Having problems with your Cars & Trucks ?

How to replace at control relay 2004 santa fe

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Am a homeowner of a drive 2001 Hyundai Santa Fe 2.7 2001 he replaced the Knock Sensor and Camsensor and reports the following code p1723 or Control Relay Stuck-on. The transmission will only accept the shift to Drive and Third. I would like to know how I can resolve this situation. Thanks


... Cars & Trucks

How to replace at control relay 2004 santa fe


... Cars & Trucks

Control box One of the relays in the control box is clicking very fast when the key is in accessories. Check engine light is on. Car wont start. Sometimes it sounds like the main relay clicks fast too but that isn't the issue because i just replaced it and the relay in the control box will do it without the main relay clicking. If i unhook the wire harness on the left the clicking stops but the check engine light stays and the car still wont start.


Try replacing the relay that is clicking ... 1992 Honda Accord

On my 1994 S-10 Blazer, the AC/Heater stopped blowing on high speed about 2 years ago. By switching the speed control quickly back and forth, sometimes High would work. But not anymore. I had the A/C compressor replaced 2 weeks ago and settings 1-3 still worked, but still no High setting. Now, it only blows on Low no matter what the control is set on. I replaced the blower motor resistor assembly (attached to the blower motor housing) AND the blower motor relay (5 pin relay attached to the ba


Sometimes the electrical connecter burns on the back side of your switch. You can get just the switch and replace it and repair the connecter when possible. ... Chevrolet S 10

I have a 1996 Olds Cutlass Supreme 3.1 and the fans do not kick on when you engage the AC. The compressor and freon has been replaced. The dash contol module has been replaced. The fuses and relays have been checked and the fans work when you short across the relays. I was told that the wire from the dash controls to the fuse box might be defective. Can I run a new wire from the dash controls? Which wire from the back of the dash module do I hook into?


Fan relay at the engine block. its a temp. sensor. dont rewire anything you can fry the computer ... 1999 Nissan Pathfinder

I have replaced the cabin comfort controls, blower motor, resistor, checked all fuses, replaced the a/c heateractuator, replaced the relay under the hood. I still cannot get the controls to operate th


... 1998 Chevrolet C1500

1986 ford ranger 2.9 v6 40 min warm-up Cuts out and Stalls Replaced booster fuel pump ,fuel tank pump, fuel filter,fuel pressure regulator Cleaned injectors replaced fuel cut-out switch replaced fuel relay,Oxygen Sensor ,Oxygen Control valve ,MAP Sensor and Computer Replaced Distributer,Ignition control module,Pick-up coil Cap n rotor Spark plugs and wires


... 1986 Ford Ranger 2WD

I have a 1994 Chrysler Concorde that has Automatic temp control (Which is bad according to the self-test and needs replaced) and would like info on trying to remanufacture the original in my car. There is a relay in the back of the ATC and I can't find a supplier of this relay, yet there are remanufacture companies that rebuild these and can get this relay. I just wish I knew where I can get a new one. Do you know anywhere I can get this relay replaced. Also when the bad ATC is on [plugged in]


... Chrysler Concorde

1989 Mazda MX-6 Turbo: Air Cond Blower does not turn on from control panel. Actions taken-1) Put direct pwr to blower motor = works fine. 2)Replaced resistor = nothing. 3)Changed blower motor relay = nothing. 4)Tested pwr to control head = nothing. Final - Pwr is at relay. Put old relay and resistor back.


... 1989 Mazda MX-6

Headlights blinking 95 concorde - recently replaced powertrain control module. Now when any door is opened, the headlights start flashing. Initial trace found that the headlamp delay relay was clicking. Remove relay and lights stop flashing. However, removing relay also kills instrument panel lamps. Currently have entire dash broken down and open. Have checked the body control module, headlight switch and connectors, headlamp dimmer switch, all door switches. No problems or defects (i.e. shorts


... 1995 Chrysler Concorde

Volvo V70 AC Climate Control not working. My Volvo V70 1998 Climate Control won't switch on. I have no flashing lights on the control panel, it works fine. I bypassed the AC relay and the compressor engaged and worked ok no problems nice and cold but that meant it would be permanently on and may cause damage? So I replaced the relay with a new one, still have the same problem it won't turn on and the compressor does not engage. Also I had the system regassed still no luck!!! Anybody got any idea


... 1998 Volvo V70

I have a 2000 Subaru impreza wagon. Keep blowing heater fuses. Replaced Control Unit, Relay and checked blower motor. Yes i replaced the fuses.


... 2000 Subaru Impreza

91 F-150, 300 inline 6, Fuel injection. I have a problem with my fuel system. When I turn the ignition to the on position, the fuel pump will not shut off. I replaced the fuel pump relay and the eec relay and problem not resolved. The only choice I have left is the powertrain control module but I would like to know if I may be missing a chance of another fault before replacing the most exspensive part involved.


