Having problems with your Cars & Trucks ?

Which wire on the ECU is for the rev limiter ?1993 accord 2.2

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Which wire on the ECU is for the rev limiter ?1993 accord 2.2


... Cars & Trucks

Shifting/tach Engine Performance problem 1994 Honda Accord 4 cyl Two Wheel Drive Automatic 145000 miles ---------------------------------------------------------------- when i drive down road full throttel the car wont shift into next gear,let up on gas an it will. it sounds like a rev limiter not letting it shift.you can also do this while in park rev up and starts popping like rev limiter is not letting you tac all the way..checked distributer plugs wires cat, converter fuel pump f


Is there a check engine light on at all? ... 1994 Honda Accord

I have a 1998 civic hx an it does not have a vtec engine. The 0bd2 code is the p1259. I believe the ecu is looking for vtec that is not there. Found on another site to fix it, bridge the wires on the connector with 2 wires and ground the other with one wire. I did this and it will then rev higher than 4k with no engine light for about a minuate then comes back on and revs out at 4k again. Is there any other suggestions u may have?


... Cars & Trucks

I have a Disco 200 V8 model. Came back from a trip and next morning, wont start. By passed alarm system with key code. No luck. Checked all wires. Launch 410 diagnostic indicate that permanent power loss to ecu. Checked ecu and found three wires that had power on it when vehicle is switced on. (according to wiring diagram) Checked cranc shaft sensor = ok. All Instrument lights are on. Still do not start.


Have a 99 disco....I had to take the gear selection control box, underneath the center consol. There isa switch that came loose that interfaces with the brake and ignition to start the car. Also there is a selenoid in the box that could go bad. al ... 2000 Land Rover Discovery

My 93 Accord 4-Dr. LX 4 cyl. began sputtering at about 35-40 the other day on the freeway, and the MIL light came on. I jumpered the test harness and got a code 43, which, according to one maint. manual excerpt I read could either mean a problem with the fuel system or the O2 sensor harness. I checked the white wire and green/white wire from the ECU out to the last O2 harness connector for opens or shorts; no problems there. I checked my injector resistor unit and the individual injector resis


Well, code 43 is Fuel Supply or O2 code.Which\015\012 O2 sensor have you replaced? Does the car have any oil leaks? Does\015\012 the car drive abnormal? hesitate, buck, etc.I have seen where \015\012the engine is leaking oil. That o ... 1993 Honda Accord

Trying to install an aftermarket deck wireing harness adapter dose not fit wireing direct unable to figure out some of the wires 2 black blackégrey with some kind of sensor white 2 dark green with a purple all the rest i think i have amtched up according to a diagram i found just the other wires werenèt listed so i wanted to check on what they are and how to wire them or do i need to the car is the limited edition with all the bells and whistles


1991-93 Buick Lesabre Stereo Wiring\015\012\015\012Constant 12V+\015\012Orange \015\012\015\012Switched 12V+\015\012Yellow \015\012\015\012Ground\015\012Black \015\012\015\012Illumination\015\012Gray \015\012\015\012Dimmer\015\012Brown \015\012\015\0 ... 1991 Buick LeSabre

My 2002 alero revs up to 4000 rpm only when in park or neutral,it stays there and hesitates to climb,is there some kind of rev limiter ,shows also dtc po300 random/multiple cylinder misfire, changed plugs,wires, checked the spark and its ok,replaced fuel filter,checked fuel pressure,reads 55 psi,checked injectors and seems ok ,resistance is 13.5 ohms and up, but when i drive the car it revs only up to 4000rpm and seems ****** doesnt want to shift up, is it some kind of a transmission problem?


... 2003 Oldsmobile Alero

1998 honda accord hard to start but idles nice but wont go it will rev nice then next time wont rev over 3000rpm i get a p0335 code could the wires be bad or the sensor


Tps ... Honda Accord

NO START OK WERE TO START I HAVE A 91 HONDA ACCORD THAT I REPLACED SOME FULTY SENSORS ON THE THREE TEMP AND SPEED SENSORS , CAR RAN GREAT FOR AN HOUR OR SO TURNED IT OFF WENT BACK 10 TO 20 MIN LATER AND IT WOULD NOT START A CHECK FOUND IT HAD NO SPARK A CHECK OF ALL IGNITION PARTS SHOWED NO POWER BETWEEN THE PGM-FI ECU AND THE IGNITER TRACED BACK FROM THERE FOUND A BLOWN FUSE AT THE ECU POWER WIRE REPLACEMENT BLOW AS SOON AS I INSTALLED IT I KNOW THIS MEANS A DEAD SHORT BUT HAVE BEEN UNABL TO FI


Boy that sucks. I assume you weren't having the blown fuse problem before you started, I can think of 2 options. Forgive me if this sounds dumb, First take a flashlight if necessary and carefully retrace every step that you did, looking for any pinch ... 1991 Honda Accord

I had a ignition coil explode in my 01 Honda accord and had to swap the engine I put an 02 in it the engine is fine but the car wont start the guy says its my Ecu, could I just need to have reprogrammed or could it have fried the wires or the Ecu


... 2001 Honda Accord

2000 Ford Tuarus 130K P0301 misfire on one. I changed Coil pack,Plugs, wires, fuel pump, fuel filter,PCV, all OEM. P0301 went away but then got a P0300 the next day. not sure what to do now.. need help. I cleared the P0300 code to see if it will come back. Also in park if i rev over 4000RPM it misses it that the rev limiter


Hi there, \012Have you tried vacuum leak test?\012You have already changed the most common problematic parts for your code.\012What you would need is a common shop propane torch.\012How you use.\0121. Start your engine. ... 2000 Ford Taurus

Bosch 0 261 203 058 ECU on 93 volkswagen jetta III GL 2.0 auto trans made in mexico VW ECU #037 906 258E need to know which pin connects to vehicle speed sensor, a good wiring diagram would be most helpful


... 1993 Volkswagen Jetta

My 91 honda accord acts like it has a rev limiter at 2500 RPMs. anybody ever hear of that?


