Having problems with your Cars & Trucks ?

I AM LOOKING FOR A LOWER WIRING HARNESS FOR A 1995 S500 MERCEDES,THE DEALERSHIP PART # IS 1404406105.I AM LOOKING TO PURCHASE IT CHEAPER THAN THE DEALER'S PRICE.

\015 MERCEDES DEALERSHIP PARTS #140406105. LOOKING FOR THE PART ON INTERNET.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Go to salvage yard
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I AM LOOKING FOR A LOWER WIRING HARNESS FOR A 1995 S500 MERCEDES,THE DEALERSHIP PART # IS 1404406105.I AM LOOKING TO PURCHASE IT CHEAPER THAN THE DEALER'S PRICE.


Go to salvage yard ... Cars & Trucks

1990 toyota 4 runner 3.0 rough idle , cuts off at traffic light oer when stopping unless put in neutral or park when rpm's jump up, yesterday one of your techs said to change IAC motor, so i called dealership gave them vin # and they told me how much part would be , Problem is i cant find it i know where TPS is and on throttle bobody there is 3 vacuum lines but i don't see anything else w/ elec wires that would indicate IAC also, i don't have new one to look at because dealer has to order but I


... Cars & Trucks

Just purchased a used car from a respective car dealership in the area I reside. I had to take the car back to the dealer I purchased it from to have them look at the gas tank, due to gas just spewing out of the tank at only about $4 into the fill-up. The Check engine light was not on until the dealer looked at but fixed the first problem. I have been informed that this could be due to my gas cap being loose. Is this a correct assumption, or should I worry? I actually took the car for a second o


There's a very minor vacumn leak somewhere in the fuel system, it's most likely the cap as stated. If the codes keeps comming back, go see the dealer that fixed the fuel tank problem about it. You should let them know your having trouble with it. ... Chevrolet Malibu

The alternator on our GMC Vandura with a V8 350 engine 5.7L locked and caught on fire. It messed up the plug in the back and by messed up I mean it was completely melted away. I purchased a new alternator and purchased a wire and plug set for the back at a GMC parts dealer. The problem though is that the wires on the new plug are all white and the two wires that have to be spliced with are two different colors, black and red. I have no clue which wire needs to splice with which wire on the n


I can help regarding the polarity on my GMC 2500 Van alternator....\015\012Facing the rear of the alternator, the red wire attaches to the screw terminal on the left. The black (grd) attaches to the screw terminal on the right. The top has a c ... GMC G2500

Looking for jsmes1027 i have a 97 explorer sport 6cyl OHV. I am trying locate a CPS because Ive been advised this is probably the solution for my no start problem. The dealership is asking for $136 for part #F0TZ6CV15DA. Online parts houses are asking from $17.50 to >$100 but most of the photos shown are different and the part numbers dont match even though the sub models are the same. Can u tell me what this part looks like, where is a good place to purchase it or where its located on t


I think you are referring to this part\012\012\012http://www.partsgeek.com/mmparts/crank_position_sensor/ford/explorer.html ... Ford Explorer Sport

Parts manual My local dealership does not have a clue how to look up parts for my Miata. Is there an OEM parts manual so I can look up parts and then have my dealer order them for me ?


If its a *** import some parts are different,you probally have a b6 engine,same as mazda astina ... 1990 Mazda MX-5

The heater fan went out on my 1995 Tercel... a local rip-off chain jerked me around on the price... they said they could only get a new part from a Toyota dealer - price was $200 for the part... the part is labled "denso 94000-0350 12V" In these tight fianacial times, can I get it cheaper and install it meslf?


Http://cgi.ebay.com/ebaymotors/ ... 1995 Toyota Tercel

The driver side window-supposedly the motor works but a wire has broken off. I was told that it is the regulator. Does it only need to be fixed by a Honda dealer? If not, can I purchase the part at a auto parts store?


