Having problems with your 2008 Chrysler Pacifica ?

How to change the fuel filter on a 2008 chrysler pacifica

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Chrysler Pacifica

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to change the fuel filter on a 2008 chrysler pacifica


... 2008 Chrysler Pacifica

How to change the fuel filter in a 2004 chrysler pacifica


... 2004 Chrysler Pacifica

ALL SENSORS HAVE BEEN CHANGED. FUEL FILTER CHANGED, FUEL PRESSURE IS AT SPECS AT IDLE BUT DIES IN GEAR. WILL RESTART BUT ALWAYS DIES. NO CODES IN SYSTEM WHEN IT DIES. NO HISTORY CODES. STILL HAVE COMUNICATION WITH COMPUTER. 1998 CHRYSLER SEBRING V6 MITS ENGINE. WE HAVE BEEN AT IT FOR 6WKS STRAIGHT, AND STILL NOT RUNNING CORRECTLY. PLEASE SOMEONE WITH THE RIGHT ANSWER/SOLUTION. THANX IN ADVANCE. 02 chrysler t&c dies at intersection, randomly that is. will restart fine. don't know what to do. 3.


Replace the distributor. This is the cause of many problems with the engine running on those cars. It contains the cam sensor, the coil and has been a thorn in many a side. ... 1998 Chrysler Sebring

How do I change the fuel filter on a 2006 2.4lt Chrysler PTCruiser. Do I need to remove the tank? Do I need to drain the tank? Finally how often do I need to change the Fuel Filter


Your cars fuel filter is inside your fuel tank along with the fuel pump....you need to remove the back seat to give way in removing the top cover of the fuel tank that holds the fuel pump and filter...no need to drain the tank with its fuel...fuel fi ... 2006 Chrysler PT Cruiser

93 chrysler t&c awd changed fuel pump and filter, van ran fine again for about 2 months now won't start and don't hear the fuel pump. changed the oil pressure sending unit and still won


Fuel pick-up in tank is blocked it has a sock over the end as a gross filter to keep out any big junk from getting sucked into the pump and causing damage to it. the sock can get so plugged up that no fuel will flow, causing the pump to run for a sho ... Cars & Trucks

I am trying to have the fuel filter changed in my 2001 PT Cruiser. I know that it is inside the gas tank but where. The parts guy at my Chrysler dealer said I'd need to buy the whole fuel pump assembly because it was attached, yet when I went online and found a fuel pump the guy said it didn't come with the fuel filter. I really need to take care of the problem and am tired of the conflicting answers. Please help??


Oem parts like the fuel pump come as a complete unit with filter and fuel sending unit, you can get after market parts that come separate, and a lot of those require a competent mechanic to install as a lot of them are snap together units not meant t ... Chrysler PT Cruiser

My 1997 chrysler t&c starts, idles, then dies like it's not getting any gas. i have had several ideas as to what it might be but none of these people are mechanically enclined. i have heard that it was "vaporlocked, could be a clogged fuel filter, a bad fuel pump.. on top of this.. my tail lights quit working about a month ago.. after changing all the fuses under the steering colum and the under the hood and changing all the bulbs (just in case) i'm at a loss. a brief history though.. about a ye


It sounds like the body control module. It controls all the stuff that has been acting up including the theft alarm. The engine control module looks at the body control module for an ok to start signal. if it doesn't see it because the body contro ... 1996 Chrysler Town & Country

Vw polo 1994 oil light comes on immediately after reaching 2800 rpm. I have changed the oil filter, oil, air filter and the oil pressure switch (blue color i think it was 0,15-0,35 BAR). Recently i have changed the instrument panel as the temperature and fuel gauge were not working. what can be the problem and are there two oil pressure switches ??? Thanks in advance.


... Volkswagen Polo

Took our tahoe in for oil change they also put in fuel injector cleaner since the we have had a hard idle problem that happens between 0 to 5 miles an hour then occasional it dies after you first start it. what do you thin is wrong we change the spark plugs to bosch plugs and new wires and a new fuel filter but it still did the same thing. We had it read at and it is still saying 8 is the problem so we put in a new silinode what do you think?


Most likely the fuel injector is the problem. ... 2002 Chevrolet Tahoe

Change air filter in 2006 chrysler pacifica - 2004 Chrysler Pacifica


... 2004 Chrysler Pacifica

1992 Chrysler LeBaron 3.0 L. V6 Engine runs beautifully but after 16-20 miles highway driving engine stalls as if flooded, or as if fuel is cut-off. After sitting for a few minutes, will start and run normally again, usually for the same 16-20 miles when it repeats the symptoms again. We've changed spark plugs and wires, distributor cap, rotor, new battery and wires, new exhaust system (not including catalytic converter), changed oil and oil filter, ran fuel system and injector cleaners throug


