Having problems with your 2007 Honda CR-V ?

Opdatering af gps på honda crv 2006 - 2007 Honda CR-V

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Honda CR-V

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Opdatering af gps på honda crv 2006 - 2007 Honda CR-V


... 2007 Honda CR-V

I have been getting an intermittent CEL on my 2003 Honda CRV for a couple of weeks now. I took it to AutoZone when the light was on and it showed a P0134 code with the following definition: A/F sensor 1 heater system malfunction Probable Cause: 1) Open or short circuit condition 2) Poor Electrical Connection 3) Faulty A/F sensor 1 Of course AutoZone wanted to sell me the $200 non-refundable sensor right away- is there anything else I can check first?


... 2003 Honda CR-V

Honda crv 2000 dock 1 O2 error code


... 2004 Honda CR-V

1 liter fuel honda crv how many km - 2005 Honda CR-V


... 2005 Honda CR-V

Which cylinder is number 1 1998 crv honda - 2000 Honda CR-V


... 2000 Honda CR-V

On my girlfriends 1992 Honda Accord we've noticed it has a shuttering problem almost as if lack of gas? It only happens when the car comes to a complete stop. The R.P.M's drop to 0 then bounce from 1 to 0 repeatedly


Sounds like your Idle Air Control Valve may be bad/faulty. ... 1992 Honda Accord

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).


... Cars & Trucks

How to fix honda crv 2001 srs code 1-1 - 2001 Honda Civic


... 2001 Honda Civic

Propercrankpositionfor correctbelttiming is there a timing mark onthe crank pulley for refrence to line up with a notch on the engine ,besides the flyweel mark? i am puzzled because i have already bent some valves & dont want to repeat my mistake. i have put the #1 piston at TDC, flat with deck ''0'' deck is this right or should it be slightly below ''0'' deck hight and or should the key way be at 12:00 position. please help me P.S, this a 89 honda accord 2.0 carb.3V A20A1 engine


Send me your email address and I will send you the proper timing positions. I can copy them from mitchel and email it.... ... 1989 Honda Accord 4 Door

2007 Honda CRV Code A 1 2 - 2007 Honda CR-V


... 2007 Honda CR-V

I have a 2001 Honda CRV with 75,000 miles on it. The check engine lite is on and the test said that there are ramdom missfires in cylinders 1,2,and 4. I changed the plugs, wires, distributor cap, and roator. I disconected the battery for half an hour to reset the light. After starting the car, it ran well for about five minutes then the check engine lite came on again and it starte to run rough as before when idling. Doing the teat showed that I now had ramdom missfires in cylinders 1,2, and 3,


I have 2005 Honda CRV miant lights came on How to resat it. ... 1999 Honda Accord

My 2000 honda CRV bangs and shifts hard when shiftng from 1 to 2 gear and worse with the a/c on.


... Cars & Trucks

Honda crv 2006 intake manifold tuning valve control circuit low bank 1


... 2006 Honda CR-V

Where can I find the manifold supply air inlet of Honda CRV Gen 1 2001 model? Picture or diagram will be best! :)


Basically, the Honda CR-V intake manifold is designed to supply fuel and air to the cylinders of the engine. It is also known as a sy ... 2001 Honda CR-V

I have a 97 honda crv with 100k on it ive replaced cap rotor plugs wires cat conver. injectors and fuel filter. i have 0 power going up hill and even less with ac on. im talkin 3mph at 2000 rpm. could it be the mas air sensor


Check the fuel pump pressure maybe u need to replace. ... Honda CR-V

1997 HOnda CRV - 148,000 mi. when excelerating from 40 -7- mph, a loud "thump, thump, thumping" begins. When foot is taken off gas the noise stops. The car does not shake. Local mechanic did not know what was wrong (although he verified that something indeed WAS wrong). Axcels, wheels & engine mount were checked and looked good. Noise appears louder when going up a hill or incline and is not constant while driving 0-35 miles distances.


... 1997 Honda CR-V

Abs light well i have a 98 honda accord v6. the abs light started to come on and when it did my cars idle would go down below 1,000 rpms and then it would die i would start it up again and it would run fine. a coule of weeks later when i was going down the road the abs light would come on and my rpm would go down and my speed amotor would go down to 0 speed and when it would do this my radio would make this noise light stadic going through it. so id pull off the road and my car would die.


