Having problems with your 2009 Lincoln MKS ?

Where's the code on a 2009 MKS?

\015 I would like to find the keyless door numbers. Used to be in the trunk in older Continentals.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

You may be able to get the code from the dealer with the VIN number.
Repair Help & Product Troubleshooting for 2009 Lincoln MKS

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

I have a 2000 Pontiac Bonneville 3.8 non supercharged. It is throwing the codes P0446, P0452, P0453. Yes it is throwing all of them and that is what is confusing me. Just reset the codes, did a start-stop-start-stop and got the 53 twice. Also, the fuel pressure isn't good, you hook up the gauge you get 0, when you turn the key on it jumps to 50 and as soon as the pump shuts off it goes back to 0, and when running it stays at about 47. I would greatly appreciate any help. and no my craftsman


... 2000 Pontiac Bonneville

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

1988 honda civic stalled,code 16,replaced main relay,code now reads 0,car still dont start


... 1988 Honda Civic 2 Door

How to enter code? went online and paid nine bucks, didn't really help me because of the following problem. 5 digit code, car radio has preset # 1,2,3,4,5,6.. one of my code is 0 and 9 how the hell am i suppose to enter it?


Come on here for free ,anyway you press preset 1 and use either the volume or tuning buttons ,maybe even the tape buttons to place the number then when all numbers press 6 to enter the code on the venerable old classic vehicle ... 1984 BMW 3 Series

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

At elev. 8500 severe power loss under load. Live feed engine data as follows:0-5 engine timing retarded,pending code fuel system fault OL and sometimes will set mass air flow code. mass a sensor replaced recently. removed air filter resonator from behind bumper,left top portion w/filter element in place. once vehicle returns to lower elev. runs great.will not set code again until returns to 8k .vehicle 30k mi. org. owner.have own scanner w/live feed.


Does your scanner give you a reading for barometic pressure? ... 2001 Hyundai Sonata

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).


... Cars & Trucks

I need the 4 digit code for my 2001 mitsubishi mirage factory radio! I don't know the code on the back of the stereo. I have called dealerships before and got the code and wrote it down but lost it again. Now when I called again they tell me I need to take the radio out. I don't have money to do that! I think I remember there being a 7,9, and a 0 in it but can't remember what the last digit was! If you can please help me I would really appreciate it!!!


Can't find your factory car stereo radio code? We can help!\015\012To all at radio-code.com. I recently experienced a dead battery in my 97 Mitsubishi Gallant ... 2001 Mitsubishi Mirage

When ignition is turned off, I loose internal lights,radio and code,side mirrors and unable to lock the car via the key fob, I have checked the trip display for error codes and am getting code 905 CHECK 0


Fuses are a good thing check fuses under hood and under dash likely an under hood fuse is cooked ... Chrysler Voyager

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05


... Cars & Trucks

Have 1995 jeep cherokee v6 4,0 my jeep run sluggish loss of power cant get over 65 mph service engine light on took it to auto parts to get code read low fuel intake somebody told me also to start it 3 times then read the flashing light where can i get a list of information on the code names. what should i check for the low fuel intake? the fuel filter maybe the pressure tested please help


This sounds like you may have a problem with your oxygen(O2) sensors or a clogged component in your exhaust system. if you have a catalytic converter in your exhaust system, the filter element inside could break up and clog the exhaust pipe. you shou ... 1995 Jeep Cherokee

Bought a 1999 Porsche boxter and it has motor electrical issue and on the machine it gives me the following defect codes P1691 p1319 p1315 p1318 p1314 p1140 p1317 0 P1313 p1316 would anyone kindly help me with this I'll be really thankful just if anyone tell me what those codes mean and possibly how to fix them thank u very much for ur time


... 1999 Porsche Boxster

Transmission problem 01 Jeep Grand Cherokee limitied. First had code p1762 and replaced the governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI and Governor Pressure Above 3 PSI In Gear With 0 MPH. Tried disconnecting the battery to reset computuer and still is doing the same thing. Any Solutions.


I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid? ... 2001 Jeep Grand Cherokee

2001 Dodge Ram, charging system not charging. No codes from the odb 2. Starts runs & drives within a few minutes the voltage guage drops to 0 & the check guages light comes on. I replaced the alternator & rechecked for codes but none show on scanner


... 2001 Dodge Ram 2500 Truck

91 Corvette - Service Engine lights, Speedometer goes (usually) to 0, Average miles per gal goes to 5Y5, engine stops. Engine cranks but will not start. Wait a bit, remove key, insert key and it will usually start. only code is 12 which is normal. (Speedometer sometimes goes to 108 or 17 instead of 0 - while sitting and Idleing) Can sometimes get out of engine stopping by flooring it - must be driving to do this.


