Having problems with your 2007 Chevrolet Silverado 2500HD ?

When you put the truck in 4 wheel drive there is a grinding sound front left wheel area

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 Chevrolet Silverado 2500HD

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When you put the truck in 4 wheel drive there is a grinding sound front left wheel area


... 2007 Chevrolet Silverado 2500HD

I have a 2002 Toy Camry and today while driving I went to make a left turn. I heard a deep "thud" sound that came the front right-side wheel area and a strange grinding noise that followed also on front right side only . Upon completing the left turn the grinding noise got louder. When I apply the break the grinding gets worse but while driving straight no noise.gringing


Check for failed wheel bearings or loose wheel on studs. Check suspension ball joints and steering joints the problem is serious so have the front inspected by a competent mechanic ... Cars & Trucks

My 1988 K1500 four wheel drive has grinding sound, 2wd works just fine, only when I engage the four wheel drive does it make grinding sounds, and the left front turns roughly and irregulary. I think I shredded a hub?


Im having the same problem... 2wd works fine, 4wd lo and hi both when the engine is just above idle and the wheels spin there is a knocking and when it goes too fast its like a grinding.... ive been told it was the actuator... but ive yet to test tha ... 1988 Chevrolet K1500

Just got a wheel alignment and the front left side bearings and ball joints replaced go to drive the truck and put on the brakes they grind something terrible.


Did you check the pads?and roters? ... 2004 Chevrolet Blazer

I have a 1997 gmc seirra 1500 4 wheel drive i just put a new actuator in the front axle for the 4 wheel drive but wen i push the knob on the floor into to four low and put the truck in drive it jumps foward like its working and sounds like its working but the wheels will not pull


... 1997 GMC Sierra K2500

Have a 2007 F150 stx 4X4 w 5.4 l V8. The 4 wheel drive lever is on the floor. I shift it into 4high, the light on the dash says it is in 4X4 but the passenger side hub whines like it is not engaged. We checked all the vacuum lines, good. We put the truck on jack stands, started it, put it in drive, pulled into 4high, and let my foot off the brake. The passenger side front axel spins but not the wheel. the hub sounds like it does not engage. The drivers side axel is not spining but the wheel can


... Ford F-150

I have a Ford F250 XL- While plowing today I notice that the truck was swaying to the left but didn't think anything of it, thought it was the wet snow. Then while back blading some snow, I noticed that the truck would not back up, almost like I didn't have any 4 wheel drive. I would lift the blade and the truck would back up. When I put the blade down and pushed the snow it would move, but I still felt like the truck had no tracktion on the front drivers side. Almost like the front drivers side


Check both front lockouts,1 side or the other could have broken,unlock 1 side and reach underneath and try turning the axel on the other side-----if it turns all the way around, then replace that lockout,if it doesnt turrn then try unlocking that si ... 1998 Ford F250 SuperCab

I have a chevy pick-up truck the year 1995 Z71. I put the truck in 4x4 high for the first time this year and did not get a light near the gear lever nor did it go into 4 wheel drive. I check the transfer case with it in neutral and the front shaft would turn freely, then put it in 4 wheel high and it would not turn. I also drove the truck on dry pavement with the 4 wheel drive high gear and 4 wheel drive low gear and had no bucking of the front end when I made turns in a parking lot. Any ideas


The accuater on the frontend is out ... 1994 Chevrolet C1500

When turning left (from dead stop or while driving very slow as in parking), horrible grating, grinding noise and the left front tire will "chirp". Very loud metallic popping sound occasionally. New left axel and differential 6 months ago. What could it be? SUV is all wheel drive.


Change hub bearing assembly recommend to do both sides. ... 2004 Mercury Mountaineer

2003 Dodge Ram 3500, my front left wheel is making 'scraping' sounds, as if the brake pads are worn down and the tabs are 'scraping' but every once in a while there is a grinding sound. Have taken brakes off and they are good, but there are tiny metal looking shavings inside the wheel. Replaced bearing 4 years ago, but we haul a lot of heavy loads, could they be bad again? Afraid to drive it for fear will really mess something up.


It's possible that the bearings need replacing if haul loads on a regular basis. Take a look at the complete hub assembly, this is not an uncommon issue with Dodge Rams. If you need diagrams and procedure info, here is a cheap factory service manual ... 2004 Dodge Ram 3500 Truck

I have a toyota 4x4 pickup and when i am in 2 wheel drive there is a grinding sound coming from my front right tire. Whenever i put it in 4wheel drive the grinding gets worse


Check the bearings ... 1987 Toyota Pickup

I just purcahsed a 2003 ford excursion and I heard a whisteling sound yesterday coming from the front left tire while driving. I have noticed a fluid leaking from the left area and I went to stop this morning and heard a grinding sound. ABS light is on and the pedal seems to have resistance with air? Heather/Mommy of 4 lol


Sounds like you are leaking brake fluid. The grinding sound may be from the brake pad not disengaing from the rotor because of low brake fluid pressure. Have this checked immediatley you may loose all brake function!! ... 2003 Ford Excursion

I bought a corvette and within the first 20 miles put on the car a mechanical failure caused my car to veere hard right from the number 1 lane across four lanes of traffic all the way to the right wall. the first time I drove the car on the freeway a clicking sound seeming to originate from the back left wheel area became louder and was joined by a violent vibration, my steering felt as though I was being forced to drive hard right, I tried to compensate by pulling the wheel back left to no ava


A failed c.v axle could have cause exactly what you are explaining... it actually almost the only thing ... 1995 Chevrolet Corvette

My front left wheel is making 'scraping' sounds, as if the brake pads are worn down and are 'scraping' but every once in a while there is a grinding sound. Have taken brakes off and they are good, but there are tiny metal looking shavings inside the wheel. Replaced bearing 4 years ago, but we haul a lot of heavy loads, could they be bad again?Afraid to drive it for fear will really mess something up.


