Having problems with your Cars & Trucks ?

2001 Ford Crown Vic - not getting fuel

\015 Car quit running. Tried restarting and only gt sputtering, indicative of nt getting fuel delivery. Replaced fuel filter and fuel pump. Still no fuel delivery, only getting 5 volts at fuel pump connection.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1989 Ford Crown Vic, the gas tank got a hole in it so I swaped it out with one from my 1991 crown vic. The problem i'm getting now is my 89's tank had the fuel sender and pump in different holes, and my 91's tank has them in the same. The wire colors were the same so i hooked them up according to color and the pump works great but the fuel guage is not reading correctly. Is there a way to make it read write? or do i have to fix my old one and put it back in?


Put the old sending unit back in the newer tank ... Ford Crown Victoria

I have a '99 Ford Crown Vic Police Interceptor, and its not getting gas to the engine. I replaced the battery, fuel filter, the entire fuel injection assembly, made sure all pumps and wires were plugged back in. The fuel isnt even making it to the filter. I checked the wires, and its getting 6 watts to the injection assembly. Any advice?


You will need to change the fuel pump had that problem with one of the customers,if my info is of any help to you please leave me a comment,thankyou. ... 1988 Ford Crown Victoria

2001 ford crown vic spark plugs with coil over, want to change plugs but it looks like a fuel rail is in the way..how to change plugs without affecting high pressure fuel inj line. i got a code on my scanner that says 'cylinder 6 misfire', and all the wires going to the coil at 6 look fine. figure if i can just get to the plugs i could start there...but cant even get started


You can use a universal joint extension and a wobble drive extension to get to the difficult ones ... Ford Crown Victoria

Getting fuel lines off a ford crown vic - 1999 Ford Crown Victoria


Determine which connection you have here\015\012\015\012 ... 1999 Ford Crown Victoria

2001 Ford Crown Vic - not getting fuel


... Cars & Trucks

I removed the fuel pump of 1980 ford ltd crown vic, i can not see or feel a push rod for the pump. how do i get it snug against the block. is there a push rod or does it just work off the cam.


No rod. The lever rest on a cup that is bolted to the timing chain. ... 1982 Ford Ltd

How do i repalce a fuel pump in a 1983 ford crown vic? can i get to the tank from above or do i need to drop the tank?


There's no way to get to it through the top (unless you remove the rear seat and cut a hole where the center of the backrest is). You'll have to either drop the tank, or the rear axle. ... 1983 Ford Crown Victoria

2001 Ford Crown Vic inconsistant starting problems. Will start most times and sometimes it just turns over and acts like it isn't getting fuel or spark. Dealership thinks it's a relay, so they have exchanged the relay with the ac relay, we are suppose to watch the ac to see if from time to time it don't work, which would let them know that it is the relay for sure ?


... 2001 Ford Crown Victoria

1988 Ford Crown Vic Strange Idle (Getting Worse)


I am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount? ... 1988 Ford Crown Victoria

1985 ford ltd crown vic is cranking but not starting. all electrical components changed out. spark from plugs to coil to distributor. fuel pump strong. what could it be?


... Cars & Trucks

1998 ford crown vic fuel gauge not working - 1998 Ford Crown Victoria


... 1998 Ford Crown Victoria

1999 crown vic keeps getting air locked at the fuel rail?


Check your fuel pressure if you dont have enough pressure this will happenwhen the fuel pressure is good the system will just push the air out through the injectors or the fuel return line ... 1998 Ford Crown Victoria

How do you replace the dashboard light bulbs in a 1986 Ford Crown Vic? I removed front facia+panel, and unbolted the speedometer unit (plastic cover, etc) but cannot get the panel out to get to the bulbs. Doesn't appear to be any access from under dash. I suspect the speedo cable is keeping the dash unit from coming out and I am afraid to pull to hard on the panel for fear of dislodging the speedo cable and not being able to get it back in. Help would be appreciated


