Having problems with your 2007 Suzuki XL-7 ?

2008 suzuki no heat - 2007 Suzuki XL-7

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Suzuki XL-7

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have 1 1996 Suzuki JLX 1.6 16v and cannot turn off the heat. When I put the heater control to cold there is still heat coming out of the vents. It is set for outside airflow not recirculate and is set to the coldest setting. Cam anyone advise please what could be the cause. Thanks John H


First of all check the coolant level and also check if the refrigerant level in the ac is not low.If its low or in case leaking then car will give hot air.Get the ac pressure test done.his will confirm if the refrigerant is low or leaking.It can be ... 1995 Suzuki Samurai

My Suzuki Alto (year 2000, 1,0 ) does not run well. I get brownish/black exhausts and the engine runs uneavenly. When i do not use the gaspedal the engine makes short speed-up and down, speed-up and down all the time. When in gear and medium speed it does not run eavenly. A test has shown exhaust-recirculation fault and I have tried changing the EGR valve. No result. Same problem


... 2000 Suzuki Swift

Clicking sound coming from right rear area next to 3rd row seat whwn rear heat fan set to 0,1,2 or 3..


... 2004 Chevrolet TrailBlazer

Suzuki vitara 2002 petrol 4 cylinder engine light keeps on flashing and ignition coil no 1 heats up and vehicle cranks but does not start


U need a diagnostic tool to check if there is any error codes and take it from there ... 2002 Suzuki Vitara

My 2005 dodge neon sxt has suddenly had an oil leak.... a major one at that. The check oil light never came on and the thermo stat always reads from 0 to about the 1st line after the cold area.... its over heated 1 time and the temp was normal.... after checking the oil it had almost none. As far as i can tell the firewall has oil sprayed on it all the back lower part of the car has oil the tranny has oil dripping off it from front to back..... im only at 78k miles..... dang what a clunker an


... 2005 Dodge Neon

I have a 1997 Ford Taurus right-hand drive (residing in Malaysia). Car labeling says GL but engine cylinder head says "DURATEC 24 Valve V6" so not sure which Ford engine it is. Prospective problem is with oxygen sensor. Diagnostic codes (run twice) are: P0135- Upstream heated O2 sensor heater circuit fault (Bank 1, Sensor 1) P0155- Upstream heated O2 sensor heater circuit fault (Bank 2, Sensor 1) P0171- System Adaptive fuel too lean (Bank 1) P0174- System Adaptive fuel too lean (Bank 2) P070


Hello! I am sending two diagrams...#1 is O2 sensor location and #2 is a vacuum diagram...Before you spend a lot of money replacing O2 sensors lets eliminate other possible causes of heater circuit failure...O2's have heater circuits to bring them up ... 1997 Ford Taurus

I just purchased a 92 honda prelude. the car temp for the most part was fine until u step on it a little bit then she starts to over heat. i guy told me to replace the cooling fan sensor and i did. didnt fix it. then it started over heating again, i turn on the heat in the car and it instantly dropped. after cutting it off it started to increase again. i went and brought a themostat took the old 1 out and place the new 1. it seem it got worse. by me turn on the heat and seeing the temp instant d


Is the thermostat installed correctly? There is a bleed hole on the thermostat with a rivet in it. That should be up.\015\012 Is the coolant level topped off? There should be a bleed screw on the manifold if I remember correctly. Honda's are very sen ... 1992 Honda Prelude

After receiving the error code p0036, (Heated o2 sensor 1 Bank 1) I replaced my o2 sensor, Cleared the computer and drove it for a day in a half.... Then the Check Engine Light came on again. After checking the code for that problem it came up P0046 The OTHER o2 SENSOR, (Heated o2 sensor 1 Bank 2) so I thought that maybe when one goes bad, they both go bad... So after replacing the SECOND O2 Sensor I again cleared the computer. Again after driving it for a day and a half the **** check Eng


... Cars & Trucks

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

My 1998 Buick Park Avenue's heater only blows heat on the passenger side. Buick Dealer said it's a $1,200 part; said it needs a new heating/cooling instrument panel. They "tricked" it into opening the door - we're getting heat now. Shouldn't I just have the dealer "trick" it twice a year (season change). It only cost me $60 to temporarily fix it and find out I need a $1,200 part. Your opinion is what? Find a new mechanic?


Well obviously you do not want to put a 1200 dollar part into a 900 dollar car. When the warranty is up, stay away from the dealer they are only there to hurt you until they can sell you another car. Go to a shop which does auto air and radiator work ... 1998 Buick Park Avenue

Hi there... ive got a mondeo mk2 LX 1997 im trying to fit leather/heated seats out of a gia x model,im not really bothered about them being heated so not interested in wiring that side of things up.under the drivers seat there are 3 wire plugs gessing 1 for air bags 1 for seat motor power, and the other for heat is this right? all i need to know is which plug is which? thanx scott.


