Having problems with your Cars & Trucks ?

Replacing idler pulley for 2001 grand prix 3.1L v6 ohv?

\015 Instructions on replacing idler pulley\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for Cars & Trucks

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replacing idler pulley for 2001 grand prix 3.1L v6 ohv?


... Cars & Trucks

On a 2002 Grand Prix, have a serpentine belt and idler pulley issue. The power steering light did come on a while ago, filled reservoir, but have had some turning noise with it. The engine just had a screeching noise by the idler pulley or alternator now. The idler pulley was shaking some and the belt was tracking to the inside of the idler pulley, then slid off against the bracket and began to rub and smoke. A washer on the exterior of the idler looks offset from center.


Serpentione belt sounds as if it is stretched. first try to reseat serpentine belt. if still a problem then go buy new belt at autozone. also buy some belt dressing. this should fix the problem. if this doesnt solve then you need to buy a new i ... 2002 Pontiac Grand Prix

Serpentine noise I just replaced the idler pulley and new serpentine belt on wife’s 96 Grand Voyager. Idler was making a lot of noise (98K on the car). I did this following the instructions below. Now have a louder shrill that coincides with the RPM’s. It sounds if coming from the air condition compressor which has not worked in 3-4 years. Anyway I thought this would be a freewheeling pulley, any ideas? I checked the belt and it looks straight. If I spray WD 40 on the pulley (compressor) it quie


... 1996 Plymouth Grand Voyager

How to remove idler pulley 99 grand prix


... 1997 Pontiac Grand Prix

I have 2002 pontiac grand prix. My tension belt popped I replaced. Then it popped again and once again I replaced it. This time when it poped I was told that the pulley on top was bad so I replaced that. And again the belt popped what is going on


Make sure there are no siezed pulleys on any of the other components. If you've already replaced the tensioner pulley, try turning the other pulleys by hand to make sure they're free before putting the belt back on. The AC pump is notorious for loc ... Pontiac Grand Prix

.0 engine on 2003 ford ranger replaced idler pulleys, fan belt, still doing it what could it be?


A faulty belt tensioner pulley could be cause of belt slipping squealing ... Cars & Trucks

Fuel problems 1999 Grand Prix GTP 3800 Supercharged VIN 1: car starts, but shuts down within 10 seconds. You can see the fuel pressure drop within those 10 seconds. If I flutter the throttle, the fuel pressure will jump back up to 50lbs & back down to 0-10. But, you can keep the car running by doing that. I have replaced the fuel filter & helped a little bit, but still shuts down. Replaced fuel pressure regulator & fuel pump & oil pressure switch & still nothing. HELP....


T.p.s. censor ... 1999 Pontiac Grand Prix

I own a 2004 grand prix gt 3800 series 3 engine I had to replace the water pump and thermostat in February of this year due to over heating.Then in May the 90 degree elbow piece that goes into the tension pulley and the other end goes into engine block had melted or cracked it was running hot had the 90 degree elbow replaced just today it ran hot and to find the same piece melted or broke again what is causing this to happen please help tired of being stranded what should be done to prevent this


... Cars & Trucks

How to take off idler bracket for pulley on a pontiac grand prix 3.8


... Pontiac Grand Am

How to replace tension pulley 2002 grand prix gt


... 2002 Pontiac Grand Prix

Idler pulley stuck - 2005 Pontiac Grand Prix


... 2005 Pontiac Grand Prix

How to replace tensioner pulley on 1995 pontiac grand prix


... 1995 Pontiac Grand Prix

Replace idler pulley for 1997 jeep grand cherokee 5.2


... 1997 Jeep Grand Cherokee

Is there a special tool or technique that is needed to replace a heater hose fitting into the tensioner pulley on a 2004 Pontiac Grand Prix?


