Having problems with your 2008 Ford Taurus X ?

Changing blend door 2008 taurus - 2008 Ford Taurus X

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Ford Taurus X

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2004 ford taurus heater will not blow hot when i turn the temp control i hear nothing, no change in the cold air. when the blend door actuator is working i should be able to hear it right? the a/c works great and all the doors i can hear open and close on the vent selector switch. and last is it hard to get to for replacement?


... Ford Taurus

Changing blend door 2008 taurus - 2008 Ford Taurus X


... 2008 Ford Taurus X

2002 Ford Crown Vic 4.6L. EATCM A/C, Heating system. Replaced the blend door actuator due to stripped gear inside it. Before replacement could hear clicking noise coming from dash during temperature changes but nothing happened. Only hot air came out all positions. A/C is engaged and working at this time. Could switch from defrost to floor to panel to defrost/floor with no problem. Red and blue buttons showed temperature change but blend door did not move only clicked. After awhile the clicki


That clicking noise you hear is likely a relay in the fuse panel that needs to be replaced. the easiest way to find out which relay it is would be to put you finger on each relay as you actuate the device not working. once you locate the clicking r ... 2004 Ford Crown Victoria

Fix the a/c blend door 2000 ford taurus - 2000 Ford Taurus


No heat, air. thermastat changed. coolant level fine ... 2000 Ford Taurus

I have a 1998 ford expedition and is experiencing a NO heat problem. After asking one of your expert about this problem, he informed me to check my blend door actuator or the blend door itself. i'm having problems getting to the actuator. i did everything he instructed me to do and still is lost. Can you go into detail as to where this actuator is located and how to change it. He told me that it is under the center console behind the glove compartment. Please help me.


The Expedition uses the same heater box as the Ford F150 pickup truck.\015\012The actuator motor is difficult to get to on the Expedition/Navigator\015\012and is located on the bottom of the box above the transmission tunnel.\015\012(it's a lot easie ... Ford Expedition

Where is the blend door on 2001 ford taurus - 2001 Ford Taurus


... 2001 Ford Taurus

2001 FORD EXPEDITION XLT 4.6L V8 BLOWING MILD WARM BUT NOT WARMING THOROUGHLY. HAVE FLUSHED COOLING SYSTEM THREE TIMES, AND CHANGED THERMOSTAT. HAVE ALSO REMOVED DASH AND REPLACED "BLEND DOOR" AND BLEND DOOR ACTUATOR IN HEATER CORE HOUSING. HOW CAN I GET TO BLOW HOTTER.


You hot air comes from the water circulated through the heater core. It is like a miniture radiator with water flowing thru it constantly. So by opening the "Blend Door" you are permitting so much of this hot air to pass thru.Seems like ... 2000 Ford Expedition

Diagram of blend door on 2000 ford taurus - 1999 Ford Taurus


... 1999 Ford Taurus

Replace blend door in a 2003 ford Taurus - 1999 Ford Taurus


... 1999 Ford Taurus

How to fix blend door 2000 ford taurus - 2000 Ford Taurus


... 2000 Ford Taurus

How to change door latch on 2002 ford taurus - Taurus Ford Cars & Trucks


... Ford Taurus

2001 ford taurus blend door location - 2001 Ford Taurus


... 2001 Ford Taurus

98 ford taurus heater blend door thumps


... 1998 Ford Taurus

2002 ford taurus blows cold air in heat position. Changed thermostat. full of antfreeze. Heater and radiator hoses heat up at operating temp.full flow through heater core. changed heat actuator. also manually operated actuator door. Any other ideas would be appreciated!


... 2002 Ford Taurus

I have 1996 ford taurus, i was changing the speedo assy. out when i went to reinstall it there was a loud beeping noise that started not the door chime. the car has loctronics on it. the battery went dead i put another battery in and the starter went bad and and now the windows wont roll up and when i push the door lock buttun you can hear the lock acuators go on and off continuously i have to turn the key off for it to stop.Any ideas. Thanks


All of the things that you mention in your description have one thing in common the Generic Electronic Module it is connected to the instrument panel fuse box ... 1996 Ford Taurus

If my ford expedition has an heater control valve i would like to know where it is located. i was also told that the no heat problem could be the blend door actuator, if so where is this door located and how do you change it.


That model does not have a heater control valve. The problem stems from a bad blend door motor or the blend door is broken where it mates with the blend door motor. The blend door motor is located under the dashboard behind the center console. It's w ... 1998 Ford Expedition

Fault codePO171and PO174 comes on my 96 ford taurus with a 3.0. I am having drivability problems. Car starts up great ,and as it warms up it starts great ,and as it warmrms up feul pressure starts to drop even though the feul pump was just changed along with anew filter.aventuellyfeul presure shows 0 psi,and no it is not the regulator eather, cause that has been changed to.So?


System adaptive fuel to lean,(bank 1),and thepo174code issame thing but on (bank 2) ... 1996 Ford Taurus

1993 ford f150 changed heater core thermostat and water pump all new hoses checked blend door still no heat


... Oldsmobile Cutlass Calais

1997 Jeep GC with manual A/C system. Dash temp. control knob will not change the blend door. I removed the blend door motor and on the bench it works when voltage is applied directly to the motor. I replaced the A/C heater dash control panel with a used one with no change. The system works when I change the blend door by hand. Is there a wiring diagram for this system? What should I check next?


... 1997 Jeep Grand Cherokee

Ford 2000 Taurus, Keyless entry remote no longer works. Changed battery no luck. Tried reprograming and found door locks did not cycle open closed. Could not go further. Any ideas? Thanks, Al


I have a 2000 ford Taurus and my keyless remote has stopped working and having problems with key unlocking the door from outside, none of the remote work do u have any idea what my problem could be ? ... Ford Taurus

FORD FOCUS 2006 AC-HEAT DIRECTION BLEND DOOR NOT WORKING EVEN AFTER CHANGING CABLE


... 2006 Ford Focus

I have a 2000 ford taurus with no heat . Ihave changed the thermostat and the heater core and checked all the heater control doors with a vacuum tester and they seem to be working any other suggestions


If the blower is working, and hot engine coolant is flowing through the heater core, then the problem has to be duct flow control related. \015\012\015\012Check fuses #216 15A, and #228 10A in the central junct ... 2000 Ford Taurus

We just purchased a 1999 ford taurus. After closing the door the interior light stays on for 40 minutes or so. We can't figure out how to change the setting. Her battery went dead from the light being on so long Hope you can help!


Look for a sticking door switch one of the door switches needs lubricated. ... Ford Taurus

How do I change the door lock code on my 95 ford Taurus?


... 1995 Ford Taurus

1998 ford taurus no heat,replaced thermostat,heater core and the blend door motor seems to be working, flushed radiator, and still no heat, any suggestions?


You might have to purge the coolent system cause when you change stuff like that you normally have to bleed the the colent system. So what you have to do is run the car untill your temp gets to 195 degrees the cut the car off and let the coolent drai ... 1998 Ford Taurus
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8768 seconds