Having problems with your 2011 Ford F-350 Super Duty ?

My 2011 f-350 the backup lights aren't working and all fuses r good this happened after I installed headache rack with lights

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2011 Ford F-350 Super Duty

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My 2011 f-350 the backup lights aren't working and all fuses r good this happened after I installed headache rack with lights


... 2011 Ford F-350 Super Duty

I have a 1969 Ford f100 3 speed manual trans, column shift it some times gets stuck between first & second gears, when this happens I crawl under the truck and move the shift linkage back and forth, this solves the problem... but what a hassle!! what is the permanent fix? prob #2 my dash lights dont work, the bulbs are good, fuse is good, & I installed a new head light switch. The turn signal indicator lites work fine.


I had a '71 dodge with three-on-the-tree that experienced binding and the only way to fix it is to replace worn parts. as for the lights, find out which connetor supplies power. perhaps it is faulty or loose. also, there may be a separate fuse locate ... 1981 Ford F 100

Backup lights out, fuses are good(passenger door jam and under hood), light bulbs tested ok, new trans installed earlier this year, not sure how long theyve been out.


Check and see if the reverse light switch on the tranny was plugged in or damaged during the transmission job. If the transmission wasn't an exact match, the switches might not have been the same and maybe they weren't able to plug in the switch. ... 2007 Mazda MAZDA5

I have a 2004 Accord LX 4 cyl. automatic. I went to start the car this morning; it turned over slowly, then nothing. The baterry tested bad, so I bought a brand new one from Honda. Installed it; tighten the terminals - everything seems good. But I have no electric. Nothing happens when I tern the key - nothing. I have no lights, horn, etc. I cannot jump start it with another car - everything is still dead. Any help?


Reset the alarm/immobiliser according to the book......(every time the battery is disconnected.) ... 2004 Honda Accord

I have a 2000 jeep wrangler 4.0 engine it ran good for 16 miles then would quit no check engine light on so i scanned it anyway came up with a p 1391 mis fire so i changed can sensor ran good about 30 minutes and died scanned again same 1391 i returned cam sensor and got a new coil pack and crank sensor i installed coil pack ran good about 30 minutes and died so i installed crank sensor and put back on old coil pack ran good 45 minutes then actually started missing and check engine light on it s


It does sound like the ecu is bad the only other thing it could be is the antitheft system is having problems ... 2001 Jeep Grand Cherokee

1999 mazda protege 5 speed - We do not have the remore conrtol. Battery died, AAA tried to jump start, but nothing happened. I installed a new battery, but nothing happens, except the security system activates. Lights blink, red dash light blinks, overhead light flashes. Is security system preventing the starting? How do I reset? Dealer said they ccannot help, because car is too old. They installed the system before we took delivery.


If you can find the name of the alarm company that make the system, they probably have a 24/7 toll free number that you can find online. It does sound like the security system is not allowing you to 'steal' your own car. You could probably find the ... Mazda Protege

Backup lights do not work...1987 325ic...new bulbs installed, all other lights work perfectly...in reverse, with lights on, backup lights do not come on. Where is the backup light switch? There is a set of wires running ''into'' the base of the rubber gasket around the shifter closing up the hole through which the shifter protrudes.


It depends if it is auto or manual. There is a nuetral saftey switch on the auto-located on the manual valve arm(the piece that the linkage from the shifter connects to at the trans.) On the manual trans. there will be a 2 pole switch on the top shif ... BMW 325

2005 Ford Focus - Backup Lights Do Not Work - fuse is good and light bulbs are good - Where is the backup sensor? Could it be something else?


The backup light sensor is part of the range switch located at the shift arm on the transmission where the shift cable connects, multiwire connector.. ... 1996 Ford Taurus

I have a 2002 4 Cylinder Saturn Vue 5 speed manual transmission. My backup lights don't work. My husband has tried to fix it but cant find the location of the the switch. Our fuses are good and the backup light bulbs are good. Could you please help (with detailed instructions) please. Our owners manual doesnt cover this problem.


The back up switch should be installed on your transmission. Contact me in this adress and i will email the instruction to you on PDF file. Good lukcEMAIL : [email protected] ... Saturn Vue

2000 toyoto echo with manual transmission. backup lights don't work. bulbs are good. fuse is good. Where is backup light switch & how do I troubleshoot & replace it?


... Toyota ECHO

Brake and backup lights check good, but no lights, fuses good


Did you check to see whether or not the bulbs need replaced? Although it would be weird to have all the rear lights blow at once unless it shorted out somehow. I would also check under the hood for a blown fuse in the relay box. ... 1994 Jeep Cherokee Country

I have a 2004 Toyota Matrix the rear running light won't come. This happens with the headlights on or off. The bulbs are both good and the fuse is good. There is no current to the running lights though the rear brake lights and the both the real blinkers both work. Is there a relay involved in these rear lights. All of the other lights work fine . Any help on this is appreciated.


... 2004 Toyota Matrix

Instrument panel lights will not work after new battery was installed. Previously, When door was opened one could hear static noise and flickering of instrument panel lights. Battery was checked and was no good. New battery was installed, however the radio lights, the speedometer needle and the gas gauge needle will not indicate any readings. Dome lights, radio and headlights work, though. Thanks for any help.


Hi 1987 Honda Civic lihgts on instrument panel. New Battery. and replaced blower unit but lights on panel not working. I am yet to install stereo unit which was taken out by previous owner - very roughly ! Wondering if not having stereo will effec ... Chevrolet Impala

Interior lights My roof interior lights don't work when I open my door but the door lights do. I recently had a command start, Pro Start, installed and now my interior lights don't work. The installer of the command, checked the wiring over and according to him everything looks good. What can I do? Is there something specific I can check? Thanks.


