Having problems with your Cars & Trucks ?

P1702 TRS CKT INTERMITENTE FAULT

\015 TIEMBLA EL MOTOR AL ESTAR PARADA DESPUES SE PARA\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

P1702 TRS CKT INTERMITENTE FAULT


... Cars & Trucks

Hi my name is Kevin, and I just had a motor put into a 1998 lincoln continental that I just aquired. He took the transmission off the old motor and put it on the motor that went in. Now the car wont go out of first gear. It shows the following codes P1519 Intake manifold runner control (stuck closed), P1702 TRS circuit Intermittent malfunction, P0702 Transmission control system electrical. AL4 Pressure modulation solenoid valve output fault. Open circuit or Short circuit to positive, P0750 Shift


Make sure the troque converter is good and all the sensors on the transmission are ok and check the linkage first ... 1998 Lincoln Continental

1999 Chrysler Concorde LXI 3.2 L engine 68K miles: check engine light came on. Began having transmission shift problems. When cold, shifted ok for first couple of shifts. When warm, won't go into high gear most of the time. Also hard downshifting. Got the following error codes:P0700 (Transaxle control system fault -- failure of transmission control module, TCM, shorted or open ckt within transaxle); P0701 (PCM has determined that the transmission control system is out of range for the current en


This sounds as if the input and output speed sensors may be having an issue. If you are putting a used tcm in it will have been powered down and basically reset to it's defaults.Would completely disconnect the battery and hold the cable ends together ... 2001 Chrysler Town & Country

Po1682 ingnition switch ckt fault


Here is the definition for code 1682. Problem could be with the ignition switch, the harness, or the computer.P1682 CHEVROLET Description\012\011\011\011There are 2 ignition voltage circuits supplied to the Engine Control Module ( ... 2006 GMC Envoy

Have been given fault codes P0708 and P1702 what parts do i need to replace. over drive light flashing car keeps jerking as though changing gear when not necessary when this happens seems to rev up on its own.


P1702 sh0ws up on ford half ton ... 1993 Saturn SC2

HOW TO FIX ODB FAULT CODE PO113 IAT CKT HIGH INPUT


This Relates to Circuit High Input for Intake Air Temperature Sensor 1 There seem to be several options of engine configuration in this model,as for most Honda.Usually the Intake Air Temperature sensor needs either cleaning with crc sensor clea ... 2005 Honda Civic

Service Engine light refuses to go off. Fault Code P0134, states O2 sensor CKT Inactive (Bank 1 Sensor 1). Had already replaced this sensor with a Bosch, mechanic cut off plug from harness and wired in per directions. Rewired in different combinations, light still on. Different opinions for solution: 1. Can only use a Mitsubishi part, Bosch won't work. Buy Mitsubishi, wire it in since plug gone. 2. Still wired incorrectly. Bosch should work. 3. Need Mitsubishi part AND plug. Won't pa


You can use a bosch, but not the universal one. Use the bosch one that is OE design. ... 2001 Mitsubishi Diamante

P0117 code failed smog test. check engine light..OBD fault code po117 ECT CKT low input


... 1996 Volvo 850

2000 Golf TDI: Have a code P0380 / Glow plug/heater CKT A malfunction. What's the primary cause of this fault?


... 2003 Volkswagen Jetta TDI

Ignition parts I had a P0353 DTC and it faulted "Ignition coil c primary secondary ckt". I bought the coil as called out at the NAPA store and was unable to locate a 4 post coil. Does this car only have an ignition module and not a coil? I have spent hours looking and have been unsuccessful. Thanksl


... 1998 Lincoln Town Car

2003 tahoe fault code p0101 maf vaf ckt range/perf p0300 random multiple misfire detected p0420 catalyst eff below threshold bank 1 p0172 sys to rich bank 1 truck suddenly started to run poorly, has little to no acceleration & wont hold an idle. recently have replaced plugs, wires, air and oil and fuel filters with no help. cleared all above stated codes only to have the first two listed return. truck still runs bad.


For p0300 ,p0240 on chevy tahoe 00- 06 check a wire going along with the battery ground to the engine block thre should be a high resistence on the small wire ,it gets corrode over time ,it should be located on underneath of the driver side engine, ... 2003 Chevrolet Tahoe

Fault B1317 battery voltage high fault P1632 smart alternator faults sensor/circut fault P0691 fan 1 control circut low fault P0306 cylinder 6 misfire detected fault U1900 can communication bus fault reciever error PLEASE CAN ANY ONE HELP FIX THESE FAULTS AS I DON'T EVEN KNOW WHERE TO START


... Ford Focus

Engine stop while running, check engine indicator is on using autoboss v30 diagnostic computer 6 fault was found fault code 11 description aps fault code 46 description inj adj v fault code 27 description aps2 fault code 31 description can comm. fault code 52 dseciption vgt cont.prs. fault code 51 description egp pos.snsr


... 2000 Mitsubishi Montero

What does the smog fault code p0122 mean?


