Having problems with your Cars & Trucks ?

How to set timing on audi tt 225 mk1

\015 How to set timing marks\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hw to set timing on an audi tt 225 mk1

... Cars & Trucks

How to set timing on audi tt 225 mk1

... Cars & Trucks

My blitz turbo timer calculates time fine and displays how long the car will continue running but when i turn the car off the time sets to 0 and turns the car off, it used to work fine but now i dont know whats wrong with it, i messed with a few settings and set the minimum tome to 30 seconds but the car will still turn off.

... 1997 Mitsubishi Galant

Had the head redone, new Carb fitted, new distributor cover and leads new spark plugs, crank timing set to mark (0)and cam timing (2e)set to mark on head. the engine swings, fires from the carb, spark on leads. engine wont start, backfires but not running

Sounds like you have your timing off. If it is backfiring, that means that 2 of your wires are crossed, causing the plugs to fire on the exhaust stroke versus the compression stroke. Recheck your timing. ... 1984 Toyota Corolla

If the timing mark on the crank shaft pulley is set at 0 would that be the same as taking off the crankshaft pully and setting the timing mark on the block

Yes. that is correct 0 = 0 ... 1990 Toyota Pickup

What should i set the timing at for my 94 geo metro i have a timing light should i set it at 0?

Unless you have replaced the hood or the sticker has been removed, there should be a label on the inside of your hood that lists the correct timing. Make sure you short the two appropriate wires in the 'test plug' before setting the timin ... 1994 Geo Metro

Engine timing i have an 1989 audi 80, set engine on timing marks then replaced timing belt, then repositioned on marks. the distributor may have moved. now it wont start. theres good crank, spark and fuel, but no combustion. how can i start it?

Put car at top dead center then put the rotor on distributor to the first piston firing ... 1989 Audi 80

Setting Timing Just replaced the timing belt that had broke on this Audi and having a problem getting it back in time can you help me out. No I do not have the tool.

You need the tools to hold the cams. ... 2000 Audi A6

Honda stream 2.0L ivtec (same as civic type r) jumped the timing checked compression 200psi in all cylinders stripped and found faulty oil pressure tensioner replaced set up timing and rebuilt and started running perfect stopped and fit covers and wheel and tried to start turning over but not starting (turning over very fast) checked compression 0 on all cylinders stripped and aligned timing marks and checked chain tension all good

... 2003 Honda Stream

How do i set the timing for audi A6 2003

There are actually special tools the cam has no timing marks the tool only goes on one way and locks the cams in place and it is actually a long process but there is no way to do it without the cam lock ... 2003 Audi A6

How to set correct timing on 1994 Audi 100 CS quattro?

... 1994 Audi 100

How to set correct timing on 1994 Audi 100 CS quattro?

... 1992 Audi 100

Code 42 set on an '88 Camaro w TBI.Also very erratic idle, occasional backfire through exhaust,"jerky" on acceleration.Feels like a "miss" or skip.Base timing set at 0;2;4;6 all btdc with ESC bypass disconnected. No difference. Seems to idle slightly better with this bypass disconnected.Idles "crazy" after bypass reconnected.Ignition module checks good;good dist cap,rotor, coil,plug wires and plugs.New o2 sensor.Any thoughts? Is Knock Sensor associated with this code? Is EST associated with this

Listen to fuel pump w/ key on , if you hear a spraying sound, you may have a split hose in the tank ... 1994 Chevrolet C2500

Its A 1991 Olds Custom Cruser With A 350 Ive Changed Pick up Coil & Modual tp Senser Coolant temp Senser dis Modual map Senser pulled egr and plugged set timing 2 deg before 0 the stock setting The Car Pings At Low Load And Severly Pings under heavy load ???

How long has it had this spark knock? Did it come on suddenly or slowly worsen over a period of time? ... Oldsmobile Custom Cruiser

94 chevy suburban with 5.7. New dist cap, rotor, plugs, wires, fuel filter, battery, and last year new ign coil, module, and ecm. I set the timing to 0 at tdc with timing advance unplugged and when I plug advance back in, it hardly will start and when it does it is very very rough to where it will not stay running.