1. Your fuel pump is going bad.2. Your brake pads has gone flat too.3. Have a look at your plugs and fuses.See an expert if you are confused.Please rate afterall has been looked at. ... 1998 Honda Accord

I have a 1997 Honda CRV with a 2.0 engine. At idle the engine runs 2 to 5 min. and dies. It will restart and repeat the cycle.The only place to tap into the fuel line is the return line and pressure there is 0 while running.A new fuel filter was instaled with no change.There are no DTC codes.


That line dumps directly in the tank so the pressure is supposed to be near 0. Before doing anything else you must find out if the fuel pressure and debit are ok after the engine died - take out the fuel line an put it in a 2 liter bottle, it should ... Honda CR-V

Honda 2000 CRV - 160 K miles. Engine dies on idle, load, steep turns, reverse. It sounds ok when accelerating, but there is a distinctly different beat on idle. Diagnostics give the code of P1399. Have replaced spark plugs, wires, engine filter, fuel filter, valves. Dealer recommends a 3K cylinder job..wondering if 1. there is some other root cause 2. is the cost worth it


Hello, it's 99% likely that your issues have nothing to do with the cylinders.\015\01275% of idle and engine power issues are caused by the emission system.\015\012\015\012EFI, ( electronic fuel injection systems ), are very sensati ... 2000 Honda CR-V

Hey, I have a 1999 Honda Crv AWD, as of lately I found that my clutch has no resistance and shifting into ANY gear is impossible! I've tried having someone push it so I can pop it into a gear along with many things. I have a friend who's fiance is a mechanic who told me that it could be 1 of 3 things. I called a local mechanic and he said that it would cost over a grand to fix it because he has to completely replace the clutch (over the phone, didn't actually look at it). Anyone know what the ex


I would start by checking the fluid level in the clutch resivoir if it is separate from the brake resivoir.If it is low on fluid then you will need to find the leak,most likely a bad slave cylinder.If it is full you will need to decide if master cyli ... 1999 Honda CR-V

1998 honda CRV 2.0 L eng. idles perfect when you accelerate hard you lose all power check eng. does not come on but I get codes po170 and po172 have replaced map and 02 sensor bank 1 no help


... 1998 Honda CR-V

After driving my 2004 crv about 20 miles ... when i apply my brakes a strange rubbing like noise comes from the rear brakes.. the brakes have been cleaned all lubricated no noise ... about 1 to 2 months later noise starts again been to honda dealer 3 times....what could it be?? the noise is similar to riding a 2 wheel bike as a kid with a piece of paper or cardboard in the spoke.


SOUNDS LIKE SOMETHING GOT EMBEDED IN BREAK PADS AND AS WHEEL TURNS IT HITS IT , BEST THING TO DO GET BRAKES REPLACED. ... 2004 Honda CR-V

Replaced 2003 honda crv battery,how to reprogram radio,and power window 1 touch does not work


For the radio you need to get the code. this is done by first geting the serial number you do this by pressing and holding the 1&6 preset buttons with the raio off and then turning it on. from that number i can get the code or you can call any h ... 2003 Honda CR-V

Honda Crv 2003 check engine light is on. Engine cuts back at 2 to 3 thousand rpm, when accelerating. Scanner says code 1259 which says 1. open or short circuit cond. 2. Vtec solenoid valve fault 3. vtec pressure switch fault 4. blocked oil passage Don't know which one it could be without going to shop. Anyone had this problem? Just started today and I erased the codes and after 25 min. drive the engine stuttered again and light came on again. When accelerating fast it does it but not slowl


Tell me what kind of motor oil r you using.regular or synthetic. ... 2003 Honda CR-V

I removed my car battery for my honda crv 2006 model and the radio is not coming on.i pressed 1 and 6 the numbers that came up are u 1000 and l 8490,please what is the unlocking code?


The code is specific to your vehicle and your radio. Go to https://www.ahm-ownerlink.com/login.asp?page=%2Fprod%5Fhome%2Easp\012and sign y ... 2006 Honda CR-V
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2173 seconds