Having problems with your Cars & Trucks ?

How do I replace the a/c belt on my 2009 Suburban

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 97 Suburban that has a loud chirping sound coming from the serpentine belt area. I have already replaced the belt, tensioner, and idler pulley. It still isn't fixed. Could the fan clutch be squeaking? There is a bit of rust in that area. Due to the fact that most everything on the top side has been replaced it has pretty much been narrowed down to the fan/water pump area.


If it has A/C it could be the A/C compressor clutch, Try turning on the A/C and see if the noise goes away or changes. ... 1997 Chevrolet Suburban

Need diagram of serpentine belt for 94Solution for "need diagram for replacing serpentine belt for 94 ford taurus gl w/3 0 v6 engine and a/c" ford taurus gl w/3.0 v6 engine and a/c


\015\012Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question. ... 1994 Ford Taurus

Serpentine belt how to replace serpentine belt on 1999 suburban-how to relieve tension on belt


The belt is being pulled by a spring loaded pulley. this pulley could be lift by using an exact box wrench that would fit at the front nut and turn the wrench to the left. the pulley would then raise and you can slide the belt off the pulley. be care ... 2003 Chevrolet Suburban 1500

2004 Kia Sedona shakes/vibrates when turning a corner and accelerating from 0-40. Repair shop replaced front left tire because stell belt showing. Stopped for day after repair then started again tod


One check if your wheels are tight 95 ftlbs if mag wheels remove make sure no heavy corrosin arond hub and rim wheel will not seat properly and come loose. 2 check front end if belts are showing check ball joints and tie rides for wear vans are also ... 2004 Kia Sedona

Belt routing diagram needed for ac belt replacement on a 2002 suburban


... 2002 Chevrolet Suburban

2003 chevy suburban 1500 LT V8 2003 chevy suburban 1500 LT replace my tensioner pulley and belt for my a/c compressor and now my tensioner is rocking back and forth and the truck idels hard when the a/c or heat is on


Have a set of ac gauges put on the ac system,cause the ac system might have a problem. ... Chevrolet Suburban 1500

2003 Chevy Suburban, Alternator failed, replaced altenator and battery, cleaned terminals,and changed serpentine belt, belt tensioner is good, battery light still comes on and message "battery not charging", mechanic says it is charging, have driven 50+ miles at night (headlights) while this continues, why is the light still coming on


I would look for a short in the output wiring at the alternator. My nephew had an intermittent charging problem and I took the car to an autoparts store and had them check the alternator output. Most parts stores will do the check for free. Anyway, w ... 2003 Chevrolet Suburban 2500

Belt change how can i replace the belt for my gmc suburban 1993,also if you have adiagram for it


Ther should be adiagram for belt touting under the hood on top of the grill this is aserpentine belt and there is a tensioner pully you cam pry loose with a long screwdriver or bar stick it between pluuy and bolt and pry pull bewlt off rethread nwe ... 1993 GMC Suburban

Replace serpentine belt on 2003 suburban - 2003 Chevrolet Suburban 1500


... 2003 Chevrolet Suburban 1500

Replace seat belt in 2005 suburban - 2005 Chevrolet Suburban


... 2005 Chevrolet Suburban

The second row seat in my 2004 suburban has a broken seat belt, where can I get a replacement and how hard is it to replace?


Junk yards are a great place to find one. they are not that hard unless u try on an older one. u might need a special wrinch tho. ... 2004 Chevrolet Suburban

I have 98 ford ranger 2.5 that broke the timing belt; What type of internal engine problems might I be looking at? I replaced the belt and did a compression test and have 0 compression.


