Having problems with your Cars & Trucks ?

INTERNATIONAL TRUCK FAULT CODES

\015 Fault Code # 5\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

INTERNATIONAL TRUCK FAULT CODES


... Cars & Trucks

What causes the following faults code on 2004 volvo S40 :ECM-250A LONG TERM-FUEL TRIM:UPPER LIMIT,BCM-0100 COMMUNICATION PROBLEM WITH ECM,EPS-0082 ENGINE STATUS FAULTY SIGNAL,CCM-001 COMMUNICATION CONTROL MODULE;INTERNAL FAULT,DDM-E001 CONTROL MODULE COMMUNICATRION,INTERNAL FAULT


Check, test or replace MAF sensor.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you ... 2004 Volvo S40

Airbag 24 Fault code System Disarm Failure or Internal Diagnostic Monitor Fault


24\012Safing Sensor Output Feed/Return Circuit - Open Repair of this problem requires special equipment and testing procedures by a factory trained technician. ... Lincoln Town Car

2003 tahoe fault code p0101 maf vaf ckt range/perf p0300 random multiple misfire detected p0420 catalyst eff below threshold bank 1 p0172 sys to rich bank 1 truck suddenly started to run poorly, has little to no acceleration & wont hold an idle. recently have replaced plugs, wires, air and oil and fuel filters with no help. cleared all above stated codes only to have the first two listed return. truck still runs bad.


For p0300 ,p0240 on chevy tahoe 00- 06 check a wire going along with the battery ground to the engine block thre should be a high resistence on the small wire ,it gets corrode over time ,it should be located on underneath of the driver side engine, ... 2003 Chevrolet Tahoe

Working on 07 Acterra with Mercedes with faults codes Pid11 1 FAiL 14 not sure about the i in the fault code it could be a 1. We have no book on this unit.This unit is a garbage truck .I do not think that 825 is correct


... 2007 Sterling 825

I have a problem with Freightliner FLD 120 year:1995. Right now there are no fault codes found. Everything seems to work fine(all the sensors, solenoids,relays..)But when I turn on my truck, fan starts working and never stops. My questions is can the old,inactive fault codes(that blink with yellow color) affect the fan. Would the reset of ecm solve the problem? Thank you


... Cars & Trucks

1998 chevrolet truck 5.7 liter code p1345 whats it mean says it is camshaft to crankshaft position correlation fault just put new distributor on because of stripped tooth new distributor came with new sensor and cap and rotor and gear of course truck runs good but cant get this code to go away can you help please


You have to cam sync these trucks. What that means is you dont time it like old trucks. You loosen the distributor slightly then with a scanner hooked up your looking at the cam data. Needs to be plus or minus 3 from 0. How you set it is you gun the ... 1998 Chevrolet C1500

Transmission gets stuck in third gear completed diagnosis codes p1762 P1757 P1752 p1772 P0745 no leaking no corrosion or water in harness Or connectors remover removed transmission control module installed good module no change in transmission operation . Code P1574 Tom internal fault installed good Tom code did not return reinstalled original Tom code returned confirmed no commit ovation withipc. Fluid clean but overfilled with odd smell.performed line pressure test and stall test finding lin


... Cars & Trucks

Abs and engine fault light came on at same time. This was almost a year ago. Local company hacked in to system and diagnosed tps sensor fault, changed thi, no difference.Drove 400 mile round trip for proper diagnosis, fault code P2106 shows up, rear abs sensor apparently.Changed this for new genuine Ford part, no change. Sent for replacement abs sensor, still no change. Take truck to local garage who specialise in fault diagnosis, they say my second replacment sensor is faulty. Get this replace


If they are checking the system at the ECU and its telling them the sensors are bad, then you have a broken harness down stream of the ABS ECU. There has to be a brake in the harness to the rear wheel sensor(s). It is a brake in the harness or the en ... 2004 Ford F150

My 96 ford f 150 4.9L. suddenly losses power and i have to shift into low gears to get more power, but the truck wont run in drive( no power). this has happened twice then suddenly it starts running fine. i had test done with the following codes come out: P0750shift sol a fault P0755 shift sol b fault P1359 spark output circuit fault P0413 sa system sw valve a circuit open. P0416 sa system sw valve b circuit P1754 coast clutch sol circuit fault P1460 wot a/c cutout circuit P0230 fuel pump primar


... 1996 Ford F150 Regular Cab

I have a 2004 jaguar X Type it has been setting missfire and transmission codes. I have replaced all plugs and coils. The ck eng light stays on and the only code is P1000. I have looked up the code and got tow definitions. One is incomplete readiness and the other is internal PCM fault. The local dealer says it is incomplete readiness. If the PCM is bad it would be covered under Federal Emission Warranty. This car only has 62k miles on it. It does seem to idle a little rough atidle. Please advis


P1000 cannot be cleared as its a permenant code and does not afect the car. Check for water ingress at the ecu connector ... 2004 Jaguar S Type

What is fault code 47 on scania 480 truck. truck has no power


... Cars & Trucks

What is fault code 31 on a 1997 Dodge Dakota Truck? The check engine light came on and is still on and someone suggested it may be a code 31.