... 1998 Chevrolet Lumina

My grans hyundai getz 53 reg had an abs fault, i tried my bosch kts an snap~on solus but would not give any fault codes, i borowed a friends diag tool an it found an engine mgnt fault in abs system, i cleared the fault, road tested the vehicle an the light came back on again the same engine mgnt fault, i road tested the vehicle with live data and found the n/s/f sensor faulty, today i replaced said sensor and tried the kts again the knock the fault code off and got c2402 (pump motor engine relay


Hi from uk for your info there was a recall back in2004/5 for the getz relating to the abs system going faulty my wifes 2003 getz gsi was recalled and i took car to dealers for her to enquire what fault has there beenon some getz with a ... 2003 Hyundai Santa Fe

P1642,p1797.po171,po174 car sets a p1642,p1797, po171,and a po174 codes. when this happens i lose the tach and it comes up with a gearbox fault and asc/trac unavailable. is this a CAN bus fault or a fuel pump monitor circuit high input fault? also is p1797 a neutral circuit fault or a CAN circuit fault?


... Jaguar X-Type

Abs fault light, engine management light, parkbrake fault (won't go off) DSC fault light, air suspension fault, 2003 Jaguar 3.5 SC V8, ah also discovered water ingress in boot, quite a lot!!, only fault code found is C1175, what is happening here, car appears to drive ok


Try disconnecting the battery both leads and join them together for 5 mins and see what happens cannot find this fault code in teh jaguar OBD codes so consult with teh code reader manufacturers ... 2003 Jaguar XJ-Series

Audi A4 3.0tdi 2006 Convertible. Misfire when cold, engine is fine when hot. Starts on the button. When cold a 'pinking' noise can be heard on acceleration. Pinking decreases as the engine gets hot?? Mate has suggested glowplugs as a fault however I question this as it is a running fault and not a starting fault. Could this be some form of a sensor fault??


... Audi Cabriolet

Abs and engine fault light came on at same time. This was almost a year ago. Local company hacked in to system and diagnosed tps sensor fault, changed thi, no difference.Drove 400 mile round trip for proper diagnosis, fault code P2106 shows up, rear abs sensor apparently.Changed this for new genuine Ford part, no change. Sent for replacement abs sensor, still no change. Take truck to local garage who specialise in fault diagnosis, they say my second replacment sensor is faulty. Get this replace


If they are checking the system at the ECU and its telling them the sensors are bad, then you have a broken harness down stream of the ABS ECU. There has to be a brake in the harness to the rear wheel sensor(s). It is a brake in the harness or the en ... 2004 Ford F150

Would replacing the egr valve fix the other faults such as egr solenoid fault,egr pressure sensor fault and egr positionsensor fault


The EGR valve can be tested with a Vacuum pump. If the diaphragm is bad, the valve will not change positions. Hence the error Code for the position sensor not opening to allow the valve to work. And the error code for the pressure sens ... 2000 Ford Taurus

Mercedes E200 Kompressor, 210048. Engine fault light came on and the fault code was "intake air device:wrong operation (work link), air flow too small. (P0410)" The air flow meter was replaced and the fault code deleted. Remained OK for about two weeks then the engine fault light and the same code re-appeared. Any assistance greatly appreciated.


CODE PO410 AIR INJECTION MALFUNCTION. CODE PO410 AIR INJECTION RELAY. PROBLEM COULD BE THE AIR INJECTION RELAY. ... 2004 Mercedes-Benz C-Class

BMW (1996) e36 318i ABS fault. The ABS fault light stays on which means that the ABS system is deactivated. The diagnostic check when the car was serviced was that the front left brake sensor was faulty and so we had this replaced however when the fault is reset on the onboard computer it comes back on after driving a short distance. The workshop (not BMW) says the ECU is at fault. Could this problem not be one of the 2 ABS relays in the fuse box?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Yes you are absolutely right\015\012this issue might be due to relays. This is a common issue in E36 and ... BMW 318

The problem with 2002 nissan altima is ,whenever the battery terminal is removed,the car wont accelerate,so i used my scanner to detect the faults,and it shows me some fault codes,e.g. ( u1000,u1001,P1490,P0650,P0037,P0113,P0462,P0447).When i wiped the faults code,the car will accelerate,But when i remioved the battery terminal again,it wont accelerate and the fault code will generate again.What is the possible permanent solution.thanks.


... 2002 Nissan Altima

My 52 plate Stilo 1.9 JTD has an ongoing fault of engine backing off at high speed (but maintains this speed if you accelerate away) and cutting out altogether when slowing down to idle for a junction for example. I've changed the fuel filter and checked ecu/sensor connections but all seems ok. I get no fault up on the dash when the fault is evident. Also the last time the fault occurred was about 8 months ago. There is plenty of fuel pressure to and from the filter housing so i'm guessing the l


I would suspect a system that is only supposed to work in mid range.I don't know the European pollution laws, but in the US, the ERG or purge valves can cause this sort of symptom.Both are essentially small intake manifold leaks, that mes ... 2005 Fiat Pininfarina

I have my rexton 3.2 ...now the problem is when im start it,the engine was running and not stable n some time ok...plug coil,plug new....i already do diagnostic n the fault code tell the (o2 sensor heater fault)(not defined)......i changed all o2 sensor,but still not stable...sometimes OK...exhaust have black smoke... the fault code some time have many,,some time a little bit..but same fault code...have a problem with my computer box or not????please help me!!!!


... Mercedes-Benz E320
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1237 seconds