... 1991 Chevrolet Corvette

Hello, I have a 2002 GMC Envoy and my check engine light is on. The code populated is P0014, I've read different solutions to this code, however I am still unsure as to which route to go. Would the replacing the Camshaft sensor resolve my issue? Also, when my AC is on the timing appears to go up and down (from 0-2), as if my truck wants to shut off, and then Pressure Oil Low // Stop engine displays. Thank you for any assistance you can provide.


DTC P0014 - "B" Camshaft Position - Timing Over-Advanced or System \015\012Performance \015\012 (Bank 1) = to see Trouble Code P0011DTC P0011 - "A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)What ... 2002 GMC Envoy

I have a 2002 galant gitting code 0340 camshaft sensor malfunction replaced but still getting same code what could it be? I'm getting fire on 3-4 but not 1-2 also noticed getting power to 2 coil pack but when I turn key to start power goes to 0


Coil pack has failed change it. ... 2000 Mitsubishi Galant

OBD II Code P0441 Incorrect flow detected, was pulled in a 1996 Chevy Monte Carlo. What would the fix be for this code? I ran an O2 sensor test and all banks passed. I then ran an On-board monitor test. Two tests failed: Test 04 data, component ID 32, module $ 10, test value 32770, min limit ----, max limit 32766, staus fail. and test 07 data, component ID 12, module $10, test value 65431, min limit ----, max limit 0, status fail. What do all these values mean? Thanks in advance


Http://www.obd-codes.com/p0441 ... 1996 Chevrolet Monte Carlo

P171 code p171 lean to bank 1. 2003 Infiniti G35. Maf sensor seems to be within range. Only thing I noticed on my scanner is my long term fuel trim was 37.5% and 0 to 3%. Short term fuel trim was 99% and 0. I checked for vacuum leaks with no luck. I'm leaning towards bad O2 sensor or clogged/bad injector.


Yes i would say the same if you are sure there are no vacuum leaks ... Infiniti G35

Code 42 set on an '88 Camaro w TBI.Also very erratic idle, occasional backfire through exhaust,"jerky" on acceleration.Feels like a "miss" or skip.Base timing set at 0;2;4;6 all btdc with ESC bypass disconnected. No difference. Seems to idle slightly better with this bypass disconnected.Idles "crazy" after bypass reconnected.Ignition module checks good;good dist cap,rotor, coil,plug wires and plugs.New o2 sensor.Any thoughts? Is Knock Sensor associated with this code? Is EST associated with this


Listen to fuel pump w/ key on , if you hear a spraying sound, you may have a split hose in the tank ... 1994 Chevrolet C2500

Radio my code is 0319 How do you enter the 0 when it initially comes up to 1000 and there is no 0 on the first button, it goes from 1-9?


Using the station buttons , left to right , 1st button is 1000's, 2nd \015\012button 100's, 3rd is 10's, and 4th button 1's, push each button until desired\015\012number from each button , once you have the number in the display it\015\012should unlo ... 1993 Volkswagen Cabriolet

2006 dodge charger, er code p0406, check egr harness for 5v power on yellow with pink wire and no voltage 0 car is idling a little rough and has slight hesitation when accelerating.replace egr before i found 0 voltage.Also would like a diagram of the relay locations in the fuse box.there are 4missing relay plug sockets


Every fuse box has empty slots, so that is not the issue, this problem is this, the "EGR valve position sensor high signal return detected", this means that the EGR system is working, just the fact it generat ... 2006 Dodge Charger

P1471 hi my name is steven I have a 02 land rover freelander and I've been having trouble with it. it has been running rough and it has trouble starting up like its getting no gas so I have to push on the gas to get it started so I hooked up a code reader and I'm getting the code p1471. And I did a live data check and it says I'm only getting 35 for the fuel pressure and 0 on the fuel rail. And sometime when I'm driving and press on the gas the rpm will shoot up but my speed will stay the same o


High pressure fuel pump under the rear drivers side wheel arch ... 2002 Land Rover Freelander

Ls400, 4.0, engine code 13, came on after changing timing belt, changed right cam sensor, still has same code, also RPM not working (fluctuates 0 to 1000 when driving ), when taken out of overdrive it has feels like a miss at cruise, car has power and shifts great, help


... 1991 Lexus LS 400
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1077 seconds