Having problems with your 2007 Ford Territory 4.0 ?
Transmission selector not engaging
\015 Shifter moves but will only select park. reversing camera does not come on when shifter is in reverse.\015
Repair Help & Product Troubleshooting for 2007 Ford Territory 4.0
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
What would cause my transmission not to engage the car when the gear selector is at D (drive) or 2, the car only engage when the selector is at R (reverse) or L and while it's in motion you slip i
... Toyota Cars & Trucks
1995 Pontiac Grand Prix will not go into 1st gear. When gear selector is in 3, only 3rd and OD will work. It will NOT go to 2nd gear when the selector is in 3 or D. When gear selector is in 2 or 1, only 2nd gear will engage. I changed the fluid & filter yesterday and added some Lucas transmission additive. After the fluid change, it would go into 1st and shifted normal for about 5 minutes, then did the same thing again. I flushed the ****** today and tried it again and it is still doing it
... 1995 Pontiac Grand Prix
Replaced steering column, now transmission won't engage. Have 1984 F250 with tilt, cruise and auto trans. Had to replace steering column with 1983 one with no tilt and no cruise. Got everything together and starts fine. Shift selector will go through the gears, and the shift lever at the end of the column moves and moves the shift rods- but the transmission itself just doesn't change gears. Any ideas?
... 1984 Ford F 250
Transmission selector will not engage into any other gear remains in park
... 1996 Ford Crown Victoria
I have a 85 Olds Cutlass w/ original 307 eng. and either 250 TH or 350 TH transmission. The cars stays in drive no matter where i place the gear selector. Even in park if u rev the gas u can feel the car trying to move but doesnt because the trans pin is engaged. I connected the detent cable, filled the fluid and dropped the pan and changed the filter and gasket, also made sure the vacuum was connected as well.
... 1985 Oldsmobile Cutlass Supreme
Vito v280 auto transmission light comes on when i engage the gear selector lever
Have you checked the fluid level? ... Cars & Trucks
The automatic transmission selector lever does not engage smoothly
... 2003 Toyota Highlander
Hi & good evening, I have a 2000 chevy silverado Z71 with the 5.3 motor. When I try to start the motor in the morning, the dash lights up but the starter or the solenoid don't engage at all. If I keep trying, it eventually starts. I replaced the automatic selector switch on the transmission but that didn't work. It appears that after the truck is warm, it starts up every time . The truck has 190,000 miles on it but it looks and runs like new. Do you think it is the ignition switch? Any advise or
I would agree with you on the ignition switch. When it doesn't want to start, check the small wire on the solenoid to see if you are getting power from the ignition switch when it's turned to the start position. If not, I'd say it's the ignition swit ... 2000 Chevrolet Silverado
Transmission selector not engaging
... 2007 Ford Territory 4.0
The gear selector on my 2002 Ford Windstar moves, but the transmission won't go into gear. Why is the transmission not going into gear?
Try to replace transmission strainer first torque convertor and see if that helps if not it probabaly the transmission ... Cars & Trucks
92 960 2 questions Q1 : transmission (when warmed up ) will sporadically engage into overdrive , in low speeds , then frequently engage and stay engaged into overdrive when stopping (like a manual transmission without disengaging clutch pedal ) have replaced all switches :transmission neutral safety , and 3-way power ,economy and ice mode switch , with no effect on condition . Does need transmission fluid changed ,but was told that would affect overdrive condition Q2 : noticed that hydraulic li
1st thing to do is run a self test of the trans for trouble codes, sounds like a problem with the electronics, may be a poor trans connector connection or a solenoid issue in the trans.\015\0122nd if the oil pressure is low and by your descript ... 1996 Volvo 960
I have a 1998 Chrysler Cirrus with a transmission problem. While traveling at highway speed I felt a solid **** from the drivetrain but I managed to drive the 3 miles to the house. Upon entering the driveway reverse did not engage and the check engine light was on. The next morning the transmission would not engage in any gear at first but after revving at 2k rpm for some time the transmission engaged in drive. The fluid is within the marks on the stick although there is some transmission fluid
... 1998 Chrysler Cirrus
1994 Buick Skylark, 138,000 mi.,V-6, auto trans. Car won't engage in gear until engine is warm. Engine must run 4-8 minutes until shifting successfully. Shift lever can be moved to all gears, but transmission doesn't actually engage until engine is warm. Once transmission engages there are no problems driving. If I shut engine off, then restart, transmission will engage as long as engine has not cooled down. I checked fluid level with engine idling and warm and levels were okay. Problem h
One thing ive warned my friends to never do and that is to never have your trans flushed cause you may have new fluids but what about the trans filter its old and iots there for that reason to keep dirt and metal; shavings from the bands so try havin ... 1994 Buick Skylark
