Having problems with your 2008 Chevrolet Malibu ?

How to replace 2008 chevy malibu third brake light

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2008 Chevrolet Malibu

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace third brake light on chevy malibu maxx 2004


... 2004 Chevrolet Malibu Maxx

How to replace 2008 chevy malibu third brake light


... 2008 Chevrolet Malibu

I have a chevy avalanche 2005 Z71.All rbake lights work esxcept the third brake light. I replaced the third brake light with a new but it still does not work. Is there a separate fuse for this and we


... Cars & Trucks

My 1996 chevy cavalier has no brake lights or blinker lights. I replaced the multifunction switch on the column and the brake stop switch. Still no brake or blinker lights. Third brake light doesn't work either. Headlights and marker lights work fine.


Take a volt meter to the sockets and see if you get any voltage. if you don't, try a continuity test on the socket and see if there are any shorts, blown fuses are good indications of shorts. if you have no voltage and no shorts, you have cut wires s ... 1996 Chevrolet Cavalier

The primary brake lights dont work on my 2006 chevy silverado but the third brake light does. I replace the turn signal switch and checked all fuse's, relays and the brake light switch.


May be it is unpluged in the back under the bed ... Chevrolet Silverado 1500

2007 Chevy Malibu--Traction Control light and check engine light come on. The information panel states "Service Traction", "Engine Power Reduced". First the right wheel bearing was repaired and back brakes replaced. Then driving a week later happened again. Then had the throttle replaced. Worked for about a week and came on again. I did notice that when I tightened the gas cap the check engine light turned off. What could be the problem? I'm already $700 dollars into this problem and the d


... Chevrolet Malibu

2009 chevy malibu third brake light in rear window not working but backup, turn signals and brake lights work. what do I do to fix it?


... 2009 Chevrolet Malibu LTZ

Replacement of Third Brake Light Bulb on a 2006 Chevrolet Malibu


... 2006 Chevrolet Malibu

I replaced my low coolant sensor on a 97 chevy malibu but light stays on. i disconnected connector...light went out....i jumpered...light came on...old sensor shows 0.L when ohmed..


... 1997 Chevrolet Malibu

I have no brake lights in my tail light lenses. High-mount tail light brakes work, but no brake lights in both tail light lenses, i know its not the brake switch, because I have the third brake light bulbs. I have tail lights, but when brakes are applied, nothing works but the third brake light bulbs. I replaced all four brake light bulbs, but still nothing.


The circuit to the taillight brake bulbs goes through the turn signal switch. Sometimes the switch can cause this problem. ... 1994 Pontiac Firebird

How to replace bulb on chevy malibu maxx third light


... 2007 Chevrolet Malibu Maxx LTZ Hatchback

2002 Chevy Blazer, rear brake lights do not work but the third light above the window does. Replaced bulbs and still not working I have the same problem got a fix it ticket the other.  Did you guys get this fixed what was the solution.  Thanks in advance.


Trace the wiring as it comes from the laft and right brake light. May have to remove the brake light covers. Sounds like a crimped or shorted wire leading to the brake lights, possibly a loose or broken ground wire. One of the wires leading from t ... 1998 Chevrolet Blazer

2002 Chevy Blazer, rear brake lights do not work but the third light above the window does. Replaced bulbs and still not working


I had a similar problem and when i went to the auto electric place the guy said its a brake switch next to the brake pedal which is not working. He took it out and fixed it. Now its all fine. ... 1998 Chevrolet Blazer

I have a 2001 Chevy Malibu. A couple of days back the 'BRAKE' warning lights went on (with a continuou beep sound) and I drove it to Goodyear for brake inspection. The mechanic said that the calipers are worn out and he needed to change the calipers and resurface the rotors. This is the quote he gave me, 2 Calipers - 148.52 each Labor cost for replacing calipers - 157.50 Resurface Rotor- 52.50 Fluid change- 19 Shop supplies - 19.95 Total - 543 + taxes. Is this a reasonable quote. Th


Brakes, unfortunately, are an expensive job.\015\012Most garages charge around $80 (U.S) per hour.\015\012I would advise a second opinion, and here is why. I see calipers on e-bay for under $50. each. Rotors are generally replaced and not ... 2001 Chevrolet Malibu

The battery went dead after replacing headlight bulbs and when starting again the dash warning lights for ABS, Anti-Skid, Brake and engine management light stays on - it feels ligjht the transmission is stuck in second or third gear - i suspect a fuse went 0 any idea which one?


... Cars & Trucks

2009 Chevy Malibu; Instrument lights flicker when adjusting the height of the passenger seat. Does not happen every time. May only occur when headlights are on. I just had a brake sensor replace and the BCM board replaced for traction control problem. May not be related.


... 2009 Chevrolet Malibu Hybrid

2004 chevy malibu third brake light works but other two do not. tail lights work like they should as well as do the turn signals. please advise any solutions or thoughts.


Did you check the light bulbs .remove bulb and check the contact points and see if melted if so replace bulbe ... 2004 Chevrolet Malibu

Replacing rear brake light on 2004 chevy malibu classic


... 2004 Chevrolet Malibu

How do you replace the third brake light on 2007 malibu maxx


... 2007 Chevrolet Malibu Maxx LTZ Hatchback

Third brake light wont work checked voltage at female connector saturday had 12+ volts now .003,owners manual does not show fuse for just third brake light iam assuming #12 st/lp might be correct fuse,left and right brake light both work.tried lighting with separate 12 volt power source no luck any suggestions chris...2002 chevy trailblazer


If you have voltage you next have to have a ground please check that next, ... 2002 Chevrolet TrailBlazer

Rear brake lights are not working 1998 chevy malibu. Brake light in the rear window works, the rest do not. Does this mean the switch on the brake pedal is ok? The fuse is fine. None of the brake bulbs light and they all seem OK. How are these integrated with park lights-explain please. How are the bake lights conected to the brake light in the rear window and how does this one work and the other brake lights do not.


See if you have power going to the break light. it may be bad bolb.or broken wires ... 1998 Chevrolet Malibu

2008 chevy malibu third brake light not working


Stop Lamps\012\012\012\011 The body control module (BCM) is responsible for controlling the stop lamps. When the driver presses the brake pedal, the BCM will receive a signal from the brake pedal position sensor. The BCM then supplies battery pos ... 2008 Chevrolet Malibu

Replace third brake light bulb on 2009 malibu


... 2007 Chevrolet Malibu Maxx LTZ Hatchback

Oil light comes on when braking and temp gauge goes up to halfway - 1999 chevy malibu - already had oil switch changed- how do we check oil pressure to rule out oil pump replacement, what could be other causes?


Just dealing the with same problem. You need to take the car to have the electronics systems tested. Trust me it will save you a lot of time and frustration and it pays for itself because you don't end up guessing at parts. The oil pump can be tested ... 1999 Chevrolet Malibu

How do I replace the brake light switch in a 04 chevy malibu classic?


There is either a clip or a nut holding it to the bracing under the dash against the upper part of the brake pedal. Unplug the connector and swap out the switch. Its relatively easy. ... 2004 Chevrolet Malibu
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8536 seconds