Having problems with your Cars & Trucks ?

Sir i have micromax v8 mp6 player. Made in china. i have problem that i starts and remain still on start up picture. Its not processing forward then start up picture. i resetit too. But it doesn't

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Sir i have micromax v8 mp6 player. Made in china. i have problem that i starts and remain still on start up picture. Its not processing forward then start up picture. i resetit too. But it doesn't


... Cars & Trucks

When i turn the key forward the engine wants to start but doesnt just makes the roaring noise and doesnt start


It could be the starter, is it high pitch screeching, metal against metal, sound? Or more of whine? If it's metal against metal, the teeth on the flywheel ring gear might be damaged. If it's a high whine you are probably hearing the electric motor pa ... 1991 Chevrolet S-10 Blazer

I keep going through alternators every 6 months Its a autozone lifetime and it works for a while, then my runner starts not starting. A jump will work but over a little time that doesnt and it finally stops working altogether. I've had new batteries put in at this point, along with new alternatror and start the process all over. This time I'm going to put in a oringinal toyota part. What do you think? Good start?( Alternator)


Well, the only answer to this issue is to determine precicely what has failed.\015\012\015\012one problem with places like autozone is the rebuilds often are not actually totally rebuilt, but rather just the problem is fixed, but everythi ... 1990 Toyota 4Runner

Where is neutral safety switch 95 jeep cherokee . This is the Cherokee Country with the inline 6 cyl 4.0 Motor. I have been having intermittent problems with a ''no start'' situation. Usually if I push the gear selector forward (almost above park) it will start up. The other thing is, just waiting 5 minutes seems to work also. Now I cant start it all. I have tryed moving the shifter to neutral also and it still doesnt start. Would also be interested in wiring schematic if available, thank's in a


Your switch is on the passenger side of the transmission opposite where the shift linkage goes in on the drivers side.It takes a bit of careful prying and wiggling and some solvent to get most to come off. after removing the hardware that holds it on ... 1996 Jeep Grand Cherokee

Steering wheel was turned in process to locate battery prior to knowing that positive and negative prongs where located under the hood for more convient jump start. after recieving an intional charge and attempting to start car, the ignition refused to turn forward and let the car start. however, the key was able to be turned backwards, so that the stero and luxurie lights would come on. so we are stumped as to if whether or not we need to reset the computer or if we are facing a differnt pro


Pull the wheel hard in the direction you had turned it when it locked, that should free the lock mechanism enough to turn the key. What's happened is that the wheel trying to go back to center had jammed the locking mechanism. Remember to turn the ... 2001 Chrysler Concorde

Need advice, soft clicking sound under my dash when I try and start my car which doesnt start. Its a 1992 honda prelude. Battery, starter, and alternator was recently checked and reported to be good. I replaced the fuel filter, and sparkplugs. Somedays no problem, other days, it wont start. Forcing the ignition key forward seems to help once in awhile, but is not the solution to the real problem. please help me. Theellisgang


Hi, I was following your problem.You may have not received my last comment.If the click is from under the dash replace the ignition relay, here is the part: ... 1992 Honda Prelude

I REALLY need help!!!!! i have a 1998 Ford Taurus and i was getting ready to leave last friday and put the key in the ignition and turned it to start the car and something just sounded like it broke or something and now when you put the key in the ignition, it will go "ding, ding, ding" and so on, but the key will turn all the way forward and the car will not start and it doesnt even sound like there is anything connected for it to start. i know its not the battery because i just got a new one n


It's the ignition switch.You will have to replace it. ... 1998 Ford Taurus

I have installed a new belt on a 88 mercedes 300TE the other day, I cannot get the belt to stay tight after starting the engine. Is the tensioner at fault? How about R&R directions and a picture of the route for the belt since I did not remove it to start the process?


