Having problems with your Cars & Trucks ?

How to replace fuel injector on Mazda 6 2007 model

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace fuel injector on Mazda 6 2007 model


... Cars & Trucks

Ford Laser Lxi, 1.6 litre, Sedan, 2000.(Mazda 323) After approx 30 min driving motor will cut out. Similar to fuel starvation. Sit for 10 min and the vehicle will start. Will run for another 10 min then cut again. Filter has been replaced twice tank drained and flushed , line flushed , injectors cleaned. Prob now 12mths old. Four shop visits where mechanics are unable to duplicate fault. Could it be electrical ? Any help would be appreciated johnb same as you i have the pah model. change


Check the fuel relay...could be overheating... ... 2006 Ford Laser

I have a john deere model 2345 tractor 3 cylinder diesel for my orchard and it has a lack of power , starts and idles fine with not much exaust gass's , when reved up for use , u get power for bout 15 to 30 seconds then it starts making a putt putt putt noise and no power , the exaust starts goin black im thinking its a fuel related problem , lack of fuel to the injectors but do not have a diagram for the fuel lines , it has had 1 injector replaced , the fuel filter as well , can anyone advise


If you are getting black smoke you are getting to much fuel.of you are getting to little fire check both. ... Ford F-100

How does a 2002 mazda tribute 3.0 fuel rail come off? I need to replace my #5 injector & all that remains is to remove the rail & replace the injector. Everything is disconnected & the rail is loose. I don't see how it comes off when the two injector banks are at different angles. I don't want to force it & possibly harm the injectors. Do you rotate it axially or does it take a special tool at this point? What's the trick?


... 2002 Mazda Tribute

I have FORD F-250 96 Model Truck Engine is 5.8 When I started my car early morning, Engine is running Ok but after while when the engine become warm , the power of the engine become low and when I remove my leg from accelerator engine get vibration and black smoke come out form Exhaust. Some mechanic inform me that it is Fuel Pump problem , I replaced both of them but the problem still the same, now he is asking me to replace the fuel injection lines & fuel Injectors . Please feed me back I


No, no changing fuel lines. You have a fouling injector. \015\012Too much unburned fuel smoke is white\015\012Too much brned fuel is black smoke Take it to a diesel mechanic that knows the 5,6's goodLuck Ned ... 1996 Ford F250 Crew Cab

1994 Mazda Protege won't run the fuel pump or start. Even if the fuel pump is jumped the engine will still not start. There is a constant hum under the hood while ignition is on. probably coming from fuel injector rail. I have replaced the fuel pump relay, wasn't the problem.


TAKE OUT THE FUEL FILTER,PUT NEW ONE AND TRY,IF DONT START , TAKE OUT FILTER AGAIN IF DRY THEN FUEL PUMP NO GOOD ... 1994 Mazda Protege

2004 5.9L Cummins Diesel cranks over but wont start? Things I have done. Replace- Lift pump new fuel new fuel filter bled injector tubes from fuel rail drain water seperator The engine has 40lbs oil pressure when running . Idles at 750rpms smoothly. Has lots of power 0- 110mpr in 3/4 of a mile. Just takes a VERY VERY small Blast of either to start. What is going on.


\015\012As mostly you have replaced all the possible parts by which this problem can occur.so most probably it’s the faulty solenoid.\015\012Check the solenoid it will have t ... 2004 Dodge Ram 2500

I have a 1991 mazda mpv 4 cycl that first thing in the morning was not cranking well, would take several tries to start and then finally would start. It acted like it wasn't getting any gas. I have replaced the plugs, wires, fuel injectors, fuel filters, gas tank and fuel lines, alt belt, a/c belt and power steering belt and battery. When I take the line off the regulator it spurts gas when trying to crank but still want crank. Now it want crank at all. What else can it be???


