Having problems with your 2008 Lexus GS 350 ?

Ballast on 2008 gs350

\015 Ballast replacement\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Lexus GS 350

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ballast on 2008 gs350


... 2008 Lexus GS 350

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

I have just purchased an Antler cabin bag with a TSA lock, should be preset to 0 0 0 as per factory setting & I should be able to open it, unfortunately this is not the case, any suggestions????


... Cars & Trucks

HID Maxima 2008: (Please do not send a google link as an answer). I have bought a salvage 2008 Nissan Maxima. It turns out that it came with Factory HID. Someone stole the Ballast and the lights. I am not sure which type replacement to buy. It appears that they were BI-XENON headlights with D2S bulbs. So, 1) Would any BI_XENON do or do I need to get a particluar type? 2) Will any ballast work or does the Ballast have to match the D2S bulb? 3) What are projectors? There are some


I just confirm and recheck D2S lamp is the correct type. Sylvania Headlamp Part Number: HIDD2S will give you a direct fit. It cost $129.99 each Shop around. === Auto maker does not make ballast, Their buyer send out OEM ballast manufacturers an ... Nissan Maxima

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

2005 Lexus Rx330 Ballast problem??? First I saw my passenger side HID headlight was on and off and then mostly off. I thought the HID bulb burnt out. I bought a new one and replaced it. After I installed it, I turn the headlight on. The new bulb seem like not so bright and about 30 seconds later, it's completely off. So it's not the bulb that burnt out from beginning. My second thought was the ballast which bunt out. I called Lexus dealer and ask them if they carry ballast for my car. Surprise


Well, we seem to have a real dilema here. I just searched the service manual for your 2005 RX330 and I cannot find any reference to a ballast for the HID headlamp bulbs. According to the wiring diagram, they are wired to the Headlamp Control Relays ... 2005 Lexus RX330

1996 Ford Explorer Third Brake Light Replacement I went to Ford but they are saying it will cost $400. They say it is the BALLAST. When I bought the light it says the Light does not require a BALLAST, but I am not sure how to by pass the BALLAST or if I should???? Can you help????


It is an old vehicle.\015\012Go to the salvage yard and get what you need.\015\012Return all the dealer parts ... 1996 Ford Explorer

I own a 2007 maxima sl & seem to be having a problem with the passenger side head light. It comes on then goes off. I have taken it to two nissan service departments with conflicting responses. One states that it is the head light while the other states that it is the ballast. If it is the headlight is this something that i can do as a self-service project. As well if it is the ballast can i fix it. And one other question... where is the ballast located?


... 2007 Nissan Maxima 3.5 Sl Sedan

2006 Cadilac CTS passager low beam light issue. Bad ballast. Replaced the ballast and the new ballast went bad in 2 days. Dealership says its a electrial problem. I need to know what to look for to check this problem and how to solve it.


... 2006 Cadillac CTS

The oil pressure gauge is going directly from 0-80.....as soon as you crank up the vehicle....Its running fine, no lights have come on, running smooth like normal, its just that the gauge in the dashboard is going from 0-80....what could this be ....this is the gauge that has 0-40-80 and the picture of the little oil container


It sounds like there is a problem with the oil pressure sending circuit. The oil pressure sender changes voltage according to the differences in oil pressure. If it is pegged all the way to the max, there may be a short (or open, depending on the w ... 2003 Chevrolet Tahoe

I have a 2006 nissan murano, it has high intensity lights. during inspection they replaced the left bulb, the part cost $180. The light still didn't work, now their telling me the ballast is bad and I need a new light houseing to replace the bad ballast, the part alone will cost $850. Is there another way to replace the light ballast without replacing the entire light? Thanks.