Heres a diagram but you must make sure thee pulley that the belt rides on are good and that nothing is bad like a pulley that bad and loose,also there are a few engines in theses 300te cars il list them all and you pick the right one by lookink at th ... Mercedes-Benz 300-Class

When starting off it acts as if it doesnt want to go, like it is not getting enough gas. the more i push the gas pedal down the slower it makes the car. Once u r able to get your speed above 35, 40ish the car will go but once you stop again the whole process starts over


Its a fuel problem, check fuel filter. if need be check plugs and wires. ... 1998 Chevrolet Cavalier

The odometer quit working doesnt light up when turn the key forward or start the car someone suggested chip in key but my car doesnt have one


No the key has nothing to do with this. You have a failed display in the instrument cluster. You will need to remove it from the car and send it out for repair. Cost is about $200.00 to repair the problem. ... Chevrolet Cavalier

2001 rodeo will not go forward at a light unless i drop it down in L and shift it myself. Have to do this all the way home. The next day it will drive fine and then start this process again. I have changed both celenoids in it and have changed the computer. Any advise is welcome. Single woman working on it herself.


Is the transmission fluid level ok? Possibly the ban in the transmission is bad. ... 2000 Isuzu Rodeo

1993 dodge caravan 3.3 liter it turns over fine but wont start it doesnt seem too be getting fuel i think its the fuseable links i dont know were there located at a picture would be great


Check your fuel filters ... 1993 Dodge Caravan

When i fill up my 2002 hyundai santa fe ,it doesnt start. i need to give it some gas and rev it for a couple of minutes before i can put it on drive and go forward without it stalling


... 2004 Hyundai Santa Fe

I need to replace the fan resistor on my Ford Fiesta 2004. Can anyone help me on the installation process and any pictures / manuals? I'm not ever sure where to start looking for where the fan and aircon are! Thank you


... Ford Focus

I have a loud rattling underneath front end, i have a 94 jeep grand cherokee laredo the rattling doesnt start until your moving forward and gets louder the faster you go. what could it be, i was thinking loose u joint or bearing inside differential any ideas what to do first


Ok first look at the bearing see if you see oil around it wheres its leaking this there sign before going out and then at the u joint check and see if it is leaking as well this should tell you which one and it will be oil around the bearing not like ... 1994 Jeep Grand Cherokee

2001 rodeo will not go forward at a light unless i drop it down in L and shift it myself. Have to do this all the way home. The next day it will drive fine and then start this process again. I have changed both celenoids in it and have changed the computer. Any advise is welcome. Single woman working on it herself.


... 2000 Isuzu Rodeo

Starter removeal I have a 2002 Jeep grand Cherokee and the start needs to be replaced. I normally do this kind of thing, and much more, my self but I dont have the book, is it straight forward as a normal starter. Do you have a picture. I am actual talking my son thru it since he lives 2 hours away. He is fairly handy so I trust he can do it. Gregory


Yes it is normal , just have him disconnect negitive batt terminal first and remember where the wires go that come off starter maybe tape each one first at starter. and verify starter are the same and if jacking up truck use jack stands and dont over ... 2002 Jeep Grand Cherokee

I have 2nd 4th and R no 1st 3rd or 5th, replaced the bushing at the bottom of the gear shift, no change, wondering how hard it is to take out shift assembly with out raising the truck or dropping the tranny the ruck wont start in gear, when i push forward it just wont go , when i push all the way to 1st it doesnt engage the gate(of the H) i can push all the way to where 1st should be the drag to the right w/engaging anything


What kind of vehical is this. SOME TIMES YOU CAN CHECK THE SHIFTING FORKS FROM THE TOP IF THE TRANNY IS A TOP LOADER.\015\012YOU WILL HAVE TO REMOVE THE FLOOR MAT AND UNDER THIS YOU SHOULD SEE A FLOOR PAN WITH 6-8 BOLTS REMOVE THE PAN AND LIFT ... 1990 Geo Tracker