MAF sensor ... 1991 Mazda MPV

My 1984 chevy citation 2i died in the middle of the road...4 cylinder model.... its not spraying fuel and not getting spark the fuel filter is good fuel is getting to the injector but not spraying..... i have replaced the plugs, wires, cap, rotor, and ignition module what else is there to go wrong with this thing


Are you getting power to the coil ?It could be the stator-pickup in the distributor or a lack of voltage to the ignition system.Is the check engine light on when you turn the key on ? ... 1984 Chevrolet Citation

How to replace fuel injectors on a 02 mazda tribute V6


... Cars & Trucks

Replacing fuel injector seals on a mazda 2


... Mazda 2

Mitsubishi montero model 1997 mitsubishi montero. check engine warning light goes on even when engine is already running.., it goes off when i step on the gas pedal. smoke emitting from exhaust is white and moist. smell is not so bad. head gasket recently replaced only 11,000 kilometers since replaced. top performance of engine except for the smoke coming from exhaust. what could be the proble? some experts say it could be fuel injectors. some say water settling in the combustion chamber. local


Sounds like injectors ... 1997 Mitsubishi Montero

I OWN A MAZDA 929 1986 MODEL A LITTLE WHILE AGO THE CAR A PROBLEM OF JUST STOPPING WHEN DRIVING ALONG.I HAD IT TOWED TO A MECHANIC HE TRACED IT TO THE ALARM SHORTING AND CUTTING POWER TO ENGINE THIS SEEMED TO WORK,BUT AWEEK AGO IT JUST STOPPED.ITIS AT A MECHANICS NOW SOME OF THE PROBLEMS NOW ARE TERE IS FUEL COMING FROM FUEL PUMP BUT GETTING UP TO INJECTORS AND IT STILL HAS THE ELECTRICAL PROBLEM WE HAVE BEEN TOLD THAT THE REMOVAL OF THE ALARM MAY BE THE PROBLEM AS THIS WAS REMOVED AT A DIFFEREN


I have a mazda 929 (luce) limited its been parked up for 2 years and now there is no fule getting to the carb ther is no power to fule pump but all fuze r okay can any 1 help ... 1988 Mazda 929

I ran my 1992 mazda marvie proceed out of fuel and suspect that the carb and injectors may be blocked, have replaced fuel filter but it still wont run or idle.Need to know how to strip and clean carb, etc


SOUND LIKE FUEL PUMP DAMAGED BECAUSE LACK OF FUEL. FUEL IN TANK.FUEL KEEP FUEL PUMP COOL AND LUBRICATED IF FUEL TANK GET TOO LOW OR EMPTY CAUSE FUEL PUMP OVER HEAT DAMAGE. ... Mazda B2600

1987 GMC R1500 2WD Have replaced all electronics underhood,tpi,esc module,est module,egr valve.cleaned injectors,replaced fuel filter.loss of power on accel.Engine starts and idles excellent.vacuum is @21inches at idle and doesn't falter when rpm is above idle.timing is set at 0 tdc


Hello best solution have a scan completed at the dealer ship to pin point your trouble the usual cost is from $25.00 to $75.00 as mentioned guessing could be one of many things that could amount to hundreds of unnecessary dollars.A scan would be the ... 1987 GMC R1500

My Audi 500 SEL 1993 model is difficult to start - as if there is not enough fuel injected when the engine is cranked. Agents tell me that the injectors are leaking and needs replacement. I don't agree with this, because at times the engine would start with the first turn of the switch. If injectors leak, they should surely leak continuously?


Bad fuel, bad fuel pump, clogged fuel fiter, injectors or fuel fiter. If injectors are leaking at o-rings on rail or cylinder head your sucking in air and changing mixture ratio, computer can't compensate. Try all these things before proceding furthe ... 1993 Audi 100

Lots of Petrol leaking out of two right hand side fuel injectors. Last problem to fix after accident. Any suggestions. Injectors themselves seem fine. All pipes are fine and not leaking. Will replacing the rack solve this? Fiesta Model


The injectors are bad if they are leaking and need to be replaced. ... 2007 Ford F

Replaced fuel injectors on Mazda 626, 6 cyc..is there a fuel reset or purge button that needs to be reset? Check engine light is still on and this was the only problem.


What is the code? I maybe able to help you out on this. Most auto parts will read the code for free, but do not buy any parts yet untill you tell me the code. ... 2000 Mazda 626

1999 Chrysler 300M, Dies on deceleration and at idle when warm. I can some time see the tach go to 0 rpm, with out the car actually dying I have had may suggestions, from EGR, throttle Body, fuel injectors, fuel pump, cam & crank sensors and more, I really would not prefere to just start replacing parts untill I find a solution. Has any body found a fix for this issue, I have seen many posts with similar conditions, but so far not a single one that says the problem was fixed...


