Having problems with your 2008 Nissan Versa ?

! lights up on dash, tire pressure continually down, only resolution was to remove valves with sensors. Now light stays on permanently, but no more tire pressure issues. Is there a problem because my daughter has same issue with her 2008 Quest. My car is a 2008 Versa. Thank you!

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Nissan Versa

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

! lights up on dash, tire pressure continually down, only resolution was to remove valves with sensors. Now light stays on permanently, but no more tire pressure issues. Is there a problem because my daughter has same issue with her 2008 Quest. My car is a 2008 Versa. Thank you!


... 2008 Nissan Versa

2005 Isuzu Ascender: white smoke from exhaust on start up. Runs for 5-10 minutes and oil pressure drops to 0. Drives for 5-10 minutes, oil pressure drops and car shuts off. We have had nothing but major issues with this vehicle since we purchased it brand new. First, cylinder 6 misfired - dealership replaced cylinder; next the transmission went (we have never towed with it, although it says we can) - dealer replaced transmission. Now this problem.


You might kill the engine because you run the engine with no oil pressure. need to strip the engine. might jammed all the bearing. ... 2005 Isuzu Ascender

My 2001 Jeep Grand Cherokee Loredo, straight six, is having a problem that the oil pressure gauge goes to 0 and my check gauges light comes on but when i accelerate it goes back up and the light goes off. Is this a sensor issue? Nothing seems to be wrong w/ the jeep


Your problem could be the result of a bad pressure sending unit but I would take care of that immediately. If the pressure doesn't return to normal after installing the new unit, do not drive 'til you have a mechanical gauge installed and the actual ... 2001 Jeep Cherokee

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

Check gages light turns on and doesn't go off. Already had the oil changed, the oil pressure needle keeps marking 0. It had the same problem once but I changed the oil and kept working fine; then about 2 months after that oil change the oil pressure needle started to drop again, so I changed the oil once again, kept working ok, and since that oil change it only has been less than a month, and the oil pressure needle dropped to 0, and the check gages light is on


At this point I would strongly suggest that you have your mechanic hook a mechanical oil pressure guage to the engine and make absolutlely sure that the pressure is up to manufacturers standards. It may simply be a failing oil pressure sending unit, ... 2001 Jeep Grand Cherokee

I have a 2001 Chevy blazer extreme, I have replaced everything. Fuel pump, filter, and fuel injection spider. None of these were the problem, when I turn the key to the on position, the fuel pressure gauge climbs upto 2 psi. After the pump cycles the pressure drops to 0. If I prime the system the pressure will climb to 10 psi, then promptly die off as the engine stalls out again. I have changed the pump twice just to find out the problem still exists. What am I missing? I have no engine codes th


Maybe the gasket theres clearly no pressure holding ... Cars & Trucks

Oil Pressure Not wanting to step on you, the issue with the Sequoia is really fixed by replacing the printed circuit board behind the inst cluster, thusly replacing the combination meter ECU. If you want, please comment back to the Client, he needs P/N 83291-0C012-RP if he desires a permanent repair... BTW...The "Experts not seeing comments is being looked into". I had two problems -- erradic oil pressure gage and low pressure at idle. I replaced the sender which fixed the erradic problem. Now


If this is truly a ecu issue, it will not directly affect the true nature of the pressure at all. its just a logical read out due to the malfunctioning ecu but, the pump action is normal. if the engine is not showing signs of low or high pressure and ... 2003 Toyota Sequoia

1995 honda passport. When engine is cold oil pressure reads about 50, when the engine is warm the pressure gauge reads 0. What is are the possible problems. Just had the valve cover gaskets changed and then the problem started


What should the oil pressure read? Mine runs fine - no oil light on, but pressure reads slightly above 30 lbs/in when warm and on the highway. ... 1995 Honda Passport

2005 Cadillac Escalade oil pressure temperature gauge keeps setting off alerts alarm gauge jumps from 0 to full & truck shifts hard while driving like its going to stop, like its transmission problem. All fuel levels are full no problem there. Tire pressure gauge keeps reading a have low tire as well.