U should take it to a decent dealer or nissan's showroom. they'll be the best to guide u in this issue. ... 2006 Nissan Murano

I have a SunQuest PRO 16 SE every since I had it the ballast blow all the time. I need a owners manual to show how to put ballast in without taking so much stuff off that takes me forever to get back


... Cars & Trucks

1990 corvette tachometer problem, when the key is turned on the tach needle moves from slightly below 0 up to 0 but does nothing more when the engine is started and revved up


... 1990 Chevrolet Corvette

1990 toyota 4 runner Gun timing mark?? 0 or degrees after 0??


... Toyota 4Runner

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05


... Cars & Trucks

Fitting 0-320 cylinders on 0-290 lycoming


\012You may have this\012posted in the wrong product category. Please select another category\012appropriate to the problem and re-post the problem so the correct\012expert will see and respond to the question.. \012\012This is for ... Cars & Trucks

My oil gage drops to 0 and then back up to 40 when i am on a incline after the car has come to a complete stop or when i am making a turn when it drops to 0 the checks gages light come on and then right back off what can be causing this


First thing, have you check the oil level, maybe its low?if the oil level is ok, when was the last time the oil was changed. could be the oil is too old. last thing, possible low oil pressure due to an internal engine problem. (bearing wear) ... 2005 Chevrolet TrailBlazer

I have a 98 plymouth voyager se 3.3l auto (4 speed) and the speedo bounces cause the vehicle to have a jerking motion. when the speedo stays a 0 the vehicle runs fine but this doesn't last long befoer the speedo bounces. it also bounces when you are not moving the bouncing goes from 0 to 200 and when moving its between 20 and 80 . any help would be appreciated We have the same problem and had the speed sensor replaced three times. That was not the issue. Now when sitting at a stand still the sp


I would suggest taking it into a Jiffy Lube or Another Auto-Repair company. They can fix it for sure, and if they don't, you get a refund, and an apology. ... 2000 Plymouth Voyager

I have a intermittent problem with my Fuel gauge dropping below the 0 line after I start driving the car. Yesterday, the brake light on the dash stayed on after I released the hand brake, this went off after i restarted the engine. Today the alarm came on after I unlocked the car and the guage went below 0 again, are they all linked?


THE FUEL GAUGE SOUNDS LIKE A LOOSE GROUND WIRE - THE BRAKE LIGHT COULD HAVE BEEN WET AND I HAVE SEEN THIS BEFORE - NO THEY ARE NOT LINKED BUT THE VIB's FROM THE ALARM COULD HAVE MADE A LOOSE WIRE LOSE CONTACT ... Lexus IS

RPM Hi there, Can U tell me why the RPM somethimes stays at '0', even if the car is running, and somethimes when I turm the car off, and I start it again, it marks the normal RPM, and later it will go to "0" again... Regards,


... 2005 Hummer H2

Oil pressure gage is at 0. should be at 30. how do you check to see if it is the pump or sensor. it used to be at 30 or so when it is running, now at 0. how do I check the sensor, or do I have to change pump..


Run a test light from the positive battery terminal to the connector on the sensor. with the engine running, the light should light up. ... 1988 Chevrolet Blazer

2005 CHEVY COBALT THE ODOMETER DISPLAY READS EITHER 0 MILES OR BLANK. IF THE BATTERY IS DISCONECTED IT WILL READ UNTILL THE KEY IS OFF THEN ITS BACK TO 0


Oh that's a first I never heard that one before. I bet u have an electrical problem. The 2005 and 2006 Cobalts are notorious for a wide range of problems. I guess GMC couldn't work out the bugs. If your car is still under warranty you might want to t ... 2005 Chevrolet Cobalt

2006 dodge charger, er code p0406, check egr harness for 5v power on yellow with pink wire and no voltage 0 car is idling a little rough and has slight hesitation when accelerating.replace egr before i found 0 voltage.Also would like a diagram of the relay locations in the fuse box.there are 4missing relay plug sockets


Every fuse box has empty slots, so that is not the issue, this problem is this, the "EGR valve position sensor high signal return detected", this means that the EGR system is working, just the fact it generat ... 2006 Dodge Charger
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0388 seconds