Having problems with your 2007 Nissan Qashqai 1.5 ?

How to change rear passenger signal light cover on qashqui 2007

\015 Someone smashed the cover for the side rear and i need to replace it how do i go about that\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Nissan Qashqai 1.5

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to change rear passenger signal light cover on qashqui 2007


... 2007 Nissan Qashqai 1.5

I have a 1999 Jeep Cherokee Sport. The front passenger running light and the rear passenger running light do not work. I have changed the bulbs to no avail. The rear passenger brake light works when the pressure is applied to the brake pedal but doesnt work when my head lights are on. also the front running light blinks when my signal is on but also doesnt light up when my headlights are on... I need to pass inspection any solutions?


Deffinately an earth fault. You could get a mechanic to check this or just add new earths. ... 1998 Jeep Cherokee

Changed multi function switch, bulbs, and passenger side rear light assembly (reverse, blinker, brake light). Everything works except the rear passenger side turn signal but the front passenger side is blinking fast. What is the problem?


You have a bad connection at the rear passenger side turn signal. It is either the connection is corroded or a wire is loose on the ground side of the circuit. ... 2006 Dodge Ram 2500

1997 Ford Light Duty F-250 Problem: Passenger rear brake light / signal light Brake light is intermittent. Signal works most of the time. Emer. flasher is intermittent. Center & left side work fine. I changed the lamp, checked and cleaned the socket. It works for a while then no brake light but turn signal works. While working on it over several days everything would work then no brake Maybe no flasher. Someone told me last month it was out but when I checked everything seemed fine??


It appears that you may have an intermittent earth connection between the globe sockets and the vehicle body.\015\012First, check how well the metal base of the globe fits into the socket. If it is a bit loose remove the globe, squeeze th ... Ford F-250

Passenger front signal does not work; rear passenger signal flashes faster. Need a bulb? Fuse is still good.(15amp #11) Recently replaced both license lamp bulbs, license lamps do light up. Did not have signal problem until after the license bulbs were replaced. If I do need a bulb, do I simply screw the signal lens cover in the lower front fascia off and replace it? Or do I need to remove the entire fascia? P.S. Driver side signals work fine.


Yes it's a bulb. Open the hood and remove the phillips screw. Then carefully wiggle the fixture out to reveal the bulb and plugs. ... 1992 Acura Integra Hatchback

2005 impala rear (passenger side) blinker and brake light wont work... the parking lights work fine. I changed the turn signal light figured that was the problem since the front passanger blinker works just blinks very fast. Any ideas? The 3rd brake light and rear driver side brake light and blinker work just fine


... Cars & Trucks

I have a 2005 Chevy Colorado. The right rear passenger tail light will not come on, I have changed bulbs, and I have changed the entire lense assembly.Everytime you put your foot on the brake the right blinker arrow lights up and you hear a click under the dash. Brakes and turn signal work. I am lost at this point.


I have exactly the same problem with my 2004,,,i add the brake switch changed and it still the same .Both arrow in the dash are ON ,,time too time when i turn LEFT at 90% ... 2005 Chevrolet Colorado

I need to know how to get the tail light lens cover off to change signal bulb


Open hatch and on inside of body where the lens is are two horizontal screws going into the lens, remove them and pull the lens towards the back of the vehicle carefully. Good luck ... 2006 Dodge Caravan

I have a 2001 1500 4wd that the passenger rear taillights do not work brake lights do and the turn signal does not.. nor on the front but the indicator turn signal in cab does... changed bulbs and board


... 2001 Chevrolet Silverado 1500

Front driver's side signal light does not work. Changed the bulb and it still does not work. The driver's side rear works and the passenger side works (front and back). Also, when the signal arm is pushed down for the left turn it clicks faster than the right turn.


When a bulb fails on one side of the indicators the other bulb, same side, flashes faster, SO.you have just answered the question yourself,as you have replaced the bulb with a new one, the contacts for the new bulb are at fault. ... Hummer H3

Jeep88 Turn on park lights and only the Front left comes on. The rear park lights never came on.when you turn the park lights on the right front turn signal also goes on. Changed headlight switch, nothing changed. Fuses are good and stay good. The brake lights work but when you put the brake on, the front right turn signal goes on. After I changed the headlight switch now the turn signals don't work. HELP???!!!


Try making sure all the grounds are good ... 1988 Jeep Comanche

No brake or signal light, passenger side rear


... 1994 Chevrolet Suburban

No rear drivers side I have no tail lights nor signal light. Bulbs appear to be good. 4 ways flashers work ok as do brake lights. I checked the internet looking for the flasher and found comments that indicate the 2008 Ford Explorer does not have a flasher and that signal light flashing is controlled by a Junction Smart Box .. Is this a sealed unit or can I buy some part to repair my signal lights so they flash properly . Everything works on the rear passenger side as well as the front


... 2008 Ford Escape

How do i remove the plastic cover to change a turn signal bulb on the rear light


The taill light bulbs are replaced from inside the trunk. You'll need to pull the carpet away from the area of the tail light. You'll see the wing nuts holding it in place. Remove those nuts and the unit will pop out allowing you replace the bulb. ... 2005 Pontiac Grand Prix

06 jeep commander passenger rear brake and turn signal work, tail light does not work. Tried changing bulbs.


