Having problems with your 2007 Dodge Caliber SRT4 Hatchback ?

Hi need to replace my fuel sensor on a dodge caliber where does it fit? John

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Dodge Caliber SRT4 Hatchback

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi need to replace my fuel sensor on a dodge caliber where does it fit? John


... 2007 Dodge Caliber SRT4 Hatchback

P209 diagnostic code, injection misfire, airflow lean left bank on 1998 dodge caravan. you stated a bad fuel injectir number 9. does the APA sensor need to be replaced also??? are the fuel injector and MAP sensor hard to get to??? I priced the replacement parts around 150.00 how much for the labor??? Ball park estimate??


I assume the injector is causing the code,the injector ,is the only part that needs to be replaced,the injector itself,is causing the code for the circuit malfunction . ... Dodge Caravan

1994 dodge intrepid. 3.5 L. Auto trans. Runs rough at idle car shakes. Runs around 1700 rpm. Drops to a 1000 surges. Starts wheezy sounding. Crank sensor replaced 2 yrs ago just had timing belt replaced intake gaskets valve cover gaskets fuel rail gaskets injector o rings fuel pressure regulator and map sensor. Dies when driving butrestarts. Do I need to check adaptive memory? Or hsomething I'm missing thanks


... 1994 Dodge Intrepid

I need a wiring schematic for a 1999 dodge B 1500 3.9 van...Truck will start instantly run 60 seconds or so at an idle then fuel will lean out & die. Will not re start ... I have replaced the fuel pump (pressure constant 50lbs) Truck has new plugs & wires. a new IAC, Cam & Crank sensors, new dist cap & rotor, New coil and O2 Sensors... Checked all fuses, relays & voltage values to & from the sensors .... Changed ASD relay & fuses .. The ECM does not seem to re set properly .... no codes presen


Hi!!\015\012\015\012Click the following link lo get wiring diagrams of your van's electrical system.\015\012 ... 1999 Dodge Ram

I have a 2001 Dodge 3500 w/ 24 valve cummins it wont start on its own without the help of starting fluid, and when it starts it idles irratically. but when I clamp off the return fuel line it idles smoothly. I have replaced the cam sensor, overflow valve, and the transfer lift pump. some said I needed to replace the tank module in the fuel tank. If anyone can help I would greatly appreciate it....


Hi, by clamping the return line, you are defeating the fuel pressure limiting valve and applying full pump pressure to the injectors. Sounds like your limiting valve is a bit too limiting. These are expensive though, so I would check the pressure b ... Dodge Pickup

The check engine light is on in my dodge ram 1500. have gotten suggestions from others saying i need to replace spark plugs, wires. some say i need to replace fuel filter. others say it is in a sensor


Hi there:\012 First, seek for diagnose at any professional shop using computarized diagnose machine. Could be a variety of failures, and this can save you money. The computarize diagnose is an accurate tool to get the right solution. Sammmyc47 ... 2000 Dodge Ram 1500 Truck

My 98 dodge 1500 4x4 5.2l automatic will not start. It has spark fuel and isn't throwing any codes. I replaced the crank sensor, the magneto in the distributor the cap the rotor the plugs the fuel pump all the relays. It needs a neutral saftey will that keep it from starting? Truck cranks over no prob. And sounds like it wants to start but won't. I tried everything that was suggested to me. Can anyone help me out?


... Cars & Trucks

Okay, our Dodge Caravan 1998 3l 2 wd was running perfectly until a week ago. We were on the highway and all of the sudden, we lost power and it would not restart. We gotit towed home. Since then, we have replaced the distributor, fuel filter, rotor, relays, coil, and crankshaftposition sensor. We are now thinking maybe it was the timing belt or camshaft sensor. We are really needing help.


Hi! As a first course of action the timing belt should be checked first for if its broken it will create more damage to the engine specially when cranked. I strongly suggest that you have a PCM (powertrain control module) checked. The PCM has connect ... Dodge Caravan

2003 dodge ram 4.7l keeps dying when you give it good throttle to accelerate. replace fuel pump tps sensor and camshaft sensor. and it is still dying what could be the problem? need help


... 2004 Dodge Ram 1500

1998 Dodge Caravan rough idle after replacing fuel pump and fuel regulator valve plus a new cam shaft sensor and also a few replaced relays. am tearing hear out trying to figure this one out!


