Having problems with your 2008 Chrysler Pt Cruiser ?

Engine motor mounts on 2008 PT Cruiser

\015 Looking for all 3 motor mounts\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Chrysler Pt Cruiser

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

2002 Pt Cruiser engine shuts off suddenly


... 2002 Chrysler PT Cruiser

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

91 Corvette - Service Engine lights, Speedometer goes (usually) to 0, Average miles per gal goes to 5Y5, engine stops. Engine cranks but will not start. Wait a bit, remove key, insert key and it will usually start. only code is 12 which is normal. (Speedometer sometimes goes to 108 or 17 instead of 0 - while sitting and Idleing) Can sometimes get out of engine stopping by flooring it - must be driving to do this.


... 1991 Chevrolet Corvette

Ignition When I turn on the ignition I drive a few feet and when I stop the rpms goes down to 0 and the engine turns off, some times it turns on but the rpms go down to 0 without driving and the engine turns off. No check engine light is on.


Check your fuel filter and fuel pump. ... 2000 Mitsubishi Montero Sport

Propercrankpositionfor correctbelttiming is there a timing mark onthe crank pulley for refrence to line up with a notch on the engine ,besides the flyweel mark? i am puzzled because i have already bent some valves & dont want to repeat my mistake. i have put the #1 piston at TDC, flat with deck ''0'' deck is this right or should it be slightly below ''0'' deck hight and or should the key way be at 12:00 position. please help me P.S, this a 89 honda accord 2.0 carb.3V A20A1 engine


Send me your email address and I will send you the proper timing positions. I can copy them from mitchel and email it.... ... 1989 Honda Accord 4 Door

Is it possible to change the miles on a 1992 GMC Sierra (1500)? I just switched out the v6 with a new 305 and for personal preference I wouldn't mind setting the miles back to 0. Not selling the truck, I mean I could always write down it's current miles to know how many miles are on the engine but it would be nice to set to 0 since its a new engine.


No if you want one with 0 miles you will have to get a new one ... 1992 GMC Sierra

My pt cruiser iver heated and the head gasget blew. I was told that I would need to get, at least a new head, if not a new engine becuase the head on this pt cruiser can't not be resurfaced. does anyone know if this is true and if so where I could go to get a cheap engine.


You may not need an engine depending on how long you drove it overheated. if your engine is not knocking or rapping it may be saveable. check with auto parts stores that resurface engine heads if haveing resurfaced have the head checked for cracks. i ... 2002 Chrysler PT Cruiser

Overhaul of the top in of 2003 jeep 4.7. It had jumped time, broke a valve spring and bent a valve. After the overhaul oil pressure at idle drops to 0 after the engine warms up. No engine noise what so ever. pressure jumps up while driving, but at idle drops back to 0. Afraid to drive, what should I do?


First thing you need to do is put a mechanical gauge in place of oil sender and read actual oil pressure. If mechanical gauge shows same condition, take a look at the connecting rod bearing serving the cylinder where the valve bent. If the piston hit ... 2003 Jeep Grand Cherokee

98 buick lesabre oil pressure dropped to 0 and engine died. added 1 quart oil, waited 30 minutes, started and drove 5 miles then oil pressure dropped to 0 and engine died. does this sound like a bad oil pump? where is the oil pump and is it hard to change for a "handy" person? thank you.


My sister had the same problem. There are 2 sensors that can cause this when they go bad. One is the oil pressure switch, which is located near the oil filter. When the PCM reads this switch, and gets a low reading, it will automatically kill the eng ... 1998 Buick LeSabre

I have a problem. We have a 2001 pt cruiser with 2.4 engine can I use a 2006 pt cruiser 2.4 engine. They told me that the crankshaft plate is different from the 2001 2.4. please advise


The only years that fit your engine are 2001 and 2002. They are correct, the 06 engine will not fit correctly. ... 2002 Chrysler PT Cruiser

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

Pliz help after taking my car for engine wash they used water to wash the engine and engine Codes came up . 16502 P0118 Engine coolant temperature circuit-G62:high . 16497 P0113 Intake air temperature sensor 1 circuit-G42:high. 16486 P0102 Mass air flow circuit -G7 0:low input. 16622 P0238 Turbo super charger boost sensor (A) circuit : high. 16955 P0571 Brake switch sporadic (A) circuit : malfunction. 18000 P1592 Altitude sensor /boost pressure sensor :implausible ratio. 16706 Engine RPM sens


