Having problems with your Cars & Trucks ?

Beeping noise from the shifter /throttle control of a Mercury 1996 60hp outboard motor ??

\015 Beeping noise coming from shifter/throttle control ...only happens when the key is in the ON position. Can you help me\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Beeping noise from the shifter /throttle control of a Mercury 1996 60hp outboard motor ??


... Cars & Trucks

I have a 2006 mercury milan the other day i was drving and the car cut off, i try cracking it the motor trun over but will not start. i check for code in the computer with a opd2 scanner and got 2 code. 1. p2101 throttle actuator control motor circuit/ open and the 2.code is p2110 throttle actuatoe control system-forced-limted prm. can some help on this matter. thank you victor


1. Remove the throttle body and clean carefully inside. ... Mercury Milan

I have a 1987 35hp mercury outboard motor,, runs great out of the water. In the water with a load it starts and idles great,, when i throttle up a little it starts to loose a cylinder. I switched coil


... Cars & Trucks

Won't start parked over night in garage. turn key and dashboard gauges and lights blink and wink with a flashing red dot on the right side near door ajar and funny noises like little motors turning on and off, (including the CD player) tried reseting as per instructions from mechanic, left key in the "on" position and got throttle control light staying on. ( HEMI ) second time failed too, mow am stranded with sick red racer...!


Hi, I understand you have a problem with the alarm.\015\012If the alarm is activated, and if the alarm is aftermarket you have a valet switch , That you can use to deactivate, or put in by pass. just you need to locate, is a little switch goin ... 2005 Dodge Ram

I have a 95 z71 350 motor, the exhaust manifold has had a small crack for years but when it warms up the noise is not that bad several months ago it started not idleing right and cut out when giving it a little gas it runs ok at higher speeds just bad and slower ones with a rough idle I change plugs, wires, idle control , throttle position senser, injector unit with new injectors, tested coil and icm, changed rotar and cap.....still runs the same..could this be result of running cracked exhaust


... Chevrolet Chevy

P1120 CODE for accelerator position sensor malfunction. In a posting here he had same problem and it was the throttle control motor. You can hear the throttle control motor clicking when its working, then suddenly it stops and you have to keep the pedal to the floor to get power. I believe the motor the be the problem but cant seem to find anyone who stocks it. Any suggestions and does this sound to you like the motor is the problem? The TPS sensor is new.


Any dealer can order them. Sounds like a TPS. The sensor doesn't read the correct voltage from the pedal. ... 1998 Lexus Gs 300

I have a 94 mercury grand marquis i am working on. i cannot get the heater temperature control to change off of cold it is a ls with the slide control on the heater/ac. the vacum controls are all working but i only have cold air heater hoses are hot engine is hot the electric motor for the temperature is not working and i have no schematics to check for points of voltage or pictures of where the motor is at, i have even changed the heater control but no change. i don't know which wire powers u


Check fuse 17 at the fuse panel. \012\012start here\012\012\012\012\012B3 MANUAL A/C ELECTRO ... 1994 Mercury Grand Marquis

Where is a throttle control relay located at and how do you go about testing it on a 1992 s10 blazer with a 4.3 v-6.i can not get this to throttle up and the idle is erratic. i can pull the pcv valve off the hose and it will idle. i have no codes but i do have 0 throttle control


The irradic idle of the engine is not a concern, after many years the fuel/air mixture gets to a point where the emission control has to constantly compensate by increasing and decreasing the idle speed. As far as you not having throttle control do y ... Chevrolet S 10

My daughter was driving her 1997 Mercury Sable (not DOHC, just regular) said he heard a noise, smelled a burning smell (just for a second) and throttle opened wide (again, just for a second). She stopped, I came out, car is running fine. No burn smell, no bad noises. Only ONE problem showing-the battery light comes on (and flickers) when you throttle up. It does not come on at idle, just when you throttle up, and it's not steady, it's as if it's "almost' generating enough juice to keep the light


Even though your reading 13.9 volts at battery at 2000rpms,you need to load the alternator and battery to get a real reading,start car,put high beams,heater blower on high,and flashers on while in low gear,your going to have to have a friend he ... 1997 Mercury Sable

Motor ticking i had the water hooked up to the motor & when i wasn't looking the water hose got a kink in it & the motor was making a noise & when i turned it off & cranked it back up it was making a ticking noise down at the propeler .. what happen & can it be fixed? it's a mercury 4stroke 60 hp.


Make sure the propeller is not lose and check the bearings ... 2001 Chevrolet Impala

Have a 2003 Chrysler Town and Country Limitied van utilizing zoned climate control with a ventilation problem. While the climate control board is off, the fan motor still operates near full speed. Turning on the control panel will get you temperature control, however, there's no control over fan speed. Almost seems like the fan control dial is stuck at full throttle, on or off mode. Is this a control panel issue or is it a relay behind the glove box? thanks for the help.


... 2004 Chrysler Town & Country

My Nissan Xterra has the SES light on and the code that came up at autozone in p1126, throttle control motor relay open. The possible causes include open or short ciruit condition, throttle contr5ol motor relay circuit open, failed relay. What should I do next? Thanks for any advice.