... Ford Merkur XR4Ti

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

I have Grand Cherokee 1999 V8 4.7 220700 mphproblem: obd Give P 0505 1. Start good rbm at 750 as it heat rbm go up till 1500 2. When the heat come to middle oil pump fall down for a second and come back in middle quickly 3. Sudden die anywhere and all gauges down even when contact on 4. Give 3 signs: a. key original sign b. check gauges sign c. fuels pump sign. 5. After 15 min. These signs disappear all the gages go up normal the car normal start up. fix done: 1. Change iac motor 2


P0505 - Idle Air Control System Malfunction The PCM attempts to control\015\012 engine speed during KOER self-test. The test fails when the desired rpm\015\012 could not be reached or controlled during the self-test. IAC circuit \015\012open \015\0 ... 1991 Jeep Cherokee Briarwood

Heat Hello I have a 2000 dodge Stratus. One of the problems i have at the moment is the heat. 1. it only works on high it used to blow out heat but 2. Heat no longer comes out. The the thingy that turns hot to cold still works cuz when I turn it to cold its a hole lot colder and there is a more flow. Friend had me pick up a thermostat. But would that also explain the blower only working on high? What is my problem?


... 2000 Dodge Stratus

2002 Suzuki XL7 2.7 V6 4wd. Code reader says bank 1 sensor 1 o2 sensor us bad. This vehicle appears to have 4. Which side is bank 1 and which is sensor 1.


Itsone one cloest to the front of the vehicle thats how there counted ... 2002 Suzuki XL-7

Bank 1 lean fuel trim , heated 02 on bank 1 senor 1 low volt and bank 2 senors 1 low volts according to the scanner there not and tere all working w/ the same amount of volts and there all moving together, this is a 1996 chevy surb w/5.7l


Throw scanner in teh bin and use old motto ,if it works leave well alone ... 1996 Chevrolet Suburban

No heat 1992 eldorado blows cold air, not hard and no heat. i drive for 45 mins. then a little heat for 1 min. then back to cold air.When i put the "heat" on, the driving temp fluctuates from 250 down to 190. A ny suggestions? Thanks


Sounds like heater core change it probably your reason. ... 1992 Cadillac Eldorado

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

2000 GMC Sierra 1500 no heat, AC works, fan speeds 1,2,3 inoperative, speeds 4&5 work so far. But NO heat.


... GMC Sierra

I have a 95 Buick LeSabre Limited that will not stop blowing heat. Only when I turn the car off does it stop but when I turn it back on within 1 minute it is blowing Heat at full force. It has climate control but none of the buttons will stop it nor can I get the air to work, it is always heat.


Make sure you dont have a vacuum line off under the hood, going into the firewall, or to a control valve that shuts off the hot water to the heater ... 1995 Buick LeSabre

I have a 99 jeep Cherokee and it gets very hot often. i have 3 elect fans in it (2 that **** in, 1 that blows through). i do not run a thermostat for max water flow, i added a new radiator (The Heat Buster), i also removed skid plate under front to allow more air flow. i placed 2 intake air vents on top of hood mounted backwards to allow heat to be pulled out on engine compartment (heat rises). yet it stills runs hot. this problem has been on going and getting worse. it started only after i re


I think you may be on the right track. If the timing is too far advanced, the engine can overheat. The computer uses the crank sensor input to time the engine. Let us know if it still over heats with the new crank sensor in. ... 2004 Jeep Grand Cherokee

1997 Chevrolet s10 2.2L 4cyl. I run a dianostic computer on it said change exhaust sensor after cataletic converter an engine running lean! I changed it, after about 5 miles service engine soon light came back on,did the same now a code P1133,P0171,The 1133 heated oxygen sensor-Bank 1 sensor,0171 fuel trim bank one condition they say its the oxgen sensor before the catalitic converter! I don't want to replace all the sensors,it says one of the probable cause - failed HO2S11 (Bank 1 Sensor 1) hea


Engine is probably sucking air causing the lean condition ... 1997 Chevrolet S-10 Pickup

How do you change oxygen sensor bank 1 sensor 1 & bank 1 sensor 2 they are b4 the catalytic converter.what will need to do this job.and are they the same sensors one is $179.00 & $69.00.if to is to hard of a job stop me and i will go to a shop.thanks 2002 suzuki xl-7 4x4 2.7L


Do not buy the 1 for 69.00 it more or less a universal wher u have to rewire it buy the 1 for 179. and it takes a 7/8 wrench and bank 1 is the 1 on drivers side up by manifold not by converter ... 2002 Suzuki XL-7

No heat I Have 98 cavalier i've change the heater core due to a leak in the core there was heat coming out of it but but it was leaking on the inside carpet and t-stat and a octopus hose to also a leak but it getgets heat only on the both sides of front vents I notice that my switch only runs on 2, 3, and 4 but no on 1 so i want to replace th e resistor is there any else i can do ?


Having done this job on a cavalier myself I feel your pain. Check the hoses that run to the vents, I bet they came apart on the center vents. ... 1991 Chevrolet Cavalier
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8615 seconds