I would suggest you change out the fuel filter and then try it, if that doesn't change anything then pressure test the fuel pump to see if it is putting out the correct pressure, low fuel pressure causes this type of symptom ... 1991 Honda Accord

What wire runs the rev limiter


... 1996 Saturn SW

I have a 1991 accord. The distributor is getting power. We have changed the button and cap. Plugs and wires changed. ECU changed. It will crank, not start. What else could be the problem?


If i remember right there are two sensors in the dist. sometimes they go bad and will not allow the plugs to fire. its easier to replace the dist. then to replace the sensors. you can get one for a junk yard for cheap. thats what i whould try if it h ... 1991 Honda Accord

Truck misses at 3500 rpm as if that is what the rev limiter is set at. I have replpaced plugs, and wires. I recently bought one new coil and took turns replacing one of the three old ones on the truck, but, nothing has helped. The truck occasioanlly turns on the check engine light. code = camshaft position sensor.


The camshaft position sensor is a $40 - $70 part at rockauto.com, depending on your engine. first check the connections to the sensor to make sure the computer is getting a good signal. You may have to remove the sensor and look into the mounting h ... 1998 Toyota T100

Wireing problem i have a 2003 chevy 2500 hd,it started to skip so i thought it was a fuel filter it wont get over 2000 rpm and its like it hits the rev limit i turned out of the store and something sparked i cant find were its comein from a buddy of my said my ignition switch is bad oh it s blowing fuses on the ignition b box if some one could help i would surly thank you


YOU NEED TO REMOVE STEERING COULIN PANELS OR HAVE ENGINE RUNNING AND SHAKE WIRING ETC, YOU MAY HAVE TO DO THE SAME UNDER THE BONNET {CAREFULL OFF MOVING PARTS}.. ... 2003 Chevrolet Silverado 2500HD

Trying to hook up tachometer to my 1998 Frontier...hooked up green wire to pink/blue strip in ECU according to directions. no good tach goes to up to zero but no higher. need to know how you can tell negative side of distributor


... 1998 Nissan Frontier

Can anyone please help me to pin out my accord 1990 f22a1 engine ecu harness socket. i need the color code and description of each wires. many thanks!


Email me at Nielsen_automotive And i Will give yoiu all theinfo you need for it ... Honda Accord

I haveb 2002 chevy malibu with 222,000 miles. The car has no power and when trying to accelerate the more you push in the gas the slower you go. If you have the car in park and give it gas it will go to about 3500 rpm and the act like it has a rev limiter. At 195,000 miles i put new fuel pump, and fuel filter. I put new plugs and wires for the second time on at 220,000 All plugs looked great. The car does not burn or leak any oil. At 200,000 new idle control valve. The car has no codes or check


Sounds like the cat is plugged replace it ... 2002 Chevrolet Malibu

CEL on; no error codes.. I havent tried hooking up a obd code checker. The problem I'm having is a hesitating idle. Every time I rev the engine a little is seems as if im running on 3 cylinders or something. Work done: - replaced plugs + wires - replaced pcv valve- repositioned distributor to see if it was misaligned. - egr is good; checked and ok- iacv cleaned and resealed with gasket maker. Should I clean the fuel rail and injectors? I did clear ecu and disconnect battery to clear error code b


Check compressions ,,,,could be dodgy valve seats ,wouldnt be the first time i have seen all this changed ,then vehicle comes to me and badly burnt valve seats are what i find ,new gasket and regrind of the valves and the vehicle leaves me driving li ... 1992 Honda Accord

Recently bought a 1988 Accord. It revs high upon starting, and at lights stays at 900rpm. Told by dealer (over phone) it's probably the Idler Control Valve - $300!! Can I just take a chance and fix the plug over the idle speed adjustment for $0$? $300 is a lot of money to me!


Yep, you can do that. You can also use Seafoam (you can get it at parts stores) and clean the intake manifold out with that. The instructions are on the can, and it's super easy to do. Also, you can take off a vacuum line from the ICV, put a WD40 ... Honda Accord

I want to remove the rev limiter off my 94 mazda familia, ive been to to take a wire off the back of the dash, but which one.


... 1994 Mazda B-Series

Hey my 2000 mk4 golf gti 2.0 petrol starts but will not take any revs tried plugs, leads, coil, airflow meter and checked wiring from ecu to the coil and airflow meter.car seems to run better when airflow meter disconnected but not for long as car cuts out and wont start. please help. thanks


CHECK VACUM SYSTEM IF OK THEN THEN CHECK cpu AND ALSO FUEL PUMP SYSTEM ... 2000 Volkswagen Golf

I have 1995 mustang gt and am installing a msd 6al ignition box and need to know wher the stock tach wire is so that i con hook to rev limiter on msd box.


A chiltons or hanyes repair book will tell u that it will run u 30 bucks at the most but it will be handy for any other problems that may come ... 1995 Ford Mustang
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6976 seconds