Having problems with your 2007 Dodge Ram Truck ?

Dodge truck beeps warning when brakes applied?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Dodge Ram Truck

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dodge truck beeps warning when brakes applied?


... 2007 Dodge Ram Truck

Brake issues I bought the truck used realizing the brakes needed to be worked on. I had the brakes worked on at Just Brakes to the tune of several hundred dollars. When the brakes are applied it feels as though the truck does not want to stop. Even when applied hard the brakes do not give a "positive" stop. I took the truck back to Just Brakes and was told that "that is just the way the Dodge brakes are." I find that hard to believe. None of my other vehicles have this issue. Unfortunate


When you hit the brake do you have to pump the brakes to get it to stop? and or do they go almost to the floor when you try to stop? ... 1997 Dodge Ram 1500 Club Cab

I have a 1999 Dakota which applied Check Engine, Brake warning and ABS Warning. The truck has only 50K miles on it. The factory manual describes diagnostic code 0420 which is an emmision problem. The UBS II shows the same code. Any ideas? The truck is sluggish when I drive it like the brakes are being applied.


Air flow meter or air filter restriction is causing the computer to lean out the mixture too far. ... 1999 Dodge Dakota

My 2008 ,2500 dodge 4x4 truck, runs great but revs up when i apply the brakes say on stop signs or red lights, the truck just wants to keep going, gotta keep the brakes lock solid


... 2008 Dodge Ram Pickup 2500

Have a 89 dodge raider;;have no turn//4-way flashers or brake lights;;all fuses good;have power to brake light switch and leaves switch when apply brakes;;found round flasher[4 way flasher]know this because have power to it on one side and when pull 4-way fuse loose power;;square flasher beside it;has power to it;loose power when i pull turn fuse[also when i remove turn fuse i loose warning lights on dash and hear relay on middle or pass side kick out]i got another turn signal switch[columum swi


Hey HotrodHarley, \015\012 I would pull out your hazzard switch and clean it real well. the signal, brake lights are connected to the hazzard switch and if it doesn't fully disengage you wont get the brake lights or the flashers to come on. ... 1987 Dodge Raider

I have a 1998 dodge grand caravan. When I pull on the belt really hard, it dosent lock up like my dodge ram truck dose. Is this normal for them not to lock up. I was told that they only lock up when you apply the brakes. Could you please let me know how they are suppose to lock up, Thanks Family with two boys and a baby on the way,, Bruce [email protected]


If you are referring to the shoulderbelt as far as I am aware these vehicles are equipped with seat belt assemblies that have a feature that converts the retractor from an Emergency Locking Retractor (ELR) to an Automatic Locking Retractor (ALR). The ... Dodge Caravan

I have a 1997 Dodge 3500 diesel dually that stalls when I apply the brakes and turn the steering wheel at the same time. It gets worse with 4000lbs in the box. I raised the truck and turned the wheel from lock to lock and there is no binding. The power steering fluid is full. Does this have something to do with the ABS not working properly when there is a load on the truck?


... 1997 Dodge Ram 3500 Club Cab

On a 92 dodge 250 with a cummins automatic 4x4. We cant seem to get the rear brakes to work. Evrything is replaced( master cyl, wheel cyl, shoes, rear wheel antilock lock valve) the pedal goes to floor and brake warning light comes on. truck has been bleed several times. Any suggestions would be great.


Sorry to hear you're having problems. Here is an old school last resort trick of the trade repair. We used to do this on race cars when we had problems with bleeders. With little to lose you might try this. Park the truc ... Dodge Pickup

Abs and brake lights on constantly on 1998 dodge dakota sport..speedometer stopped working..trucks stalls out at times when brakes applied


... 1998 Dodge Dakota

2007 Dodge Ram 1500, under 30k miles. Problem started around 15k miles. Driving 5-10 mph, brake applied for a turn, truck completely dies (usually in the middle of the intersection). Runs rough and seems to have trouble switching between gears at speeds under 35mph; not sure if that's related. I have taken it into the Dodge dealership five times; the first two times they said they couldn't find anything, the next two times they replaced computer modules (and, I believe, the EGR valve). It's curr


WELL THE CODES WOULD HELP A LOT BUT IT SOUND LIKE IT MAY BE LOCK UP IN TRANS MAY BE BUT CODES WOULD HELP ... 1999 Dodge Ram

Shaking brakes 1999 dodge ram 1500, the truck shakes when applying the brakes even stroger if you do it from higher speeds


Your rotors are warped. You also probably need to brake pads. Take your rotors off and inspect them for cuts and grooves. If the surface is not flat you'll need new ones. If not take them to a machine shop and have them turned. Turning your rotors wi ... 1999 Dodge Ram

On my 2000 Lexus lx470 the vsc warning light goes on, sounds a very loud beep and brakes are applied hard on freeway at 50 mph in a long sweeping left turn. Speed limit on this freeway is 70. the car dive hard to left and scares the @!$#$ out of me when it happens. it is now increasing in frequency. ( couple of times a week but most every time I drive this stretch of pavement.