Its very possible that the light has just burned out, try replacing it from one at your local parts store. ... 2004 GMC Sierra 2500

I have no brake lights or blinkers on the rear of my 1989 Jeep Wrangler. I had one left blinker in the rear but not now. Both blinkers work fine on the front. I tried grounding the rear lights straignt to the battery with a long wire and nothing happens. I replaced the turn signal switch and nothing happened. I got a test light and get no power at light. I followed it to the connector near the fuse box and still cant get power. All my fuses are good. What can I try next????


Did you you check all your power ground sources from the switch to the light seem like you power source is not properly ground ... 1989 Jeep Wrangler

Aldl 1990 Cutlass Supreme. Drove car home. All good. Let car sit overnight. Went to start next morning. Turned key all dash lights went dim. ECM acted like it went into self test mode. Tried jumping pins A to B to read codes. When jumping pins A and B at ALDL connector all dash lights and relays go nuts. Have checked stater. Stater checks good. Checked alternator. Alternator checks good. Checked circuit wire from ECM thru ALDL to ground. Circuit good. Replaced ECM and installed original MEM-CAL


You have a defective battery. ... Oldsmobile Cutlass Supreme

Aldl When jumping pins A to B at the ALDL connector on a 1990 Oldsmobile Cutlass all dash lights and relays flash. Stater has been checked. Stater good. Alternator checked. Alternator good. Wire circuit from ECM thru ALDL to ground good. ECM replaced. Original MEM-CAL re-installed. Same problem. Ground wires checked for good ground. Still same problem. All dash lights and relays go nuts when pins A and B jumped at ALDL connector.


... Cars & Trucks

Electrical issuse I was having wiring issues with my trailer. in using a test light we thought we had made contact and blew a fuse to my trk. which took out the tail lights, parking lights and instrument panel lights. I pulled those fuses and they were fine. I then pulled EVERY fuse and all fuses show as good. This happened once before and we had a fuse totallly unrelated blown. we replaced it and all was good. Thats why I pulled every fuse to check them. I am at a loss.


Did you check fuses under hood as well? You may want to check if power is getting to the headlight switch. That controls all the lights that quit working. ... 1996 Ford Ranger SuperCab

Left headlight, dash lights, and both tail lights do no illuminate. brake lights and high beams work fine. what would cause this to happen, fuses are good.


Most certainly a wiring fault, you need a wiring diagram, these items are related as in all on same circuit. Check rear of fuse box. ... Hyundai Santa Fe

GM mechanic installed GM brand reversr backup sensors on my 2011 SRX. Sensors keep beepin when car is turned off when someone is standing beind the car untill daytime running lights go off. Mechanic said he installed the sensors to back up lights not the daytime lights.


... 2011 Cadillac SRX

Hi there, please help... my AC it's not working, not even light up in dashboard the same with the odometer needle and odometer numbers ( blank ) I noticed, the tempature needle on the left, died too. it's not moving ( hot/cold ) this is happening after i try to install a fog light ( somebody install it for me last time and it works fine ) until, i try just to replace with new fog light but using old wiring. old wiring has 3 cable and the new one only has 2. when i try to connect to 2 wi


You need to check all the fuses,in both fuse boxes, by the sounds of it you have blown a ignition fuse, it is in the fuse box above the glove compartment ... 2003 Toyota Corolla

I recently installed new wiring on a 4X8 utility trailer. All of the lights on the trailer work, except the brake lights. I have checked all of the wiring, the ground is good, no bare spots. I even installed a converter on my truck. But, still no brake lights. I am at my whits end. Can someone please help?


Start with the simple stuff first.Make sure you have 1157 bulbs in and not 1156 bulbs. ... Cars & Trucks

98 Maxima 200k. Car suddenly shuts down. It doesn't stall, I just lose complete power. Happens from time to time, but it will start back up. At times if I turn the radio on this will happen, at other it loses power when I turn the lights on. Started happening after my mechanic installed new battery and alternator. I took it back to him because thought something wasn't installed properly, but he says battery and alt are fine. Loose ground? Any thoughts are appreciated. Thanks.


... Nissan Maxima

I want to install aux. backup lights and not wiring them to the jeeps backup ligts. I don't understand the switch. It has three prongs on the back The diagram shows one is power coming from the relay one is for the ground and the other is for attaching to the headlights (these are fog lights) so do I not use the prong to the headlight? And are 55W fog lights ok to use. and do they need to be a certain height and width?


What diagram? What switch? Are you using a switch that salready in the Jeep, or a switch that you bought? You really need a relay to handle th ecurrent of the lights. The relay will have 4 terminals, The relay is really just a remote switch. Let th ... 2004 Jeep Wrangler

I own a 71 datsun pl 521 pickup. The IGN. warning light on the dash turns on and off as I drive. I installed a new fan belt and adjusted the tension to the service manul specs. No help. I installed a rebuilt alternator. No help. When the IGN. light comes on the turn signals work fine, but when the IGN. light goes out the turn signals stop working. I'm not good with electrical. I just bought the truck and have no idea what the previous owner did to it. Please help. Kevin.


Withthe ING light on it means one of three things battery is low or altaanator is not charging or battery posts and or cables dirty and loose You may have a malfunction in the points as well. Does it back fire or run rough? ... 2000 Datsun 510
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4549 seconds