... Cars & Trucks

Both my back up lights on my 2004 Jeep Grand Cherokee are not working when the vehicle is put into reverse. The turn signals and brake lights work, as well as the parking lights. About four months ago, I discovered that water had been sitting in the passenger side rear light fixture and had corroded the metal contacts, so I replace the entire lamp. I cleaned up the sockets and the rear light on the passenger side still did not work. However, the driver side back up light was still working. About


If you are sure it is not corrosion at the bulb sockets then it could be the back-up switch at the transmission. ... 2004 Jeep Grand Cherokee

2005 pontiac montana SV6, last 6 months blowing the same rear drivers signal light( fishy ) so i cleaned the connection and put dielectric grease, problem solved( i thought ). recently the "service park lamps) " warning turns on with no other issues. then one day weeks later both signals (rear is also brake light) front and back stop working, however 3rd brake light still works, light in the van flashes real fast both sides. What i've tried... changing fuse #20 10a fuse(park lamps), blown- repla


Never replace a circuit with a fuse that is stronger than what is asked for as you will then burn the wiring.i would get my hands on a wiring schematic and trace the problem with a tester.once found replace the bad wiring or relay with the right part ... 2005 Pontiac Montana SV6

1984 BMW 318i My rear passenger blinker light stays on without flashing. Inside the car witht he lights on, the right turn arrow is lit up as well. When kicking my turn signal on the driver side, the rear light flashes fast as if to signal an out bulb. I just put in new front blinkers and side parking lights and then the problem occurred. Any ideas?


... BMW 318

I have no running light(night lights)on the left front or left rear..iv change the bulbs the fuse and they still wont work..the rear light comes on when i aply the brake and the turn signal comes on in the front when i use the turn signal but the night running light will not come on..right side ones work fine no problem there..please help


... 1996 Volkswagen Jetta

Rear lights work when turned on. No brake lights or rear turn signals. Front turn signals flash more rapidly. Replaced both rear bulbs with no change


If you're getting a more rapid flash in the front you have a possible blown relay to the back. Check fuses first and see if those are out. ... 1996 Chevrolet K1500

WHEN I TURN THE TURN SIGNAL ON TO THE LEFT OR RIGHT THE 4 WAYS BLINK ON THE DASH AND ON THE FRONT BUT THE LEFT REAR LIGHT DOES NOT BLINK WE HAVE CHANGED THE BULB . ALSO WHEN WE HAVE THE SIGNAL LEFT OR RIGHT AND STEP ON THE BRAKE THE 4 WAYS SHOW ON THE DASH AND ALL TURN SIGNAL LIGHTS COME ON THE LEFT REAR BULB DOES COME ON WHEN YOU STEP ON THE BRAKE . WE HAVE CHECKED ALL THE GRDS.


Clean the sockets and put in a new bulb the blinker and stop bulb have 2 different functions one may work while the other dosent ... 1994 Chevrolet C/K 2500

Hi, my car NISSAN PRAIRIE (Liberty) this with certain problems, accelerating the car stopped the motor of 3000rpm is not, is not in progress of 120km / h, cut to 90km / h, when the change in rear hitch "R "rear lights do not light up, no signals and the rear lights of the gearbox (automatic P, R, N, D) is also on the panel no longer light up. I went to a workshop and made the diagnosis that computerized accused 3erros which are: P0115 COOLANT T SEN CIRC, P0650 MIL / CIRC P1110 INT / V TIM-CON T


... Cars & Trucks

Water recently got into the rear light assembly of my 1993 Honda Accord EX. I realized this when my 'brake lamp' warning light came on...I removed the water and cleaned up the sockets. The signal light is working and the running light works when I turn on the headlights, but I can't get the brake lights(passenger side rear, trunk hood or back window)to work on the side that got wet. The only part that doesn't light is the filament that lights when the brakes are applied. Besides drying out every


Did the water short the system out and blow all the bulbs? ... 1993 Honda Accord

I tried changing the license plate bulb on my 2001 ford focus and I cannot pop the cover back in. I also broke my license plate cover in the process. Now none of the lights in the rear of my car are working at all. Could I have busted a circuit while attempting to change the light.


Sounds like something is connecting to the car body, I would inspect the bulb you changed make sure the metal clips or wires are not touching anything. ... 2001 Ford Focus

Having trouble with a 2010 tiguan . low beam right waring came on as well as rear left signal. I changed the front low beam warning still there and light doesn't wok. What is my next step?


Check grounding on the fixture. Usually the fixture only gets the 12v+ from switch. The 12v- comes from the fixtures mounting or it has a black wire that comes off of fixture and goes to ground. ... 2010 Volkswagen Tiguan
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.0374 seconds