Having problems with your 2008 Ford Fusion ?


\015 ITS ON BUT HAS NO POWER , WITH AC OFF IT OK\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

The engine\012and transmission in this cars drive train are fully\012electronically controlled by a computer called the PCM (Power Train\012Control Module). Whenever a problem like this occurs the computer\012stores a record of the problem (there are of course some exceptions\012to this, like the fuel pump, engine coolant temperature sensor and\012MAF sensor for instance) in the form of a fault code in its memory,\012to read these fault codes you must have the systems memory scanned\012with a special tool. Once the fault code(s) are read you then must\012perform the appropriate diagnostic testing to find and resolve the\012problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN\012HAS DIAGNOSED THE PROBLEM TO AVOID SPEDING YOUR HARD EARNED MONEY ON\012PARTS THAT MAY NOT CORRECT THE PROBLEM

Repair Help & Product Troubleshooting for 2008 Ford Fusion

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Last year my battery died on my 2009 Ford Fusion. Had to get a boost. Last month, battery died again in a shopping mall yard. No warning light stating problem. Helpful stranger attempted boost to no avail. Dealership replaced battery. Found out that next door neighbour who also owns a 2009 Ford Fusion ( actually purchased hers a few days after mine) had same problem - twice. Could it be the alternator that is not charging the battery?

I think you just got a bad battery right from the get go,One quick way to check if your Alt, is good,Pull the pos,+ wire off with the car running if it keeps running then its good, A bad battery is not uncommon The dealer should have tested your Alt, ... 2009 Ford Fusion

All power windows stopped working on our 2008 Ford Fusion. The fuse under the dash is ok. What is the next step to determine the problem? Is there a history of such problems on the 08 Fusion?

... 2008 Ford Fusion

I have a Ford Fusion 1.6 TDCI and when slowing down it jumps out of second gear. This is an intermittent fault. Ford have investigated the problem and cleaned up the gearbox but the problem is still

... Ford Cars & Trucks

2007 ford fusion problems - 2006 Ford Fusion

... 2006 Ford Fusion

2007 ford fusion battery and cd problems - 2007 Ford Fusion 1.4

... 2007 Ford Fusion 1.4

I have a 2008 Ford Fusion SEL. Battery keeps going dead. I finally took it autozone and everything checked out ok. Battery good and alternatir also good he said. But got home and checked it again after a couple hours and not enough juice to start up. What could ut be?? Just started the day on Monday. I thought it was a charger i left hooked up but i always do that and never had this problem. Had everything disconnected and problem continued. Please Help! Thanks in advance.

... Cars & Trucks

2006 ford fusion elect probleme / flash/park light stay on at l/f - also both frt flashers not operating if disconnect fuse # 19 in engine compartement -light goes out // cruse control not fonctioning // relate probleme

... 2006 Ford Fusion 2.3

I have a 2007 ford fusion 4 cylinder. Hen I start it it idles low and when at a stop also it started stalling when at stop car runs perfect when driving. I'm stumped I have changed that spark plugs and when changing the 2 and 3 plugs saw oil so I changed the valve cover gaskets. Still didn't fix problem got code or 1 coil pack changed that still having problem now what and how do I proceed I'm totally stumpted please help also I don't have much knowledge in cars as I'm a nurse and a single mom b

... 2007 Ford Fusion I4 SEL Sedan

This is in regards to a problem I am having with my 2008 Ford Fusion. Every time there is a heavy rain water pools in the back seat floor board on both sides. I have taken it to the dealership where I bought it and they cant find the problem. I have driven through some deep puddles when there has been heavy rain. The dealership tells me the door seals are all fine. Also, one time I stopped and got out of my car the day after a heavy rain. When I stopped there was water pooring out of the b


Breather problems on ford fushion 1.4tdci - 2006 Ford Fusion

... 2006 Ford Fusion

The heater (blower) on my 2007 Ford Fusion is not working. The problem used to be intermittent (it would turn on randomly), but now it doesn't work at all. I had a similar problem happen about a year ago, and when I brought it to the dealer, I was told it was a blown fuse. Before I had brought the car to them, I checked all of the fuses (underneath the hood, and underneath the steering wheel), but none of them were blown. I rechecked all the fuses this time around, but with the exception of