I have a 2006 ML 500 with the new transmission before Mercedes went back to their "4 matic" version of transmission. The transmission has been worked on several times for different reasons. The problem now is that occassionaly when I accelerate from a stop the transmission does not engage and I feel like the transmission is slipping or just not engaging. The Mercedes house has worked on the transmission so often I am concerned that I will always have problems. I have an extended warranty, bu
This kind of problem is caused by low fluid pressure, this can be a leaking valve body, a sticking fluid check ball or a defective pressure pump, u did not say if u have ever had any trans trouble codes that have been set for this intermittent ... Mercedes-Benz ML500
My 1987 (2.0 3SGE motor) Toyota Celica automatic transmission does not shift into overdrive. I noticed the transmission would take longer and longer to engage OD. At some point it would take 2-5 miles on the freeway at high rpm b4 finally engaging OD. Now OD doesn't engage at all. A transmission shop has looked at it. They believe it is an electrical problem. They've tested the solenoids and they are fine. They have (and I have on my own) done the on board diagnostics looking for error codes but
... Toyota Celica
Hi, I own a 1997 Ford E 350 Econoline, I have the following transmission engagement problem: Truck will not start: Transmission will not engage any gear, neutral or park. The shift lever feels like is not engagin any thing (moves freely) except at the very bottom (like 2-or 1 position, I feel like engage 1 or 2 gears). I did the following troubleshooting? myself: Raised vehicle and manually moved transmission lever to the park position with the following results. 1.- The truck started 2.- Transm
The weld on the manual lever is known to break loose. First, with the wheels off the ground, with the lever in the park position, does the drive shaft lock in park? If yes or no sometimes, drop the trans pan. I bet the nut on the lever camd loose. ... 1994 Ford Econoline
Manual transmission I have 1996 S series. The manual transmission will not engage, it acts like it is out of fluid. We bought it used, ran ok for a bit, but then it needed more RPM's to get it to move. Coming home the last time it just stopped moving about 100 yards from the house. The engine starts and runs fine, just won't engage. There is a leak somewhere around the transmission, but the oil looks like ATF, not gear oil (no garlic smell either). Can you add fluid to the manual transmission, w
The Saturn transmissions, manual or automatic, both use ATF. I was a dealer guy for a few years and it was the first I had seen with ATF, but it is correct for the Saturns. ... 1996 Saturn SL
Buick 2000 Le Sabre-transmission does not engage in any gear.
Try unplugging the electrical connection on the transmission to lock it in 3rd. It might get you moving. Although the transmission is going to need rebuilt or replaced. ... 2000 Buick LeSabre
1997 Cadillac Seville transmission does not engage any gears
It sounds like the problem started with the brake shift iterlock switch by forcing it he now broke the trans shift cable mech at the column ... 1997 Cadillac Seville
Ford Mondeo '97 MK2 (Automatic) Zetec 2.0L Transmission won't engage in any gears, wondering if it could be due to VSS wire not working. What would happen on a running mondeo mk2 if you were to cut off the VSS wire, would the transmission also cease to work? Things I've tried: Tried every gear, none engage. Tried unplugging every visible sensor one by one to see if it would make any difference. Just recently read up the transmission on automatic mondeo mk2's could stop working because of a
... 1997 Ford Escort
The transmission on my 2004 Cadillac Escalade ESV will not engage above 20 mph, 40 mph when in tow mode. At that speed the transmission will disengage and go into neutral. It will then only engage and drive in 2nd Gear. The problems started when towing a trailer. While the check engine light came on when the problem began, it is no longer illuminated. The transmission fluid was low at the time of the first occurrence but is good now. The problem still occurs whether or not Stabilitrack is
... 2004 Cadillac Escalade Esv
I replaced the engine on my 1997 chevy blazer and now the transmission will not engage. The torque converter was engaged in the pump and after installing I installed the 3 torque converter bolts to the mounting plate and now the transmission will not engage. Is there anything else that I should check?
... 1997 Chevrolet Blazer
The transmission has always been sluggish on take off, but recently the reverse gear seems to engage initially and then again a couple of seconds later when the car is at operating temperature. When the car is cold there seems to be only the one engagement. Would changing the fluid and filter be the initial step to consider in rectifying this problem or is a transmission rebuild or repair involving removing the transmission the likely cure. regards me
... 2003 Audi allroad
I have a 1990 GMC Sierra 2500, 350 2-barrel with a standard transmission. recently, the transmission is slow to engage, after changing gears and releasing the clutch In all gears, the motor winds before gears engage. Is this a clutch or transimission problem? I did find a dime-sized hole in my transmission casing, which I repaired with JB weld and it seems to be holding. I fille with 80 wight gear oil, but no change in the problem.
You obviously need clutch service,but you knew that ... GMC Sierra 2500
Automatic transmission does not engaged, sometimes will engage when the engine newly start. when it run and you apply brake , the transmission does not engage anymore.
... 1994 Honda Accord