You need advanced test equip that only a dealer can provide. ... 1998 Dodge Caravan

Before we replaced the transmission we didn't have this problem. We replaced the tranny with a used and that's when it began. I knew that we needed to do some things to the jeep so I did the following, replaced: Crank shaft sensor,fuel pump, distributor, cap, button, wires, plugs, fuel filter, air filter, vacuum hoses, cleaned the intake and throttle body, replaced with used the speed sensor, (did not change out any of the other sensors from the old tranny).Had 2 different computers(diagnostic)


I am sorry,you did not say what the problem was. ... 1992 Jeep Cherokee Briarwood

Fuel is leaking from the fuel filter housing around where the water sensor is. This is a Dodge diesel 3/4 ton 4 X 4. I have had some say that there is an o ring to that sensor that can be replace, but it is not a manufacturer part. Dodge dealership said that entire housing has to be replaced at over $1000.00. Do you have any alternative that you can suggest. Thanks


... 1999 Dodge Ram

Engine light was on and van was running rough. The local repair center says that it needs a new fuel pump (2 of 6 sensors are receiving low fuel pressure ratings). I keep getting different answers on what this involves. I thought it would just be a fuel pump and a filter, but now I'm hearing there are 3 pieces to the fuel pump system - pump, motor, filter. Want to replace this myself, but I don't want to have to repair it twice. What exactly do I need to replace the "fuel pump"??


First check the pressure at the fuel rail at the top of the engine with a fuel pressure gauge these ar fairly expensive for what they are about a 100$ so if you can borrow one it would be great. doing this ensures you truly have low fuel pressure in ... 2004 Ford Freestar

2004 Volvo S40 2.4I engine check light is on, light is cleared and returns a week later, engine drives normal with light on. codes read P0172 system too rich bank one, P0191 fuel rail pressure sensor circuit range/performance, P1090 fuel rail pressure sensor circuit. now i need to know how to test to see if its the sensor that is faulty or the wiring circuit, replacement of the sensor is over $1000 and cant be returned so need to know im making the right choice by changing the sensor. thanks


... 2005 Volvo S40

I have a 2004 Dodge 1500 quad cab pick up truck. It has a strong odor of gas, however, I don't see a leak. I took it to my local dodge dealer. They said it does have a fuel leak behind engine by firewall, near valve cover? They also mentioned might be a vapor line? They said I would need to replace fuel line bundle. I tried to locate this part online but have not had any success. I assume this is several fuel lines together? What would be involved the process to replace the fuel bundle and where


Well the fact that one line is leaking dosent mean you have to replace the whole darn thing . there are lots of aftermarket. shops that can repaiar those plastic fuel lines . they sell a kit at napa to repair them . but it be more cost efective to ha ... 2004 Dodge Ram 1500

How to replace fuel temperature sensor on a 08 Versa (OBDII code =P0183)? My service soon light turned on on my dashboard. I did a reset of the code but after 60 miles this light came back again. Code read = P0183. Fuel temperature sensor Input A high. I am thinking about replacing this sensor... Is there any check I need to do before changing it? How to change this sensor, is it accessible? Thank you.


... 2008 Nissan Versa

What will my 2003 Mazda 6 do if the Electronic Control Module needs to be replaced? What will the diagnostic show if run on the car if this is what needs to be replaced? I have replaced several parts already and the car still will not start (replaced, CAM shaft positioning sensor, and the fuel pump and fuel line)


... 2003 Mazda Mazda6

Please I need help. I have a,1995 geo prizm. I have replaced the fuel pump, fuel filter, fuel pu relay switch, temp sensor. Took it to a shop and hooked up to machine for check engine light and found out about the sensor. The other code was 14 no ignition reference signal. Guy a shop doeant know what that means. My car takes a long to crank when its cold. Does anybody know what it means? I hears I need to reset igmitor switch but cant find it