... 2008 Ford Fusion

2007 fusion clutch problem - 2006 Ford Fusion

... 2006 Ford Fusion

Ford fusion starting problems

... Ford Fusion

Ford fusion Fuel Problems

... Ford Fusion

2006 ford fusion ac problem

As a Ford dealer tech I found this was always caused by the AC compressor cycling switch, it shuts the compressor off when it reaches about 30 PSI, this prevents freeze up and saves fuel, when the system press rises again to about 42 PSI it turns the ... 2006 Ford Fusion

My check engine light on my 2007 Ford Fusion is on and the codeP0128 indicates a thermostat problem. How can this be fixed?

... 2006 Ford Fusion

Window problem window on ford fusion works part time

The most common cause of this is the window electric motor, the brushes stick on the commutator. ... 2006 Ford Fusion

2006 Ford Fusion 4 cylinder. When idling in gear at stop lights, engine keeps revving up and down between 200 RPM and 1500 RPM and on many occasions stalls right out. Happens when engine is well warmed up. Dealer has not solved problem which is annoying/dangerous in city traffic.Dealer has said it may be related to air condition.

Sounds like fuel pressure reg on fuel-line ... 2006 Ford Fusion

My 2006 Ford Fusion is idleing very rough when it starts and it acts as if it is going to die but it doesn't. It is also shaking when it starts and the check engine light keeps flashing on and off. It recently was very low (almost dry) with oil unknown to me and when I discovered this I immediately put oil in and then all of the problems that I have described above started. Any thoughts?

It could be a fouled sensor you need to put it on a code reader first, that would be the cheapest start,it may be a bent rod .... i mean there is a lot of things that it could be.but it sounds more like a sensor or electrical system problem. ... 2006 Ford Fusion

Hearing a steady ping coming from engine and check engine light is on for 2007 Ford Fusion. Doesn't seem to be any performance problems.

You can buy your own diagnostic code scanner. Amazon has some cheap ones for \015\012around $40. You can pull the code yourself, and erase the code and turn\015\012 the light off. If you have any autozone early, they can read it for free.\015 ... 2006 Ford Fusion

I have a 06 ford fusion 80,000 miles. recently I have had a jerking problem from the rear. The first time this happened I thought someone hit me from behind.

I am only going to guess \015\012\015\012You may have a bad EGR Valve,if it slams,bucks,etc,with the slightest amount of gas applied or won't go up any hill. Disconnect the vacuum lines to the valve,plug them and road test to confirm ... 2006 Ford Fusion

I have Ford Fusion 2007; 1,6 manual . There is a problem: driving switches on a sign " a sort of gear with ' ! '. The computer diagnostic gives the result : "error P061D". What does it mean & is it possible to solve it by myself? Thanks.

... 2007 Ford Fusion I4 SEL Sedan

What do i do; Having problems starting my 2008 ford fusion

... 2008 Ford Fusion

I accidently topped off my 2009 Ford Fusion coolant system with wipper fluid. Is this a serious problem?

That depends on how long you have ran the car with it in the cooling system, if not long or at all, then you should just flush the cooling system and you'll be fine ... 2009 Ford Fusion

My 2008 model Ford fusion (diesel) car has following problem: After driving for a while, when I want to bring the car in standstill motion, the clutch pedal is pressed but the clutch is still engaged & also the gear liver doesnot come back to neutral position, when moved. Further, the engine stops automatically due to this abnormality. after engine is stopped, it is found that the clutch pedal is still stuck in pressed position and after sometimes comes back slowly and possible to change the gea

I think you just need a new master cylinder thats all not a big job to change it ,also try squirting the spigot bearing carrier with some engine oil if you get it onto the shaft as the slave cylinder is inside the bell housing on this model andf it c ... 2008 Ford Fusion
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8365 seconds