Having problems with your Cars & Trucks ?

Firing diagram for 1993 chevy 1500 4.3 engine 6 cylinder

\015 Firig order\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 95 chevy s10 with a 4 cyl engine. Problem is its running on 2 cylinders. 2&3 is firing SO i switched the coil paks to see if one was bad and it still fired on 2&3 but still nothing from the 1& 4 cylinder? .


... 1995 Chevrolet S-10 CA Edition

Engine diagram Again I failed I have a 440 big block I it is in a Sportscoach it is only firing on 4 maybe 5 cylinders I cannot see much in the engine compartment. I need to know Which cylinder is the no. 1 then the no. 2 and so on like if you draw a block with 8 circles two on top and four down. I am sorry to be so inexperienced.


Maybe this will help. firing order 1,8,4,3,6,5,7,2. Counterclockwise ... 1983 Chrysler New Yorker

5.3 liter Chevy engine #1 Cylinder not firing at idle


... 2005 Chevrolet Silverado 1500 2WD

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

I have a 2000 Chevy Monte Carlo with a 3.4l v-6. The check engine light comes on, and when it was scanned it says cylinder 1 is mis-firing. Is this a plug or wire issue, and if so, where is cylinder one located on the motor?


Number one should be first plug passenger side front bank. if you don't want to invest in a tuneup try swapping the wire with one from another cylinder and see if the misfire moves to that new cylinder. ... 2000 Chevrolet Monte Carlo

I have a 454 7.4liter engine for a 1994 chevy truck and I can not figure out the firing order. I know it is 18436572; but I cant find #1 on the cap. I cant fell the presure of the air going up in the pistions. I would like to see a diagram of the engine or someone to help me. The truck seems to backfire or pop instead of starting.


OK lets have some history, did this happen all of a sudden, or after its been messed with? Number one is left front cylinder. Take the spark plug out and hold your finger over th ehole, now slowly have someone BUMP the eng over, when you feel air pus ... 1994 Chevrolet C/K 2500

In what order does the engine fire in 5 cylinder engine. in a 4 cylinder the fire order is 1342 a vw caravelle has 5 cylinders starting with the #1 cylinder in what order does the engine fire?


1-2-4-5-3 I hope this helps you, and have a merry x mas, and please vote on this solution, ... 2005 Volkswagen Microbus

Check engine light on and sometimes flashes. Had it hooked up to the computer and it says cylinder 1 misfire. I am lohing for the diagram of firing order.


Number 1 is front driver side plug ... 2005 Chevrolet Equinox

I bought a 1984 chevy 350 engine from a salvage yard that ran but never ran right. Come to find out it had a bad exhaust valve. we took the head off blew it out and replaced the valve and put the head back on and hooked everything back up. We set the valves and the timing. It wont start at all. It fired a couple of times but never started. We checked timing again with the valve cover off and made sure it was on tdc with distributor pointing at #1 cylinder. We tightened and loosend the rocker arm


... 1985 Chevrolet El Camino

Firing diagram for 1993 chevy 1500 4.3 engine 6 cylinder


... Cars & Trucks

Firing order diagram ford taurus v6 3.06 6 cylinder engine, and which one is the number 1


FIRING ORDER IS 1 4 2 5 3 6. STANDING IN FRONT OF CAR ON PASSENGER SIDE FIRST CYLINDER FRONT IS 1 2 3 ON DRIVER SIDE FIRST CYLINDER FACING YOU ARE 4 5 6 SEE 1 CYLINDER FACING YOU ON PASSENGER SIDE.GET A PIECE OF PAPER WRITE NUMBER ON TOP ACROSS LA ... 2000 Ford Taurus

Check engine light flashing runs rough not firing on all cylinder2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed up fuel tank vacuum 3. system too lean bank # 1 4. cylinde # 3 missfire detected 5. cylinder # 4 missfire detected 6. cyclinder # 2 missfire detectd I installed a new mass More 2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed u


This could be a bad cam sensor that hasnt gone yet. It would explain why you are running to lean. ... Lincoln Navigator

I have a chevy 2.8l engine I just installed and it won't start. I have checked to make sure that I am not 180 off, and I have spark and fuel. the chiltons manuel shows the distributer with the #1 wire on the distributer pointing at the #2 cylinder on the engine with the engine at TDC on #1 ,but the other manuel shows the distributer pointing at #1 with the engine at tdc on #1. I have tried it both ways and also wired it as if I had put it 180 off both ways just in case I had a brain fart. The en


# 1 cyl. is on driver side front . remove # 1 spark plug and put your finger over spark plug hole and have somebody bump the starter over . when the cylinder air blows your finger back that is close to tdc. #1 compression. The timing mark ... 1991 Chevrolet S-10

93 honda accord engine no fire cylinder 1


You have same valve problem, either the intake or exhaust is burn out ... 1993 Honda Accord

