Having problems with your Cars & Trucks ?

Wiring for brake light 96 chevy blazer - Cars & Trucks

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wiring for brake light 96 chevy blazer - Cars & Trucks


... Cars & Trucks

I have a 1997 chevy blazer with check engine light on, speedometer and rpm not working and gas gage stays at 1/2 tank. First it was just the check engine light on. Got a tune-up, checked the computer on truck for problems, had wires traced for possible shorts. Check engine went off for couple hrs while mechanics checked out car. It came back on while I drove it home. I called mechanics and they don't know what the problem is. Since then, the speedometer, rpm, and gas guage stopped working. I cha


It sounds like you have a lose or bad body ground!!! ... 1997 Chevrolet Blazer

2003 chevy blazer tail light wiring diagram - Cars & Trucks


... Cars & Trucks

Chevy cobalt brake light wiring diagram - Cars & Trucks


... Cars & Trucks

I need a wiring diagram for a 78 chevy truck the diagram needs to include all wires under the dash for turn signals brake lights and tail lights andall the way to the wires running to the chassis but not the whole chassis diagram my in dash wires are really chopped up thew truck was a wrecker and it is a 1 ton dually with a flatbed


... Chevrolet Silverado 3500HD

I have a 2003 Chevy Trailblazer. The brake lights work sometimes and not other times. I have changed the bulbs and the "panel" (the part that all of the bulbs plug into) on each side. When we start the car, we check the brake lights and if they are not working, we tap on the brake light cover and they come on. I have checked the ground wire for the lights and it is solid and not corroded. What does this mean and how can it be fixed?


Sounds like a loose terminal inside the harness connector, disconnect harness connector and check to be sure all female terminals fit tightly to male counterparts. ... 2003 Chevrolet TrailBlazer

Bought a new brake light switch, wires fell off the old connector, need to know where and what order the wires go on the new brake light switch 1995 chevy blazer 4.3 engine , 4-door


It shouldn't matter what order the wires are attached. The switch is N.C (Normally Closed).When you press your foot on the brake all it does is Open/Break the contact between the two wires. ... Chevrolet Blazer

01 chevy blazer brake lights stuck on. When you turn the right single on, the brake lights work, right turn single dont. When you hold foot on break pedle and turn the key off lights go off car still runs. I replaced brake pedle switch also front an back turn bulbs and a flasher switch. I can not find any burn up fuses


Sound like you have a short in the turn signal switch or the wireing to it. ... 2000 Chevrolet Blazer

I have a 96 chevy s-10 with a 2.2 liter 4cylinder.My problem is that when i go to use my heater my abs and brake light comes on when i put my heater on...Also i notice my truck starts to backfire...I have tried to pinpoint where the short can be if thats the problem.Im not sure but its by my abs pump.I zip tied the wires up and my heater started working and the abs and brake light goes off..Now after awhile the abs and brake light comes back on and my heater dont work again....Can you please hel


Under the dash on the passenger side you will find the resister block for the fan motor. it's near the fan mounted on the duct work. there are a couple wires going to it connected by a plug. there are 2 or 3 screws holding it in. replace that and ... Chevrolet S 10

I am having trouble with the abs braking system on a 1998 chevy blazer. The yellow brake light is usually off for the first few minutes of driving and then comes on and stays on until the car is turned off. The abs brakes pulse and make a noise and seem to try to work even when touching the brakes lightly. It has 170,000 miles.


The yellow light is warning you that a problem exsists with the abs. unless you are experienced with brakes and abs would highly suggest you take it to a shop. ... 1998 Chevrolet Blazer

I have a 1999 Chevy Silverado 1500 that i need to add an electric brake, i have the brake wiring and a factory harness, however i need to switch out the harness at the rear of the truck to a 7-pin, do i need to order that part from chevy and will the trailer lights and brakes work then?


Try http://www.etrailer.com/faq-wiring.aspx. ... 1999 Chevrolet Silverado 1500

I have a 89 chevy pickup 1500 v8 350, truck had been stalling at stop sign, red light or when u put in gear, or apply brakes. Have move on to bigger problem, will crank but does not start. Replaced rotor cap, and coil, plugs and wires changed approx. 3 months ago. Got truck to start twice, wiggled the connector wires on coil. Thought that was problem so replaced connector that goes from coil to distributer. Much to my dismay, truck still will not start. Help really need some help not sure wh


DID YOU REPLACE FUEL FILTER ? DO IT ! REPLACE YOUR EGR VALVE, ITS ALL SCREWED UP & CLOGGED . DO IT ! I HAVE A 1988 GMC 2500 4X4, V8-350. ITS FUEL PUMP WENT !!! YOURS MUST BE ON ITS WAY OUT !!!!!!!!! REPLACE IT ! REPLACE ALL G ... Chevrolet Cars & Trucks

Here's my problem...My truck has four wires for my trailer, Red-Brake, Brown- Running lights, Yellow-Left signal and Green-Right signal. My trailer also has four wires, Yellow-Left signal, Green-Right signal, Brown-Running lights and White-Ground. My Question is, how do I get my brake lights to work on the trailer when all the wires are already used up for signals and running lights. I still am left with the brake wire on my truck. Am I able to get brake lights working on my trailer too?


