Having problems with your Cars & Trucks ?

Where is the o2 sensor on a 94 ranger 2.3l

\015 I have a 94 ranger 2.3l and need to put a air fuel gauge in it what wire do i cut into to get it working right???\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

The sensor is below the vehicle on the exhaust pipe. Before the catalytic converter
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

91 ford ranger o2 sensor one or two sensors? - Ranger Ford Cars & Trucks


... Ford Ranger

93 Ford Ranger,3.0 jerks while at cruising speeds. It has a squeal on cold starts that goes away after driving a few blocks. And rough idle. This engine does not have an EGR valve. I was told it could be a bad distributor or cam sensor. Does it have a cam sensor and/or distributor? I dont want to feel stupid when I take it in and tell the mechanic that info and he tells me that I dont have them. But I think my older Ranger (93) does have distributor and not a synchrnizer. Thank you!


I just changed my fan clutch on my 93 Ford Ranger and the difference is amazing. It stopped making noise and it drives much smoother now. The fan clutch was only $45 and fairly easy to replace so you might want to check into that. ... Ford Ranger

1999 ford ranger running to lean repalced m f snesor idle air c ontrol sensor throttle body sensor 3 o 2 sensor temperature sensor


... 1990 Ford F150

1998 ford ranger obd code cam sensor miss fire monitor bought a a used motor 97 last year the assembly and sensor were missing so we used the one from old motor witch worked fine but now it is time to smog the mil lite stays on. It won't pass replaced sensor useing tool for assembly no change


Please get a brand new sensor.New parts are better than used/ old parts.Visit www.repairpal.com (for estimates)Visit http://www.autopartswarehouse.com/ (for genuine parts)Good luck and remember to rate ... Ford Ranger

My 93 ford ranger will start but will not stay running new fuel pump and filter different mass airflow sensor and idle air control sensor different ignition sensor what could this be?


What engine? Will it stay running if you keep your foot on the gas? ... 1993 Ford Ranger SuperCab

1998 and 2003 rangers will not start unless ether or gas is poured into the intake.2003 has done this 4 times,it only has 32k miles on it.i researched other rangers online and they have the same issue.eventually they will pick a day to start.one guy replaced the whole fuel system includeing the tank...another guy spent 2400.00 at the dealership and his still has the same problem..any ideas on the ranger mystery? from what i researched every sensor,relay,etc had been replaced on some of these veh


... 1994 Ford Ranger Supercab

My 2000 Ford Ranger 3.0L V6 engine first started pinging.Now it's started having a.loud knocking noise ,like its the conrodbarrings knocking .But I looked up in ford. Repair manual knock sensor and it said a.faulty knock sensor could cause the knocking from the engine.Where is the knock sensor located ?


... Cars & Trucks

Got 97 ford ranger 2.3 rough idle has not died on me but will drive down road like normal but lil jumpy it is throwing codes for egr valve , mass air flow sensor, o2 sensor, so I put new ones on, I put new vacuum lines on almost all but can't find no leak also replaced egr sensor


... Cars & Trucks

1988 ford ranger 2.3l 5spd 2wd. Exhaust pipe tip is black. Fuel mileage is 13mpg. Replaced fuel filter; 8 plugs and wires, o2 sensor,thermostat,air filter,egr valve,cleaned iac and intake,ran sea foam cleaner in vacuum lines. Idles ruff on cold start, then smooths some, low power, clean low miles vehicle. All 8 plugs were black as well as o2 sensor. Not oils. Too much fuel. Where is and how check air sensors? What fuel press at idle and rev up? Where is fuel press reg? Any other suggestions? Tha


... Cars & Trucks

My 2000 Ford Ranger 3.0L V6 engine first started pinging.Now it's started having a.loud knocking noise ,like its the conrodbarrings knocking .But I looked up in ford. Repair manual knock sensor and it said a.faulty knock sensor could cause the knocking from the engine.Where is the knock sensor located ?


... Cars & Trucks

Tengo un motor ford ranger 94 4L reconstruido lo mande a montar en una mazda pikop 96 B4000 despues de montadola guagua corrio bien por dos semanas y me esploto el sensor del aceite que era del otro motor le combie el aceite y el filtro y le puse otro sensor de aceite nuevo corrio como dos semanas imedia y bolvio esplotar el sensor de aceiter me podrian esplicar que susede. gracias


... 1996 Ford Ranger SuperCab

1988 ford ranger, 2.9L V6. IF I DRIVE OFF BEFORE IT COMES OFF HIGH IDLE, IT STARVES FOR FUEL. THIS PROBLEM IS EFFECTED BY WEATHER (HOT DRY AIR IS WORSE THAN MOIST COOL AIR). CHANGED FUEL FILTER, O2 SENSOR, TEMP SENSOR. COULD IT BE MAP SENSOR? ANY HELP APPRECIATED.


