Having problems with your Cars & Trucks ?

Where is the relay of the vw microbus 1992 2.5i

\015 Diagram of the relay and fuel pump\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2006 dodge charger, er code p0406, check egr harness for 5v power on yellow with pink wire and no voltage 0 car is idling a little rough and has slight hesitation when accelerating.replace egr before i found 0 voltage.Also would like a diagram of the relay locations in the fuse box.there are 4missing relay plug sockets


Every fuse box has empty slots, so that is not the issue, this problem is this, the "EGR valve position sensor high signal return detected", this means that the EGR system is working, just the fact it generat ... 2006 Dodge Charger

1994 e-150 conversion with a battery guard system. not starting, no click at solenoid, just relay click. I replaced the starter relay due to the relay clicking but no starter rotation after. The ignition wire to the starter stays hot all the time (12 volts), but goes to 0 volts when the ignition turned to the start position. Any ideas???? I might have wired the relay incorrectly. I'd like to find a picture or description of the exact relay wire placement.


Bad ignition switch it sounds like. A contact may be bad inside your switch upon turning it to the start position ... Ford E-150

I have a 99 dodge ram 1500 5.9 we put a fuel pump with regulator in and a relay .still would not start it will start with the fuel relay out the psi will drop down to 0 and still will run just at idle but still run as soon we put relay back in it stall like it getting to much fuel


... Dodge Ram 1500

I have audi A8L 2004 4.2L. The car starts and after 30 sec. main fuel pump relay shuts off and pressure drops to 0 and engine shuts off. I'm auto technician, I checked circuits to main fuel pump relay and signal from ECM to relay is disapering after 30 sec. Car starts fine every time after shut off and every time it shuts off after 30 sec. Tell me what problem could it be or what I should check? Thank you. Sincerely Jerry


Could be an oveheated fuel pump! Extract the pump out from fuel reservoir and test it! ... Audi A8

Hello I have a 2002 dodge durango. 4.7 L Problem is po138 problem is i have no power going to either 0 2 senor. This system has only 2 o2 . not 4 my problem is my alldat info has the wrong wireing diagrams. they show in the pdc box a o2 heater relay, and a u fuse. i have empty pin cavitys. i have allway know chryler to power the o2 heater throught the asd relay with the coils and injectors. need to get a diagram or answer to where it get its power from thank you


Your best bet for a visual of the wiring diagrams is to buy a Haynes book for your truck at Autozone,they have a pretty complete set in the back of every book.$20.00 ... 2002 Dodge Durango

Relays in dash pass side clicks, lights go on and off, security light comes on, 3 of the relays get hot, battery voltage drops to 0 car stays running.


Test alternator for proper voltage gain. ... 2002 Chevrolet Monte Carlo

I got a microbus 2.3 2000 model, the fan is not working. i have checked all fuse and relays all are fine what next must i check. i did also check the wiring frm the fan to the relay ,everthing is looking fine. please help


Run leads direct from the battery to the fan and check that it runs. Check that there is power at the fan (the fan runs) when the thermostat on the radiator is shorted out. ... Volkswagen Microbus

Glow plug relay reading 0 with ohm meter. changed


Pick up a copy of Haynes Diesel Repair Manual, part # 10330. It has an extensive diagnostic and repair section for glow plugs in your truck, either 6.0 or 7.3. It's only $20 and well worth it. It has diagrams and wiring especially pins on the plug-in ... 1991 Ford F250

Does the VW microbus 2.3i 1997 have a fuel relay?


... Volkswagen Microbus

1988 honda civic stalled,code 16,replaced main relay,code now reads 0,car still dont start


... 1988 Honda Civic 2 Door

Where is the relay of the vw microbus 1992 2.5i


... Cars & Trucks

Where is a throttle control relay located at and how do you go about testing it on a 1992 s10 blazer with a 4.3 v-6.i can not get this to throttle up and the idle is erratic. i can pull the pcv valve off the hose and it will idle. i have no codes but i do have 0 throttle control


The irradic idle of the engine is not a concern, after many years the fuel/air mixture gets to a point where the emission control has to constantly compensate by increasing and decreasing the idle speed. As far as you not having throttle control do y ... Chevrolet S 10

Where is the fuel pump relay located on a 1991 ford mustang gt 5'0 just need to know where its located.


