Having problems with your 2010 Mitsubishi Outlander ?

Replace a wheel stud on a mitsubishi outlander

\015 Wheel stud replacement\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2010 Mitsubishi Outlander

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace a wheel stud on a mitsubishi outlander


... 2010 Mitsubishi Outlander

Replace front axle what tools are needed on a 2003 mitsubishi outlander i have a lot of noise from left ft i've had wheel bearing replaced and it's still has a lot of noise at speed when the wheels are rotating


Wrenches. tire tool. hammer , pliers , a jackstand or blocks to support the vehicle. a jack to manipulate the lower control arm . air compressor and air impact wrench and a socket ( metric and usually a special size ) available at Auto zone for rent ... 2003 Mitsubishi Outlander

Replace both front wheel bearings cost - 2003 Mitsubishi Outlander


I just had mine done about 3 months ago and it cost me roughly $400 bucks. ... 2003 Mitsubishi Outlander

Replace wheel stud for mitsubishi montero


... 2002 Mitsubishi Montero Sport

Having trouble replacing wheel stud on an 01 Chrysler town and country van. we are replacing the studs. and need ideas of being able to get the rotar off the van so that we can replace them (replacing the studs).


What kind of trouble you having taking off? or putting on? ... 2002 Chrysler Town & Country

How do you remove the Wheel hub from a 2003 Acura mdx awd? I broke a wheel stud while getting the tire off and now am trying to replace the wheel stud.


If memory serves,you should be able to replace wheel stud by hammering it out backwards/inboard.then replacement is a case of pulling new stud through. ... 2003 Acura MDX

Wheel Stud We broke a wheel stud off trying to change a tire and it looks like we will have to take the whole axle assembly apart to take the stud out. Is there a better, quicker way? The rubber boots that hold grease on both sides is busted also. Will I have to take the whole axle apart to replace these?


If you remove the wheel drum you can knock out the broken stud. It is pressed into the hub. Take the hub to aan auto parts store ( so you get the same size stud) and buy a new stud. put the stud into the hole in the hub. When you remount you remount ... 1996 Kia Sephia

Wheel studs keep breaking after being replaced, also replaced wheel bearing


... 2007 Hyundai Tucson Limited

Clicking coming from wheel assembly when in four wheel drive. I just replaced the wheel studs on my 2000 Nissan xterra. When I took it for it's first test drive I noticed a buzzing noise coming from the wheel I worked on, the noise goes away when I take a turn In either direction. When I put the car in four wheel drive a clicking noise seemed to come from the wheel assembly. About two clicks per rotation of the wheel. Any help on what you think might be causing this would be greatly appreciated.


... 2000 Nissan Xterra

Replace broken wheel studs on 1997 ford sho front wheel can't remove top center bolt in axle housing to bacck out broken studs and put in new


... 1997 Ford Taurus

Wheel studs How to replace wheel stud 96 chevy s10 pickup


... Chevrolet Cars & Trucks

Wheel stud front wheel stud needs to be replaced


I have replaced one of mine, you have to buy a stud that has tapered serrations, remove the disc and hammer out the old and hammer in the new replacement. ... 1996 Honda Civic

2 broken wheel studs need to remove wheel and replace studs think someone was trying to steal the tire and loosen all the nuts


Steal or wheel wasnt tightened correctly check other studs for damage any damaged replace them also use drift pin and hammer or press unit to press out broken one push new one in and use a stack of washers and lug nut tighten nut until stud in place ... 1992 Lexus Ls 400

Trying to replace 3 broken wheel studs on front wheel. how do I remove the round bracket holding studs?


For Wheel Stud replacement, you need follow the next steps:\015\0121. Remove wheel\015\0122. Remove the Caliper from the knuckle. you ... 1998 Mitsubishi Galant

Replace fuel pump 2003 mitsubishi outlander - 2003 Mitsubishi Outlander


... 2003 Mitsubishi Outlander

2000 Malibu Broken front wheel stud. Can I replace the stud or do I have to replace the entire hub?


Just punch out the old stud & replace it with a new one. ... 2000 Chevrolet Malibu

Wheel studs how do you replace the wheel studs on the front passenger side of a 1995 ford escort lx


Normally you can take off the spindel but if you remove brake disk and back plate you should be able to punch out the studs with no problem and than push new one in and press it in by tapping it with hammer on the back and than putting some washers o ... 1995 Ford Escort

Replace water pump mitsubishi outlander 2003 - 2003 Mitsubishi Outlander


... 2003 Mitsubishi Outlander

How to replace rear wheel studs on 4 wheel drive 1998 jeep grand cherokee?


... 1998 Jeep Cherokee

Front wheel stud replacement for a 2006 Hyundai Sonata GL.


Grind a flat spot on the round head of the new stud this should give enough clearance to install it. don't pull the hub this will damage the bearing. ... 2006 Hyundai Sonata

Does the wheel barring have to be replaced when the stud is broke


If you use a hammer to drive the broken stud out you can cause damage to the bearing.\015\012If you use a wheel stud press, the hub bearing will not be affected. The press will remove the old stud and install the new one.\015 ... Honda Civic

Hi there I have an Mitsubishi Outlander LS 2.4ltr. The problem is the front left tyre is always scrubbing out on the outer side. It now to date has had 5 wheel alignment/balances, of which the last was undertaken by Zupps Mt Gravett Mitsubishi & Peugeot service department. In the same time it has now worn out 3 new tyres and I am about to put on the the 4th, all of the above services and parts at a great expense to myself. The only out come that Mitsubishi can give me is that it is just


... Cars & Trucks

I have a broken wheel stud on left wheel of a two-wheel drive 2002 Envoy. How do I replace it?


TAKE VECHICLE TO SEARS AUTO CENTER OR ANY TIRE WHEELS BRAKE ALIGNMENT SHOP THEY CAN PRESS OUT THE STUD WITH OUT DAMAGING WHEEL BEARING.AND PRESS YOU IN A NEW LUG NUT STUD.PROBABLY CHARGE YOU $25.00 DOLLARS. ... Cars & Trucks

I here a sound from what appears to be the right wheel. I have replaced the tire and still hear the noise. I am told it is the wheel bearing for a 2000 Mitsubishi Galant.I have also been told that the wheel can come off if not repaired right away, is this correct?


Hey\015\012\015\012yes it can but thats the most exteme case if you ignored it al together!! change it as soon as possible\015\012\015\012Damien ... Mitsubishi Galant

How to replace a wheel stud on a 2002 Kia sedona


... 2002 Kia Sedona
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6549 seconds