Having problems with your Cars & Trucks ?

Air/conditioning in 2005 Chevy Silverado/a/c fan will not work/last year replaced the resistor package/worked until this summer/fan does not work at all /resistor replaced again and nothing happens except compressor engages

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Can we just remove the ac unit?
There is a factory bulletin about this problem and a kit that must be installed to correct it. Contact the dealer and the factory customer service number for factory assistance with this defective design.
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Air/conditioning in 2005 Chevy Silverado/a/c fan will not work/last year replaced the resistor package/worked until this summer/fan does not work at all /resistor replaced again and nothing happens except compressor engages


Can we just remove the ac unit? ... Cars & Trucks

1995 Jeep Cherokee AC blower doesn't work. Replaced blower resister, blower, and Aux fan fuse and still it doesn't work. I'm running out of things to check. Original problem was that blower was screeching and then quit working. At the time it was only working on high speed. It quit working and also the AC compressor doesn't engage when switched to that position. I replace the usual suspects like the resistor and blower motor, but still no joy on getting it work. Will not work when switched to ve


Do you have feed to blower motor ?? sorry CSI is coming on TV now and er indoors is screaming that i spent too long on here '¡'¡'¡'¡'¡ usual ----typical woman ,if you have her i will throw my jag in the deal for free ... 1995 Jeep Grand Cherokee

Volvo V70 AC Climate Control not working. My Volvo V70 1998 Climate Control won't switch on. I have no flashing lights on the control panel, it works fine. I bypassed the AC relay and the compressor engaged and worked ok no problems nice and cold but that meant it would be permanently on and may cause damage? So I replaced the relay with a new one, still have the same problem it won't turn on and the compressor does not engage. Also I had the system regassed still no luck!!! Anybody got any idea


... 1998 Volvo V70

The AC on my 97 Ford Taurus only works sometimes. The clutch does not always engage. When I tap on it, it will then engage. What do I need to do? A few times the clutch only partially engages and it just rubs for a while without actually starting the compressor. If the clutch is bad, can I just replace it or do I have to replace the whole compressor? Thanks!


There is too much air gap between the hub and pulley. Usually, there are shims under the hub to set the proper gap. If you remove the small bolt in the center of the hub, it should slide off. There should be shims that look like small washers on the ... 1997 Ford Taurus

My heater blower stopped working on my 2002 Malibu. For awhile it worked only on a couple of speeds, then stopped working entirely. I replaced the blower resistor and this fixed the problem for about a week, then the blower stopped working again. I replaced the relay and the fuse, with no result. Recently, I noticed that the blower sometimes starts working for awhile when I slam the driver's side door hard, but it eventually stops working again. It works on all speeds when this happens. What do


Hello,\015\012\015\012The blower motor, as you have probably seen, is under the dash on the passengers side. While in Park with the parking brake applied:\015\012\015\012Turn the Key On with fan blower set to High. Locate the ... 2002 Chevrolet Malibu

Bought a used 93 mazda protege.(as is) A/C compressor does not start or engage.. When warmed up and running large primary fan is on. I fouund aux fan fuse removed from fuse box.under hood. I also found aux fan unplugged at connector.I replaced the fuse and compressor started working and main fan turned off at the same time. I reconnected aux fan (in front of radiator) and it did not work.I spun the fan manually and it started to work slowly then fuse blew within 5 min of replacing fuse. I tried


... 1993 Mazda Protege

1991 Buick Park Ave. climate control stopped working. Replaced electronic (dual zone) climate control module, unhooked negative battery cable to reset module and climate control worked for appx. 3 weeks, now same thing again. After replace & reset performed, all functions worked properly. When not working properly, only ''ECON'' is available and compressor will not engage.