The owner probably rerouted the fuel line because like my 92 chrysler lebaron v6 3.0 the fuel lines keep seeming to come off and the clamps always break. I have replaced the clamps 5 times in a month and replaced filters 2 times in 2 months. The on ... 1995 Chrysler LeBaron

How to change the fuel filter on a 1996 chrysler cirrus 2.5l


... Chrysler Cirrus

My 1998 Chrysler Sebring will have ample fuel but while driving on the freeway it appears to be running out of gas. it will stall and or stop. I cannot start it right up it turns but it's doesn't appear to be getting any fuel. If I let it sit for 20 to 30 minutes it may start. Sometimes I can turn the switch back and forth multiple times while pushing the gas pedal to the floor and it may start. I have had a tune-up, and changed the fuel filter. Is it a fuel system problem or something else


Could be your fuel pump. ... 1998 Chrysler Sebring

1994 Toyota Camery 4 cylender. No key on fuel pressure. Changed fuel filter and now new fuel pump. Also, sevire intermittint bog on exceleration. 40 lbs pressure at idle, but 0 pressure under flow test with fuel guage.


Check and replace the fuel pressure regulator on the fuel rail ... 1994 Toyota Camry

Changing fuel filter on 2004 chrysler town and country


\015\012Remove or disconnect the following:\015\012\015\012Negative battery cable\015\012Raise the vehicle and support the fuel tank with a transmission jack.\015\ ... 2004 Chrysler Town & Country

Lacation of fuel filter for 2006 chrysler pacifica


... 2006 Chrysler Pacifica

I own a 2000 chrysler grand voyager 3.0lt v6 the problem is while driving it will stall and sometimes hesitate but all electronics stay on and function except for rpm gauge which will sometimes stick at present rpm,drop in rpm's or sometimes rise in rpm's with no change in speed i've replaced fuel lines,fuel pump,fuel filter,o2 sensors, and code read out still says those things are probable causes so i eventually had motor replaced 3 months ago and it began doing same thing..am i correct in assu


You could have a bad crank sensor , I believe its located on the belhousing of the transmission. If you have alocal garage with a scanner that gives live data they possibly could record the signal while driving and record it.Good luck ... Chrysler Voyager

I have a 1999 ford f250 v-10 superduty and when i drive between 0 and 2000 rpms it has a stutter and a miss and has no power and takes about a minute to get up to 30 mph. Even when it is above 2000 rpms if you punch it to the floor it will and almost dies. You cannot even go up a 2% grade incline unless you are going about 30 mph,if you are at a stand still and try to go it will bog out and not let you move. We changed the mass airflow sensor,fuel filter,fuel pump and fuel regulator. HELP PLEASE


Replace the throttle position sensor. ... 2005 Ford F 250 Super Duty

I have a 2001 Chevy blazer extreme, I have replaced everything. Fuel pump, filter, and fuel injection spider. None of these were the problem, when I turn the key to the on position, the fuel pressure gauge climbs upto 2 psi. After the pump cycles the pressure drops to 0. If I prime the system the pressure will climb to 10 psi, then promptly die off as the engine stalls out again. I have changed the pump twice just to find out the problem still exists. What am I missing? I have no engine codes th


Maybe the gasket theres clearly no pressure holding ... Cars & Trucks

Have 1992 chrysler new yorker engine stalls then if you let it sit a few minutes restarts change fuel filter seemed to fix problem for four days then samed problem occured


... 1992 Chrysler New Yorker

How do you change the fuel filter on a 2004 Chrysler 300 M


... Cars & Trucks

Change fuel filter 2008 chrysler 300 ltd - 300 Chrysler Cars & Trucks


... Chrysler 300

1991 chrysler new yorker fifth avenue had fuel tank, filter, and fuel pump replaced today, 2-28-2011, after sitting for two months. previously had injectors routinely replaced and all woked fine. in late 2008, i had the computer replaced because of the same symptoms as follows: the car starts up for two seconds then dies down to a rough idle as long AS I KEEP PUMPING THE GAS PEDAL. IT WILL NOT RUN ON ITS OWN IDLE. the garage that changed the original computer said that the anti theft was not wo


Have you changed the old gas? ... 1991 Chrysler New Yorker

2001 chrysler town and country V6 3.3L stalls after warmed up then won't start again....changed fuel pump, fuel filter, wires and spark plugs, MAP sensor and crank sensor....at a complete loss


... 2001 Chrysler Town & Country

I have a Chrysler 2003 mini van town and country, with 74,000 miles.Since when it was at 70,000, it started stopping at every stop signal,in slow motion when the engine is started. I got changed the fuel filter and the spark plugs. of no use.Now the mechanic recommends to change spark plug wires. I am not sure that it will help. Some times it runs perfectly all right with no problem at all . Any good suggestion ?


This happened to me. The valve that controls the air intake gets stuck which stalls the motor. I removed the air intake hose and wiped it clean using Acetone (nail polish remover). Its been running perfectly ever since.... ... 2003 Chrysler Town & Country
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8574 seconds