Having problems with your 2009 Mini Cooper ?

Reset brake light on 09 minni cooper

\015 Reset brake light\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2009 Mini Cooper

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Reset brake light on 09 minni cooper


... 2009 Mini Cooper

I have just changed front brake pads and wear sensor on a mini cooper 57 plate but the brake light warning indicator is still on how do i reset this


... 2008 Mini Cooper Clubman

Mini cooper brake warning light reset - 2005 Mini Cooper


... 2005 Mini Cooper

Mini Cooper 2004 Brake Pad Warning Light Reset


One method describes just turning the key to position 2 and giving it about 30 seconds and that it will reset on its own. A manual method is described here: ... 2004 Mini Cooper

Reset brake warning light on 2009 mini cooper s


... 2007 Mini Cooper Convertible

How do I reset my brake pad service light 2006 mini cooper


If I was working on it I would disconnect battery to "try" to reset the computer usually i have managed to succeed doing so wait a couple of means with both terminals off before reconnecting them. ... 2004 Mini Cooper

How do i reset brake warning light on a 59 mini cooper


... Cars & Trucks

My daughters 2002 Tahoe has no brake lights. Bulbs are good checked the fuse under the hood=good, also checked the fuse under the back seat labeled brake, it was good also. Now the ABS light and hand brake dash warning lights are on. My guess is pulling the fuse under the back seat tripped a code for the warning dash lights. So how do I reset the dash warning lights? By the way, still no brake lights...turn, direction, and running lights are good. Also the brake light over the back window


To clear the code disconnect the battery, you could have a bad brake lite swich, its under the dash by the brake pedal ... Chevrolet Tahoe

How do you reset the Service light on a Mercedes CLC 180 Kompressor Sport - Just done a full service myself as a partially trained mechanic but cannot find the manual reset and don't want to pay a garage for resetting a silly light, also changed the brakes and the sensors but brake light still on :-(


I will need to know the year make and model of this car, as far as the brake light if the sensors are new then close all doors and trun the key on without starting the car and wait about 15 seconds and the brake pad warning light will go out, send me ... Mercedes-Benz CL-Class

I have a VW touran diesel 1.9. Recently there was a brake pad warning light indicated on my dash board, so I took it to my closest gargae to check. They replaced two new brake discs and the brake pads. However, they could not find a way to reset the warning light. So even though it is fixed, the warning light is still on my dash board. Do you know if it can be reset without going to the dealer?


Nope,it has to go back to a dealer(the computer is too expensive for a diy mech)they will reset it IF GENUINE parts have been used, as sensors are inbuilt into the pads. ... Volkswagen Golf

Just completed front brakes on 2006 Prius. Flushed system of old brake fluid. Now ABS lights and red brake light are on. Road tested to possibly reset system and only had rear brakes. Is there a procedure to bleed or reset system?


On yours car is a special ABS hydraulic system bleeding procedure, guided by Toyota (Bosch KTS, Gutmann, TEXA, ...) diagnosis scantool tester !!!\015\012After correct bleeding operation completion, you need also erase faults stocked i ... Toyota Prius

Just did front brakes on 2006 prius. Flushed out old brake fluid. Now ABS lights and red brake light on. Drove car to reset and only had rear brakes. Is there a procedure to reset system?


Start at the master cylinder and bleed the lines,then the a b s if there are bleed screws,then the wheels,this will get the brakes back. ... Toyota Prius

The ABS, Traction Control and Brake Warning Lights came on in my 2003 Cadillac CTS. I took it to a mechinac who turned the rotors and replaced the pads. The lights came back on but the brakes seem perfect. The mechanic did not know how to reset these warning lights. Do the lights mean there may be another problem or do they need to be manually reset and, if so, how do I do it.


Lights usaly come on when there is a system fault. check for a broken or chiped wheel speed sensor ring, or a damaged wheel speed sensor. try disconecting the negative battery terminal for a few seconds to reset lights ... 2003 Cadillac CTS

1998 Olds 88, Replaced all the brake lines (because of corosion) I took care to get lines back on anti-lock unit in same position as origonal. Brake light on dash did go out but the ABS and Traction control light stayed on. Is there a reset? I disconnected battery and ABS fuses to try to reset lights to no effect. Why are my lights on? I havn't had a chance to down load computer.