You can use a small amount of coolant to lubricate the outside of the fittings to aid in assembly, ... 2004 Pontiac Grand Prix

How to fix replace the smooth pulley on the supercharger of a 1999 pontiac grand prix gtp


... Cars & Trucks

Ive checked service book and read the timing belt and idler pulleys need replacing at 100 000km (Crysler Grand Voyager 2.8CRD Lx)Is that correct? and what are the costs in SA?


Typically thats about right give or take a few thousand to replace the belt and the pulley will cost you around 12-1,500 give or take a few hundred. this depends on the labor rate of the shop that does the work. my shop is 85 dollars an hour. ... 2001 Chrysler Voyager

Coolant leak on a 2000 pontiac grand prix gt. Its coming through what Im assuming is the water pump. Not sure. Is it the component below the alternator attached to the idler pulley?


... 2000 Pontiac Grand Prix

How do I replace the Idler Pulley on my 1994 Jeep Grand Cherokee?


Should only be one bolt going thru the center of the pulley. probably a 14 or 15mm size. ... 1994 Jeep Grand Cherokee

How to remove the idler pulley on a 2003 grand prix


... 2003 Pontiac Grand Prix

I need to replace the idler pulley for my 1999 Suzuki Esteem. The specs under the hood say 1.8 engine. I got a pulley for that size engine and it was too big. I still have the old broken one. I don't know if the engine was previously replaced in the car, I've only had it about 4 months. What are the dimensions of the idler pulley for a 1.6 and 1.8?


... 1999 Suzuki Esteem

Idler Pulley I have a 1999 Mitsubishi Galant 16V I4. The idler pulley (or is it the crankshaft pulley?) that drives the two serpentine belts is loose. I didn't notice it for a while and just thought my belts needed to be replaced because the car would squeak on startup. Finally one day there was a grinding noise, when I checked it out the idler pulley was out towards the plastic encasing under the hood. So, I took both belts off and it went back to were its supposed to be, but it still will wobb


Which ever pulley it is, it's not hard to replace. If you don't know which one, do you want to take a pic of the engine(and the particular part), send it to me and I will help?! If it is twisting at all, it is only a matter of time before it comes ap ... 1999 Mitsubishi Galant

Our 2000 dodge caravan 3.8 L serpentine belt keeps shifting to one side , we just replaced tentioner and idler pulley after belt shredding and slipping off 4 times over a year and a half after the 4th time my husband put the new belt on and it kept slipping off and that's why we replaced tentioner and idler pulley. Can anyone tell me why it is shifting? By the way we live in washington and it has been raining while my husband did this work but with a tarp over the hood / engine


This can be caused and often is by a defective crankshaft harmonic damper pulley. ... Cars & Trucks

99 Grand Prix GTP pulley for Supercharger...


For a pulley im not sure . if you got whole works pulley and supercharger. maybe . i check the garage who fix it. ... 1999 Pontiac Grand Prix

My truck had a vaccum belt burning smell, I replaced the fan belt and the idler pulley as recommended by parts store to fix problem. I tried to replace tension pulley also but could not get bolt loose to replace, will try again later. After belt replacement still had smell and truck did not restart. jumped truck and it started immediately, but when I tried to back out it died and would not restart again. I think the alternator is shot and that is the source of smell and starting problem, but


Sounds like your alternator. you can pull of and have tested for free at most parts stores. batteries should be ok. it is best to charge them and not just crank up and let vehicle charge them from completly dead this will cause an extreme pull on the ... 1995 Chevrolet Silverado 2500

Purchased a 97 Jeep Grand Cherokee with an empty and leaking power steering pump. I replaced the pressure and return hoses and filled it but it makes a chirping noise when the engine runs cold. The pulley also has a slight wobble. I would like to replace the pulley and pump. Is te pump sold with the pulley already assembled or will I need a tool to install a new pulley on a new pump?


When you but a aftermarket power steering pump the only thing you get is the pump so make sure you take off & keep your pulley & reservoir BUT you can buy the pump with the reservoir but you still need your pulley & dip stick... ... Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3796 seconds