... Cars & Trucks

Gages fluctuate I have had the same issue for over a year. When I idle or go up hill, all the gages fluctuate irradically. One problem I found was brake fluid was leaking into the "speed control pressure switch" located directly under the brake fluid reservoir. I replaced the pressure switch and Fuse 10. It seems to be some issue with Fuse 10, but I haven't figured it out.


Faulty fuel gage causing otthers to fluctuate ... 1999 Ford Windstar

Temp gauge showing 3/4 to the red after 30 minutes or so. I have replaced t-stat, radiator, coolant, flushed the system, fans are working. I have check for head issue nothing to indicate problem. Timing is set manufactured spec at 10 degrees. still having same problem. I have pressure tested the coolant system no issue here either. suggestions.


Is the temp gauge accurate.Is car overheating, maybe car is not running hot.Check engine temp with different source.Gauges can go bad over time. ... 1990 Geo Prizm

I have a 99 ford expedition eddie bauer eddition. the verhicle had a hard shake to it, and my friend told me it was the transfer case, i found that one of the tires was the wrong size, and replacing it fixed the issue, then it would happen every now and then if my tires went low on air pressure, but filling them up resolved the issue. now its stuck not working right, and the tires all match, and the air pressure is good, what could be the problem short or getting a new transfer case?


Does it shake only at certain speed or rpms? ... 1999 Ford Expedition

1990 Isuzu Trooper Brake Problems. The breaks on my trooper seem to have an issue. I had replaced the pads on all 4 not long ago. Just the other day my brake peddle pressure is almost gone. I was told that it could be the booster. I took it to a shop and was told it was the booster. So I replaced the booster and still have the same problem. I checked the valve hose on the booster seems to work. I was wanting to know what else could be causing this issue. I have to down shift and pump brak


Get your vehicle's brakes master cylinder checked, tht could be the problem. ... Isuzu Trooper

2006 H2, 113K miles. DIC indicated Low Oil Pressure at idle. No engine noise, seems to run fine. Happens only at idle. Pressure gage rises correctly while accelerating, at steady speeds oil pressure steady no drops. At idle oil pressure drops normally and stays steady. Had sensor replaced, had manual oil pressure checked all ok, had oil pump replaced by dealer. Dealer says they cannot find the problem. Has any one had this issue?


Did you try changing the actual oil pressure gauge? ... 2006 Hummer H2

2004 Silverado 4.8l Oil pressure fluctuates from 40 down to near 0 when driving according to the gauge next to speedometer. When pressure shows about 10 or less, the audible warning constantly sounds. Shut engine off for 5-10 min and pressure is back up (temporarily). Problems start about 1k - 1.5k after an oil change. Pressure gets very low on when driving on highway rather than short trips in town. Been doing this for about 6 mths now.


Have the oil pressure checked, asap, at a service center to make sure the oil pump is not going bad. i would also take into consideration the suggestion offered by fixcar001. i would also refrain from driving until you've made sure i's not just a mon ... 2004 Chevrolet Silverado

Fuel problems 1999 Grand Prix GTP 3800 Supercharged VIN 1: car starts, but shuts down within 10 seconds. You can see the fuel pressure drop within those 10 seconds. If I flutter the throttle, the fuel pressure will jump back up to 50lbs & back down to 0-10. But, you can keep the car running by doing that. I have replaced the fuel filter & helped a little bit, but still shuts down. Replaced fuel pressure regulator & fuel pump & oil pressure switch & still nothing. HELP....


T.p.s. censor ... 1999 Pontiac Grand Prix

Oil pressure loss at times while driving down the highway . the oil pressure gauge goes from 40 pounds to 0 pounds. you shut it off right away then restart it and oil pressure comes right and holds 40 pounds again. you may drive 10 to 25 miles down the highway before the problem happens again.