Not Good: The Expensive main computer brain sustained a short from either the heat of the solutions or leakage allowing fluids to enter the components. If after a drying period this still occurs; then the computer brain needs replacing. ... 2005 Volkswagen Touran 1.6

Have a 1999 Ford F150 4.9L engine that won't start when temp is 0 or below. Engine turns over but won't fire. Dealer replaced the battery two weeks ago even it was only three years old and stilled turned the engine over. They said it was not operating the fuel injector and raw fuel had fouled the plugs and entered the crankcase.They also cleaned the plugs and changed the oil and filter. But same problem yesterday. Is there a coil or some other device on the engine that could be preventing the p


You need to have the engine coolant switch \015\012checked,since the computer relies solely on sensors,the ect tells the computer how cold or hot it is so the \015\012compu ... 1996 Ford F150 Regular Cab

1990 ford bronco 351 windsor engine, e40d at transmission. Drove on hwy at hwy speed for 2.5 hrs, turned off and engine started to sputter and pop with very low idle rpm. Shortly idle went to 0 rpm and engine stopped runing, 1 hour afterwards engine started up and ran normall next day also. What is problem?


I have an 89 with a 351w. Mine did the same thing. Sounds like its vapor locking. After you let it sit for an hour or so it should start up but you should take the EGR valve off and either replace it or clean it with carb. cleaner. That should el ... 1990 Ford Bronco

Have a 1999 Z71 chev truck with 5.3 L engine that has fluctuating oil pressure. Started with low oil pressure after start with engine clak that disappeared after it warmed up. Changed oil and found sludge in crankcase. cleaned as best we could and blew back through oil filter housing. Now engine shows ''0'' oil pressure after start for about 10 seconds then goes to mid range on gauge. After it warms up, oil pressure starts to drop and engine appears to labour intermittitently.


In some cases where the oil is not changed properly, the oil pump screen maybe plugging or your oil filter is defective. Fram is a good filter. If there is no problem found, replace the pressure sensor. ... 1999 Chevrolet Silverado 1500

Frozen engine I have a 2006 PT Cruiser and it's -17 degrees in Chicago this morning and my engine won't turn over. The Engine Malfunction light stays on, but the battery is not dead. What can I do to get my engine started without killing my battery?


It Must Be THAWED Out Literaly Sounds Wild But I Towed for Years Here in INDIANA And I towed them to shop Put them inside for an Hour or so with Salamander Heaters Blasting at them and that WORKED. I Hope this helps you and you have a Better DAY!!!!! ... 2006 Chrysler PT Cruiser

1990 corvette tachometer problem, when the key is turned on the tach needle moves from slightly below 0 up to 0 but does nothing more when the engine is started and revved up


... 1990 Chevrolet Corvette

Which engine oil is used by a 1992 land cruiser prado EX 2l-te engine


... Cars & Trucks

Which engine oil is used by a 1992 land cruiser prado EX 2l-te engine


... Cars & Trucks

Toyota Fj cruiser camshaft sensor location on the engine block. This is not a popular vehicle you see them but not a lot. It's a V6 4.0 liter I think. Check engine light with all the anti skid lig


... Toyota FJ Cruiser

Quantity of engine oil used in 1 HD engine toyota land cruiser


If you have just bought the car change the oil and the filters asap on the grounds that the oil and filters may have not been changed for quite a while also change air and fuel filters also and grease any steering and tail shaft joints check brake fl ... 1994 Toyota Land Cruiser

2001 PT Cruiser: my 2001 pt cruisers check engine light will not co...


GET THE CAR SCANNED FOR ERORS ON ANY ELECTRIC PARTS THAT MIGHT B FAULTY OR BROKEN ... 2001 Chrysler PT Cruiser

1989 F150 351 oil pressure guage starting dropping to 0 suddenly and engine light comes one. When I rev the engine it goes back to normal but a soon as the rpms drop the needle goes all the way to the left again and the engine light comes back on... Any suggestions?


Hi:\015\012Usually your oil light doesnt come on unless you have less than 10 lbs of oil pressure. You either have a bad oil pressure sending unit, or your engines oil pump is bad. The only way to verify your engines oil pressure is to buy a di ... 1989 Ford F 150
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9257 seconds