Also try http://www.etrailer.com/faq-wiring.aspx. They have easy to follow directions and color codes. Plus you can order anything you might need. Hope this helps. ... 1987 Toyota Pickup

I have a 2007 Chevy Aveo LS 5-speed manual transmission hatchback. It's been a great car so far, no major problems, great gas mileage, etc. It now has 36,700 miles on it. As per the maintenance schedule (and I realize I was a little late in getting the 30,000 mile stuff done),I just had the spark plugs and wires replaced, a new serpentine belt installed, brakes cleaned and adjusted, and the brake fluid replaced. My check engine light now keeps coming on. The car runs smoothly, nothing seems out


... Chevrolet Aveo 5

I am having problems with rear brake lights,checked all bulbs, replaced brake switch, fuses checked, loose wires, both running lights and signal work, car is a2001 chevy lumina


Check the turn signal switch. especially if the center brake is the only brake light that comes on when you step on the brake pedal. Sometimes wiggling the switch will get the brake lights to work momentarily. ... 2001 Chevrolet Lumina

1999 CHEVY BLAZER WHEN I DRIVE THE ABS LIGHT COMES ON THE BREAK PEDAL ACTS AS IF IT IS ON ICE LIKE IT DOES WHEN YOU APPLY THE BRAKES AND HEAR THE ABS UNIT GROWLING. THE TRUCK LOOSES POWER AND CANNOT GO OVER 20 MPH UNTILL THE ABS LIGHT GOES OFF. THEN THE SPEEDOMETER STARTS WORKING AND THE TRUCK DRIVES NORMAL AGAIN. pLS ADVISE.


HI. This will be a ABS sensor to ABS module communication error. Your vehicle is equipped with four sensors(speed sensors), that are located on each axle assembly. These sensors transmit signals to the module, during transit. When one or more of the ... Chevrolet Blazer

I just put a leer camper shell on my 1991 chevy truck now how do i wire up the brake light on the camper shell so that the light does not blink when i put on the turn signal i heard there is a wire you tap into for that can anybody tell me where to find it


You should be able to tap into either brake light as long as your turn signals are separate from your brake lights. If they are the one and same bulb, you will have to add a diode to keep that 3rd light on the camper from flashing with the turn signa ... 1991 Chevrolet C1500

'96 Chevy Astro van -- check engine light comes on and car starts to hold back and shake. replaced crankshaft sensor, air flow sensor, did extensive tune-up -- everything new -- wires, plugs, cap, rotor etc. -- timing - cleaned out distributor --runs good for a while -- then, usually at stop light with car running and foot on brake, for no reason, it starts to hold back and act like it is going to shut down. Mechanics are stymied. They have done everything and cannot find the problem. HELP


... Chevrolet Astro

I have a 94 chevy truck and the rear tail light don't work. Running light and turn signal work. Changed out the switch on the brake pedal and the muti function wire on the column. Still no lights what else do i need to do to get them to work without having to take it to a shop.


Did you check the switch on back of brake pedal if not try replaceing brake light switch hope this helps ... 1999 Chevrolet Silverado 1500

Wondering why my brakes lock up on my 2002 Chevy blazer? My car ran good until I noticed my brakes started sounding like a big trucks air brakes. Then I was leaving my house and the pedal locked up.


You should check the brake pads and the calipers and rotors and check the brake fluid all these could cause your problem ... 2002 Chevrolet Blazer

The brake lights on the cab of a 2006 chevy silverato do not work. the brake lights on the box do work fine . I do not have 12v on the wire going to the cab when the brake leaver is pressed.There is only one switch on the brake leaver that i can see .I have 12v on the switch at all times and i do get power on the white wire when i press the brake leaver . The white wire is the only wire that gets power when i press the brake . Do that white wire also feed to the brake light on the cab or is ther


White wire feeds both and it may be connection inside roof area behind light lens bracket. ... 2006 Chevrolet Silverado 1500HD

Tow plug We have a travel trailer that when the trailers plugged into the truck the left turn and brake light don't work. All other lights work and it comes on when head lights are on. We can't figure it out. we have gone over every part of the wiring of the tow plug. Could it be the camper plug? I don't know. We also had to install a brake controller in the truck. F-250 it has 4 colored wires and the brake controller has the same colored wired. It said to hookem up to the same and it would work


Check and clean all the ground connections.It sounds like a ground issue if they come on with the headlight switch. ... 2005 Ford F 250 Super Duty

2001 chevy truck brake light wire harness color code


... Cars & Trucks

1999 Chevy Blazer ABS Light and Parking Brake Light


You will need to find out which speed sensor has gone bad. Only way to know it to hook it up to a scan tool. The burning smell is possibly a caliper sticking as these vehicles are bad about them sticking after brake pad replacement. ... 1999 Chevrolet Blazer

Here is my problem. my 1996 pontiac mph was jumping up and down and the car was running very bad. so i changed the plugs(wires were arcing) and wires. also i changed the o2 sensor that was causing car to run rich. the car had 13 codes in it. this happened when my wife left for work in the car. so i bought a new computer for the car. now all the lights on the dash are on. low oil light air bag light low coolant light, abs light, brake light. the car runs great now but i have all these lights on n


Depending on the year it most likely is the body computer. that is what all of those light have in common. you replaced the engine computer. so i would look at the body computer now. weird hope both could be bad but cars never seise to amaze me. try ... 1996 Pontiac Sunfire
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.3568 seconds