Having problems with your 2007 Land Rover Range Rover Supercharged ?

My 2007 Range Rover is telling me to "check spare tire pressure". The spare tire pressure appears fine. How is it monitoring the spare tire to know that I need to check it anyway?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Hi - the spare tyre can loose pressure over time - I was told it detects this through a sensor to the computer system. You need to top up the pressure if it needs it and then either take it to a main dealer to take the warning light off or I was told you need to drive at a constant 50mph speed for 20 mins and it should take the pressure light off automatically ! It didn't work on my 07 RR so the dealer did it in the end free of charge.
Sensor in tire on wheel.
Repair Help & Product Troubleshooting for 2007 Land Rover Range Rover Supercharged

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My 2007 Range Rover is telling me to "check spare tire pressure". The spare tire pressure appears fine. How is it monitoring the spare tire to know that I need to check it anyway?

Hi - the spare tyre can loose pressure over time - I was told it detects this through a sensor to the computer system. You need to top up the pressure if it needs it and then either take it to a main dealer to take the warning light off or I was tol ... 2007 Land Rover Range Rover Supercharged

2006 Jeep Liberty Limited spare tire light and TPM monitor overhead both show a low spare tire pressure. I have checked pressure and it is at 33 pounds. I let air out and refilled to 33 psi and did not help. The overhead monitor says spare pressure low and also check TPM monitor. And again light in dash is on too? Any suggestions?

... Jeep Liberty

I just recently bought a 06 chevy suburban and it didn't have a spare tire on the winch because someone cut it. The jack and tool used to lower the winch is not present also. I just bought a new tire winch which I'm going to install I just need to know where to purchase the tool used to lower winch? I need help to determine whether the shaft to the key hole also needs to be replaced because it is not connected to the existing tire winch.

That's going to be a dealer item unless you call around to the junk yards and hope fully they\015\012might have one laying around\015\012\015\012hope this helps you\015\012bob ... Chevrolet Suburban 1500

Have a 2013 Honda CRV and need to know how to turn off tire pressure monitoring system as I have installed new winter tires on new rims which don't have tire pressure monitor value stems

... Honda Cars & Trucks

I need the information for replacing the spare tire. Tire size and such. I know it is a 15" 5 lug tire but they are telling me I need more information. It is for a 2003 Toyota Corolla LE

There should be a sticker with that information on it about your tire size, inside your drivers door jam, glove box or trunk..\015\012Hope this helps yu ?? ... 2003 Toyota Corolla

I need to know if I need any special tools to remove and replace the ac pump on a 2000 gmc Z71 sierra with a 5.4 ltr motor. Also it would help to know the best way to get it out. It appears to look like the way to go would be to remove the passenger side front tire and inner fender well and approch it from the lower side rather than comming down from the top. ????????

I dont think so but u have the right idea about removing it from truck go boy go ... 2000 GMC Sierra

Need to know where I can get a spare tire crank to lower spare tire these are usually located on top of the radiator attached by two clips in engine compartment. Who would sell them?

With some luck you can get one at your local junk yard for a few bucks ... 2000 Ford Expedition

Alignment problem I just had new tires put on my truck (153,000 miles) and had them check the allignment while it was there because my old tires were wearing like it was out of alignment. I wont bore you with the numbers, but the caster (both wheels), camber (both wheels), and left toe were all pretty far out, the right side toe was out a little but still within tolerable limits. I know I need new ball joints and tie rods ends, but I need some assistance on which parts to replace to correct thes

If the tie rod ends and ball joints need replacing do these first before getting the tracking done. After replacing these don't assume it will correct the alignment automatically as you would have disturbed the settings while changing them so getting ... 1997 Dodge Dakota

At first, the light to let me know about the air in the tires turned on, and after a couple od days I took it to the car dealer where I bought it..The tires were check and was told that the light will turn off after a while.7 days later, I got a flat tire,the back tire on the passenger side, so we took the car to get the tire fixed, and 3 days later onother light went on, I think TPMS,well, we took the car to the dealer, and now they told us the car needs sensors, and we have to paid for it,caus

Contact the place where the tire was changed and let them know that they damaged the TPMS sensors. If they have a grain of integrity, they'll make it right. ... 2008 Hyundai Sonata

The tire pressure monitor was working ok. After i pumped air in the tires I decided to reset it. Now the yellow light of tire presure is on and I have an alarm that the tire system need to to be check. When I ask the car to recheck it makes the claxon (honk once) and the I have to wait. I am sure it is a software problem. Any idea how to reset it.

Most of the ime after recalibrating,or reseting or changing the ar pressure,the system will calibrat itself after a while give it about 20 miles or so to see if it will reset,if it does not a garage can make it reset with a system monitor. ... 2010 Chevrolet Camaro

Brake lights dont work, replaced switch, checked for power, power to switch, power to fuse, checked wiring to back end, all appears to be good, put power to white wire, no brake lights still, i need some help please, anything i can check, does someone know were to find a wiring diagram, should i check the direction switch, thank you

You hit it on the nail, you have check every thing we would have checked here at my repair shop, it's going to be the turn signal switch, as you now the brake light circuit run's through it and more then likely your center top brake light works.Bad s ... 1991 GMC Sierra

Need to check spare how do you let the spare tire down on a 1999 ford e-150?