I had same problem change the front bearing ... 1998 Dodge Ram 1500 4WD

I have a 2000 Blazer and when I drive down the road I get a kind of grinding noise from the front end. It makes this noise when I drive straight, but if I turn the wheel ever so slightly to the left the noise goes away. It sounds almost like a rubbing of the tires, but I see no evidence of that going on. It seems to be on the left side mostly, although it could be on the right, I just don't sit there.


It might be the hub bearing assembly on the driver side. If you can have someone drive for you so you can check out the other wheel. ... 2000 Chevrolet Blazer

I recently had the front left wheel bearing replaced cause it seized up.a month later i started hearing the same noise before it siezed..the mechanic said the front end was sloppy and needed to be replaced.so he replaced the tie rods and two differnt arm assemblys.kept hearing the sound so he warrantyd the first wheel bearing,put in another,and it still is making a metal on metal grinding sound.his next opinion is it could be the axle.i am not sure.i am gonna take it to another mechanic and see


Hi, The one thing that causes repeated failure of the front bearings is being over tightened when they install them. A great number of mechanics try and rush and uses air tools to tighten axles nuts down. This usually over t ... Chevrolet Silverado 1500

2001 buick century off trac lite comes on you can feel a vibration and hear a grinding growling noise, i put on computer, it said left front wheel assembly we replaced it but it didnt fix the problem, if you leave the wheel off and put it in drive theres a little vibration at about 45mph?transmission seems to run out good is this a transmission problem or is there something else


Check wires and connector to speed sensor. ... 2001 Buick LeSabre

Went to the store came out started the car pushed on thebrake to put it in gear heard grinding sound and car just rolled backwards. will not get any gears, it is an automatic too.02 passat front wheel drive. when i try to put it into park it grinds then stops. i also have to use the e brake to park it.


... Volkswagen Passat

2009 RX 350 is making a loud grinding sound when I accelerate, then it goes away. The noise appears to come from the front right wheel area. I have AWD. It especially happens while driving up a hill. I've taken it in 2 times and no one can reproduce the sound, which is strange because it make the noise every time I drive the car. There are 46,000 miles on the car and it's occurred since I brought it home (34,000 miles).


... Lexus Cars & Trucks

I have a 2000 Alero and have front wheel drive. My front left tire will rotate to go forward but as soon as I put the car in reverse the tire will rotate a little bit but than stops and drags with the car. It does not want to go backwards but goes forwards. Also when I press my breaks it starts making a crunching sound and when I do drive it is squeeking.


Sounds like a brake issue to me, like the caliper sticking. I've taken the axle, brakes and hub/wheel assemblies off these many times, pretty simple. If you choose to DIY, I would suggest you buy a Haynes manual....about $20 well worth the investme ... 2000 Oldsmobile Alero

Popping sound when pressing or releasing brake. also has scraping sound while driving. sounds like the left front wheel is going to fall off. I had new brakes and hubs put on about 6 mos. ago. also new bushings.


Check front brake pads or calipers. sometime time the rotor get a rusty spot and pads rub on this spot and a scraping is heard. ... 1999 Ford Ranger SuperCab

I have a 1999 Toyota Tacoma 4x4 2.7L and I am getting a noise under the left front wheel. When I put my left foot on the floor, to the left of the clutch pedal, it sounds and feels like rocks hitting the floor of the truck. Took it to the shop today and they looked at the stearing and said it was fine. They could hear the noise but not sure where it's coming from. Any ideas?


Funny you should say that i had that happen to me once and it was a rock lodged between the frame and the body, check the body mounts, and look for any bracket mounts that may be loose, ... Toyota Tacoma

Shift solenoid im pretty sure the shift solenoid is screwed in my 97 jimmy 4x4, is there any way i can change the solenoid or do i have to cheage the whole transmission? The jimmy i am looking at is a 95 4 wheel drive.. all gears work, no slipping or grinding or any odd sounds of any kind. what is the problem is that you can be driving along and it will just go into neutral. If you shut the truck completely off and restart an put it back in drive it works great again for few minutes an then poo


You can change the solenoids you should be able to drop the tranny pan and they are right there but you might want to unbolt the cross member that holds the tranny up so the pan comes down easier or you chance breaking the solenoids if you try to for ... 1997 GMC Jimmy

The truck makes a noise when starting out turning and stopping. I place the truck on jack stands and the front wheels turn count to each other and do move the front drive shaft. Running the truck in drive the front left wheel start to turn then stop and the wheel binds? I think it is a bearing /hub issue - thoughts? Thanks


May be the cv shaft between the diff and the bearing the joint freezes up on 1 cup and it will bind ... 1997 Ford Explorer AWD

My 1999 Jeep Grand Cherokee Laredo with Quadra Trac II makes a thudding noise when I accelerate. When I first start the car rolling and turn the steering wheel, it is very pronounced. It sounds like it comes from an area below the steering wheel or toward the front left. I've had the brakes and pads replaced, and they seem to work well. The tires are fairly new and I keep them rotated. I put an aftermarket transmission into it last year. It shifts fine, although I must add fluid periodically. I'


... 1999 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.0066 seconds