Having problems with your Cars & Trucks ?

Replace 1996 chevy camero timing chain gasket

\015 Auto\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace 1996 chevy camero timing chain gasket

... Cars & Trucks

I have a 1996 chevy corsica , I have replaced all gaskets, timing chain is timed, new map sensor, alternator is good battery is good, I can get the car to start but it shuts down after a couple mins then restarting the car is a no go after a while,

Is your fuel pump working & if it is when did you change the fuel filter last? Did you move fuel line close to a heat source? I.E. exhaust manifold rad hoses etc. You could be experiencing vapour lock. Insolate fuel line with fuel line protecter ... 1996 Chevrolet Corsica

How do you replace a gasket and cover for timing chain and rear seal gasket for oil pan on a 1978 Chevy 350 motor

The oil pan will need to be removed to repalce the rear seal, so replace the front seal and gasket then, replace the timing chain/gears if sloppy, then reinstall the oil pan. ... Chevrolet Blazer

Just replaced the head gaskets and timing chain on my 91 firebird with the 3.1 v6. ive rest the timing to 0' tdc. the distributor is new and just about everything else as ive been trying to resto

No idea here ,look at the valves on no1 or any cylinder come to that then take not of what cylinder it is then rotor arm should point to that HT lead,the inlet valve should be up and to the left and the exhaust up and to the right piston at the top , ... Cars & Trucks


Check ur model and statt from here\015\012\015\012http://www.autzone.com/shopping/repairGuide.htm\015\012\015\012plz rate ... Buick Regal

I have a 2002 Saturn Vue 2.2L. I thought I needed to replace the timing chain. When we took it apart, we realized that the bolt on the timing chain tensior had snapped off and went into the head. So, we replaced the timing chain tensior, timing chain, the head, all the gaskets. New spark plugs, and a coil pack modular. Now, when we put everything back together, it wont start. When we take the piece that the spark plugs go into, out and turn it upside down, i have spark, but when I put it back in

It sounds like the timing chain was not position correctly. That will cause no ignition spark if the timing is off. Was it positioned correctly upon assembly? ... Saturn Vue

CRAP.............. I have a 2002 Saturn Vue 2.2L. I thought I needed to replace the timing chain, but when we took everything apart, the timing chain tensior, timing chain, and head, plus all the gaskets had to be replaced. We also replaced the spark plugs. We then went out and purchased coil pack modular. When we take the part that the spark plugs plug into out of the engine, and have it upside down, we have spark, when its in the engine the way it supposed to be, we dont have spark. We can not

Did you check to see if you have fuel pressure to your fuel injectors??? You probably have spark, just no fuel from your fuel injectors. Check that and go through the trouble shotting your fuel system, common for the fuel pump on saturns to wear out ... Cars & Trucks

Replaced intake gasket on my 92 chevy 5.7 TBI and now won't start. It does have 206000miles on the motor. I've triple checked the firing order and #1 at TDC lined up right. WON'T START. DRIVING ME NUTS. it does have spark and is getting fuel. Plugs are black as if it has been running rich. Ran fine before. I've done at least 15 of these distributors and never had ne problems. HELP ME I WANT TO DRIVE MY TRUCK. collapsed lifter?Bent push rod? Slipped timing chain?

... Cars & Trucks

1992 ford explorer. Hit a deer. Messed up front end. Need to replace gasket behind timing chain cover to fix water leak. Already replaced water pump. still have the leak. Can timing chain cover be replaced with engine in the car??? Also, since hitting the deer, engine backfires and runs like ****! COuld this be the cranks sensor? How do I replace that? Thanks!!! Joe

Sounds like the engin took a real wack???? \015\012i hope you eat that deer!! its cost you dear to fix it?\015\012you could do the gasket in place but its a right old job,,,when mine started leaking i just tiped in a big bottle of rad wel ... 1992 Ford Explorer

