Having problems with your Cars & Trucks ?

307cc peugot bumper removal

\015 How do i remove rear bumper of peugot307\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

307cc peugot bumper removal


... Cars & Trucks

How to remove rear bumper of peugot 307 sw 2003


... Cars & Trucks

I need to remove the right side headlight assembly. Deal says the bumper must come off first, is this true or can I remove it without removing front bumper. If I remove front bumper do I have a problem with airbag switches


No, you don't have to remove the front bumper. The headlight bulb is in a tight spot so you will need someone with small hands to reach it. Pull the rubber boot with the connector offand there is a spring clip that holds the bulb in place ... 2006 Suzuki Grand Vitara

Bumper estimate My son backed into the rear bumper of a 2000 pathfinder. It caused minor scratch marks and about a quarter size dent. Estimates for repair at two locations in the Seattle area were $550 and $640. The lady was just as surprised as us on the costs of repair. She said most of the cost was in the bumper removal. Could you explain the reason for so much labor to remove the bumper? Any insight or help would be greatly appreciated.


If this car is a second car why don't you find out if a shop would bench repair the bumper? You could take it off, have them recondition the part and then you reinstall it.\015\012If you have time and luck there may be a twin car to yours in a ... 2000 Nissan Pathfinder

2006 jeep grand Cherokee headlamp assembly removal( passenger side): got the grill off and the air filter intake removed as well as one of the 3 screws holding the assembly in. However i cant figure out how to get to the 2 screws below the assembly that are blocked by the bumper. It seems that the bumper would have to be removed to get to these 2 screws. Any input would be greatly appreciated!


... 2006 Jeep Grand Cherokee

My 2009 Corolloa LE was bumped in a parking lot by a yellow truck, on the right rear bulge of the bumper, leaving a ding in the bumper. I can only partially access the backside of the bump by removing the right rear tailight. The ding has a crease so none of the 'easy' methods of pulling it out work. How do I remove the entire rear bumper?


Go underneath with socket and wrench. there will be 2 bolts with nuts on one end and two on the other end. Then the entire bumper can then pull off. ... 2009 Toyota Corolla

Toyota Echo 2004 Hatchback Replace Rear Bumper Hi,I have removed two screws along the hatch, and two more on the bottom of the bumper, but still could not remove the bumper. Need some help on this. Thanks in advance.


There is a screw on each side of the bumper cover at the wheel wells. It should be a 10mm. You might have to move the 1/4 liner over a bit to fond them. After those bolts are removed, you can pull the sides of the cover away from the quarter. ... 2004 Toyota ECHO

How to remove a front bumper on ford f 150 1994. My bumper is not level. I want to remove it and reinstall it correctly


... Ford F-150

Removing the rear bumper cover on a 2003 cadillac ext. I need to replace the rear sensor. I was told I need to remove the bumper cover to install it. thanks craig


... 2003 Cadillac Escalade Ext

How do you remove the front bumper of a 04 cadillac srx in order to replace the headlight turn signal bulbs? The wheel well cover and cover beneath the bumper has been removed.


... 2004 Cadillac SRX

Front bumper on my 2001 xterra is rusting. I want to remove it , sand it and repaint. How do I remove the front bumper?


Grab a factory service manual it will make it much easier, plus you may need to remove other parts as well. Here is link to a factory ... 2001 Nissan Xterra

Headlight how do you remove the front bumper of a 04 cadillac srx in order to replace the headlight turn signal bulbs? The wheel well cover and cover beneath the bumper has been removed


Well according to my mitchell manuel you don't have to.here is the procedure.\015\0121. open the hood.\015\0122.Remove the push-pin retainer's that secure the top of the upper facia and grill assembly to the upper tie bar to allow the upp ... 2004 Cadillac SRX

Remove front bumper cover 06 Toyota Highlander. The one I have is dented and I want to replace the front bumper cover. Is there a removal of bolts sequence? Where are the bolts/clips?


... 2006 Toyota Highlander

How do you replace a tail lamp on a 2007 toyota avalon it appears you have to remove the bumper if that is the case how do you remove the bumper is there special tools ?