... 1988 Ford Ranger

I have a 1999 Ford Ranger 2.5L 2WD. The check engine light is on and displaying 5 codes when I scan it. P1506 (IAC overspeed error), P0135 (O2 bank 1 sensor 1), P1451 (Evap), P0141 (O2 bank 1 sensor


... 1999 Ford Ranger SuperCab

O reading for O2 sensors on 98 Ranger XLT


Yes the 98 ranger has 3 02 sensors,they are located in the exhaust system under vehicle,2 of them\015\012are in front of the cataletic converter and 1 behind it.I replaced mine ,reset the codes and the check\015\012engine light still come ... 2004 Ford Ranger

The overdrive went out of my 93 ranger while driving. There was a vibration right before it went from drive to overdrive. Is there a sensor that could help this problem? Just wanting to take the cheap route before replacing the transmission. (This ranger is also 4x4.) Thank you


No the bands inside the trany burnt up, sorry ... 1993 Ford Ranger SuperCab

How does a fuel tank level sensor fail and what can cause it to fail? Four days ago I bought a 2006 Ford Ranger from a Ford dealer. Just before driving it off the lot the fuel gauge started acting erratically. Would properly indicate a full tank and then for no reason indicate empty. Engine trouble codes P0461 and P0463 also appeared which are related to tank sensor. Had been on the lot for a while without a gas cap and with very little fuel in it. But now the last couple days the gauge has


To have it done it will be $400.00 to $700.00. Depending on where you go.\015\012\015\012If you are going to do it your self then here is the deal.\015\012\015\012Well it's a common problem that occ ... Ford Ranger

I have a 1998 ford ranger and the temperture gauge will not work. If i ground the wire that goes to sensor the gauge moves I replace the sensor and nothing happens the gauge never moves.


When you grounded the wire which goes to the sensor you produced a short to ground thru the guage. This probably either blew a fuse or burned out the meter. ... 1998 Ford Ranger SuperCab

I have a 1993 ford ranger with a 2.3 4 cyl. I cant get spark i have replaced ignition modul and engine computer . have not replaced coil packs because they pass the test that my Haynes manual showed. Can the crank angle sensor or one of the other sensors cause this problem?


Yes the crank angle sensor can couse and but some time the coil test ant always right ether they may test good and be bad hope this helps ... 1993 Ford Ranger SuperCab

98 ford ranger 4.0L runs very rough when mass air flow sensor is plugged in. runs, but still a little rough but drivable when unplugged. tried new sensor, still the same. any ideas?


When Driving my 98 ranger in the hills it miss fires, what would cause this ... 1998 Ford Ranger SuperCab

I have a ford ranger 2001 V6 3.0 I have been trying to smog since feb. we did a valve job/replaced the mass air flow sensor/replaced the computer/sychronizer/ had the sychronizer reset have driven truck 600 miles and have 4 monitors not reset,oxygen sensor heater monitor,secondary air injection system monitor,catalyst efficiency monitor,oxygen sensor monitor and or evap monitor 4 of these monitor won't reset after about 600 miles of driving check engine light is not on, What to do!!


The system has not reset, it is not how many miles u drive but how u drive them, it takes special types of driving for the system to complete self testing and clear drive not complete which is a code P1000, here is the Ford service manual drive cycle ... Ford Ranger

I just bought a 2001 ranger and the abs light was on, looked at the abs sensor in the front and seen it was not hookd up, so i hooked it back up and it went off but as soon as i started to move the truck the light came back on, i already replaced the front right and back sensor, any idea on wat it could be? thx in advance


Check sensor wires that plug in at loer driver side of the master cylinder. The wires sometimes break inside the conector on the end of the wires ... 2001 Ford Ranger Regular Cab

My 97 ford ranger wont idle it dies i have to drive it with one foot on the brake and one on the gas. I looked at the engine and found some sort of sensor with two tubes coming out of it and a wiring harness plug in coming of the exhaust manifold. one of the tubes had a hole melted through it i replaced it and two days later the hose barb that the tubing slips onto had melted off. What is this sensor and what can i do to fix it. it seems like there is a bigger problem causing it to get to hot wh


... 1997 Ford Ranger SuperCab

I just bought a 2001 ranger and the abs light was on, looked at the abs sensor in the front and seen it was not hookd up, so i hooked it back up and it went off but as soon as i started to move the truck the light came back on,the speedometer/odometer and tranny work fine and i already replaced the front right and back sensor, any idea on wat it could be? thx in advance


The most common problem in this system is the wheel speed sensors, which i believe is what you have, this can be a sensor having metal particles on it and confusing the signal (they are magnetic sensors) or the sensor or the wiring to th ... Ford Ranger

Got a 94 ford ranger its coding 172 and 177 which is lack of oxygen sensor switches indecates lean and hego [ho2s-2*]sensor circut indecates system always rich how do i fix this


... 1996 Ford Ranger SuperCab

I have a 86 Ranger 4x4 2.9 5 speed.When the rpm get to about 2500 rpm it start to cut out.I have replace all the sensor, pump in the tank,dist,fuel reg,plugs,wires,coil air valve (all new parts).I have check pressure on both side of the cats (2.5lbs).Fuel pressure is 40lbs key on 30lbs when running.vac is 15lbs strong my elv.is 4200 ft.I have check volts at the dis.and sensors and they check good.It runs good up 55 mph gas milage is at 20 mpg.where do I go next? Could there be a voltage feedback


Check the hall effect switch in the distributor ... 1986 Ford Ranger 2WD
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0458 seconds