99 venture ran excellent had head gasket problem replaced all gaskets and put on a timing gear and chain will not fire up right it sounds like only one or two cylinders are firing like the timing is off. checked the gear and chain its right on checked firing order checked spark i even used starter fluid all sounds like timing is off all new spark plugs & wires it ran almost perfect before i tore it down dont know what to try, Dave

If anything moved prior to your replacing these items you could be on the exhaust side of the stroke vs the compression side,, (180 degrees out of time) remove the number one plug,, and this sounds dumb , but it works,, put your finger ... 1999 Chevrolet Venture

What would cause my1999 Saturn sl1 not to start after a new head gasket was put on? Ok so today we replaced the head gasket on my 1999 Saturn Sl1 single cam. We made sure the timing chain was put back on correctly per the timing mark specs.The heads are not warped either. Now when we go to start it it is not kicking over. We have checked the spark plugs and wires double and triple checked the timing chain and still nothing is happening. The starter and alternator and battery are all good. I don'

Check the cam/crank sensors. Also, if the car happens to have a distributor, make sure it is not 180 degrees off. If this does not help, then do a compression check. Remember, and engine only needs three things to run. Fuel, Spark, and Compressio ... 1998 Saturn SL

90 toyota pickup won't idle. The timing chain wore a hole in the timing cover, so i took apart and replaced all of the head gaskets in the kit, the timing chain, gasket and cover and even the water pump and thermostat. Now I have everything back together and it will start but won't idle. I have checked the spark plugs and wiring to the distributor. I don't know what to do next... help

Hi,\015\012 It sounds as though your timing is off, just a little. Since you seem to be pretty handy, I won't bore you with the details, it should be easy for you to adjust it. If you don't know how... please contact me.\015\012 ... 1991 Toyota Pickup

Trying to put timing chain back after replacing head gasket on a Nissan N22 motor. Need to find adjustment to loosen timing chain so that i can attach timing gear with chain onto OH cam. can you help on how to loosen timing chain?

No adjustment neccesary. There is a timing chain tensioner, which you will simply push back in to its body. once you do that, there should be a small hple somewhere on the body of the tensioner. That' sthere so you can piut a paper clip into it to ke ... Nissan King Cab

My alto k10 lxi car engine head gasket is damaged i replace the gasket but the timing chain is not to fit camsoft gears so how can i fit timing chain in camsoft gears pls help me

... Cars & Trucks

98 Chevy Blazer 6 cylinder. Just replaced timing chain, ran good for 30min. died in middle of road. Towed it back and opened it up again, timing chain was fine. Put it back together and started it up, ran for 30min. and died. Next morning replaced fuel filter, ran for 30min. and died. Please help!

... 1998 Chevrolet Blazer

Put a new head gasket on this altima GXE 2.4. timed the crankshaft correctly and cams but yet still wont start. put new distributor, cap, rotor, plugs, and wires. thot the timing chain was stretchd so i also replaced the one for the camshafts. i put everything were its suppose to be timed and when i hand turn the engine with a wrench on the crank it seems to move a tooth over. as i wus doing that i had someone watch the chain and u didnt see the chain jump at all. ny suggestions?

I would check the compression in the cyl's it will tell you if the engine is timed right, I belive the compression is around 180 psi in each cyl. this will save you a bunch of time. ... Nissan Altima

I cant get timing set correct on my chevy truck it it 93 1500 4wheel drivewith 4.3 v6 i have replaced ignition coil plug wires and tps and fuel filter ignition module cap and rotor cant read degree marks on timing tab i had the timing chain checked by a local machanic he says there is a small amount of play but it does not to be replaced the engine code is z it the engin id says zero degrees timing i think the computer is working against me how do i return it to base time so i can set the timin

You can take a yellow chalk marker to the timing mark on the balancer and make it stand out. You then clean off the template on the block that has the marks. If you cannot use the timing marks then you can use a vacuum guage on the intake main vacuum ... 1993 Chevrolet K1500

