Having problems with your 2008 Chevrolet Malibu LTZ ?

Engine code po 496 - 2008 Chevrolet Malibu LTZ

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Chevrolet Malibu LTZ

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine code po 496 - 2008 Chevrolet Malibu LTZ


... 2008 Chevrolet Malibu LTZ

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

1997 Chevrolet s10 2.2L 4cyl. I run a dianostic computer on it said change exhaust sensor after cataletic converter an engine running lean! I changed it, after about 5 miles service engine soon light came back on,did the same now a code P1133,P0171,The 1133 heated oxygen sensor-Bank 1 sensor,0171 fuel trim bank one condition they say its the oxgen sensor before the catalitic converter! I don't want to replace all the sensors,it says one of the probable cause - failed HO2S11 (Bank 1 Sensor 1) hea


Engine is probably sucking air causing the lean condition ... 1997 Chevrolet S-10 Pickup

Pliz help after taking my car for engine wash they used water to wash the engine and engine Codes came up . 16502 P0118 Engine coolant temperature circuit-G62:high . 16497 P0113 Intake air temperature sensor 1 circuit-G42:high. 16486 P0102 Mass air flow circuit -G7 0:low input. 16622 P0238 Turbo super charger boost sensor (A) circuit : high. 16955 P0571 Brake switch sporadic (A) circuit : malfunction. 18000 P1592 Altitude sensor /boost pressure sensor :implausible ratio. 16706 Engine RPM sens


Not Good: The Expensive main computer brain sustained a short from either the heat of the solutions or leakage allowing fluids to enter the components. If after a drying period this still occurs; then the computer brain needs replacing. ... 2005 Volkswagen Touran 1.6

Collapsed lifter 06 Chevrolet Trailblazer 5.3L DOD engine. Cylinder #1 misfire code P0301 with lifter noise. Upon removing drivers valve cover I found no movement on the intake valve rocker. I have searched to see if this is a common problem on the DOD engines and there is very little information available. The lifter was collapsed completely. The dealer stocks new lifters but there is no advice as to replace all lifters or just the failed one. Is this a common issue with this engine?


If it is higher mileage i would replace all of them since you are already tore down to replace one. it is not a common problem.You could replace the one and never have another problem just never know. ... 2006 Chevrolet Trailblazer Ext

The check engine light on my 2005 chevy malibu keeps coming on and off sporadically. the car seems to be running fine. the only thing is that the fuel guage reads full all the time and then suddenly drops to empty and the fuel light comes on. diagnostic tests read the code p0455. i have replaced the fuel cap already. the other possible causes list 1. EVAP canister broken, cracked hose or not connected 2. Purge or vent solenoid defective or 3. vacuum leak at engine. i really just need to know how


... Chevrolet Malibu

Rebuilt my 454 engine, installed distributor with rotor at 0 TDC on #1 cylinder. Engine ran fine but ses light was on. Code was P1345-- disagreement between cam sensor and crank sensor. Scanner showed anywhere from 19 to 25 degrees advanced. Rotated dist. shaft. to ****** timing. Wouldn't run. Tried two teeth positions in either direction from original setting. Ever have a sensor go bad. The crank sensor is new, cam (on distributor) is not.


The ignition timing is not adjusted with a timing light or with the engine running, and to set the ignition timing follow these procedures.There is a mark or notch on the distributor housing that the rotor should be pointing to when the e ... 1998 Chevrolet K2500

Chevrolet malibu 2009 engine code p0010 - Chevrolet Cars & Trucks


... Chevrolet Cars & Trucks

1999 chevrolet 1500 with a 5.3 engine engine light on had check had a code in it po171 and po174 sey burning to lean on bank 1 and bank 2 what should i check for did pass inspection


Running lean on both banks? Check intake tubing/hoses for loose clamps and cracks/tears aft of the mass airflow sensor. Could also be a fairly large vacuum leak. ... 1999 Chevrolet Silverado 1500

1997 malibu / I had faulty code po440 . I Replaced Purge valve behind engine, canister valve solenoid, gascap from dealer, charcoal canister, smoke test. 1 week later check engine light on again wit


Diagnostib Test Code (DTC) P0440 is defined by SAE J2012 simply as "Evaporative Emission System".This code is what I call a "catch-all" code for the evap system. This is the code that sets when all the other EVAP codes do not a ... 2001 Chevrolet Malibu

Malibu engine misfire code 300, rough idle - 2006 Chevrolet Malibu


... 2006 Chevrolet Malibu

1997 malibu / I had faulty code po440 . I Replaced Purge valve behind engine, canister valve solenoid, gascap from dealer, charcoal canister, smoke test. 1 week later check engine light on again wi


... 2001 Chevrolet Malibu

I have a chevrolet silverado 1999. Started acting up a 2 weeks ago and been trying to fix it since. got all these codes from a modis; maf circuit out of range, maf circuit signal low, o2 signal low bank 1 sensor 2, o2 heater circuit bank 2 sensor 1, engine misfire detected. Tried new plugs, new wires, new MAF sensor. Runs rough if it runs, 300ish rmp and almost dies instantly when a load is applied. shakes almost violently when put into gear. Was told to check the timing and the catalytic