You should be able to access taillights through the trunk unloosen 2 or 3 fasteners and the globe where the bulbs are located. ... 2007 Toyota Avalon

How to remove bumper to change the fog lights glass is broken from the fog lights in volvo s 40 sport 2003 how to remove the bumper so its possibleto change the glas


YOU SHOULDNT HAVE TO REMOVE THE WHOLE BUMPER.JUST REMOVE THE LOWER BUMPER PLASTIC COVER. ... Volvo S40

I need to remove the front bumper cover on a 2002 Toyota Highlander to be able to install new headlight assemblies. I found information that indicates you need to remove both the grill and bumper cover to be able to take out and reinstall the new headlights.


Open hood and look on top of headlamps. You see a piece that looks like it slides in behind the light.Have removed two mounting srews. Disconnected plastic grill. The bottom of the head light is held in by snap clips. The bumper cover nee ... 2002 Toyota Highlander

Bumper just fell off and I noticed the plastic tabs that hold it to the bumper are all broken off . How would you be able to remove the screws that fasten the bumper tabs to the bumper. There seems to be no access to the screws.


... Mitsubishi Mirage

Indicator light on right side not working on bumper. told by garage have to remove bumper !


... 2006 Volkswagen Passat

Vw polo 2000 remove front bumper how to remove it


... Cars & Trucks

How do I remove damaged bumper from 1999 Honda CR-V?


... 2005 Honda CR-V

How do you replace the rear bumper on a 98 mercedes ml320? is that something i could do myself? I dented the rear bumper and want to rplace it, but i want to go to a salvage yard to find a replacement so i don't have to buy a new one. how do i remove the bumper without damaging it and how do i put it on. are there special tools required? i have some car repair experience.


Its actually pretty easy to replace the rear bumper. I don't think you should have any problems doing it yourself. If I remember right I think there is only like 6 or 8 nuts that hold it on. 2 one each of the side and a couple in the middle. Just nee ... Mercedes-Benz ML320

Daughter has a 94 Acura Integra RS. She hit the back end of a POS and dented the guy's bumper (not that you could really tell any difference from before), but she smushed in her right front bumper area of her car. It pierced the condensor (we ended up removing it - doesn't need ac right now anyway). From what I can see, if we simply pull out the right front bumper area a little, the end of the quarter panel would go back into place and it would be smooth again (it's sticking up over the end o


THE BEST THING TO DO IS TO TAKE TO A BODY SHOP AND FIND OUT IF YOU GOT FRAME DAMAGE JUST BY WHAT YOUR ARE SAYING IT SOUNDS LIKE DOES ALWAYS LOOK AT BODY LINES BODY LINE CAN TELL YOU A LOT ABOUT THE CONDITION OF THE FRAME OF THE CAR... ... 1994 Acura Integra

Trying to remove right front fender of 94 Grand Cherokee to get at attenae to replace it. can't see where last screw on right needs to be removed near headlight so that I can slide fender to right. Does front bumper need to be removed to do that?


Yes and maybe the front grille. Its pretty obviouse that stuff needs to be removed to access everthing. ... Jeep Grand Cherokee

How to remove front bumper on 2002 almera I have removed all obvious bolts and plastic popout studs but something is still holding it at the front corners at each side of the headlights, I removed the plastic wheel arch covers thus exposing a self tapping screw, but there is something still holding it.


... 2003 Nissan Altima

I have an 02 Mazda Tribute with a leaking radiator.Are there any tricks in removing the radiator to repair it? The Radiator People told me that they have never done one of these before and may have to remove the bumper to access the radiator and that they can't do it because they are not licensed to remove bumpers.I want to do it myself because I can't believe it could be that difficult .


1. Drain coolant\015\0122 Remove lower splash shields\015\0123. Disconnect the lower radiator hose and the high pressure transaxle line\015\0124. Lower the vehicle\015\0125. Disconnect the transaxle return line\015\0126. ... 2002 Mazda Tribute
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0190 seconds