... Lexus LX 570

A warning beep when i brake in my 05 liberty - Cars & Trucks


Inspect for a brake light that may have went out,also check the brake fluid level ... Cars & Trucks

2007 dodge ram 2500 diesel a "ding" is heard when brakes are applied but no warning light


You have a light bulb out, check the brake lights ... 1999 Dodge Ram

Went to start my truck Sun morning and it idled very sluggishly. When it was given the gas it hesitated. Applied brakes and it died but started right up. No warning hadn't driven it for a couple of days, driving rain the day before. No other engine problems before this. Thank you GMC sierra 1500 1999 4x4 V-8


I own a 93 GMC and I have had this happen a few times, First its a chevy they are cold blooded take a bit to warm up and get heat. That and im sure the oil had not warmed up and gotten up to the top end. Let it warm up then try it out. ... 1993 GMC Sierra K1500

96 Dodge ram 5.9 what would cause my truck to die when I applied the brakes


I think it could either be a vacuum problem or an idle motor problem.The brake booster operates with vacuum from the engine.Check for a vacuum leak.Or if the idle speed motor is bad or sticking it would affect the idle.Be sure that the battery is in ... Cars & Trucks

1988 d150 brake warning light is on - D150 Dodge Cars & Trucks


... Dodge D150

92 Buick LeSabre brake warning light beeps - Buick Cars & Trucks


... Buick Cars & Trucks

2009 Dodge Caliber - The ABS & Brake Light came on as well as the feeling/sensation of the brake being applied very hard for a split second.


... 2009 Dodge Caliber 2.0

BRAKES WHEN I APPLY MY BRAKES I HEAR AIR COMING FROM NEAR THE BRAKE PEDAL WHEN I,M SITTING STILL AT A RED LIGHT OR STOP SIGN. LIKE A VACCUM LEAK BUT ONLY WHEN I APPLY MY BRAKES. I PAID THIS TRUCK CHEAP IT,S A 1997 CHEVY 1500 FROM THE POLICE DEPT, NARCOTIC DIVISION IT HAS A 5.7 VORTEC IT HAS 162000 MILES I HAD 1 PRIOR A CHEVY WITH A 5.7 BUT THIS TRUCK HAS A LOT MORE GET UP TOO IT A 100 MPH IN A HEART BEAT IS ANY WAY I CAN FIND OUT IF THERE,S A PERFORMANCE CHIP THEY WOULDN,T TELL ME AN I,D LIKE TO


I have the same problem. and according to the manual mine is due to a bad wheel speed sensor in the front driver side hub. it has something to do with the abs system. ... 1995 Chevrolet K1500

I have a 2008 Dodge Avenger with rear drum brakes. I recently started experiencing braking problems. if you apply the brakes firmly the car will stop with no probelms, but when the brake is applied very gently, the pedal will go all the way to the floor before applying the brakes. what would be?


Brake master cylinder is bad needs to be replaced. ... Dodge Avenger

I have a 2003 F-230 superduty. My brake warning indicator comes on and the alarm beeps (and beeps and beeps). I have checked the brakes, emergency brake and fluid levels and all is good. But the buzzer just continues to come on. Please help me turn off this beeping.


... Ford F-250

Problem with brake system on 2002 dodge dakota brakes replaced, new rear drums, brake fluid drained, flushed and replaced, wheel cylinders replaced, brakes adjusted, no leaks at master cyclinder. Brakes good for 3 days then brakes started locking up again causing truck to slide instead of stopping, at times it would slide then grab then you would leave rubber on the road or parking lot because of them grabbing. Dodge dealership doing the work they have advised they really don't know what the p


A 2002 should not need a new master cylinder yet. If it is the rears grabbing, they probably installed something wrong, or they did not get all of the air out of the system which would be my best guess. A professional brake ... Dodge Dakota

I have a 2008 Dodge Ram that came with the tow package. When I plug in my 7-pin trailer (with electric brakes) everything works fine until I turn on the truck lights. When I turn on the truck lights, I loose both of my turn signals and brake lights on the trailer. The running lights stay on. I unplugged the brake controller and still have the same problem. I compared my trailer plug diagram to my trucks manual and everything appears to be wired correctly.


If you have amber signal lights & red brake lights, it's 2 separate circuits. You'll need to buy a small converter that you wire into harness to correct that. Not expensive, try autoparts store or RV/trailer sales, should have them. ... 2008 Ford F-350

I own a 2005 dodge ram viper pickup truck srt 10 which i bought 2 years ago. The problem is vehicle vibrates when braking at any speed over 20mph and the steering wheel shimmies from side to side After i purchased truck, about 2 months later in 2007. I had the brake pads and rotors repla ced with vehicle having 16,000 highway miles no city driving on vehicle. and since then I've had to change the front brakes every four weeks. Just today I picked up the truck from marino chrysler in


This One is One Of Two Things 1. Change The Rear Brakes!!!!!! Thats Right When Your Rear Brakes Are Worn You Go Through Front Brakes Like Crazy As They Are The Only Way Your Car Can Really Stop. 2. Check The Brake ... Chrysler SRT
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.4966 seconds