Hi, it is not a bad idea to check for a blocked exhaust. Not sure if you have done that yet as you were contemplating. If that isn't the problem, I suggest you check your fuel pressure regulator for a torn diaphram. This is a very common cause of ... 1999 Chevrolet Silverado 1500

99 malibu 3100 engine codes p0171 - 2003 Chevrolet Malibu


... 2003 Chevrolet Malibu

I have a 2001 Hyundai sonata. While driving home I started to lose power. I pulled over and the engine was running extremely rough like it was miss firing and halfway between the 0 and 1 on the rpms. Not sure if that is abnormal or not never payed much attention. Any ideas on what. Would be causing it. As of the moment it is not running. It turns over but does not start. And does anyone know if I can manually check the engine codes?


You can only check for codes with a code reader orProfessional Scan ToolAfter 30 years of these systems, it is had to believe peopleknow nothing,how is thatNormal,abnormal,don't pay attentionWhen I spend $40,000 fo ... Cars & Trucks

Sat, sometime in January cel appeared Sun Engine steaming, upper hose clamp on engin was loose at engine connection cyl 1,3 side tightened clamp, washed away antifreze Mon read codes, engine misfire cyl 1,3 assumed something to do with antifreeze leak, cleared codes. 60 miles cel, same codes, replaced sparkplugs, swapped cyl 1,2 wires, cleared codes. 60 miles cel, replaced coil pack, air filter, ysed can of injector cleaner, cleared codes, 160 miles cel, used another can of injector cleaner. 160


I am sorry to tell you this but sure sounds like a head gasket getting weak. By year a model I am figuring you have a EJ-25 2.5 boxer motor. Not easy to really do plug test but are your plugs coming out with moisture on them? Check oil for water also ... 1998 Subaru Forester

My 1995 subaru legacy lsi cuts out when I rev the engine around 1 rpm. Plus the check engine light is on. I took it to the dealership and they couldn't fix it, but they got a code from the check engine light. The code is p0441, it says it is an evap system leak but where could it leak causing the engine to cut out at 1 rpm? Basically when I rev the engine around 1 rpm it will want to cut out and then it dosent, as if you pushed on the gas and then took your foot off the pedal repeatedly.Please h


... 1995 Subaru Legacy

But the check engine light came on yesterday. I checked the car using a OBD scanner, and it found 3 codes for the car: P0012- Camshaft position timing over retarded bank 1 P0301- Cylinder 1 misfire detected P0327 - Knock sensor 1 circuit low bank 1 or single sensor. After I checked the codes, (I did not erase any code) the check engine light went off . I do not notice any problem in the performance or running of the car and am generally not seeing any differences like fuel smells, lea


I think your idea is wrong. A fault code indicates a problem, though, cars can be used normally, but the problem is there, need to be addressed.or you can ask the 24 hrs live technical support http://www.diyobd2.fr/service/ , they will like to help y ... 2002 Mazda Miata

The check engine light came on yesterday on my 2002 Mazda Miata LS with about 140k miles on her. I checked the car using a OBD scanner, and it found 3 codes for the car: P0012- Camshaft position timing over retarded bank 1 P0301- Cylinder 1 misfire detected P0327 - Knock sensor 1 circuit low bank 1 or single sensor. After I checked the codes, (I did not erase any code) the check engine light went off . I do not notice any problem in the performance or running of the car and am general


... Mazda Cars & Trucks

1999 chevy malibu 3.1 rough idle only win car is in park not as bad win its in drive did a full tune up no check engine light on 0 codes has lots of power I just don't it i check for vacun leaks none found at this time ran some fuel injector cleaner no luck still the same fuel pressure is fine map sensor and tbs are all working had all sensor tested cleaned out egr


Clean your iac (idle air control) and then replace ignition plug wires and clean off terminals on coils before putting new wires on, use scotch brite pad or equivelent. could also be intake gaskets leaking, did you notice 1 or more spark pl ... 1999 Chevrolet Malibu

Chevy engine code p0014 - 2008 Chevrolet Malibu


... 2008 Chevrolet Malibu

Chevy engine code p0013 - 2008 Chevrolet Malibu


... 2008 Chevrolet Malibu

For my 2002 audi a4 quattro .0 litre I keep getting check engine light. The code is P0441 - Evapporative emission system incorrect purge flow. Also says warm up catalyst efficiency below threshold. Fuel system 1 cl Fuel system 2 cl calc load (5) 9.4 ect (5) 102 stft b1 1.6 What does all this mean. What is my problem. Thanks George


... Audi A4

My 2000 chevrolet 3500 454 cranks but wont start,when cranking it will it starts and runs for 1-3 seconds and dies,the fuel pump is working replaced 2 years ago with dealer unit. About a week prior I had a check engine light code P0125.


... Chevrolet 3500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2480 seconds