Having problems with your Cars & Trucks ?

How do I reset my Fuel pump inertia switch on my 85 Buick Electra

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Usually in the trunk on the side
Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I reset my Fuel pump inertia switch on my 85 Buick Electra


Usually in the trunk on the side ... Cars & Trucks

1998 Ford Windstar Inertia Switch Van wont start but turns over, wife has had 2 accidents and I found that I may need to check this Inertia Switch. I found the fuel pump reset button but when I push it, I dont feel it move. It almost feels as if it is stuck. There is about a half inch to an inch that I can stick my finger in and touch the button. Any suggestions? Also I was wondering if there was a way to check if the fuel pump is working without it costing me anything? Thanks.


... 1998 Ford Windstar

Inertia switch i changed my fuel pump and filter-fuel pressure regulator- fuel filter good cranks wont start seems the pump does not turn on changed pump twice were would i find a reset button for my fuel pump


... 1995 Mazda MX-6

Smells flooded? reset the inertia switch and 1988 bronco II v6 2.9 efi would start but will not idle now and smells like its flooding out? Only things i have done or changed is tested the fuel pump relay at the test center on pass fender and reset the inertia switch now wont idle?


If it is getting too much fuel you should be able to pull a vac hose such as the one to the PCV valve and make the engine speed up.If it is too rich could be a fuel pressure regulator or injector problem.Pull the pump relay and see if it star ... Ford Bronco

Won't start Cranks and cranks, but will not start. Replaced starter, starter solenoid, reset inertia switch, both fuel pumps, fuel pump relays, ignition switches, checked fuses. Can someone please help me? I have no clue what the problem could be!


Either check your knock sensor, map sensor or fuel shut-off switch ... 1987 Ford Bronco II

Fuel Reset How do you reset inertia Switch and Fuel Pump Cut-off Switch?


Only Ford products use an inertia switch for the fuel pump.You have an ASD relay that could be failing, but no switch. ... 1995 Dodge Neon

Replaced fuel relay - ignition switch, fuel pump too - and no gas comes out fuel rail with key on - fuel inertia switch is reset - what else do I try?


Do you hear the fuel pump engage when you turn on the ignition if not look for the fuse that controls the fuelpump relay and make sure its not blown. ... 1991 Ford Explorer

1991 XJ6 (XJ40) 3.2 auto. This car has a LPG conversion fitted and is duel fuel. It starts on petrol, and then switches to gas at 2000 rpm when the switch is engaged. A few days ago now it would't start, and i suspect it had ran out of petrol. However, I have put petrol in, but it still wont start. I have tried to find the inertia switch to reset it, as there is no evidence of the fuel pump working, as referred to in the manual, but it isn't where it should be behind the passenger side kick pane


I have a dealers manual somewhere and i put it somewhere safe and i cannot find it ,typical but if its converted right it should start on lpg with no problem without starting on petrol but it all depends on the type of conversion and who fitted it i ... 1991 Jaguar XJ6

Wont start 96 ford explorer 4.0 v6 was running great . car was taken good care of. then one day it would'nt start coming out of the super market. acted like it ran out of gas. i sprayed quick start fluid in the throttle body and it starts right up in fact it will run if i keep spraying. i tried a new fuel pump relay. (nothing) same thing. i tried reseting the inertia switch. (nada) same thing. i had just replaced the fuel filter a couple months ago. my question is: how many fuel pumps does it ha


CHECK SHRADER VALVE ON FUEL RAIL FOR PRESSURE. IT IS COMMON FOR PUMP'S TO GO OUT. YOU CAN HAVE SOMEONE LISTEN TO TANK FOR A BUZZ NOISE ON KEY CYCLES OR TEST FUEL PUMP CONNECTOR HARNESS FOR POWER. TRY KEEPING AT LEAST QUARTER TANK AT ALL TIMES TO KEEP ... 1996 Ford Explorer

Cant find a secondary fusebox on a 1989 ford bronco xlt. need to check on relays and fuses for fuel pump after replacing gas tank. reset inertia switch but still doesnt start. cant get fuel to the secondary fuel pump


The fuel pump relay should be in a group of relays near the battery. ... Ford Bronco

Hello, I have a 1986 ford e 350 Bus/van with a 5.8 gas engine,i replaced the fuel filter near the carb , it has an inlet fuel return and supply to the carb, it will start up and run and then dies, it has an inertia reset switch, this has a carb, i am guessing it has a pump in the tank. it also has a canister type fuel filter witha paper element, does this have a pump in the tank, it is an old red cross bus, any help would be great, Thanks, Carl


BACK IN 1986 IF YOU HAD A MECHANICAL FUEL PUMP LOCATED ON SIDE OF ENGINE. YOU HAD CARBURATOR ENGINE.AND ELECTRIC FUEL PUMP IF YOU HAD FUEL INJECTION.ENGINE.THE FUEL PUMP IS IN GAS TANK.OR MOUNTED ON THE OUTSIDE OF GAS TANK. ... 1986 Ford Econoline

1990 Ford Ranger Fuse box Diagram. Fuel pump stopped instantly. I checked the inertia switch and it didn,t need reset. I was wondering if there is a underdash relay for fuel pump.


