Having problems with your Cars & Trucks ?

How do you put a rover colt gear box together

\015 I need a gear box assembly so i can put it back together\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you put a rover colt gear box together


... Cars & Trucks

My rover 75 2.0 v6 knocks twice when put in to drive not smooth through 2nd 3rd and when put in reverse jerks to say in but will not move came up with fault code witch says its solenoid in gear box can i bye this and were


The Solenoid is INSIDE the Transmission, accessible by removing the Transmission Pan. They are Very Easy to Remove and Replace. IT is harder to find a new one for a Range Rover ... Cars & Trucks

When i put in gear makes loud bang more so when car warm it sounds more like front diff than gear box area( common ) land rover discovery 95


Gear clunking is normal in the Rover's transfer case. It uses straight cut gears - they are stronger, but louder. If not out of the T-Case, check the front driveshaft - another common wear point. ... 1995 Land Rover Discovery

Were put oil in gear box rover 216 - Cars & Trucks


... Cars & Trucks

Ford fmx 73 mustang changed out selector seals put gear box back together dont have reverse or neutral


... Ford Mustang

Ford escort 1999 td gears realy crunchy put new oil in box etc now they gone all together any help cheers


Is it manual? There was a trick we used to do with the older ford sierra gear box when they did the same, put auto trans oil in it. ... 1999 Ford Escort

Recently bought a range rover 4.2 automatic 53 year only done 51000 miles broke down on monday. auto gear box has gone has any body come across this before as landrover tell me it will cost £3000 for gear box then labour and vat on top warranty only goes up to £3000 we will have to pay vat plus labour costs can any body tell me if this is the true cost of gear box for 4.2 auto gear box.And should it have gone with so few miles.


I'm not familiar with the conversion of dollars to your currency however if yo can help me with that i will gladly research the problem for you. as far as any part of any vehicle, poor maintenance will almost always result in premature wear and break ... Land Rover Range Rover

Limp mode car went into limp mode garage put new gear box in drove for 2 days started shuddering garage put old gear box back in still in limp mode


Hi Mary, You have not told us the vehicle make or model, or basically anything we can use to determine what fault it may have. Take your vehicle to a reputable garage and ask them to carry out a diagnostic scan. Regards John ... Cars & Trucks

Mazda astina 2000 auto transmission neutralises and wont drive again put another box in starts and gets gears ok drive for 5 mins come to a stop go to take off gearbox neautralises and wont go again put another box in gets all gears drive 5 mins neatralises again


... Mazda Cars & Trucks

I have removed my pitman arm and pwr steering gear box and replacing them both. The new pitman arm is very hard to put on the gear box...literally using a sledge hammer to beat on it and the pitman arm won't sit all the way down on the gear box shaft. The grooves are all aligned correctly, it slips on easily about half way and then I have to beat on it to get it to budge even a little bit...seems no way to get it to sit all the way down. Is there a special tool or technique that you know of? Doe


Welcome to FixYa.com\015\012You should not have to hit the Pitman Arm to install all you need is an impact gun install Pitman Arm and run the nut up with impact. \015\012Check the part make sure the Aftermarket one is correct some aftermarket parts m ... 1999 GMC Suburban

What type of oil for Mitsubishi Colt gear box


First drain completely out whatever is in it. All the gear boxes and rear ends use 90w gear oil. Buy a name brand.Some of the really cheap stuff is recycled used oil.\015\012I hope this helps you. ... Mitsubishi Colt

Recently repalced a new clutch kit and when ******* to 5th gear have to lift a little bit to put into place.The only time you have to lift the gear is for the reverse only. why do you think this is.when putting back the gear box saab parts dealer said one bush did not get palced right he sent me the diagram showing the part.Which is part 9 as per the diagram.Could you sort this out so the 5th gear shift can be shited as usual.


... 1997 Saab 900

How do you know what gear the box is in when putting in an automatic turbo 700 gear box as to the gear stick in the car??


