (enough to move wheel on passenger side). Am I in trouble because I might have moved differential side gear out of place? How do I know if I did? Manual says to use special tool so that diff side gear does move out of place, unfortunately I forgot this part while doing install.

Your okey\015\012You have to turn the new axle\015\012after you install it to check it out\015\012\015\012The other side is going to turn,\015\012if it didn't ,you wouldn't have the \015\012replacement axle even in ... 1994 Mazda 626

Just replaced rotor and caliper on passenger side and it works fine but the driver side piston in the caliper is sticking. Also would like to know if I need to bleed both sides even though only 1 side was replaced?

Yes you need to bleed both sides starting with the one farthest from the master cylinder and you should try and clean all of the parts with a wire brush that the caliper slides on so that it dont get hung up you can also put a very light coat of gre ... 2000 Chrysler Grand Voyager


Hi if one sides wearing a lot more than the other there is a problem with the caliper or the linkes seizing on if its one pad this would seem likley as good brake pads drove correctly will last 35000 i bet you had to pay for the replacement pads ... 2006 Hyundai Elantra

2000 mercedes CLK 320 (w 208) driver side floor mat is soaked, most likely from clogged drain of driver side water collector. This happened after the vehicle sat for a week under a tree that shedding little flower petles all over the car. How can I get to or snake the drain on that side - preferably from the bottom of the drain end rather than top of collector (which I've tried, but can't see what I'm doing). There is no problem with the drain of the collector on the passenger side.

I have had the exact problem twice..remove the grills right below the front windshield..(out side of course) you will see a black resivor for catching water..but you must first un-clip all the clips that secure it..on the passenger side is a wep hol ... Mercedes-Benz CLK

I have a 97 jetta and when i try and bleed my brakes i start on the passenger side bleeder valve. and when i start bleeding the brakes i have pressure and the pedal goes to the floor but when i bleed the other brake valves i still have pressure but the pedal doesn't go the the floor when iam bleeding the brakes. and also when i turn on the car i lose all of my pressure and when i shut the car off i get my pressure back.

When bleeding you start at the rt rear to left rear to rt front to left front always checking to make sure master stays with fluid, also start by removing one bleeder at a time and make sure the hole is clean and free of dirt brake clean should flow ... 1997 Volkswagen Jetta

My chevy lumina has only 39000 original miles. recently the temperature guage started fluctuating from one extreme to the other while driving. the driver's side fan comes on once in awhile and the passenger side not at all. when the drivers side fan comes on it only stays on a little while and does not affect the temp guage at all.

You don't say where you are. You probably need a new thermostat. Cost for the part should be about $10. Labor to change it out should be $50 to $70, it takes less than an hour. Spring for fresh coolant, too.The fans: the d ... 1995 Chevrolet Lumina
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8369 seconds