... 1990 Ford Ranger SuperCab

1992 ford ranger new fuel pump and sending unit new relay switch inertia switch has been reset but still wont start getting no fuel at filter


... Ford Ranger

86 F250 w/ 460 auto. I have no fuel to carb. I have no power to fuel pumps. I have checked & reset inertia switch, nothen. I have found no fuses for pumps or a relay. The only relay r trailer tow. I did find broken fuseable link off starter relay on fender, repaired it still nothing. It sat for 3 yrs, I cleaned carb n fired her up made it to end of street and ran outa gas, never started again. ( yes I put gas in it). Where should I look for theis wires to ck for rodant damage. Thanks


... 1986 Ford F 250

Here's one for the books. 2000 Jaguar S Type 4.0 Sport - no fuel pressure past fuel pump. Checked inertia switch, fuel pump fuses and relay - all good. Installed new fuel filter, fuel pump was shot - replaced fuel pump and I can hear the pump prime when turning the ignition switch on, but NO fuel pressure at fuel filter and fuel rail. Engine started with starter fluid, any help would be appreciated.


Check if the input side of the fuel pump has a restriction . a perished rubber hose can be a problem , the pump should be able reach a pressure 35 psi + and a flow of a quart every 30 seconds at this pressure. ... 2000 Jaguar S-Type

2002 BUICK LE SABRE FUEL PUMP RESET SWITCH - 2002 Buick LeSabre


... 2002 Buick LeSabre

Where is the inertia switch on an 04 lincoln ls? Or the fuel pump reset switch?


It is not in the trunk. It is on the left side, in front of the drivers door, just above the floor mat. Side panel if you want to call it such. What problems are you having? I have the same veh and all the manuals including wiring diagrams. ... 2004 Lincoln LS

I have a 93 Ford Probe that ran fine the last time it ran. Now it just cranks, and will not fire. The "fuel cut out" light is lit as soon as the key is turned on, and this was not the case when it ran. The fuel pump does not run at all. I have a Haynes manual, and tried reseting the inertia switch, It felt a little flakey, so I'm trying to jump it out to determine if that is the problem, but I'm not sure how to do so. There is a normally open, and a normally closed designation, as well as a comm


Spray brake cleaner to seeif it will fire. This is to determine if you have a fuel issue or ignition issue. If it starts then most likely the fuel pump failed. If it doesnt start then you have an igniton issue. No way to tell what part of the ignit ... 1993 Ford Probe

I have a 1991 mustang lx with the 5.0 with the 5 speed, will turn wont start reset the inertia switch,and only when I supplpower to the inertia swith will it start. Could it be the fuel pump relay and if it is, where is it located?


Fuel pump relay is located under the drivers seat. ... 1991 Ford Mustang

1996 Oldsmobile fuel pump in gas tank and we were going to replace it this weekend. However, it may be that there is a reset button in the trunk of the vehicle and we want to try resetting the fuel pump switch before we begin working on the vehicle. Also, could the problem lie with the fuel pump relay switch that is located near the dash? How should we proceed?


\015\012Sputtering is the\015\012indication of clogged fuel filter and worn out fuel pump.Get the\015\012fuel pressure checked at any local car garage .If the fuel pressure\015\012checked low then its the problem of clogged fu ... 1996 Oldsmobile 88

Iam getting no voltage tto my fuel pump,front tank doesn't work,I changed the ignition switch,still no luck. the continuos power to my fuel pump reads 6.5 volts. From what I can tell my electrical sytem runs like this,my power control module relay from the relay it goes to the fuel pump relay then to the Inertia shutoff switch, to the Front and rear tank selector switch, to the back tank. Like I mentioned before I am only getting 6.5 volts at the fuel pump.


Poor earth connection most likely causing hifgh resistance voltage drop. \015\012\015\012Could also be a faulty pump. Run a separate power supply to it and recheck. ... 1997 Ford F250 SuperCab

I cant find the inertia switch to reset my fuel pump


No Inertia switch on Saturns! Check Fuel Pump Fuse Or Fuel Pump! ... Saturn Ion

My 98 windstar gl is not getting the ground comand through the pcm to open injecters and the fuel pump relay is not exciting the pump for initial start pressure and i have replaced most every sensor pcm and relays checked grounds replaced fuel pump eec dioad and clutch dioad pcm relay fuel relay ignition switch and more fuel pump is fine if iremove pump relay and jumper it run i have also tested the inertia switch the other pain in the but is i bought an obd meater yet it is unable to establish


If you don't think your getting the ground command through your PCM, you can make your own ground just by bypassing the PCM all together. First you need to find a PCM connector end view showing which pins are which wires and locate the ground you nee ... Ford Windstar

If you run out of gas will resetting the inertia switch reactivate the fuel pump?


... 1988 Ford Thunderbird

How do you reset a fuel pump in a 1998 chevy s10 truck 2.2 liter engine, 2 wheel drive? The truck hit a curb going pretty fast and now when you turn the key on the fuel pump does not come on. Is there an emergency fuel pump shut off/on button or some other switch to turn on or reset the fuel pump?


... 1998 Chevrolet S-10 Pickup
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2090 seconds