I bought one from auto zone for a 1995 Accord. ... Honda Civic

I have a 2000 Intrepid with a 2.7L engine, it has a spun bearing and its making a tapping noise... i need to make the noise stop. I just purchased the car and it started to make that noise the day after, so now im looking to trade it in at a dealership and am looking to get the best price i can. If you have a solution that would make the noise be quiet for even just a day that would be great!!! Thanks!


Gear oil best bet but don't use alot it can catch the engine on fire. P.S i work as the forman for a dealership and 2.7 engine have known sludge issues I don't think there are going to miss this. when we get a old generation 2.7 we change the oil r ... 2000 Dodge Intrepid

Rear brake pads are worn on 1999 lexus rx300 would like factory part number to find factory parts at cheaper price,other than dealer


You won't get factory parts cheaper but you can get after market parts that meet factory specification's You want semi metallic pads because they last longer and don't wear out the rotors as bad as ... 1999 Lexus RX 300

I purchased an 88 mitsubishi pick-up someone has removed the distributor dealer part# MD110419. I would like to know what other vehicles share that part. So I know what to look for at the junk yard.


You would need to contact a salvage yard for this type of info, they have a parts cross over booklet ... Cars & Trucks

Hi I'm emailing from Ireland having just been given a quote of ?625 to replace inlet manifold flap motor and relay under fuse box. From looking online it would appear these parts which i am being quoted ?500 for from main dealer are available in UK for approx £200. could i just purchase parts from UK and get mechanic here to repair my car? would appreciate any help that might save me some hard earned cash!!


Most repair shops will allow you to purchase your own parts. But if the part fails, they will charge you to take it off and reinstall another one. ... 2006 Audi A3

I am looking for a Gem Module or a Body Control Module at a lower price than $400.00 for a 2001 Ford Windstar . My odometor,speedometor are not working ,my abs light is on along with my brake light. I was told to replace this part in order for the problem to be fixed but am having money problems and need to find a cheaper price and were to find it at this time.


Autozone has them for about $80 ... 2001 Ford Windstar

2004 Ram V-6 3.7 Liter. Start truck oil pressure gauge stays at zero. Shut it off and re-start and gauge works perfect. It only acts up at first start up. I purchased an oil pressure sending unit for the problem and went to replace it but then the plot thickens. Next to the oil filter is a sending unit that looks like what I bought from Dodge dealer how ever I wasn't able to get the connector off yet but there is a purple wire that goes into the end of the connector and it is cut off and wire is


To diagnose this properly and get all the information on locations your best bet is to go to mitchell1diy online and pay the 12 bucks for the info. I doubt this is a sensor issue. Its most likely a instrument cluster or computer problem. ... Dodge Pickup

Where is the transmission output speed sensor I purchased one but I cant find anything on the trans that looks like I found 2 sensors connected by a wireing harness and a single plug the part I have has no wires and one 3 prong male plug the vehicle is a 2000 elantra gls automatic trans


Located on top of transaxle on the side of the top RH bell housing bolt ... 2000 Hyundai Elantra

I got the p0443 code for evap system. took to mechanic they installed new solonoid.check engine light came back in ,they switch with another solo and still on.they switch around all 3solo check wires and everything they cant get engine light to stay off.voltage on evryting is good.they said take to dealer to see if something wrong with my computer to see why its not communiicating that the parts are good and they might have to flash the computer.what should i expect in price, or any solutions


Generally around $80.00 to $100.00 but is different prices in all parts of the USA. Depends on hourly rate or what they claim they have to do. Computer hook up alone generally runs around $60.00 to $80.00. ... 2002 Jeep Grand Cherokee

How much labor is involved with replacing the wiring harness to the PCM in an 03 Dodge Neon, dealership quoted $561 and I'm thinking that's too high, from what I looked up online it's only a $30 part..any help or guidance offered would be greatly appreciated.