Looking at the wiring diagram - the controls for the pump are...\015\012Fuel Pump relay (already changed)\015\012EEC Power relay (already changed)\015\012EECM\015\012\015\012There IS a slight chance of the can-purge purg ... Ford F-150

MY 1996 Lincoln Mark V111 has no fuel Pump ground car will not start unless you ground the fuel Relay to battery, body,or engine. The fuel pump relay is supposed to ground by Power Control Module (PCM) thru the Variable Load Control Module (VLCM). I REPLACE THEM BOTH


... Lincoln Mark VIII

I have a 1993 Honda Accord (auto-matic, cruise control) and recently it started cutting off after about 10-15 minutes on constant driving. I was told that the main-relay may need to be replaced or soddered (bad spelling). I replaced it and the car starts more frequently now, but still cuts off just as much. Another mechanic told me that the distributer is heating up and causing the something electronic (possibly the main relay) to shut the car off. My other problem is that every once in a whi


The distributor must not heat up. If the distributor is really hot, then the distributor must be replaced.\015\012\015\012Your car is not a PC, you do not know that this is an heating problem. Normally, a car only heating problems are concernin ... Honda Accord

97 Sable no voltage to any power windows/ replaced interior lamp relay and all fuses in fuse box under dash and relays in engine compartment, replaced drivers control switch on door. is there another power supply area I haven't found, where is it, what else can I look for? definitely no power to any windows not just drivers


The circuits get their power from the BATTERY SAVER RELAY (K115) which feeds the ACCESSORY RELAY (K65) which feeds ONE TOUCH WINDOW RELAY (K50) and all the the other power window circuits. Central Junction Box (C ... 1997 Mercury Sable

Fan works in high speed only, replaced control panel, no change.the compressor will not operate, replaced compressor relay and clutch relay, no change any help!!!!!!!


I can't help with your compressor issue but I can with your blower motor fan. It is more than likely the blower motor resistor. They're designed so that when they fail they default to high. I can't really give you a location or installation instructi ... Ford Contour

I have a 1992 hyundai scoupe it is not getting fuel throught the injectors i replaced the electric fuel pump in the tank and it is not getting any fire to the pump i can run a hot wire to the pump and it works but car will not start fuel gets to the fuel rail just fine but seems to not get through the injector. i replaced the fuel pump ,fuel regulator ,ignition control module,and have since purchased a fuel injection relay but i have no idea were it goes i have a new fuel pump relay also but i


Hello\015\012First i would like to say you may be chasing your tail on the fuel pump, the opump doesn't run for more than 1 second if the ignition is turned on unless 1. the engine is cranking to start or 2. the engine ... Hyundai Motor 1992 Scoupe

Ac compressor wont go on jumped comp took full charge replaced relay could it be control panel had friend who is a good tech do it he said its probably the control panel is there any oter relay. could it be a fuse he said he checked.


Ac compresor relay diagram/scamatic ... Chevrolet Corvette

I have a 2001 Grand cherokee Laredo, 4.0, 6 cyl. Have had the Fan Relay replaced and Control Module because of overheating. Now it is overheating again. Any suggestions? And are the fan relay and control module the same thing?


If the fan is not cycling when the engine gets hot, you'll have to test the fan motor and the temperature sensor. If the fan is running and it's still hot, the thermostat may be the cause. ... 2001 Jeep Grand Cherokee

Climate control not working and both fans staying on. Has new climate control unit put in and a/c gas has been replaced still no a/c or heater.All relays and fuses have been replaced as well.Does aanyone know anything about these cars? HELP....! 2006 VW GTI 5 door


Is there any faults in the system? the big radiator fan could be faulty.the condensor could be blocked.have the fault codes read first. ... 2006 Volkswagen GTI

Driver's side headlight will not work. Daytime runlight control was buzzing (like a stuck relay) so it has been removed, will be replaced. Even without the daytime control the headlight will still not work. Bulbs have been replaced on both side of vehicle. Any ideas?


... Nissan Altima

1994 Caravan 3.3L replaced fuel pump with junkyard unit from a different year, now truck stalls at low speed driving (idles OK). Tried direct wiring pump (no relay), I can solve this by interrupting electricity to the pump for a few seconds at intervals. Does the replacement fuel pump have too high pressure? Does the pump relay cycle in operation to control pressure?


I wouldnt have put in a used pump especially with all the work needed to put it in. And one from another year is definitely not recomended because we dont know what each years flow rate is. Also chech your fuel pressure regulator as this should be co ... 2004 Dodge Grand Caravan

1999 DODGE DURANGO, 5.2 PCM SHORT. came in for a check engine light, troble codes p0740 governor pressure soleniod, p0753 overdrive solenoid circuit, p1682 charging system voltage too low and p1765 transmission voltage relay circuit. test and found pcm was not controlling field voltage from altenator. pcm replacement and altenator replacement was done and rechecked for charging and test driven for transmission codes and all is good. pcm connector pins, circuits, solenoids and relays were tested


... 1999 Dodge Durango

My headlights will not turn on nor flip up. My brights will turn on and flip up, but not the normal headlights. I have replaced the Headlight switch control arm AND the control circuit relay box. Mechanics have been tracing lines and can't find it. They say there may be a short somewhere in the harness. How do I replace the harness?


\012The observation with your vehicle implies mechanical malfunctions likely caused by insufficient, clogged, or burnout lubrication fluids. Since the component parts experiencing malfunction are observable at significant v ... 1992 Toyota Celica
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.9194 seconds