Where the hole is for your say t bar selector on gear box, should be closest to the rear of your car so park is forward in the car means the gear box selector should be in opposite direction means closest to rear of car if having problems give me a c ... 1995 Holden VR Statesman

Subaru impreza 1995 wrx automatic gearbox repair can not get any gears put gear box in car .the gear box came out of a legacy


You have a bigger issue,the diff ratio in the gearbox needs to be the same as the rear diff,is it if not you need to change it you may need another box alltogether ... 1996 Subaru Impreza

I have an audi 500se auto and the car only moves in its gears when I change it from 1 to 3 and when i put it drive it stay in 3 . It does not changes gears in drive gear. oil is top up and some one told me its the computer box. and I have disconected the battery but same problem. We took out the box some one sort of fixed it and he said he must set computer cause the competer still reads the error. Please advise


... 1993 Audi 100

1995 honda accord. blows fuse when i put car in D4 and barely begin to accelerate. This fuse also cuts power to alternator so it stops charging. Car will not shift properly after fuse blows. I can manually put shift selector lever in 1st or 2nd but I believe it only shifts into second gear in either position. In D3 or D4 when fuse is blown it will not shift. It remains in 3rd gear or maybe 4th. Hard to tell which gear. This is my friends car, no diagram for interior fuse box, but I think i


... 1995 Honda Accord

Isaac Got in my VW Golf 2002 1.6, started driving everything was fine, then as i put in 4th gear i realized that the knob its self became really loose to the point where i could touch both sides of the book in a gear, then when i came to stop again i realized i could not longer get into 1st or second, and later i found out reverse as well. I messed around with it for awhile and if i tried putting it into reverse it would reach 1st but after pressing down. Is this a bad gear box? or something to


Check the linkage first . A pin may have fallen out of a pivot point and the linkage has fallen off. ... Volkswagen Cars & Trucks

My 1999 xr6 manual gear box is jaming.very hard to put in gear


First thing to check is the fluid level and type. Overly thick fluid makes for hard shift lever. ... Cars & Trucks

I have been told that my 98 Dodge truck which has 56,000 miles needs a new steering gear box. Steering wheel has about 2 to 3 inches of slack. Have put on a track bar and a tie rod for 700 bucks and still have the problem. Why would the steering gear box wear out in 56,000 miles and they want 500 bucks to fix it.


The gear boxes are just cheaply designed and made, its a very very common problem with these Dodge's. Even the new ones experience whats called the "death wobble", where the truck will all of a sudden veer left or right. The most common things ive ... 1998 Dodge Ram 1500 4WD

Hello fix ya, I have a 94 lt1 Camaro with a 4l60e. It had no 3/4 gear. So I dropped it and took apart and clean it up. I put bogg Warner clutches in it. It had reverse, 1,2 but slipped outta 3rd. Now that it has all new cutchs in it, put all back together like it should be, it has no reverse, it's like in nuturel and I drove it around the block so all drive gears are working as they should. Got any ideas?


When you put the shift module back on the side of tranny did u line it up right if so are you sure you put the tranny together right? When u take off the shift cable it has to be line up right to shift inreverse if u put car in reverse will it start ... Cars & Trucks

I have a r reg megane scenic when i start it up the gear box is very noisy when i put my foot on the clutch and put it in gear the noise stops


Get a second opion, but it looks like the thrust bearing is on its way out. That'll probably involve changing the clutch as well. Do it soon or you'll wreck the gearbox. ... Renault 181

Transmission problem I have a 2000 VW passat 1.8t and it is triptronic transmission. When selector lever is put on "D" it illuminates all gears selected and it moves but does not upshift. When put on "R" there is a cracking noise from the gear box


I have the same problems it seems like it's the TCM that is wrong check out these links : http://forums.fourtitude.com/zerothread?i ... 2000 Volkswagen Passat 4Motion

Gearbox hi all my car is ford escort 1600cc 1998 gear box manual buy i have abroplem when i put no.5 he didnt work and some noise voice came from it ... her in jordan ididnt found another geer and all parts not found can i take another gear for another cars and put it in my car


5th gear should be to right of nuetral and up towards dasboard. ... 1998 Ford Escort

Mazda 6 2.3 petrol 2002 if i select 1st gear too quickly it crunches in but if i put it in easy teres no problem it only happens in 1st gear and i put a new clutch in after the problem started and its still the same any idea of wat part is gone in the box


1st gear syncromesh Is worn or broken. This usually is caused by forcing lever in when clutch is not disengaging fully, or changing gear with out disengaging clutch. MMP ... Mazda MAZDA6

I have a auto Hyundai excel that doesn't move in any gear. it think it is slippage in the gear box. I brought it of some one unregistered. i took out about 4 liters of extra transmission fluid but there is still too much. I need to service the engine and when i service the engine i am going to service the g-box to. can you tighten the bands and do you think that servicing it and putting in the correct amount of transmission fluid in would work?


... 1994 Hyundai Excel
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9790 seconds