Having problems with your Cars & Trucks ?

Hi all my nissan maxima shuts off after the gear is engaged.am confused cd it be d gear is bad or sumtn tu b fixd.am very confused

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi all my nissan maxima shuts off after the gear is engaged.am confused cd it be d gear is bad or sumtn tu b fixd.am very confused


... Cars & Trucks

I am looking at a 1992 Nissan Maxima to replace the vehicle I have and my husbands uncle has it. He said that it runs great but when he put it in gear it wouldn't go. Then he shut it off for a few minutes, restarted it and it went fine. Is there a trans lock or something on the manual 5 speeds that could be going bad?


No trans lock. The clutch could be bad or the clutch master or slave cylinders. Check the fluid level in the clutch system resivoir.\015\012How does the clutch pedal feel? Is it firm and returning normally? ... Nissan Maxima

My 97 maxima shuts off while driving only sometimes. completely unpredictable but only when in gear. three mechanics have not been able to figure it out. i do notice that its more prevalent when the engine idles. it will shut off. i will start it back up. as soon as i put it in drive it will sputter and shut off. it will start again and struggle to stay on. i see the rpm drops below 1k when its about to shut off. i little while later its ok. by that time i dont want to drive it anymore. i now us


I would be looking at the ignition switch it self. not the piece where you put your key, but the piece that is the electrical portion of the switch, which is on the back of the ignition switch assembly. you dp not need to replace the whole ignition s ... 1995 Nissan Maxima

My trany on nissan maxima 1996 works ok, when it works, but it jumps out of gear and makes griding noise, but when it locks in it sounds like new, problem is it jumps out of gear at any time, very unreaeble, is it bad PCM power train module or AT solenoids?????


This is going to be one of the Solenoids or the TCM module. Have the TCM tested, if it is good you will have to pull the pan and test each of the Solenoids, I forget if there are 3 or 4 of them. Now, I'm sure one of these are the problem however, i ... 1996 Nissan Maxima

Okay my 79 civic manual i was diving it on the highway and the tranny felt like it was slipping it got so bad to the point not the car will not move at all even when car is shut off an in gear or should say that it is in the gear position the vichle stay in neutrel thought it could be the clutch but never had on that effected the vechle by not in gagging even when off


Clutch completely smoked. ... 1997 Honda Civic

I have a 1987 Chevy V10/Silverado 4x4 1/2 ton. The past two months has been sporadically sputtering like misfiring.I changed the Plugs,wires,distributor cap/rotor.Kinda helped but still sputtered from time to time.So then I change the ignition coil.Ran like a champ for like 10 min.But then just shut off.The ECM fuse had blown.Stuck another one in,but then it's like sputtering real bad,almost shuts off when putting in gear,and has massive power loss.And ,eventually will blow the fuse again..I als


What codes is the ecm logging? \015\012There are several things that you need to check. \015\0121. The TPS on the throttle body\015\0122. The ground connections on the ecm\015\0123. The oxygen sensors.\015\0124. The run ... 1986 Chevrolet Chevy

I have a 2001 Maxima with approx 142,000 miles. When the car is warmed up good, it sometimes will either not shift out of 1st gear, or it shifts into neutral & I have to stop the car to either shut it off for a 5 -8 minute cool down, or let it shift back to 1st gear before proceeding. I have a intemittent "service engine soon" led which I had checked and the code that we got was "J74" which I was told was a transmission speed sensor malfunction or failure. I took the car to my Nissan dealers


Possibly get speed sensor replaced this could be causing problem without speed input to control module the module doesnt know what gear it should be in or use\015\012have this part of speed sensor circuit tested ... Nissan Maxima

I have a 1993 dodge grand caravan with a 3.3 liter motor and a overdrive transmission that has 248000 miles. It was working good no problems till about a month ago. Then one day it didn't want to shift up any higher than 1rst or second gear. After shutting off the engine and restarting it was fine. This routine went on for a week or so. Then it started shuddering bad and stalling at stop signs ect like it was'nt shifting down into 1rst gear. Restarting the engine doesn't solve this problem. I've