... 2001 Dodge Neon

Is the oem factory eletric moonroof both the same complete assembly / same glass size / track dimensions / and motor / wiring In the 1997-98-99-00 chevy lumina sedan 4dr (AND) the same years chevy lumina z34 2dr moonroof I have a 1998 chevy lumina sedan 4dr and I looked at a 10th vin digit (N) the sticker was gone and I think the lumina sedan and the z34 moonroof is the same Tomorow I will go to the chevy dealer parts department and compare Iam in the auto industry


We dont understand your question.- If you are asking about if the moonroof work in this and other models, the answer is YES.- If you are asking about WHERE find this repalecement parts, I suggtes looking in any junk car, the dealer is ver ... 1998 Chevrolet Lumina

Looking for part number for hood release cable (2002 Volvo S80). The portion from inside cabin to engine compartment. And/or somewhere to purchase one besides the dealer.


... 2002 Volvo S80

I currently have a 2008 750i with a 24 month lease 15,000 miles per year. Purchase price was $85,000. My current payment is $1490 and residual s $55,000. I am looking for new 2010 750iand have gone to (2) dealers. The lease rates they have proposed were over $2000 per month on a $95,000 sticker. I want to pay what I am paying now or hopefully less. How do I get the best lease and who should I go through?


Your quotes are about right. Remember, it's not the dealer who's financing the lease, it's a bank. Because of that you aren't gonna get one cheaper, the banks have raised their interests and they tend to lend, especially on car leases, much harder an ... BMW 750

What would cause my 1999 vw beetle turbo exhaust to seperate? i was driving from the used car dealership the day i purchased it and only 20 miles away from the dealer it started making a very loud noise and vibrating. we pulled over off the highway looked under the car and saw the exhaust hanging and seperated. it is so frustrating because i had just signed all the paper work AS IS! so now i have to figure this out on my own. To top it all off the check engine light ended up coming on as well th


The problem is called rust and as exhausts rust from the inside you were just unlucky....sorry.the check light would have come on at the same time as it went. ... 1999 Volkswagen Beetle

I have a problem with a 2002 Chevy Impala, it has a slight hesitation when accelerating,also it has died a couple times then won't start for20-45 min. I had it looked at by a local shop and was told the catalytic converter needed replaced,parts alone were estimated at 650.00 . I checked witha couple other places and the estimates were 1/2 that amount. the car was purchased from a Chevy dealer and has 830000 miles on it, my problem is no one sounds certain that's the problem, any ideas?


I am having an issue with MAJOR hesitation when I step on the gas. I've changed the fuel filter and the throttle control sensor. Any suggerstions? ... 2002 Chevrolet Impala

Just bought a 2002 Mercury Sable LS, I brought it to Ford/Mercury repair to get a full diagnostic, they said I need to change the DPFE sensor, which some people say it's the same as the EGR sensor, but dealer said it's not the same. They also said I need to change all the vacuum hoses for the DPFE, can u please tell me where the DPFE sensor and the vacuum hoses are located & how it looks (eventually show pics) & where I could find all this cheaper than at the dealership. Thanks


You will need to get the parts from the dealer. What engine?the EGR valve is generally located on the backside of the intake plenum near the throttle body. There will be a metal pipe that goes in between the EGR valve and the ... Mercury Sable

MY BACK WINDOW FELL OUT OF THE CONT. TOP. The car is a 05 with 9000 miles garage kept but the dealer and everyone else I contacted told me I have to by a whole new top? Can't the window be sealed back to the top? I purchased a 2005 Crysler Crossfire two weeks ago and my back window fell out. The dealership also told me that I have to replace the top to fix this problem. I am looking for a solution to this problem.


Ya actually they only have a 3 year 36,000 mile bumper to bumper warranty. So unfortunately you are right outside of it. Though I would contact chrysler directly as that is pretty ridiculous to expect you to pay for it when the vehicle is that low of ... 2005 Chrysler Crossfire

Hi, the door check on drivers side of my 2003 Vibe is broken and door swings open freely as a result. I went to dealer and price for part#88973010 was over $100, not including labor. Need cheaper fix, any suggestions?


Strangely enough a simple door check does list out at well over $100. $146.62 to be exact. You may want to google a site that sells gm parts at wholesale prices and install it yourself. It should be nothing more then 4 small ... 2003 Pontiac Vibe
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.5812 seconds