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

I have a 97 chevy tahoe. I changed the spark plugs, wires, distrubutor cap, rotor. About 300 miles later engine light came on. I thought maybe cheap distrubutor cap and rotor was cheap. I went to auto zone and got another one. Engine light came off on free way. Came back on later on that day. I checked compression test was good. Only miss fire on cylinder 6. So I changed plug and wires again. Still engine light is on. You can on tell the miss fire when your at a stop sign or going slow. Also I


The number 6 cylinder is located (if you are looking at it from the front of the car) it is on the left side third cylinder back from the front. you probally have a bad injector that is just dripping fuel into that cylinder. ... 1999 Chevrolet Tahoe

We have a 1999 Isuzu Rodeo that will only fire on 3 cylinders. THe cylinders are all on 1 side and seemed to point at the Powertrain control module as the problem. We changed out the PCM, EGR valve, checked the timing belt, plugs, wires,as well as fuel pump, and also changed the fuel pressure sensor switch. If you disconnect any of the 3 coil packs on the drivers side while it is running the engine continues to run. If you disconnect any of the 3 coil packs on the other side it shuts the engine


Check the coils themselves ... 1999 Isuzu Rodeo

I have a 2003 chevy 2500 with an 8.1l engine and I am gettin deposits on cylinder 1 and the truck is misfiring on numerous cylinders and its using a lot of oil . The engine has been rebuilt. I have changed the wires and all the plugs and I'm still gettin misfire. Any idea what it could be?


... Cars & Trucks

Iaccording to Haynes manual, shows firing order as 1-2-3-4-5-6, with #1 cylinder passenger front. saddly it doesnt run, backfires when trying to start. is there any other firing order for this engine, used in many GM vehicles?


... Jeep Cherokee

Ignition coil Our 2002 Lanos is pulling a misfire code. I have discovered that the ignition coil is firing 1 and 4 cylinders. Cylinders 2 and 3 seem to have a very weak spark output. 1 and 4 are on the same half of coil, and work fine. 2 and 3 are on other half of coil. I have changed the ignition wires twice to check for bad wires. Problem seems to be coil. I am buying one on Ebay, good price. Hope this resolves issue. Engine dies while driving, no warning. My guess is that as coil heats up und


Hi, the reason for the engine to die when you turn, is because it make more effort while turning ,this is part of the same problem, if you dont have presure some times it can be the pump ,be sure you hear the pump runing when you turn the key ... 2002 Daewoo Lanos

I would like to know the firing order of my 2004 Kia Amanti looking down on the engine . I have a code of P0301 cylinder #1 misfire. I want to know what is the cause I just change the wires and plugs about two months ago . I just got the car back from the dealer on Friday for the replacement of power steering pump and today I go to drive the car and it is rough idling like it is missing a cylinder and the check engine light came on. I pust my computer on the car and it gave me the code above. I


Kia Amanti 2004-06 - Repair GuideFig. 3.5L engine\015\012Firing order: 1-2-3-4-5-6\015\012Distributorless ignition system ... 1986 Lincoln Town Car

Switched the engine in a 1995 Chevy Blazer, 4.3 liter vortec W series. The engine fired up on the first try then it wouldn't start up again. I'm looking for a wire diagram with pin outs. I need to know where wire# 468 lo side inj B is in the pcm plug. Its pin# is A9 on the diagram I have but doesn't show the pin#. I checked the fuel pressure, its good and changed the coil and fuel sensor. Its making me crazy. Anyone that has had the issue or advice will be appreciated. Ken


Have you checked for spark? If yes, will it start if you spray carb cleaner in the intake? ... 1995 Chevrolet Blazer

Engine Light problems , I have replace Fuel injector, new Coil pack new pig tail lead for #i1 Coil Pack , Check Vacuum, and Compression Cylinder, Now if the Idle fall to 535 RPMs Engine light will come on and a Code of P0301 Mis fire on Cylinder 1 is this ldle to Low if the light comes on I can Slowly push the gas and 625 to 700 Rpms the light will go Off


You've done all the right things, so piston rings or leaky valve is out of the mix now. Now back to the simple stuff. Change your spark plugs to A/C Delco 41-103 if you haven't already. Don't try and gap them, the iridium will come off and possilb ... 2006 Chevrolet Trailblazer

Engine firing only cylinder #1


... 1986 BMW 3 Series

2005 expedition 5.4 bank 1 too rich, cylinder 1 misfire, o2 sensor 1 error, I changed o2 sensor,spark plug & coil but engine is still smoking,raw fuel, doesn't seem to be firing on bank 1


Un plug the fuel injector and see if the raw fuel smell, goes way, if it does the injector could be stuck open. if this is the case the more you run it the more fuel is getting into the crank case, this can wash the bearings and ruin the engine, che ... 2004 Ford F150
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2117 seconds