Can't say I know more about that transmission that you but i will tell you this much, that I have been there, done that, and both times ended up at a tranny shop, too late to save it. &1500-$2000 later, back on the road. I hate to admit defeat a ... 1993 Dodge Caravan

Buick Lesabre I have a 91 buick lesabre .i drive it every day .one day i took off it would mot shift out of first gear. so i took it home and shut it off and checked vaccum lines all was fine. cranked it drove it 5 more months till it did the same thing want shift out of first. this time it stays in first gear no matter what .i think its not a bad ****** .any advice would help. 91 with a 3.8 6 cyc


I would check a couple things, the vacuum modulator and the passing gear cable, a clogged filter will not prevent it from not shifting, it would slip instead so that can pretty much be ruled out. you have the old school 3800 and they have decent ... Cars & Trucks

94 Olds Cutlass Supreme driving after warm trans free wheels until you pull over put in park and shut car off. Start car put in gear and drive away untill it does this again. Seems like a sticking pressure releif valve or the govenor valve sticking. I had a 93 Grand Am that had a bad torqeconverter solinod that acted similar with the shut down wait restart but it would lock the converter and not release so car would buck and die like not putting the clutch. This has me stumped Thanks for any Hel


I bet u hav as many miles on dat cars as a trip to the moon-the trans is old in alot of places-varnish on parts from heat etc-u can get troubleshootin lit in library sec629 chiltons or haynes in discount auto ... 1994 Oldsmobile Cutlass Supreme

My transmission in my 2000 nissen maxima gets stuck in first gear intill i shut the car off and turn it back on then its fine


... 2000 Nissan Maxima

I have aye 1993 Nissan maxima engine Shakes on idle and drive gear then if I slow down it shuts off


Run compression test on all cyclinders if ok check for vacum leaks brokenor unconected lines ... 1993 Nissan Maxima

Engine-no go this car had been running fine then went to store 3/4 mi away, shut it off then when leaving car ran fine until I shifted to 2nd gear and then it died. Could not start it again, had wife tow me home. Changed plugs (old plugs were SHOT), plug wires, dist cap and rotor and it started and idled fine but when accel pedal depressed the motor would bog down bad and die. Engine will start and idle fine but when accelerating the engine, it WILL NOT rev up, unless the pedal is feathered quic


I think the dist is adjable try advanceing it some times the after market caps are a little diffront ... 1996 Ford Aspire

05 Pathfinder, 97,000 miles, always had updated maintenance and runs great. Yesterday it shook hard at 45 mph like trying to shift but kept going. 1 minute later it started shuddering, in gear, and would not move when I pressed the gas. The check engine light and other things were flickering badly. I put it in park, shut it off. It started and ran fine after that. What happened? Computer chip? Dropped cylinder? Transmission?


Hi,Provide few more details :-1. Is there any driveability issue's now?2. Do you see check engine light being ON?Thanks!! ... 2005 Nissan Pathfinder

How do i know that my automatic transmission is bad and need replacement.the has burnt smell and the car jerks on changing gear wit sluggish movt in D but not R and manual aspect. Nissan maxima 2004


You have a failing transmission, get the piggy bank out and start saving, it will stop working completely very soon. ... 2004 Nissan Maxima

I changed my plugs, wires, distibutor cap, rotary button, fuel filter,i made sure there was no bad gas or water in the tank because i ran it completely empty and the fuel pump is working properly, but my truck stills acts as if it doesn't want to start. when it does finally start and i idle the gas slowly it will not putter or stall out but as soon as i hit the gas kinda heavy then it shuts down again. can someone please help me with this problem because im confused.