Mate .2 things.The oil pressure sending unit is playing up or its not.The other is how long since an oil /filter change.If you know the oil is ok ,get the sender unit fixed.Oil is a lot cheaper than metal if things are not right.If it happens all of ... Dodge Cargo

What's your problem?poor pressure from window washer front and back on renault coupe 52 plate, cleaned out pipes and housings as well as water bottle, when connected up again still same issue, water just dribbles out of nozzles. To test pressure temp sealed the flow to the rear in an attempt to put all pumps pressure to front nozzles but this had no affect.....?


... Cars & Trucks

Transmission problem 01 Jeep Grand Cherokee limitied. First had code p1762 and replaced the governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI and Governor Pressure Above 3 PSI In Gear With 0 MPH. Tried disconnecting the battery to reset computuer and still is doing the same thing. Any Solutions.


I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid? ... 2001 Jeep Grand Cherokee

My two daughters each have a cavalier, one is 1998 and the other is a 1999. Both vehicles seem to have the same problem - turn ignition (no problem with battery), engine will crank but will not start, unless I depress the gas pedal and force fuel into the engine (which should not be necessary). After turning a number of times there is a gas smell from flooding the engine. Problems seems to be when the temperature drops and there is moisture in the air. Once the car is running, there is no issues


Hi Tony,When you are pushing on the gas pedal you are not giving it gas anymore,That is a throttle body,you are giving it more air!You need to check and probably replace the ECT switch.\015\012you need to have the Engine Coolant Tem ... 1999 Chevrolet Cavalier

What seems to be the problem with my 2004 chevy silverado? The oil pressure gauge goes from 0 to 80 when turned on. When driving, it fluctuates back and forth from 0 to 80.


Is your oil level low? make sure it has enough. if that is ok maybe the sender or wire to it is bad ... 1999 Chevrolet Silverado 1500

1996 Trooper with pretty decent rear main leak. Can this be repaired without pulling the engine? Also not holding oil pressure, I assume the leak is the issue as I see no other problems but open to suggestions if that is not typically the culprit. Runs great other than the leak and low pressure.


Bad leak at the rear main wont give you low oil engine pressure ,its sign that the main bearings are worn or the thrusts .\015\012Check the crank pulley end float and lift first but the main can be done in place drop the gearbox and flywheel. ... 1996 Isuzu Trooper

99 Jeep Grand Cherokee 4.7 Oil Pressure reads 40 PSI at Idle and drops to 0 at higher rpms. I just changed the Oil Pressure sender/ Same Problem


I'm having the same problem. Did you get yours fixed? ... 1999 Jeep Grand Cherokee

My 98'Ram, 160K., locked up when I lost oil pressure. It was fine when I started on my trip,I was cruising along at about 65/70 MPH for 40 miles when she started bucking. Checked gauges, oil pressure @ 0, I was on an Interstate, finally found a spot to pull over, shut her down. That was it she won't start back up. Is this a common problem with this vehicle?


Hi Bobby,Its a known fact that Chrysler built engines have weak oil pumps in their engines,If you check out the questions under Dodge ,Chry,Ply,Jeep, There are so many Questions of oil lights flickering at stop lights at an Idle,But if your oil ... 1998 Dodge Ram 1500 4WD

My 1977 924 is having a hot start problem ? at the same time it is having a hot engine issue (overheating) and the # 3 cylinder is missing . any thoughts? thanks joe I had someone try to figure it out and make the repairs. he couldn't. had my car for i yr. i know, messed up ey. he put on a fuel pressure regulator . said it was the cause for both issues. hot start and overheating. can u help me please. the day i took it home after paying him, it had no change in performace. it overheated heated


Check the timing and timing belt on this. Too much advance can make it overheat and hard for the starter to work. ... 1987 Porsche 924
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0518 seconds