31 is evaporative emission control system. If it's running ok it's probably just your fuel cap gasket. if you can carefully remove the gasket clean it put it back on and clean the filler tube. Could also be hole in filler tube or vent tube. ... 1997 Dodge Dakota

I have 3 fault dtc codes for a 2003 international 4300 i want to find out what the codes arerelated to so i can fix it or take it to the shop


... Ford F-450

CODE READER SHOWS FAULT CODE P0022 - S-Class Mercedes-Benz Cars & Trucks


... Mercedes-Benz S-Class

Renault midlum truck fault code mid 1280cc - Cars & Trucks


... Cars & Trucks

Nissan 1987 King Cab with manual transmission has code 24 fault, Haynes manual says transmission/clutch switch fault. Truck starts and runs for 2-3 seconds then motor quits.


... 1987 Nissan King Cab

Car: 2000 Jetta GLX V6 5 speed manual (150K miles) (engine code AFP) Lights showing: ABS (constant), brake (flashing), engine (constant) _ STOP-Brake Fault on control panel Since last fill up (added gumout high mileage fuel injector cleaner at same time) I had a few misfires on the road. I pulled the codes and came up with 13! P0300, P0304, P0303, P0306 cylinder misfires P0442 EVAP emission control sys-small leak P1131 Oxygen Sensor (Lambda) B2 S1 internal resistance too high P14


Before replacing the onboard computer, I would try a thorough tuneup with plugs, wires, etc. I would not rely on the water mist test to determine the condition of the plug wires. Multiple ... 2000 Volkswagen Passat 4Motion

2008 F350 DIESEL has no transmission forward gears or reverse.a manual pressure guage was installed at the line pressure port and nopressure was found in any range selection position (pnd321r )EXTENSIVE CHECKING OF WIRING FROM tcm totrans plug and plug on trans to internal connections.also all solenoids checked out with ohm meter a known good PCM was hooked up and no symptom change was noted.DTC codes found fault in PCA (pressure control solenoid ) pinpoint checks for that code were carried out


The over fill may have put too much pressure on the main oil pump, and the input shaft may have broken.You should always have line pressure no matter what gear is selected, so if there is none, then none is being made.There is a slight ch ... 2008 Ford F-350

Airbag fault code 93d7 internal fault was stored on 2006 bmw 525i


... BMW Cars & Trucks

I have a 1998 ford E-350 armored truck. air bag light is flashing. i have a B1232 fault in airbag system. the snap on scan tool willnt tell me any info on this code. What does this code mean?


Passenger belt and buckle asembly pretensioner circuit resistance out of range.\015\012\015\012Possible Causes \015\012\015\012Damaged wiring on Circuit 1081 (Y/R) or 1082 (Y/BK). \015\012 ... 2003 Ford Expedition

What would cause the fault code, ABS fault. my brakes are still working good, but this is flashing on the display panel. Will this afect the operation of the truck.


It is most likely the abs sensor is dirty or bad,It won't affect the operation but it will prevent the abs feature from working.You can have it checked at any brake shop.Some will even do it for free. ... GMC Canyon

Truck still shake when I drive after addressing the clogged convertors,low coolant,changed belt,and spark plugs.I went to auto zone and they found a code P1299 from the computer read.Stating all the above plus the:Failed cylinder head temperature sensor,which I didn;t address yet.I went back for a second read and they came up with two new codes P0305 and P0306 meaning there is a Cylinder misfire in both of them having the same problem.Probable cause:1-ignition system fault-spark plug(s),ignition


The problem with having a misfire on two side by side cylinders is this generaly points to head gasket issue especially since you have a head temperature issue also. You will need to do a compression test first to verify the engine is ok before spen ... 1998 Ford Expedition

4wd issues!!! When I start the truck, all 3 lights( 2hi 4hi and 4lo) flash once on the switch then go off ( all of them). It drives just fine but is in 2wd. When I push any of the buttons the 4hi and 4lo flash, the tccm clicks, but remains in 2hi with no indicator light on on the switch. I ran the codes by grounding out pin 13 and it flashed twice which means that it is an encoder fault so I replaced the encoder motor erased the stored codes and still the same result.


THE 4WD SWITCH IS A PROBLEM. ALSO THE GROUND CONNECTOR ON THE FRAME CLOSE TO THE DRIVERS DOOR IS A PROBLEM. IT USUALLY HAS A COATING OF THE UNDERCOAT MATERIAL ON THE FRAME THAT IS NOT REMOVED BEFORE THE CONNECTORS ARE PUT IN PLACE.THERE A ... GMC K1500

Mercedes benz actros truck fault code - Mercedes-Benz Cars & Trucks


I want to sent me wiring diagram of actros truck ... Mercedes-Benz Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8193 seconds