For the price of a can of throttle body, spray cleaner, I'd remove the IAC motor , clean it, and port it came out of and try it and see what happens. It sure sounds like the same old dirty IAC problems that are frequent . Normally that will cure it, ... 1999 Chrysler 300M

Have a 1999 Ford F150 4.9L engine that won't start when temp is 0 or below. Engine turns over but won't fire. Dealer replaced the battery two weeks ago even it was only three years old and stilled turned the engine over. They said it was not operating the fuel injector and raw fuel had fouled the plugs and entered the crankcase.They also cleaned the plugs and changed the oil and filter. But same problem yesterday. Is there a coil or some other device on the engine that could be preventing the p


You need to have the engine coolant switch \015\012checked,since the computer relies solely on sensors,the ect tells the computer how cold or hot it is so the \015\012compu ... 1996 Ford F150 Regular Cab

2001 ford e250 5.4 v8...vehicle has not been running for 2+ yrs...I replaced plugs, coils, fogged cylinders, dropped fuel tank and cleaned perfectly, replaced fuel pump and sending unit, replaced fuel filter, removed and cleaned injectors and fuel rail, cleaned all fuel lines...basically cleaned and replaced everything from fuel tank forward to injectors....I went start vehicle and fuel pump only turns on for a couple seconds and then shuts off...i have no fuel pressure...could this be the fuel


It can easily be a relay. There is also a PCM relay which is suppose to trigger the fuelpump relay.\015\012Check the pressure before the Regulator and vent air out of the line at the Injector pressure spout.\015\012I have included an art ... 2001 Ford Econoline

1987 chevy s10 fuel injector problem. Install new fuel injector but fuel comes out steady causing engine to idle high and bog down when i step on the gas pedal. i have previously replace swapped ecm and checkeed fuse. ecm has 12v fuses good, i also replace frul pressure switch, map sensor, o2 sensor, trying to find out why fuel comes out steady of injector and not spraying as it should. note: this is the second injector i have put in


Check the fuel pressure at the shredder valve, you should have 13 to 13.5psi, anything other then that will give you problems in the GM TBI. If the pressure is bad, then you may have to replace the fuel pressure regulator at the bottom o ... 1987 Chevrolet S-10 Pickup

5.0 fuel injected tpi 88 firebird replaced fuel pump map sensor and now the vehicle will start and idle great i can give it gas and will continue to run but excessive gas was leaking on manifold. i took apart plenum and runners and fuel rail and 3 fuel injectors appear to have been replaced by previous owner and o-rings appear to be new. Fuel pressure regualator also appears to have been replaced. I checked injectors while still hooked up and they appeared to be firing and i checked the socket a


Hi, Even though the Pressure Regulator has been replaced,It could have a raptured Diafram. Check to make sure your fuel return line is not Plugged, Other possibilities are Leaking Injectors or Damaged. Also check your Throttle body gaskets and Fuel F ... 1988 Pontiac Firebird

2000 chevy 3500 7.4L cranks and hits every once in awhile, but wont stay running. checked fuel pressure had 60psi, checked fuel flow appears to be good . checked for spark it has good spark, removed plenium and ohmed injectors all turned 12.4 . checked all injector plugs with a noid light and i have pulse. no codes in computer , replaced crank sensor , replaced fuel filter, replaced fuel pump,


The\012following are the general instructions on the start of diagnosing any\012electronically controlled engine or transmission problem.\012The\012engine and the automatic transmission (transmission control is\012only for ... 1998 Chevrolet C3500

Hello, I have a 1993 Astro van. The problem began with 5 stalls within a half mile trip home from the train station. Next morning would not start at all. Proceeded to replace the pickup in the distributor...new alternator...fuel pump...thought it was the fuel regulator, so replaced with rebuilt fuel injector spider. Checked for spark on all plugs...have spark...set timing...confirmed fuel was entering injectors, but no ignition. Established there wasn't a pulse to the injectors, although there i


If changing the map sensor doesn't work, check the vacum sensor. I experienced the same symptoms when my car's vacum sensor got busted.. ... Chevrolet Astro
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3008 seconds