Having problems with your Cars & Trucks ?

Evap code on 2006 chevy 1500 - Cars & Trucks

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).


... Cars & Trucks

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

06 chevy aveo evap code very small leak - Aveo 5 Chevrolet Cars & Trucks


... Chevrolet Aveo 5

1999 Chevy tracker emissions evap code large - Cars & Trucks


... Cars & Trucks

Evap code on 2006 chevy 1500 - Cars & Trucks


... Cars & Trucks

Evap large code Chevy tracker 1999 - Cars & Trucks


... Cars & Trucks

The check engine light on my 2005 chevy malibu keeps coming on and off sporadically. the car seems to be running fine. the only thing is that the fuel guage reads full all the time and then suddenly drops to empty and the fuel light comes on. diagnostic tests read the code p0455. i have replaced the fuel cap already. the other possible causes list 1. EVAP canister broken, cracked hose or not connected 2. Purge or vent solenoid defective or 3. vacuum leak at engine. i really just need to know how


... Chevrolet Malibu

COLOR CODE I CANT FIND THE COLOR CODE FOR MY TRUCK (ITS RED) SO I CAN GET TOUCH UP PAINT ITS A 2005 CHEVY SILVERADO 4X4 SINGLE CAB 5.3 / I KNOW ON MY LAST CAR IT WAS ON THE DOOR BUT NOT ON THE TRUCK


Its normally on the bulkhead on the opposite side to the chasis number. if this helps please rate me ... 2005 Chevrolet Silverado

2001 Chevy Silverado 4.8, had code PO442 cleared and drove 52 miles. Catalyst, evap and O2 sensor heater tests not complete. Hit 57 miles and code PO453 fuel evap press. sensor switch high. Fuel pump was replaced 1 yr.ago rechecked elec. conn. OK.Could sensor be faulty or gas cap,hoses. What is most common problem?


I would check the evaporator canister and vent hoses ,to make sure they are clear,try driving the vehicle with the gas cap off,just to see if it is a vent problem,if so,start checking the vent hoses to the canister,and I believe there is a pressure s ... Chevrolet Silverado 1500

Chevy truck has engine code p2108 - Chevy Chevrolet Cars & Trucks


... Chevrolet Chevy

How to enter code? went online and paid nine bucks, didn't really help me because of the following problem. 5 digit code, car radio has preset # 1,2,3,4,5,6.. one of my code is 0 and 9 how the hell am i suppose to enter it?


Come on here for free ,anyway you press preset 1 and use either the volume or tuning buttons ,maybe even the tape buttons to place the number then when all numbers press 6 to enter the code on the venerable old classic vehicle ... 1984 BMW 3 Series

EVAP code P0446. I have replaced perge solinode and the canister perge valve. Can drive car all day long without check engine light coming on,even turning car off for a couple of hours light will not come on. When I let it set over night light comes on after about 1 or 2 minutes. Also after filing up car runs rough for a few seconds(rich, I think). Also when the tank is full the light might not come on after sett ing over night.


... Daewoo Leganza

2002 Chevy S10 4.3 02 sensor bank 2/sensor 1 code P0155. Hi My name is Robin, I have recently replaced the fuel pump and fuel filter on this truck. Before any of those repairs were made I was getting the above mention code and my service engine light is on. Replace the sensor and drove it about 100 miles. The same code popped back up again. Any ideas?


Problem is in replacement of O2 senser try again to put it.take a help from a link>>http://www.popularmechanics.com/automotive/how_to/4219927.html?page=2happy to help u any time.Thanks for using FixYa. ... 1991 Chevrolet S-10

96 Chevy C3500 6.5 turbo diesel with a 4L80e trans. Service engine light was on, checked the code po751 shift solenoid stuck closed. I changed both 1-2 and 3-4 solenoid, new filter, new fluid, cleared the code drove the truck about 5 miles and the service engine light came back on. Pulled same po751 code. Any suggestions?


... Chevrolet C3500

I bought performance ignition accel part # 140040 all 8 replace.The code that coming up is Message 1 of 7 PO 351 Ignition coil A Primary / sec circ error.The next code reads the same but said PO352 coil B,PO352 coil C,so on up to 357 COIL G,I all so have new MPG Plus spark plug wires,E3 spark plugs,a Flashpaq tuner superchip model 2815.All bought from Stylin trucks.Accel tech can't help me the same with Stylin trucks.My truck is 2005 chevy silverado 5.3 1500 the 8 vin # is T.I clear the code but


TRY swapping back to your factory coils. I believe you are gonna find these coils are not compatable with the gm system. I assume truck is running fine? also the plugs may not work well with truck but this would show a po300. computer is designed to ... Chevrolet C1500

05 corolla, after gassing up, whether partial or full fillup, car is hard to start. will crank but runs rough before going dead. after 3-4 starts and runs fine. toyota dealer checked codes; po 171 system to lean bank 1, po 441 evap incorrect purge flow, po446 small gasleak, emission charcoal canister bad causing codes and check engine light. replaced canister and cleared codes but still have same problem


