Having problems with your Cars & Trucks ?

Firing diagram for 1993 chevy 1500 4.3 engine

\015 Firig order\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

I have a 454 7.4liter engine for a 1994 chevy truck and I can not figure out the firing order. I know it is 18436572; but I cant find #1 on the cap. I cant fell the presure of the air going up in the pistions. I would like to see a diagram of the engine or someone to help me. The truck seems to backfire or pop instead of starting.


OK lets have some history, did this happen all of a sudden, or after its been messed with? Number one is left front cylinder. Take the spark plug out and hold your finger over th ehole, now slowly have someone BUMP the eng over, when you feel air pus ... 1994 Chevrolet C/K 2500

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

Switched the engine in a 1995 Chevy Blazer, 4.3 liter vortec W series. The engine fired up on the first try then it wouldn't start up again. I'm looking for a wire diagram with pin outs. I need to know where wire# 468 lo side inj B is in the pcm plug. Its pin# is A9 on the diagram I have but doesn't show the pin#. I checked the fuel pressure, its good and changed the coil and fuel sensor. Its making me crazy. Anyone that has had the issue or advice will be appreciated. Ken


Have you checked for spark? If yes, will it start if you spray carb cleaner in the intake? ... 1995 Chevrolet Blazer

5.3 liter Chevy engine #1 Cylinder not firing at idle


... 2005 Chevrolet Silverado 1500 2WD

I need the firing order diagram for a 1977 chevy 454 engine


1365472, 1 3 5 7 are on the pasengers side 2 4 6 8 are on the drivers side. ... 1977 Chevrolet Silverado 2500

Diagram for firing sequence for 2000 chevy impala 3.4L engine


... 2000 Chevrolet Impala

I have 1 1992 Chevy 1/2 ton pick up with a 350 engine. The ECM failed and the engine would not start, no ignition. I replaced the module and it fired right up drove like 30 miles all fine. Then it stalled, and I have a different condition, it will start and run fine but begin to idle rough in like 8 to 10 seconds then it shuts down, stalls. You can then immediately turn it over and it will start and repeat the same failure in 8 to 10 seconds?


Try taking vacuum hose off the egr and see if that makes it run.if it does then the egr solonoid bleed filter under the cap on the sol. may be plugged clean it and try again.sol.may be bad to. ... 1992 Chevrolet K1500

I own a 1999 chevy k1500,with a 5.3 vortec engine.Whem the engine is cold it fires up right away,but after I drive for awile,and shut the engine off,and try to start it again it takes a little while to start,and the tac fluctuates between 0,and 500 RPMs,then levels off at 500 after a minute.It then is fine.Battery is fine.


Check the fuel pressure regulator. Pull off the vac line when you shut it off and make sure no fuel leaks out of the regulator. ... 2000 Chevrolet Tahoe

Engine diagram Again I failed I have a 440 big block I it is in a Sportscoach it is only firing on 4 maybe 5 cylinders I cannot see much in the engine compartment. I need to know Which cylinder is the no. 1 then the no. 2 and so on like if you draw a block with 8 circles two on top and four down. I am sorry to be so inexperienced.


Maybe this will help. firing order 1,8,4,3,6,5,7,2. Counterclockwise ... 1983 Chrysler New Yorker

I have a 2001 Hyundai sonata. While driving home I started to lose power. I pulled over and the engine was running extremely rough like it was miss firing and halfway between the 0 and 1 on the rpms. Not sure if that is abnormal or not never payed much attention. Any ideas on what. Would be causing it. As of the moment it is not running. It turns over but does not start. And does anyone know if I can manually check the engine codes?


You can only check for codes with a code reader orProfessional Scan ToolAfter 30 years of these systems, it is had to believe peopleknow nothing,how is thatNormal,abnormal,don't pay attentionWhen I spend $40,000 fo ... Cars & Trucks

1981 chevy 350/or 305?, it is a rebuilt engine, but when I set the timing at 0, 2,4,6,or 8 degrees it sounds good, however, when it warms up it won't start without moving the distributor. I checked the rockers on #1 cylnder at tdc. They are both closed. When I advance the distributor the car starts when hot, but doesn't have power. I am at a lost. I am thinking that it might be the ignition module, or ignition coil. Is there a way to tell? The engine is in a 1981 Caprice Classic and don't reall


Is your heat riser siezed? If it is siezed closed you have too much back pressure. You will need to free it up. To do this you may have to take the exhaust manifold off as it is situated in it. Use heat & WD40 to free it up. Good luck! ... Chevrolet Caprice Classic

I have a 95 chevy s10 with a 4 cyl engine. Problem is its running on 2 cylinders. 2&3 is firing SO i switched the coil paks to see if one was bad and it still fired on 2&3 but still nothing from the 1& 4 cylinder? .


... 1995 Chevrolet S-10 CA Edition

I need a belt diagram for a 1985 chevy 1 ton truck auto 350 engine


... Chevrolet Cars & Trucks

I need a diagram of a 2000 Chevy Asto 4.3L, and I'd like to know the firing order of same engine


2000 Chevrolet Astro Van 2WD4.3 liter V-6\015\012\015\012 ... 2000 Chevrolet Astro

I Need a 454 Chevy Engine Firing Order Diagram. 1988 model Suburban


18436572 ... 1988 Chevrolet Silverado 2500

I need a 1988 Chevy 454 Engine Firing Order Diagram


Here's the firing order part of your question\015\012\015\012\015\012\015\012 ... 1988 Chevrolet Silverado 2500

I have a 2000 chevy 1 ton 350 vortec engine I'm having some problems with the electronics my gauges won't come when I turn on the ignition, it's not kick on my fuel pump or sending fire for the motor to start check the fuses and relays and all are good don't know what the problems is.....


... Chevrolet C3500

DIAGRAM FOR FIRING ORDER FOR A 3100 ENGINE IN A 2001 CHEVY MALIBU


2001 Chevrolet Malibu 3.1 liter V-6 VIN "J"Hope helps (remember rated and comment this). ... Chevrolet Malibu

I need a diagram for the firing order on a 1992 mercedez 220E. It is shown that the Engine order is from the front of the car : 1-2-3-4. How is the high voltage order?


For 2.3L engine, Firing order 1-3-4-2, Distributor rotates clockwise ... 1992 Mercedes-Benz Mercedes Benz 400 Class

Engine diagram for 2004 chevy impala so I may replace the oxygen sensor (bank 1 sensor1)


... 2004 Chevrolet Impala

I need a diagram for the firing order and # 1 location on the distributor for a 1995 1.4 volkswagon golf engine AEX.


... 1999 Volkswagen Jetta

Is there a diagram for the firing order for a chevy 572 engine? If so could I get a copy to [email protected] Regards, Scott J Pender


If it follows the normal big block chevy order, it is: 1-8-4-3-6-5-7-2 ... Chevrolet Silverado 3500HD

Check engine light on and sometimes flashes. Had it hooked up to the computer and it says cylinder 1 misfire. I am lohing for the diagram of firing order.


Number 1 is front driver side plug ... 2005 Chevrolet Equinox

I have a 2000 Chevy Monte Carlo with a 3.4l v-6. The check engine light comes on, and when it was scanned it says cylinder 1 is mis-firing. Is this a plug or wire issue, and if so, where is cylinder one located on the motor?


Number one should be first plug passenger side front bank. if you don't want to invest in a tuneup try swapping the wire with one from another cylinder and see if the misfire moves to that new cylinder. ... 2000 Chevrolet Monte Carlo
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.9793 seconds