Having problems with your 2007 Chrysler 300c AWD Sedan New Cars ?

ABS Traction control light stays on

\015 After hitting a bump the ABS Traction control light comes on....If the cruise is on it shuts off.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Chrysler 300c AWD Sedan New Cars

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The ABS light stays on. At first it was intermittent. The Traction Control message stays lit too, and has been on simultaneously with the ABS light. At first it was just on for a drive and then did not stay on next time. Progressed to point it just stays on -- both ABS and Traction Control -- all the time. When the trouble began, it began with TC operation when not called for (gentle braking in dry condition) and the ratcheting brrrrrrring noise was heard when the ABS and TC came on and


Sounds like the abs sensor is malfunctioning and needs replacing.. To verify this.. remove the abs fuse in the fuse panel below the hood.. This will disable the abs system and your brake would work as if it was not abs .. Drive the vehicle and see ho ... 1999 Ford Crown Victoria

I had the ABS light come on along with the service traction control. I had it checked at a GM dealer and was told that the right hub needed to be replaced. I OK'd the work thinking it would take care of both of the service lights. The ABS light is out but the traction control light still comes on when making turns or when backing up at times. The GM service rep said nothing could be done until the light stayed on. What is causing the light to come on when traction control is not even needed?


Hi,the traction control light coming up means there is a fault detected in the system and a scan tool will be required to learn what fault has been detected. Possible steering angle sensor, wheel speed sensor or brake pressure sensor since the light ... 2002 Oldsmobile Silhouette

I have a 2001 Chevrolet Monte Carlo SS, 3.8 engine. Every time I start a forward or reverse movement the Traction control system comes on and I feel it engaging the brakes like as if my tires were spinning but the tires are not spinning. Then of course the traction control light comes and the traction control deactivated light comes on and then about 5 seconds later the ABS service light comes on too and both lights will stay on until the car is shut off. I have replaced both sides front axle


... Cars & Trucks

Service traction control system light comes on at startup along with the ABS and TRAC OFF lights . Servcies traction control system goes off and other two ABS and TRAC OFF stay lit when I drive. I would like to understand what could be wrong and is there anything I can do before I have to take it to a mechanic


One of the "hall effect" sensors may have a damaged lead, or the sensor itself has failed. ... 2000 Pontiac Montana

1998 Olds 88, Replaced all the brake lines (because of corosion) I took care to get lines back on anti-lock unit in same position as origonal. Brake light on dash did go out but the ABS and Traction control light stayed on. Is there a reset? I disconnected battery and ABS fuses to try to reset lights to no effect. Why are my lights on? I havn't had a chance to down load computer.


You probably push air into the ABS unit when getting your lines replace but the Traction Control light might be on because the system might use the wheel speed sensor on the ABS unit to enable the Traction Control....... ... 1998 Oldsmobile Eighty Eight

My ABS and T/C (traction Control) lights on my 2004 chevy avalanche are on. I recently replaced the U-joints and the brakes. after replacing the U-joints, a week later the light came on. Any idea what to do?? I pulled front ABS sensors and cleaned and T/C button will not stay pressed in when pushed.


... 2004 Chevrolet Avalanche

Dash brake light comes on flashes once then stays on. traction control and ABS lights stays on.


... 2004 Chevrolet Malibu Maxx

Fuel gauge not working in Olds Aurora 1997, Took the battery out for the winter and when I plugged it back in the fuel gauge isn't working, Traction control (off) and ABS light staying on the dash. Traction control won't come on. Thanks


... 1997 Oldsmobile Aurora

Fuel gauge not working in Olds Aurora 1997, Took the battery out for the winter and when I plugged it back in the fuel gauge isn't working, Traction control (off) and ABS light staying on the dash. Traction control won't come on. Thanks


... 1997 Oldsmobile Aurora

Abs and traction control light stays on


Cheapest option would be to have the fault code read by a dealer or specialist. Its likely to be a wheel speed sensor but its finding which one that's the problem. You could disconnect each one and take an ohms reading across the connections. They sh ... 2003 Ford Focus

My esp/bas lights and traction control lights stay on as well as brake and abs lights.


... 2009 Dodge Ram Pickup 1500

Esp/bas lights stay on as well as the abs, traction control and brake lights.


... 2009 Dodge Ram Pickup 1500

I have a 2008 grand caravan and I have three warning lights on at the same time. The lights are the ABS,traction control, and the ESPBAS,all are yellow .The van is running fine except after driving for a couple days now my heads up display says GATE and my interior lights won't go out. The three lights stayed on for 2-3 days steady now it comes and goes. Any help would be very appreciated.


I had the same problem it was a loose connection under the dash passenger side which got loose by accidentaly kicking it with my right foot ifs right next to the side panel I think there is one on the driver xide too ... 2008 Dodge Grand Caravan

I have a 1996 Volvo 850, non-turbo. It has a traction control button near the gear shift (never worked). On the dash idiot lights, ASB, Trax Loc and Service Engine warning lights stay on constantly and have for a long time. I replaced the mass air flow sensor as was indicated when I had a service analysis performed. Is there anyway to turn off any of the warning lights? I tried pulling fuses for the abs and trax loc, but nothing. I know the service engine light is a dealer specialty, but sure


Hi! Its really annoying to see these warning lights specially when you yourself knows that everythings fine and even if there are few shortcomings it doesnt matter to you for you managed to live with it. If I we're to ask how to get rid of the check ... Volvo 850

2007 ford edge abs and traction control light came on this morning and stayed on


The most likely cause is a faulty wheel speed sensor,there are four,one on each wheel.you will need to plug in a diagnostic tool to determine which one. ... 2007 Ford Edge SEL Plus

Abs and traction control light stay on


... 2008 Ford Escape

ABS Traction control light stays on


... 2007 Chrysler 300c AWD Sedan New Cars

The ABS Light The Traction control Light and The Brake warning light all stay on . It shows Codes C1412 andC1448


Hi Berns,The c1448 message is pertaining to the ignition cylinder which made me wonder because this part is not related to the warning lights mentioned as those are triggered if the car is is loosing traction.To have a quick f ... Cadillac DeVille

What causes the ABS light brake light and traction control light to stay on in my 03 Cadillac deville


... Cars & Trucks

I have a 2008 gmc Sierra and the abs light and stabilatrac light and traction control and service trailering lights are flashing or staying on I appreciate any help


... Cars & Trucks

I have a 2008 gmc Sierra and the abs light and stabilatrac light and traction control and service trailering lights are flashing or staying on I appreciate any help


... 2004 GMC Envoy

My abs light, brake light, and traction control light stay on. I have a 1994 cadilac fleetwood brough.


... 1994 Cadillac Fleetwood

2003 impala ABS and traction control lights stay on all the time but no ABS.


... 2003 Chevrolet Impala

Both abs and traction control light stays on also spedo not working have checked all related fuses all ok have tried to scan with both snapon solus and launch x431 niether will communicate with abs ecu but will go into eng managment have you any ideas.The car is a 2000 vectra 2.2 petrol with abs/tc system thanks sash


Had my 2000 chev impala 3.8 liter ,traction control llight and abs light both go on the reset it and go right back on .so i replaced both sides of the bearing hub assembly this is connected the senser,so far so good.replaced it dec 21 2009 about 3 h ... 1997 Acura CL

2003 Lincoln LS 3.0 has both the ABS and Traction control lights staying on, throttle actuator code comes up on the computer. Is the throttle system tied into both the ABS and the Advance Trac? initially thought it might be a wheel sensor but the computer thinks otherwise. Anyone have any ideas?


... 2000 Lincoln LS
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.5651 seconds