Having problems with your 2008 Ford F 250 Super Duty 4WD ?

How to reset engine light on a 2008 Ford F-250 6.4L diesel?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Ford F 250 Super Duty 4WD

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have tried 3 methods of checking fault codes via flashing check engine light (1. turn key on-off-on-off-on-off-on...hold trip reset button then on-off-on-off-on release trip reset... then trip reet, on-offx5 and release... still no flashing engine light. I am under the impression that i should at least get a code 55 that everything is ok?? Dec build 1997 turbo diesel XJ cherokee...thanks:)


1996 and above it's obd 2 this mean no flashing codes you need a scanner in order to pull the codes. ... 1997 Jeep Grand Cherokee

We have a 1998 Ford Windstar with a 3.8 liter engine in it with roughly 240,000 miles on it. The van has never really gave us much trouble. About a year ago we had the egr sensor, egr valve and ports cleaned because it was running rough. After we left the Ford garage about 15 miles down the road the check engine light came on. So we took it right back down for them to reset it again. They stated that since we replaced 1 oxygen sensor that one of the other 3 (cause there are 4 of them) is going b


My 95 ford windstar had over 300 k on it before i sold it. two things that may have been are are consistent problems with them are relays in the fuse panel under the dash and the EGR module failing which causes the light to go on. if the light went ... Ford Windstar

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

Reset engine light on ford 6.4 diesel


... 2008 Ford F 250 Super Duty 4WD

How do i reset the check engine light on a 2006 ford f-350 6.o diesel


... 2006 Ford F 350 Super Duty

2004 F350 Ford 4x2 DRW Crew cab 6.0 V-8 Diesel; how to reset check engine / service engine light


Easiest way is to disconnect batteries step on the brake pedal then reconnect ... 2004 Ford F350

1998 FORD CONTOUR CHECK ENGINE CODES P1131 AND PO171. REPLACED 1 OF THE OXYGEN SENSORS, CHANGED PLUGS, PLUG WIRES, OIL AND FILTER, ALSO REPLACED AIR FILTER AND CLEANED PCV FILTER, RESET PC AND IT RAN GOOD UNTIL WARMED UP (check engine light back on). STALLS IN IDLE AT EVERY STOP, RUNS DECENT OTHERWISE


Sounds like EGR valve and sensor this controls idle speed when at a stop. the po171 is a burn lean or rich code need to know what bank 1 or 2. also check for a vacuum leak from one of the hoses. ... 1998 Ford Contour

How do I reset the engine service light after service on a 2000 ford truck with a 7.3 diesel engine?


That is probably the same as the check engine light, which would require you to use a scanner to clear the codes and turn the light off. ... Cars & Trucks

How can I reset the service engine light after service on a 2000 Ford truck with a 7.3 diesel engine


... Cars & Trucks

Reset service engine soon light on a 2006 ford 250 super duty diesel


... 2006 Ford F-250 Super Duty

I have a 04 ford transit connect diesel 6 months ago it started knocking ,the garage had it weeks engine out twice , was said to be number 1 cylinder bottom end ect , i was ripped off to the tune of £2,200, it is now knocking again so i tookit back thinking it would be under warranty ,its in bits again and they say its number 4 cylinder now ,same thing ,sasy this time it will be £500 but with no g tee in case same happens to 2 and 3 ,we treat it like a baby its very lightly used ,i he said i d b


... 2003 Ford Explorer Sport

I have a 1999 dodge ram 1500 3.9 ltr with 99500 miles on it. The code im getting is misfire cyl # 2. Ive changed the plugs wires rotor cap etc reset the code and it still comes back on after a second complete trip in the truck. Just to make sure my scanner was working i pulled the wire off of # 1 and sure enough i got two codes then. Misfire on 1 and 2. Reset the codes engine light went off and drove to work code came back on. Drove home from work check engine light is back on. There is no hesit


Check compression in cyl #2. If ok, the listen to injector on #2 with stethoscope and compare sound with other injectors. Remember also, that anything that slows the engine for a split second, ie acsessories can cause that crank sensor to pull up a m ... 1999 Dodge Ram

How to reset engine light on a 2008 Ford F-250 6.4L diesel?


... 2008 Ford F 250 Super Duty 4WD

My ford focus diesel won't start. i only have the transponder key. the dash light flashes quickly when the engine is turning over. it is a 51 plate tddi. is there a sequence i can take with the key to reset it or do i need new components. thanks


No their is no sequence on this car to reset the key as you think because its too new i think but i do not know what year this vehicle is as a 51 plate is some sort of secret code to me .This vehicle is quite easy to by-pass the immobilisor when you ... Ford Focus

I have a 2004 ford sport trac and my check engine light it on. i tried reseting the computer it work for a day or two but came on. then had it check and its saying that something about bank 1 bank 2 that fuel pump doesnt have pressure or it could be fuel pressure regulater or fuel rail so all of this is expensive and i dont know which one of this is the problem already replace the fuel filter and i dont have enough cash to be buying each part then to find out that the part i bought wasnt it. so


... 2004 Ford Explorer Sport Trac

Have ford focus 2004 zts with 118000 miles. check engine light comes on. fault code po-420 (bank 1 efficiancy below limit) shows up. Took it to the ford dealer for repair- they replaced top o2 sensor- said that should fix problem. It didn't, chk engine light back on. Now they want me to replace a $1600.00 exaust part (not including labor) an there is no guarantee that it will make my check engine light stay off. Need this car to pass emissions test but am running out of money. What should I do!