Check to make sure that you have enought freon to engage the compressor, then you will need a flow chart to take you through the rest of the steps necessary to diagnos this problem. The Electrical system manual for Buick is the only one that will hav ... 1991 Buick Park Avenue

AC Squeal The AC makes a a noise that sounds like a loose belt. However I have already tightened the tension adjustment completely and replaced the belt. At higher RPM the squealing stops. My question(s) are: Is this indicative of a failing clutch? If it is most likely belt slippage, could I replace belt with slightly shorter belt or do I need to replace the tension adjustment device (the tension adjustment appears to be working properly)? The AC works fine its just whenever the compressor engag


Odd,possibly the AC is overcharged,or a pulley(either tensioner orPS ) is out of line. Wish I knew what kind of vehicle. Might help. ... Cars & Trucks

On my 1994 S-10 Blazer, the AC/Heater stopped blowing on high speed about 2 years ago. By switching the speed control quickly back and forth, sometimes High would work. But not anymore. I had the A/C compressor replaced 2 weeks ago and settings 1-3 still worked, but still no High setting. Now, it only blows on Low no matter what the control is set on. I replaced the blower motor resistor assembly (attached to the blower motor housing) AND the blower motor relay (5 pin relay attached to the ba


Sometimes the electrical connecter burns on the back side of your switch. You can get just the switch and replace it and repair the connecter when possible. ... Chevrolet S 10

Ford 91 crown victoria car auto transmition small d is not working on high speed.after 60 kmph gear is not engaging other gears are working This happened after I replaced both belt and also there was water and steam leakage from the big hose near the out let and temperature raised to half of the meter I replaced big hose and out let pipe at the engine.kindly help.


... 1994 Ford Crown Victoria

I have a 2000 Saturn LW2 V6 3.0. My heater quit working 2 years ago so I did my hw and found it to be the blower motor resistor. Well, the heater quit again with the same symptoms as before...intermittance...sometimes it would work on all settings, sometimes not at all and would come on or tirn off as I was driving down the road. I replaces the resistor yesturday...today..NO HEAT! Could someone please give me a clue as to what could be causing this to happen? I say a short or the blower motor is


With the vehicle running and the blower switch set to high and the blower motor not working tap the bottom of the blower motor with the handle end of a screwdriver. If the blower starts to work it is bad. Usually the brushes are worn out and tapping ... 2000 Saturn L-Series

Air contioning I recently replaced my compressor and it worked great for about a week then it started blowing warm air out so I took it back to the shop and they repalced the compressor again. now the same thing happened and it still isnt working consistenly, one day cold then the next hot air


Ck the a/c press. if its ok try a a/c relay ... 2005 Ford Taurus SE

2005 Chevy silverado a/c compressor not engaging. I can sometimes wiggle the relay under the compressor will engage. It may work 1 minute or one month then I have to do it again. I tried a new relay but change. Do I need to replace the junction block?


... Cars & Trucks

My bottom break light won't work. The top brake light works but neither bottom lights work. I've checked the fuse and replaced both bulbs but they still don't work. When I manually engage the brake pedal switch the same thing happens, top works, bottom won't. Thanks


You may have a problem with the turn signal switch, as power comes out of that switch to power the brake lights, the high mounted brake light does not go through that switch. ... 2003 Ford Explorer

Blower Earlier this year I had the car flused and new anti freeze put in, a new thermostat, heater core flushed, and a blower resistor replaces. Everything worked fine for the few times I used it, now the blower won't work at all. This happened a couple weeks ago where the blower didn't work and then it did and now it doesn't again. Also, not enough heat when it does work. Don't know what to do. Help and thanks. Helen


Well if the blower resistor was replaced, it was probably because the blower was drawing too much power so you probably burnt it again and so the resistor will need to replaced and the blower should be replaced as well to help prevent further problem ... 2002 Ford Taurus

I have a 2007 Ford Expedition EL I bought used last year. The Air conditioner stopped working last year after making a really funny sound and causing me to pull of the freeway to investigate. After replacing what sounded like everything front and rear (compressor blew and put medal through the lines) it worked again. It just made the same sound yesterday and the AC stopped working again. Is this a common issue with the Expedition? The interesting thing is both times it happened my travel trailer