You probably push air into the ABS unit when getting your lines replace but the Traction Control light might be on because the system might use the wheel speed sensor on the ABS unit to enable the Traction Control....... ... 1998 Oldsmobile Eighty Eight

2004 Taurus SEL with 27,000 miles (Not a typo - 27K miles. Bought from old friend. Her mother's car - who is no longer driving). When I got it about a month ago, brake light was on. (Friend said it was checked at local Ford dealer and 3 other places b/c of light being on. Everyone said brakes were fine.) System was showing data error for parking brake and brake fluid. System reset and light went off. Was fine for about 2 weeks. Suddenly, brake light is on again. Now says data error for open door


Check for loose ground wires in the trunk, under the hood and at the battery. Remove and clean any connections that you can get to. With all the electronics on todays cars one loose ground wire can cause you to pull out all your hair. ... Ford Taurus

How do i reset my brake warning light after a brake line has been replaced the repair shop said he didnt know he tried with his hand held computer is there another way to reset the brake warning light on the dash of my 1999 olds bravada


Brake warning light could mead a damaged ABS senser, perhaps happened when the brake line was replaced ... Oldsmobile Bravada

My brake pads have been replaced, however the dash brake warning light still appears. In addition, the cruise control is not working. This has reset a few times and the light has gonen out adn the cruise resumed working. I want the light out/cruise working consistentley! Have also tried disconnecting the battery in hopes it would reset. Just disconnected for a minute or 2... Mountaineer V-8, 85K mi


Look at your brake master cylinder, open the top to it, and check your brake fluid. If low, that is why the brake light is on. Or check to see if your emergency brake is pushed in. Check your fuses for the cruise control. Hope this helps, James Booth ... 2004 Mercury Mountaineer

2002 buick century over heats unless ac is running. I changed antifreeze, thermostat, temperature sensor, coolant level sensor, and all hoses. Also coolant light won't come off even though its full. I also changed out front brake pads, rotors, calipers, hub assembly's, and axles along with rear brake shoes, brake drums, wheel cylinders, and hardware kits but brake light won't turn off. There is no problem with the master cylinder. Is there a way to reset the brake light? Just brakes did it befor


Sounds like the computer is not powering the fan relay when the engine reaches 220 degrees. You might want to jumper the temp sensor to see it it will trigger the relay. You may need a scanner to monitor the data signal from the temp sensor.As ... Cars & Trucks

Hello we have a 2000 mercedes clk430 and when you are driving and attempting to stop it feels like the brakes are pumping themselves (the brake petal) and then sometimes the abs and check engine light comes on and the car goes into fault mode and you have to pull over and restart the car to reset it and the check engine light will stay on but the abs light will go off of it and it will drive right until the abs light goes off again. We changed all four brakes and brake discs because we figured t


... 2000 Mercedes-Benz CLK

How to reset service indicator light on 2005 Mini cooper S


Low fluid level will keep the light on also the pad wear sensors need to be replace once the pads have worn down to the sensor they are not resetting sensors ... Cars & Trucks

Periodically the clock resets itself when the car is restarted. This morning on the way to work the ABS and brake lights came on and braking was difficult. Then when I stopped for a light the ABS light and brake light came on again and the ABS kicked in. Then it was fine. Tonight when I got home, I tried to lock it with my remote. It wouldn't work, so I tried to lock using the lock button inside. No luck! Not only that the car won't start at all, no lights,no radio, can't shift. However, while I


This is a pinched wireloom problem the harness has a short in it possibly damaging a relay or, two.\015\012the best thing to do is: take your car to a certified auto electric shop: before it causes a fire; the cost will be well worth it and, s ... 2004 Chevrolet Malibu Maxx

BMW 645 Rear brake Change light was on at 600 miles to service .got brakes changed and tried to reset dash on rear brake but went to. -15000 then brake light came on instead how do I get the light off?


You need to replace the wear sensor it will rest itself ... 2005 BMW 6 Series

2003 passat 1.8t, GL My left brake light wasn't getting brighter when I braked for a while, replaced the bulb and no luck. I replaced the bulb housing and it still wasnt working properly until I took the old bulb out and tested it using a bulb from the right tail light. I had a lot of bulbs next to me and wasnt paying attention when I put a turn signal bulb in the brake light socket and it instantly cut off my right tail lights. Tried resetting them and tried switching the fuse. Any idea?


... 2003 Volkswagen Passat

Low Brake Fluid light, BRAKE light and TRAC off light all illuminated, the fluid level is fine and the Brake Pads are atleast 75% good. I tried disconnecting the batteries for an hour to try and reset the system, however the lights are still illuminated. What else can I do?


Try replacing brake fluid level sensor...worked for me ... 2004 Chevrolet Monte Carlo

My indicator says i have 4 malfunctions all light related brake light, it says it it using the substitute brake light. I have changed all lights, and theres seems to be no lights not working. How can I reset the malfunction, i even checked and I have 12 volts going to each light.


Dear Sir,\015\012 \015\012 As you said , you are getting massage that 4 fault code are present in system.\015\012It is exactly the codes which are just showing or we can say it is in a memory of computer of ... 2007 Mercedes-Benz ML350
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.4914 seconds