... 2004 Ford Focus

2000 Ford Excursion Diesel has check engine light of P1391


Glow plugs preheat the fuel to help the engine start.....when its hot outside its not that bad...the colder it gets the harder it will be to start with bad glowplugs.. ... 2000 Ford Excursion

I have a 2005 Ford Focus ZX4 ST. I have less than 73k miles on it. Have never had any issues with it. Perform all the regular maintenance at required intervals. About a month ago the check engine light came on. Every so often, at highway speeds, the check engine light would flash. Checked the codes and had misfire on cylinder 1 and 4. Replaced the plugs with no change. Actually got worse. Replaced the coils. Engine runs better at low speeds. But the check engine light comes on once and awhile an


I would start with plug wires rubbing on something and created a short.and is not compleatly worn through. a cheep place to start. good luck with it. ... 2000 Ford Focus

We own a 1996 Dodge Stratus and the check engine light is coming on. After changing all the spark plugs the light went out. The next day the light comes back on. While driving on the freeway the speedometer went down to 0 and when I gave the gas peddle gas the engine ribbed up while it was slowing down. (as if it was in neutral). Pulled over turned engine off. Waited about 1 hr turned the ignition key and it started up and the light was back on again. When in idle it shakes and there is t


The only way to tell why the check engine light is on is to have the engine codes read with a scanner. This will pinpoint exact problem location. It will also have to be shut off and reset with this scanner. Many part stores will do it for free. ... Dodge Stratus

My 2005 chevy silverado 4x4 check engine light came on. It went on after a hard 4x4ing in deep water. I have a programmer and ran diagnostic. Sys too lean Bank 1 and Bank 2. MAF sensor was also a problem but I noticed my K&N was filthy so i cleaned it and reset codes. Engine light came back on but only the sys too lean Bank 1 and Bank 2. Curious if it may actually be the MAF or possible a couple 02 sensors.


... Chevrolet Silverado 1500

I have a 4 liter V6 2003 Ford Explorer ( 2 door). The check engine came on and then it started idling rough. When it idles rough the AC blows hot. Recently it has started stalling when idling at a traffic light or in stop and go traffic. The problem has been consistent until tonight when I had no problems but check engine light still on (rough idle has only been during the heat of the day so far). Read the codes for the engine light and they were as follows System too lean bank 1 system too


Hello! Most probable cause is a leak in the vacuum line or broken elbow connection to the Positive Crankcase Ventilation (PCV) valve...Check PCV and its vacuum line...Send results...Guru..............saailer ... 2003 Ford Explorer

2004 Explorer Replaced Alternator, but car idle still not right, stalls, ck engine light still on. Car lights when dim and then car died. Mechanic said it was the alternator. Alternator replaced. Car check engine light still remained on. Mechanic said it would reset itself after a little while of driving. Not happening and when starting the car, the engine idles rough or low and then stalls. Does software from ford need to be downloaded on the car?


... 2004 Ford Explorer

My 1999 subaru impreza outback automatic transmission oil light came on...took it back to dealer...he reset it...2 days later, it came back on and the check engine light came on...when the AT light comes on the car would stay/default @3rd gear. If I placed car @park, stopped/restarted the engine, the AT light would go off, & shifting was normal. Car under warranty, so had transmission rebuilt. 1 day after having car back on road(I drive about 130+ miles/day) the AT light is back on. So is check


... 2003 Subaru Outback

How do I reset the Check Engine Light on a 2005 Ford Taurus? The system check says everything is OK. Previously, a dirty air filter caused the light to come on. I replaced it (it was somewhat dirty.) but the light did not go out. Also, a couple of days ago, my "gas cap" and "Brakes" lights came on. I restarted and the fault was cleared. However, the check engine light came on later.


Only way to clear is with a scanner. The scanner will also give you the codes so it can be diagnosed. If its an emission issue your warrenty should cover it. ... 2005 Ford Taurus

Whle driving my 04 diesel honda loses power and the VSA light and engine management light come on . When i turn off the car, it resets and the VSA light disappears but the engine management light stays on. When hooked up to a diagnostic kit it reads error code P2138? Can u help


Hey did you ever figure out what was wrong with your car? Mine is doing the SAME exact thing ... 2004 Honda Accord
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.2513 seconds