... 1999 Ford Escort

2004 Tahoe- Check Tire System Monitor- RRRing vibration/noise

Chevrolet uses tire pressure sensors for the system, check the tire pressure in all tires including spare and they should be set to about 38psi. If any of the tires are low it will trigger the abs because the abs system goes off wheel speed and a low ... 2004 Chevrolet Tahoe

Spare tire location in a 2003 expedition? Have a flat and need to know where the spare and jack are located.

The spare is located under the truck in the rear behind rear axle, it is dropped down with a cable whench ... 2003 Ford Expedition

I have a 2005 chevrolet tahoe. The check airbag light is on, the check tire monitor light is on, and the cruise control is not working. The small fuses apear to be good. I am assuming one of the bigger fuses is out. Which one would it be. Or would I need to have them tested? I would test them to find out myself but I am on vacation...

... Cars & Trucks

I don't have a problem, just need to know how to get the spare tire out from under the car if I ever need it.

Look at the floor board in the center near the dash. There should be a plastic cap. Remove it and get the tools from the back then unscrew. ... 2008 Dodge Grand Caravan

I just had an oil change and my air filter changed out 3 days ago. Tires rotated and pressure checked 4 days ago and when they checked pressure during oil change said they said it was way too high and let out air. Don't know if they were right anyway after that. Filled up with gas last night and went to work this morning, everything fine. Go to go to lunch and my engine light came on, cruise light blinking (tried reset in case I did hit it. Didn't work), and my vehicle dynamics control "off" lig

... 2006 Subaru B9 Tribeca

Not firing R&R alt. R&R voltage regulator, R&R soleinoid getting fire on hot side of soleinoid but is not completing circuit on negative side of soleinoid still unable to get fire @ plug tired of just replacing parts need to know proper diagnostic procedure was told to try ignition control module but dont know how to check it . THANKS

Take it into someone that noes what there doing unless you have money to burn, ... 1985 Dodge Ramcharger

I have a 06 chev silverado with a ses light on, scanned vehicle found p0122 code. checked ground at tps - good, checked voltage at tps - bad .02v at rest. with use of a test lamp from 12v to 5v ref at tps the voltage goes to 5v. i suspect a wiring issue but need to know the ecm pin points to check resistance, if resistance value checks ok need to replace the ecm, i need to know the ecm pin points and what else runs off of that 5v ref(map, evap,crank sensor ect) can you help?

These vehicles are different depending on the motor.I looked up the 4.3 because the 5.3 does not show a t.p.s.cause it has electronic throttle controls.You did not specify the motor.The connectors on the pcm are c1 and c2.C1 is blue and c2 is green.T ... 1999 Chevrolet Malibu

We found the sticker in the spare tire but we dont know what number we need to put in the radio on a 1998 volkswagon beetle

It should be XXXX or 4 characters. ... 1998 Volkswagen Beetle


It looks like a tire iron (sometimes looks like a crank) with a square or hex tip that you just slide into the hole in the bumper trim ... 1997 Chevrolet Blazer

I have 2004 Dodge Intrepid I my car is making a whinning noise. I was that it appears that my ballbearings need to be check and possible rotate the tires. Any suggestions

Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill ... 2004 Dodge Intrepid

I have a 88 Ram 50 2 wheel drive w/Manual transmission. It seems to be slipping when in second and 3rd gear, 1st and 4th seem fine. I took it to a shop and they did not even look at it but tried to tell me I needed a clutch rebuild kit which they would charge me $650 to install! It seems to me that if the clutch plate were burned up it would slip in every gear. Anyway, I inherited the truck so I know almost nothing about it but cannot seem to find how to check the transmission fluid levels,

1st is such a low gear,that the clutch wont slip,or as bad but 2nd,and 3rd put a higher gear and the power from the engine is too much,and it will put more torque on the clutch,it will slip.and 5th gear is a over drive,and you already moving pretty f ... Dodge Ram 50

I need to know if my car came with a spare tire

They all do due to its manditory under the safety bylaw.......Hope this helps. ... 1989 Oldsmobile Delta 88

I just need to know if I must use a "puller" to get the drum off the back wheels to check the state of the pads. 1993 Ford Festiva. I also put some 13 inch wheels from a Mazda 323 on my car but the shocks on the back just barely touch the tires on the inside. Can the shocks be lifted somehow?

No, the brake drum is separate from the axle. You may find that the brake drum is rusted to the axle. Car up on jack stands, Level surface. Wheel Chocks placed in front of the Front tires. Emergency brake off, and if you have a helper, th ... Ford Festiva
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.1433 seconds