Try switching the throttle control motor relay with another equivalent relay and seeing if that works. ... Nissan Xterra

I HAVE A 07 TAURUS. 49000. MILES . IT FEELS LIKE A MISS-FIRE AT A STEADY RPM SPEED. WHEN IDLING, YOU CAN SEE THE RPM NEEDLE BOUNCE 600RPMS TO 450RPMS . When the engine drops rpms on idle. you can here a slight thumping noise coming from the air box. so i remove the air box and the thumping noise was coming through the throttle body. I have replace plugs, plug wires, coil, fuel filter, with gas treatment , air filter, and clean the throttle body and mafs and air control valve. with all this done.


Hello. You may have one clogged fuel injector. Go to an autoparts store and get a bottle of a fuel additive called seafoam. Pour it into the fuel tank and then drive for 5 miles. This should clear the problem. Joe\015\012\015\0124 th ... 2006 Ford Taurus

BMW 320d e90 fan noise from AC/climate control unit. Very annoying. It comes and goes. Please note the AC/climate control still works and the noise seems to be the only problem. It only started a couple of weeks ago when the temperature was very low here, below 0 degrees C. I also had the light come on to add coolant. Can any1 help?


... BMW 3 Series

98 Dodge Intrepid, with automatic climate control. Two problems. 1) Fan motor stuck on high, other controls, temp and direction are functioning fine. 2) Fan motor is now making a squeeking noise.


... 1998 Dodge Intrepid

2005 Mercury Grand Marquies Car is equiped with automatic temperature control. It seems to me that the baffell which diverts the air flow between Air, Heat and Defrost is stuck in one position (defrost). Is this likley to be something stuck, a defective activating device (motor) or a control issue? How does one isolate this cause? Hot air comes out the windshield defrost when hot air is called for and cold air comes comes out the same location when cold air is called for. Blower motor works fine


If your connections, including the vacuum harness on the rear of the EATC head unit are tight, then it's highly likely your problem is an O-ring leak in the vacuum solenoid(s).If you're handy you can fix it yourself. The instruction ... 2005 Mercury Grand Marquis

2004 nissan sentra throttle control motor relay


... 2004 Nissan Sentra 1.8

96 Olds LSS New blower motor does not work. The old motor was making a ton of noise like the bearing and then brushes went out. Then it quit working period. I hoped replacing the blower motor would fix the problem but it still does not work. I got a flash light and checked the fuses and could not see any burnt fuses. Also looking at the owner's manual it appears the fuse for the blower motor is the same as the ac controls, which still work. The compressor is about 1 1/2 years old and w


Check the blower resistor, most likely problem ... 1998 Oldsmobile Intrigue

96 Olds LSS New blower motor does not work. The old motor was making a ton of noise like the bearing and then brushes went out. Then it quit working period. I hoped replacing the blower motor would fix the problem but it still does not work. I got a flash light and checked the fuses and could not see any burnt fuses. Also looking at the owner's manual it appears the fuse for the blower motor is the same as the ac controls, which still work. The compressor is about 1 1/2 years old and work


You probably have a bad resistor. I'm not sure on your vehicle but it may be located on top of the housing that your blower is in. Hope thats of some help to you. ... 1998 Oldsmobile Intrigue

2010 Dodge Nitro when I turn temp control to high it makes loud noise like a relay chttering or motor noise


... 2010 Dodge Nitro

Driving on the highway with the AC on then it started blowing hot air. Drove down the highway and when exiting the highway and high speed driving, the car kept trying to stall, had to keep my foot down on the accelerator pedal. A friend tested the car and came up with the idle air motor being bad. I have seen idle air control parts and located it on the engine, but have not seen a motor?! It is a 2004 Mercury Sable, LS 3.0L gas engine, not flexifuel. It seems that maybe the motor has someth


You may have two problems here. The idle air controller (I.A.C.) has nothing at all to do with the vehicle's air conditioner. If the A/C is not working, I would look at the compressor to see if it is working. The compressor clutch could be causing a ... 2004 Mercury Sable

2010 Mercury Milan hybrid. Off road a month for left side body work, until yesterday. Now on driving at highway speeds for a while the throttle control warning light goes on, and when gas pedal is pressed the accelerator seems to pulse on and off. Collision shop spoke with dealer, they said probably a dirty throttle body. If so, I think it may be from sitting too long. Can I just put injector cleaner in tank or similar product for throttle body, and keep going?


Injector cleaner is a waste of money and\015\012doesn't repair or resolve anything\015\012\015\012Think about 10 oz in an 18 gallon tank\015\012Won't do much\015\012\015\012It is new & under warrantee,let the deale ... 2010 Mercury Milan Hybrid

2001 hyundai xg300 3.0 liter no throttle response, codes p1191,p1151 tps checks out ok,aps checks out ok,throttle motor ok and throttle control module ok


... 2000 Chevrolet Blazer

2001 hyundai xg300 3.0 liter no throttle response, codes p1191,p1151 tps checks out ok,aps checks out ok,throttle motor ok and throttle control module ok


Check the fuel filter to see if it is restricted,and if it is not have the fuel pump pressure checked,this is the most likely cause of your problem. ... 2001 Hyundai XG300

I have a 98 Tahoe that has a groaning noise coming from under the dash. Sounds like it coming from the area above the heater core in the dash. I unplugged the fan motor and temp acuator and the noise is still there. Doesn't matter if the fan is running or not. Changing the temp control and vent to different postions has no affect on the noise. Sounds like it's haunted.


... Chevrolet Tahoe
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.5856 seconds