Sounds like timing is a little late. try a SLIGHT advancement (1-2 degrees) of the timing. keep trying until idle smooths out, listen for pinging on a steep hill in top gear. if engine pings at all other than at full throttle, timing is too far advan ... 1994 Chevrolet S-10

After i replaced cracked exhaust manifold engine has no power will idle but won't pull hill or run without missing at any speed and can get very little speed. I set timing at 8deg BTDC from 0 deg nothing changed. how do i re-time?

... 1996 Geo Tracker 2 Door

Hi I have a Audi A4 which the tensioner bolt broke and this made the timing belt become loose, replaced with new tensioner and set the timing up, car wont start, removed the rocker head cover and all the input valves are down does this mean that the valves are all damaged, the car is 20 valve 1.8.

If the intake valves are down you will have to remove the head and replace the valves. A compression test will confirm the issue. If the fact that the motor turns over to fast is not enough to convince you. Some motors are designed not to bend the va ... Audi A4

How can i increase or decrease settings? rpm low when warming and running low during normal operations? checked timing it's a 0 tdc. increasing idle speed works with rpm setting and carb?

What is Make, Model ,Year, and Engine?Does this have a distributor? Many GM's run a few degrees advance of TDC (Top Dead Center) on ignition timing.If it has a carburetor, be sure to unhook and plug the vacuum dash ... Chevrolet Silverado 1500

At elev. 8500 severe power loss under load. Live feed engine data as follows:0-5 engine timing retarded,pending code fuel system fault OL and sometimes will set mass air flow code. mass a sensor replaced recently. removed air filter resonator from behind bumper,left top portion w/filter element in place. once vehicle returns to lower elev. runs great.will not set code again until returns to 8k .vehicle 30k mi. org. owner.have own scanner w/live feed.

Does your scanner give you a reading for barometic pressure? ... 2001 Hyundai Sonata

What is the ignition timing set for on a 1989 Chevy 350CID 6 Liter engine. My truck was manufactured in Canada an there 350 CID engines are 6 Liter. When I adj mine for 0 Degree TDC like a 5.7 Liter engine it runs like the timing is wrong.

Try 10 btdc. ... Chevrolet Silverado 1500


Hi Tim,\015\012 Please check that there is no leakage in your water cooling system. If there is leakage, it causes the engine to heat up and burnup the gasket. You need to make sure your thermostat is also reset properly depending on the wea ... 1994 GMC Sierra

My Audi remote control key fob has stopped working.I've got a 2002 A4 Avant. Batteries have been replaced and still not working. Tried everything but no good tried resetting sometimes works for a short time but much worse now.What can i do now? My car only locks and sets the alarm if i manually lock the door with the key.My local garage says i need to go to an audi garage to solve the problem. Rather not.

Hi i gather you have done the rest the key by..pressing one of the buttons, then manually locking and unlocking within 30 seconds, then leaving it 1 minuet to set?, if you have then unfortunately your local gara ... 1996 Audi A4

How to set the timing belt on an audi a4 v6 - 1998 Audi A4

... 1998 Audi A4

How to set the timing belt on a 2002 audi - 2002 Audi A6

I need to know which year and model you have (A4, A6, A8, etc) and which engine (12v or 30v V6, 4.2 V8, 1.8T, 2.0T), and then I can help you with this. I hope you have not yet removed your belt - if you're looking for info on setting up the job, the ... 2002 Audi A6

What do you set the timing at? I need to know if I set it at 0 or at 26 degrees top dead center.

The timing specifications should be on a sticker either on the under side of the hood or on the cross member that houses the hood latching mechanism. Disconnect and plug the vacuum hose going to the distributor at the time of the procedure if this ... 1995 Ford Mustang
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6924 seconds