Hello gandolfph: My name is Roger and I will help with your question. I have Alldata and Mitchell on demand programs. I looked at both and neither one says this is a interference motor. That is where the valves bend if the belt breaks. I would go bac ... 1998 Ford Ranger SuperCab

I have a 2002 VW TDI with 140,000 miles, but engine was rebuilt after broken timing belt, and trans was replaced under warranty at 98,000 miles. My problem is that the engine cranks eight or nine times when starting next morning, even though car is parked in indoor and heated garage. All services have been performed right on time and I use nothing but MOBIL 0-40 OIL and high quality oil filters, etc, etc. It has a new timing belt (the newer type which came out in 2003) Glow plugs are all okay a


Hello, I have something that might help you. If you know where your fuel line goes into the engine. I would let it sit overnight and then take the line loose. Then hold the fuel line into a bucket and have someone turn on the key in the car. This sho ... 2003 Volkswagen Jetta TDI

I replaced belt on my 97 Suburban but the tention pulley did not click. But the belt feels tight. The pully moves back and forth. Is it safe to drive without me hearing the click sound.


Yeah it'll be ok for you to drive it as long as its not sloppy loose or super tight you'll be ok. but if you still have doubts replace your tensioner pulley ... 1997 Chevrolet Suburban

2000 dodge caravan is it a 0 tolerance vehicle? Water pump out and timing belt needs replacing. just need to know if it is 0 tolerance or not. Thank you.


... 2000 Dodge Caravan

2003 Suburban Air Conditioner belt replacement procedure


... 2003 Chevrolet Suburban 1500

.0 engine on 2003 ford ranger replaced idler pulleys, fan belt, still doing it what could it be?


A faulty belt tensioner pulley could be cause of belt slipping squealing ... Cars & Trucks

2003 chevy suburban 1500 LT replace my tensioner pulley and belt for my a/c compressor and now my tensioner is rocking back and forth and the truck idels hard when the a/c or heat is on


Hi! You may need to put a washer on the pulley. The nut may be pressing the pulley so much. Putting a lock washer on the pulley and loosening the belt a little can help the pulley work freely. Hope this helps and have a good one! ... Chevrolet Suburban 1500

How do i adjust the valves on a 1999 chevy suburban? replaced head gaskets starting over on this vortec 5.7L engine the ac bracket and pump has to be removed so it has no serpentine belt. used original method of taking out the valve lash then going one turn further but now have no compression.


Push rods are adjusted hydraulically,by oil pressure.your 1 turn further was 1 turn too many. ... 2003 Chevrolet Suburban 1500

How to move the serpentine belt tension pulley on a 2001 chevrolet suburban in order to replace the alternator? thanks


You don`t have to remove the pulley itself.Use a light and look at the tensioner.You will see a square hole on the front of the tensioner.All you need to do is put your 3/8 ratchet in this hole and relieve the t ... 2001 Chevrolet Suburban

I have replaced timing belt have checked the timing several times and i am not able to get it started and i checked cylinder compression and found that each cylinder only had about 0-25 lbs. compression


Sounds like bent valves or as a worse case scenario you have the CAM shift 180 degrees out. That timing mark will line up in the correct position and when it is 180 degrees out. If the original timing belt broke while the vehicle was running the mo ... 2001 Kia Sportage

How to replace serpentine belt suburban - Cars & Trucks


... Cars & Trucks

Surpantine belt is squeeling after replacing the power steering pump on a 1990 chevy suburban 2500 4x4


MAKE SURE THE POWER STEERING PULLEY IS NOT OUT OF ALIGNMENT.CHECK THE BELT FOR CONAMINATION ... 1991 GMC Suburban

1988 chevy suburban charging system problem alternator wont charge new alternator new ignition switch good battery good belt removed old alarm system removed and replaced fusible links no shorts in system i am stumpted


First check alt At The Back of Alt Big Red Wire Were hooks to Post (stud) Do you have voltage ?? How Much??\015\012What Voltage do you have at same Place with Engine Running ??\015\012 Now At wires Were they plug into Alt ,Top. Wire ... 1988 Chevrolet Suburban

Hello i have a 02 suburban i notice when i turn the ac on i have a noise i went under the truck and i noticed the belt is a little bit lose is that means the tensioner needs to be replaced but i can see many people have the same problem and they say even after they repalce the tensioner still doing that noise what can i do?


I would replace the belt first. It could of stretched or is contaminated. The tensoiner should have a min and max position. Mark the position before you remove the belt so you can see if the tensioner is maxed out or still about in the middle or les ... 2003 Chevrolet Suburban 1500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.7039 seconds