It sucks but there is a plastic clip on the cable were it goes in the cluster . and yes you need to pull the cluster to chang the bulbs ... 1986 Ford Crown Victoria

I have a 1999 ford f250 v-10 superduty and when i drive between 0 and 2000 rpms it has a stutter and a miss and has no power and takes about a minute to get up to 30 mph. Even when it is above 2000 rpms if you punch it to the floor it will and almost dies. You cannot even go up a 2% grade incline unless you are going about 30 mph,if you are at a stand still and try to go it will bog out and not let you move. We changed the mass airflow sensor,fuel filter,fuel pump and fuel regulator. HELP PLEASE


Replace the throttle position sensor. ... 2005 Ford F 250 Super Duty

Location of fuel pump relay on a 2001 Ford Crown Vic


Where is the fuel pump relay on a 2001 crown vic p71 ... 2001 Ford Crown Victoria

I have a 1994 crown vic and the button for my fuel door is broken how can i get it open until i can get it fixed


You have to go into the truck, and on the right side there is a pull cable which will release the fuel door. ... 1994 Ford Crown Victoria

Fuel Pressure for 2002 Crown Vic? - 2002 Ford Crown Victoria


... 2002 Ford Crown Victoria

I have a 1994 crown vic and the button for the fuel door is broken how can i get the door open until i can get it fixed?


There should be a pull cable in the trunk that you can pull to open the gas door, it may be behind the carpet on the wall behind the gas door inside the trunk. ... 1994 Ford Crown Victoria

96 crown vic fuel pump reset button location - 1996 Ford Crown Victoria


... 1996 Ford Crown Victoria

I have a 1986 Ford LTD Crown Victoria Station Wagon. 302 Fuel Injection. When I turn the key on I use to here a the Fuel Pump come on and then a few seconds later after the pressure buildups up it stops. Now I hear the Pump Constantly running. I also hear a hissing noise coming from the Throttle Body near the firewall. My car will not start. The only way to get it started is to spray starting fluid into the Throttle Body. After starting, the cars runs rough. When I put the car in drive and push


You may also check your fuel pressure module...it is located behind your throttle body, near the firewall. I was able to isolate a vacume leak in that same area with the same symtoms before starting the car, although mine runs an idle ok, it hesitate ... 1986 Ford LTD

2001 ford crown victoria was running great, turned off and 2 hours later will not start, turning over fine, checked all fuses, fuel shut off switch in trunk is not pushed up, acts like it is not getting fuel?


... 2001 Ford Crown Victoria

Where is the fuel pump on a 86 crown vic - 1986 Ford Crown Victoria


Hello pepper524: My name is Roger and I will help you. If your car is fuel injected. Your car has two fuel pumps. A low pressure pump in the fuel tank that is a 10 psi. lift pump. You also have a High pressure pump mounted on the frame rail that is a ... 1986 Ford Crown Victoria

How to replace fuel pump 1999 crown vic - 1999 Ford Crown Victoria


Almost all vehicles made the last 30 years ,need to remove the fuel tank to get the sending unit and or fuel pump out. Can not believe the thousands of people with that question! ... 1999 Ford Crown Victoria

1992 ford crown vic. chockes and tries to die out but doesnt. rough idel . i changed,and put or replaced these things new spark plugs,fuel cleaning injecter fluid , fuel cleaning done,and the engen light comes on .toped off all fluides. and still no difference .


Have you changed the fuel filter? ... 1992 Ford Crown Victoria

On a 1996 Ford Crown Vic 4.6L interceptor motor I can smell a heavy odor of fuel from under the hood and around the outside of the car. The car runs great and I cannot find a fuel leak anywhere. Do you have any suggestions on where to start looking?


Look at the fuel injectors themselves as I have found the injectors to leak thru the body of the injectors.They should all be dry when engine is running or off.Also look to where the fuel hoses attach to the fuel rails. ... 1999 Ford Crown Victoria
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8771 seconds