... 2007 Ford Expedition Eddie Bauer EL

Airconditioner compressor (clutch) on 2001 chrysler neon 2.0 does not activate when turning on a/c. a) bypass of a/c relay in engine comparment control box causes clutch to engage b) fuse is not blown. c) relay is not faulty, no input signal. Q1 how do I release the centre console inside the car? Q2 what is the purpose of the pressure switch on the A/C compressor? The switch was replaced by agents, but still could not get a/c to work. Q3 compressor shudders when running with electrical bypass, a


Resolution:\015\012The problem turned out to be a blown fuse labelled EBL Clutch, located in the instrument console (side panel in the dashboard next to steering wheel on a RHD model).\015\012\015\012I downloaded the m ... 2001 Chrysler PT Cruiser

Clutch wont engage the compressor. Everything has been checked and seems to be working. Mechanic states I need to replace the whole compressor b/c clutch and compressor is not sold seperatly. Any other ideas?


Hi just a suggestion here that might save you some moneyHave the whole system drained and then fill it up again, bleed it through and see if that helps. it should cost you much but I had a similar problem on another model some years ago and it ... 2004 Honda Accord

2005 f150 a/c blower motor mot working? a/c still works if i put it on outside air and go 60mph you can feel cold air, the compressor still engages and works fine but no fan? maybe the resistor?


If it is the Blower Motor resistor, usually high speed still works.Check the blower motor relay ( next to the flasher by the steering column up under the dash ) and fuse #116. This is the relay that powers the blower motor from the HVAC ... 2005 Ford F-150

A/c not working . replaced compressor,evacuated flushed and recharged system, compressor will not engage. i need some help please


... 2007 Dodge Caliber SXT Sport Hatchback

2002 Ford Crown Vic 4.6L. EATCM A/C, Heating system. Replaced the blend door actuator due to stripped gear inside it. Before replacement could hear clicking noise coming from dash during temperature changes but nothing happened. Only hot air came out all positions. A/C is engaged and working at this time. Could switch from defrost to floor to panel to defrost/floor with no problem. Red and blue buttons showed temperature change but blend door did not move only clicked. After awhile the clicki


That clicking noise you hear is likely a relay in the fuse panel that needs to be replaced. the easiest way to find out which relay it is would be to put you finger on each relay as you actuate the device not working. once you locate the clicking r ... 2004 Ford Crown Victoria

1998 GMC Sierra. Blower motor works sometimes. No particular circumstances, just when it wants to. Checked all fuses, relays, even replaced the resistor, nothing. Followed the wire harness and found the two pigtails that others have mentioned. Took the wires off, black and purple, and turned ignition on. Getting around 11 volts on all sittings except for the highest setting, it reads 0 volts. The compressor turns on at the console, all the switches on the console work, just not the fan.


Could it be the blower motor it self? sometimes they have a "bad spot" when it is not working, can you hit it and make it run? pretty common on these trucks. the switch is also common. they often melt at the connector on the back making a bad connect ... 1998 GMC Sierra

I have a 2003 Hyundai Sante Fe. I'm told that the compressor has a leak in it and needs to be replaced. When it first started happening after driving for about 30 minutes straight it would stop blowing cold air and the flow of air would decrease alot. We had more freon put in and the system charged and it worked for a while and the same thing happened again. What do you think?


... 2003 Hyundai Santa Fe

I need to have the a/c clutch bering in my '99 Nissan Quest replaced. I am being told it would be less expensive to replace the compressor with the clutch and belts instead of just the bering. Any advice? Also, other than the ac not working, what will happen if the clutch on the ac goes out?


No that is not true, just replace the pulley and bearing assembly, the pulley and the bearing and field coil are sold as an assembly, you will need a special puller to remove the pulley or two small pry bars and a set of snap ring pliers from the com ... Nissan Quest

I replaced my blower motor on my 2003 pontiac aztek seems to be working great except now the air does not seem to come out any of the vents.i know the motor was bad cause i hooked up a new resistor to it and it still didnt work i didnt change anything else but the motor why is this happening?


... 2001 Pontiac Aztek
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3605 seconds