I am have the same problem if u find out could you please let me know [email protected] thanks ... 1995 Chevrolet Suburban

Lost all gears while driving at approx 30mph, no engine codes or indication of a bad trans, oil pump still works, car starts no problem? very confused


Is the car automatic or manual. I'm assuming its automatic. Do you still have the same problem after turning the car off and restarting if so your transmission is probably fryed ... 2000 Mitsubishi Eclipse

I have a 79 dodge 318 it had been running badly,so i tuned it up and that is when my problem started, i have no type of spark until i shut off the key and then at times it will backfire through the exshaust. repaced timing chain& gears,comlete tune up including moduel,ignighter,ballest and even ignitition switch got to be something real simple but not sure what can someone help me out please. is there any type of relays or sensors to look for??????


Hmmm you have addresssed a lot of the possibilities and I sympathize with you for the headaches, did you have a look at another coil or leads? I would triple check the ignition timing. Sorry couldn't offer much more help, really need to visually insp ... 1983 Dodge Cargo

I have read the question about the crankshaft pulley wobbling really bad and needing a harmonic balancer and my question is....is the harmonic balancer and the crankshaft the same thing? I have the same problem with my 1996 maxima and I was doing research but people are telling me that the harmonic balancer and the crankshaft pulley are the same exact thing! Is that true? I am confused and i need to know cuz i have to fix my car and i dont want to buy the wrong part!


The end of the crankshaft is usually called a snout, because that is \015\012what it looks like — just a shaft sticking out of the front of the \015\012engine between 1½" and 2" in diameter, with a threaded hole in the front, and a key-w ... 1996 Nissan Maxima

Burns gas rapidly; exhaust emissions has pungent smell and is dark brown/black; idles rough at standstill whilst in gear; shuts off at times; fuel injectors were cleaned. One mechanic suggested throttle body is bad-maybe, maybe not. Help.


Try changing the engine coolant temperature sensor, and has the check engine light ever came on and stayed on? Durring this problem. If so have the on board computer scanned. Good Luck. From Ernie @ RedDeer, Alberta, Canada. ... Nissan Sentra

CAR SHUTS OFF WHEN THE BRAKES ARE PRESSED. CAR STARTS AND RUNS BUT STALLS AS SOON AS I TOUCH THE BRAKE TO PUT IT IN GEAR. I CANT FIND ANY BAD HOSES.


... 1993 Saturn SW2

2 problems. first problem, once the truck is started it won't shift out of park. i have to shut it off and shift into neutral and start it again and then shift into gear. second problem, the truck sounds like its missing and then it sputters badly when accelerating. hooked it up to a computer and it said number 4 plug wasn't firing. i replaced all the plugs and plug wires and still got the same problem. replaced the coils and it still didn't work.any suggestions would be greatly appreciated.


The shifter problem sounds like the shift interlock is not releasing, check to see if your brake lights work, if not probably a fuse or brake light switch. Your misfire could be a bad injector or no compression in cyl 4. You probably had code P0304 ... 1998 Ford F150 Regular Cab

My oldsmobile 2000 alero was having some problems and now it chugs really bad when i depress the acclerator ive replaced the engine and ran it clean also i have used many cleaners it shuts down sometimes also if i keep it goin or idle it and slow go it runs for the most part it has violent shaking like something was in the gears stopping then taking off the rpms jump around could you please help


Well did you say u replaced the engine? Well if thats the case you may have a clogged cat CONVERTOR. to start out, first we need to remove the bolts from the exhaust manafold to the down pipe.try to prop the pipe slightly away (about an ... 2000 Oldsmobile Alero

My truck stalled out while backing up an inclined driveway. I tried to keep accelerating and nothing happened. I put it in park and the gears grinded badly. I shut the car off, restarted and tried to put it in drive but the the acceleration wouldn't work and the rear differential started leaking. I put it back in park and it grinded once more. idk what could be wrong


Check and repair the carburator , check the transmission gear ,check and replace oil seal of the differential . ... 1995 Dodge Dakota

My 1993 nissan maxima shutting off when i put the reverse gear


... 1993 Nissan Maxima
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9460 seconds