Coolant Problems I've been doing extensive work with my 1999 Ford Taurus 3.0L OHV. I have replaced all engine gaskets from the head gasket up, the front bank cylinder head (#'s 4-6)- the rear bank head only had a maximum of 20% leakage on the leak-down test and showed no signs of warpage (used a feeler gadge and razor blade set at a myriad of angles and positions to check). We have changed the timing chain, front engine cover gasket (timing gasket), front oil seal, water pump, radiator cap, flus

Hi there. It sounds like you have done the most obvious checks and I can assure you by-passing the heater core will have no effect. There are three possible causes that you need to investigate further and you will need specialist equipment for it - ... 1999 Ford Taurus

I have a 1985 chevy pick up S10 with a 2.8L engine my problem is i threw the timing chain , i replaced timing gears and chain top dead center hard to start ran rough after a while took it to a mechanic see if he could help worked on it ran rough and would back fire every so often 20 mi. back fire 2 or 3 times and lose power on inclines. harmonic balancer came apart went to fix that took it all apart again to check top dead center agaian was ok putting back together new plugs wirers cap r

... Cars & Trucks

2000 Mercury Cougar V6 Automatic Got a problem, the spark plug boots were getting wet with oil from thr ring seals on top of the valve cover, took the valve cover off to replace the gasket and the ring seals , and checked the timing chain,, it has 2 camsfafts on each head, and two different chains, each one goes to each one of the heads, now found out that one of them (timing chain) is not tensed, it's loose., just with my fingers it goes up and down, and the other side is very tight, is this n

\015\012\015\012\015\012No this is not normal and yes the tensioner needs to be adjusted or replaced if you want this corrected.\015\012You have to remove - \015\012\015\01 ... Mercury Cougar

1994 Chevy Suburban K1500 5.7L v8 157 thousand miles.. replacing timing chain on the vehicle and after replacement truck ran steady at 1k RPMs. During idle in park the following day the truck died, re

First you need to retrace your steps...before you changed the timing chain and gears did It run ok ? what was initial problem, next put a fuel pressure gauge on your fuel line and cycle your key on to run pos, dont have to try start, just run and see ... 1994 Chevrolet Suburban

1982 gmc truck 305 engine how to replace timing chain cover gasket also I know that I have to take the waterpump off also to access the timing cover. Is there a way to replace this without taking off the oil pan also? also what is the right way to tighten the bolts when installing these components?

You just loosen the pan you will however have to take the front 2 pan bolts all the way out and then you can remove your cover,your kit will come with new seals and gasket,I hope this helps you and thank you ... 1983 GMC C1500

2002 Chevy Cavalier - have just replaced the fuel pump and fuel filter for a second time in under a year. Car runs but is running rich. Can drive it but at the 3 or 4th stop, the car acts like it is going to die or does die. Will start right back up. Checked all sensors - not the problem. Timing chain was replaced Fall 2010. Also just had a tune up.

Http://realfixesrealfast.com/realfixesrealfast.com/Diagnostics/Pages/Stall_at_idle.html\015\012\015\012T ... 2002 Chevrolet Cavalier Coupe

2001 Dodge Intrepid SE, great condition, new water pump, timing chain, transmission lines, cam sensors, thermostat, head gaskets, raditor, 0 miles on oil change, Eagle R tires, DOESN'T RUN - NEEDS TIMING CHAIN and BATTERY whould i bye it for 1,400

After the repairs needed and the associated cost you will be above value for the vehicle, if you havent heard it run and know it needs a timing chain you run the risk of buying a car with twisted valves. resulting in the need of an engine ... Dodge Intrepid

I am replacing the timing cover gasket on a 02 chevy s10 4.3L...will also need to replace oil pan gasket...need a little help on sequence and procedure...

Too much to type...you should buy a book at Autozone on your truck, its about $20.00....it will help you .. ... Chevrolet S 10
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6695 seconds