I'm showing it on the passenger side of the radiator support, in the CCRM, Contstant Cntrol Relay Module. 4 realys in one module. For 1994 anyway. I don't have 91. ... Ford Mustang

Ford focus cmax electrical discharge. checked alternator, fuse box, relays, wiring. still has a 0,4 discharge


You would need some draw for the memory in the radio, the onboard computer, the antitheft and its Keychip reader, and possibly electronic shift memory.\012\012Check your Battery case and put a temporary piece of cardboard under the batter ... 2003 Ford Focus

I am not getting fuel to the throttle body. The pressure is at 0. If I dump gas into the throttle body, it will start and then I have pressure and stay running. I did this a couple of times and after that it would start up about three different times (morning, night and morning). Now I can't get it to start at all and the pressure gauge is on 30 psi.(does want to though). Thought it was the relay, but then found out that it was the fan control one that we would mess with. Any ideas on what


Check fuel filter,listen to see if fuel pump cycles when you turn the key on,shuld run for 3 seconds,sounds like fuel pressure regulator ... 1987 Jeep Wrangler

Where on the car is the relay switch for the cooling fan control,,2004 jetta 2,0


Usually one at rad itself & one other in hose or coolant passage area. ... 2004 Volkswagen Jetta

I was talking to you about the relay signal on a 200 0 grand prix? well i think i have found it. the problem is that the turnsignals dont work at all


And you have checked all fuses? The relay may not always be the problem, it may actually be the switch itself. A pretty easy part to find, try junk yards or if you have to parts stores should have the switch mechanism itself. ... Pontiac Grand Prix

03 dodge Caravan while driving home speedometer went haywire. It would go from 0-120 then it would down shift hard. I think the speed sensor is out. I drove it home and parked it and went back to work. Now i can't get it to start at all. I pulled the altanator it is fine Battery is fine fuses and relays are fine. I'm not sure what to do. Please help my wife is driving my Truck and i'm having to drive Motorcycle. It's December and it's to cold for a motorcycle. HELP!!!


Check body control module - or theft detereant module ... Dodge Caravan

1996 gmc yukon. replaced fuel pump 3 times in 2 months, finally running then it wouldnt start one day. cranked it over for awhile and nothing. sat 15 min it started right up, drove home shut off, then started back up. next day no start. just replaced fuel relay still no start, checked fuel pressure its at 0, is it possible the pump is bad again or could it be the clip for the power to the pump being loose or faulty?


This is a very common problem. GM has issued a service bulletin to replace the wiring connector at the fuel pump assembly on top of the tank. check the end of the plug for burnt terminals. the service bulletin states that these corroded connectors ca ... 2000 Chevrolet Tahoe

S10 1999 bearings bad 0 oil pressure,removed and rebuilt engine, replaced most all. back in and...Won't start, not a crank or a ticking from the starter. Starter and starter selanoid, battery all tested OK.conecting to starter and starter getting power. Replaced neutral safety switch twice , check all 3 relays all OK. Still no response. Lights and accessory lights all go on when ignition turned. Have tried all gears but still nothing. Could I have forgotten to replace something. Is there a way t


Yes, you can hotwire the starter, use a button starter to energize the solenoid. there is a chance thet the new or rebuilt starter isn't working. it has happened to me I went an bought a newly rebuilt starter but it was no good, it happens sometimes. ... 1999 Chevrolet S-10 Pickup

I have a 2002 hyundai elantra I have replaced the alternator and got a new battery well it ran for one day then while driving it the next day there was a big clunk like something fell out of the motor then the RPM dropped to 0 then it died. Now the battery is dead and it will start if it is jumped it will run for about maybe 2 minutes then the RPM drops and it dies. So what i am asking is is there a relay or fuse or sensor that has failed or did I get a bad alternator??? Please help ASAP I miss


Crank sensor will cause similar stalling issues. You may have got a bad alternator, if the battery light is on after you jump it, probably needs a new, new alternator. make sure all your connections are tight and plugged in, both on battery and alt ... Hyundai Motor 2002 Elantra

Help!! i have 91 acura integra. Car died yesturday while driving. The tac went to 0 while slowing down. Has a new main relay. No spark with spark plugs. Do you think it is a fuse issue? and if so where is the ignition fuse located in the car? thank you ~niki


Sounds more like the timing belt broke ... 1991 Acura Integra Hatchback

1998 GMC Sierra. Blower motor works sometimes. No particular circumstances, just when it wants to. Checked all fuses, relays, even replaced the resistor, nothing. Followed the wire harness and found the two pigtails that others have mentioned. Took the wires off, black and purple, and turned ignition on. Getting around 11 volts on all sittings except for the highest setting, it reads 0 volts. The compressor turns on at the console, all the switches on the console work, just not the fan.


Could it be the blower motor it self? sometimes they have a "bad spot" when it is not working, can you hit it and make it run? pretty common on these trucks. the switch is also common. they often melt at the connector on the back making a bad connect ... 1998 GMC Sierra

Won't start Worked fine last night, didn't start this morning. Battery level fine. Lights, radio, dashboard indicator lights, all work fine. Blower fan for heater doesn't work, and turning the ignition gets me silence. 12.3 volts to starter, multimeter registers 0 on other solenoid terminal when key is turned into start position. Seems like the restart relay is the common element between fan and starter, as I look closely at chassis wiring diagram. Probably have no A/C, but can't tell with engin


A friend here solved it. It was a bad connection of the ground wire, with the paddle-shaped connector loose. He cleaned it a bit, slid it back on, and crimped it a little (not easy to do in that tight space). Solved both problems. ... 1993 Isuzu Trooper

Where is the Microbus Exclusive 2000's fuel pump relay situated?


... 2005 Volkswagen Microbus
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5705 seconds