Sounds like you may have an issue with the check valve on your in tank fuel pump. When these go bad, you have to crank several time to build up enough pressure in the fuel rail for engine start. With a good check valve, the fuel pressure will not ble ... 2005 Toyota Corolla

CODE P1135 BANK 1 SENSOR 1 HOW TO FIX - Tacoma Toyota Cars & Trucks


You have a bad heater on your O2 #1 sensor.. These are fairly easy to replace as long as you can get access to the underside of your car. ... Toyota Tacoma

I have a 2002 trailblazer ltz, I go to start the truck and it just clicks under the hood, no noise or anything. The lights on the console comes on and the radio says that's it's on but it only plays static. Also everything seems to be reset in the car like the car was saying "Driver 1" even though I had the driver 2 key and remote and also the time on the radio was reset to 12:00. Also as I'm turning the key the radio screen says "Need AMP". what do you think this could be?


Sounds like either a loose connection at the battery, or your battery has failed. Check your connections and make sure they are clean and tight, if so, then have your battery tested, and change if recommended. ... 2002 Chevrolet TrailBlazer

1999 Grand Am GT ''Service Engine Soon'' light. AutoZone did a scanner, and the codes are 1. ''engine burning too rich'' 2. ''evap leak'' 3. ''engine misfire.' The light has been going off and on for the last 200 miles. I had a smoke test done on the car, and the mechanics could not find any evap leak.


The Evap leak is the least of your worries right now,concentrate on the rich exhaust which sounds like there is a spark plug not firing and raw fuel is going out your exhaust system which could damage your cat.converter.Can you get the exact codes th ... 1999 Pontiac Grand Am GT

2005 chevy trailblazer po497 code. - Chevy Chevrolet Cars & Trucks


It is a EVAP system vaccuum leak usually around the canister area or the ourge valve itself is leaking ... Chevrolet Chevy

My 2000 Chevrolet S10 ZR2, 147,000mile is miss firing and hesitating. Comes up with codes P0301, #1 cyclinder misfire and p0453. I took my truck to Chevy garage and they did a compression test, came back ok(120psi)in all cylinders. Had cyclinder leak down test proformed, 100% leak. I took the heads off when i did #1 push rod had some carbon build up. Had them sent to a machine shop, they were pressure tested and decked. They said heads were fine. I have replaced, Distributer and module,Distrib


I have done a full engine replacement on these, a zr2 to be exact. I have found that a p0300 (multiple misfire) usually points the the Piece of **** injection spider, then I had a p0301 as well after replacing that with the multiport unit upgrade an ... 2004 Chevrolet S-10

I have a 2004 Spectra. Driving to work this morning, car stalled out twice. Cranked car later in the day and the engine sputtered and idling high to keep from dying. Engine smoothed out, but MIL came on with codes p0449(evap vent valve/solenoid circuit), p0303(cylinder 3 misfire), p0304(cylinder 4 misfire), p0300(random misfire), p1166(no description), p0140(O2 sensor no activity bank 1, sensor 2). Any ideas about a common problem?


Well, it is either a timing belt/chain going out or a bad crank position sensor most likely causing the other problems. The O2 sensor may be bad as well but that usually doesn't cause the Misfire. The vehicle on board computer is confused, that is ... 2004 Kia Spectra

When I disconect the vaccume line to the map sensor the truck idles, the part is new. It is a 1988 Chevy 1 ton pickup with a 5.7, the problem is that after I pulled a trailor with a car on it the truck died and would not idle, it loses power on take off (falls on it's face) I have replaced Fuel filter, Throtle position sensor, Idle air valve, Map sensor, o2 sensor, and plugs, I checked comprssion and it runs an average 150 through out. I have run out of ideas?


From the information you have supplied......check the fuel pressure......or just change the pump if you have over 150kms or 100 miles.....you will need one soon anyway.You may have low pressure which would account for the "idle with map v ... 1988 Chevrolet C3500

2003 Chevy Silverado 2500HD The check engine light came on and gave a P0443 code. It says it could be 1 of 4 things: 1 Purge or vent solenoids defective 2 Check connector and wiring 3 Fuel saturated vapor canister 4 Failed EVAP vent solenoid How do I go about checking these things?


... Chevrolet Silverado 2500HD

I tried to charge my car battery with a Chicago Electric charger model 66783. I followed the directions for charging the battery in the vehicle. After selecting the charge rate of 10 AMPs, the ammeter pulsed back and forth between zero and about 9 AMPs. The 'Charge Complete' light cycled on and off also. This is not consistant with what the directions describe is supposed to happen. Do I have a charger problem or a battery problem? I have not driven my vehicle (1954 Chevy truck) for about 6 mont


Relax, the charger is working fine. What it is doing is charging the battery to 15.5V. During this time, the "charge complete" LED is off, and the current meter shows the needle going to the right. When 15.5 volts is reached, the current is shut of ... Chevrolet Classic
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8971 seconds