It's not really a switch. Below is a desciption of what the code means. In about 50 percent of the cases it's a bad connection which is causing the failure and there are many tests to check different circuits. In order to rule out the ignitor here is ... 1995 Geo Prizm

I need to replace my fuel filter but I don't trust the local dodge service center - I have caught them trying to gouge me in the past. Any advice on how to replace the fuel filter? and how often it needs replacing? I don't believe anything they are telling me. Thanks! Ed


CLICK HERE.check if the link above is the same as yours ie looks the same they are all usually pretty much the same idea.Now a ... 2004 Dodge Sprinter

Hello, While driving on the interstate my 2000 Dodge Neon just went dead (like running out of gas) just bought it couple days ago. Car was parked in a yard for over six months. Trying to get engine running started few times but pressing gas pedal just killed engine. What I think is that fuel filter needs to be replaced but can't figure how to replace it. I'm hoping that's the problem. My question is if do I need to remove fuel pump assembly or can I get filter replaced without doing this.


"within an aluminum like cylinder were plugs are located deposits of engine oil covering almost entirely the spark plug."\015\012\015\012Those are the Spark Plug Wells you are referring to. I just had the same issue. It sounds like you ne ... 2000 Dodge Neon

2000 Ranger 3.0 Flex Fuel with no start condition. Have good fuel pressure, have replaced crank sensor, have replaced cam sensor, have replaced coil pack, have checked for camshaft turning,have noid tested injector harness, originally started to act up a year ago. Developed to needing to hold throttle wide open and crank to get it to start. Got progressivly more frequent. Now won't start at all. While cranking now, it cranks and sounds more like it wants to start with throttle wide open. Help Pl


U may have an intake manifold leak or low cylynder pressure ... 2000 Ford Ranger SuperCab

It appears that I may have a bad catalytic convertor in my 2005 Dodge Neon according to a repair shop I took it too. They also suggested replacing the 02 sensor as well. It gave the P0420 engine code which means Catalytic convertor efficiency. I'm not sure if I need to not only replace the catalytic convertor but the O2 sensor as well. I did not notice any exhaust leaks as of yet. How soon will I need to get this fixed? Or how long can I go without replacing it before it gets worse. It looks li


You will likely not notice any drivability problems, although there may be symptoms.\015\012\015\012\015\012\015\012A code P0420 may mean that one or more of the following has happened:\015\012\015\012\015\012 ... 2005 Dodge Neon

99 Dodge Diesel, had trouble starting it so replaced the fuel filter. Ran for a couple weeks then while driving it popped and died. Could not start. Had it towed to Dodge dealership. They say we need to replace the fuel pump injector and that the Fuel Pump Control Module is part of it. They are quoting $3800.00. Does this sound right?


... 1999 Dodge Ram 2500 4WD

2000 GMC Jimmy 4.3L CSEFI won't crank. Fuel pressure is 50psi and should be between 55 to 60psi. Fuel filter 1yr old and fuel pump is probably stock & needs replaced but never had problem before replacing injection system. Not getting any solenoid/starter or cranking noise. So could low fuel pressure cause a no crank condition? Parts replaced: lower & upper intake gaskets, new spider injection assembly, new starter/solenoid, new crank sensor new starter relay switch . Major tune up 1yr old, in


No low fuel pressure won't cause a no crank condition check for blown ignition fuse ... 2000 GMC Jimmy

1995 dodge dakota 3.9L not getting any spark or fuel. Have changed fuel pump, ( engine started right up and ran a day then nothing again). Changed spark plugs, distributor cap and rotor. Replaced ecm (with a used one from salvage yard), ignition switch (not tumbler), and battery. This vehicle was given to my son from his grandfaher after it had sat a few years. Siphoned most gas from tank and replaced with new fuel and fuel treatment. This model truck has fuel pump, fuel qty sensor, and fuel


Ok, try to forget all you have done and start a fresh with a new outlook.\015\012\015\012If you have no spark and no fuel ALWAYS concentrate on the spark first. The reason for this is most engine management systems can identify a non-spar ... 1995 Dodge Dakota
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6422 seconds