I have had nothing but problems with my jeep sense the day I got it I've replaced the fuel pump,the starter and multipil other things and yet it still doesnt work. when it does work I need to put the key all the way forward and let it sit then my fuse box under the hood will click for some time some times its only a few seconds some times its 20 min. then my check engine light comes on and it starts up and runs great...that worked for awhile now something is constantly drawing power from my comp


Possibly the computer is faulty, when you turn the key just before starting then you wait for the check engine to come on. A guy told me when it is starting to get faulty it will take 5-10 seconds, then 15-20 seconds and so on. I knew the trick so I ... 1993 Jeep Grand Cherokee

Internet video playback is slow and jerky on my new Archos 9 and virtually unwatchable. Even youtube doesnt run smoothly ! My laptop works fine so i know its not my router or broadband connection. I thought the Archos 9 was a graphics video playing machine ? How come i cant even watch youtube without it appearing like a serieries of still pictures, with the sound out of sinc ? I hope its not just the processing power of the Archos 9, if it is i will be decidedly p****d off, what good is a portab


Yes that 60gb's=HALF your hard drive could be some of your problem, do you run a cleaner and or a ram free'er? if not then you may want to,majorgeeks.com has a few realy good free tool's to help you out, good luck ... Cars & Trucks

Brakes used to stick somehow. by stick i mean that after you come to a complete stop and then u let off on the brake and start to accelerate it doesnt move for a second or two and then you hear a pop noise and it will surge forward. it seems to stick in the rear of truck. it had stopped sticking for a while but i recently had front and rear brakes replaced and now it is doing it again. i asked my mechanic to check it out but he said he could not get it to do it when he test drove it. any ideas?


If they are shoe brkes then you can buy a kit to repair the brake cylinder. If they are disc then you need to clean and maybe replace the calipers ... 1995 Chevrolet C1500

I have a 90 735i in good condition runs great. the problem im having is lately it doesnt start after ive driven it somewhere and go to get back in it and start it again it doesnt do anything but everything comes on but it doesnt turn over or nothing then i wait for 30 mins and it starts after trying for about 4hrs one day it started right up please help me with my problem


The starter motor needs to be repaired. sometimes it is just the solenoid, but most of the time it is either the carbon brushes or the starter armature that has an open circuit on the commutator. ... 1988 BMW 7 Series

My 2005 cadillac cts doesnt start, the keys is locked in the ignition,when i turn the key it doesnt do anything. if i take the negative terminal off the battery and tap it to the negative side of the batt about 3 times then i connect it to the batt, and the cars then starts.then im able to shutt off and take the key out of the ignition. sometimes when i try to start again it starts but 99% of the time after leaving it off for more than a day the car doesnt start. the car was in an accident front


I need a little clarification.. You stated wen you take off the neg terminal and "tap" it to the neg side or the batt 3 times then connect it to the battery it starts (i don't really understand what that part is). Also you say when you disconnect th ... Cadillac CTS

Audi tt sometimes doesnt start almost like it has immobolised itself. then if i leave it it may start a couple of hours later. or if i just hold the ignition in start it may fire up after 20 - 30 secounds however sometimes not. it is ver intermittent but catches me out at bad times. when it doesnt start it doesnt even tick over just goes dead. i know for a fact the battery is good as tested?


If this is a security issue you will have a code stored. Best bet is to get the PCM data and codes before doing anything else. If you don't have the knowledge or information to work on this car there is no way for the home mechanic to do anything. ... 2000 Audi TT

My 1998 Ford Contour will either start or it wont, when it does start it does so just fine, but sometimes it wont prime (it wont make that short whirring sound before you start the engine) and wont start, it goes like it will start, but then doesnt. Also it seems to want to die at an idle when I let it sit for too long after I first start it. When I drive it it runs fine, doesnt putter, or stall or shut off. The problem is simply when I try to start my car. I had fuses checked everywhere, cable


You might want to change the fuel pump Relay. You seem to know when it is getting fuel and when it does not. It is a lot easier to change a Relay than misdiagnose a bad pump. There are several signals which combine to make all the terminals on the ... 1998 Ford Contour
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.3294 seconds