Having problems with your 2007 BMW X3 3.0si SAV ?

How to remove rear wiper blade on BMW x3 2005

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2007 BMW X3 3.0si SAV

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to remove and replace the wiper blades on a 2006 BMW 325i.


My suggestion....go to Schuck's/Kragen?Chief's?Auto Zone....they will install them for FREE. ... BMW 325

Bmw rear wiper blade removal - 2007 BMW 328xi Sports Wagon


... 2007 BMW 328xi Sports Wagon

How to remove rear wiper blade on BMW x3 2005


... 2007 BMW X3 3.0si SAV

Remove water pump have removed outer plastic blades of viscous fan and the four small bolts behind the water pump it seems loose but will not come away, is it just the internal impeller blades dont want to force it too much in case. have I missed something. have not removed large centre nut on viscous fan yet as i dont have big enough spanner (story of my bloody life) is it a left hand thread if i do have to remove it. thanks led


What's up led, the large viscous nut is loosened in the clockwise direction. after you remove the 4 nuts on the water pump, you should see one hole on each side of the water pump body. if you take 2 bolts out of the thermostat housing, you can use th ... 1996 BMW 318

How do i remove the fan blade from the water pump -= the seal is leaking and i am replacing the seal behind the water pump - but i cannot figure out how to remove the fan blade .


If you go to Auto Zone or some other auto parts store that offer a loan a tool program, you can get a fan clutch removal tool. It looks like a large two prong fork that fits around the small bolts to the pully and a large wrench for the nut on the fa ... 1996 Ford Explorer

What is the correct procedure for removing the intake manifold actuator on a 2002 BMW X5 3.0 I have a leak, when I spray starter fluid on the actuator the idle speed go up. I had misfires and changed all 4 oxegen sensers and the problem got better but I still get P0171 and P0174 errors. I ordered a new intake manifold actuator, but don,t know how to remove and install. I also ordered the 2002 BMW X5 maintenance manual,


... 2002 BMW 5 Series

How do I remove my wiper blades on a 1992 Cutless Ciera? I do not see any place where I can remove it from the "pin". I see nothing to "snap" open. The blades have been on the car for two-three years.


An auto parts store will do it for you. ... 1988 Oldsmobile Cutlass Ciera

BMW OIL filter change. Once you've got the filter out how do you remove the old paper cartridge. Is it brute force to remove it from the spindle of does it unscrew? My BMW is a 2005 3 series (the new shape)


I am puzzled by your reference to the new shape. I just looked up the oil filter covers for three different 2005 3-series engine configurations and they all came up the same part number that has been used on the 3-series since 1991. Which model do ... BMW 318

Emblem Removal I just Bought a 1986 BMW 325e 4 door as my First car, However the BMW Emblems on the Bonnet, Trunk and wheels are in really bad shape, We want to remove them but we can't find any place to unscrew them. How do I get the badges off?


To get the one's on the wheels off you have to take the wheels off and pop them off the the back. The one on the hood has two little plastic things you have to pry off. The one on the trunk are similar, but they are glued (at east mine were.) If you ... 1986 BMW 3 Series

I just purchased Bosch Icon wiper blades at an Auto Zone store. #'s 26A and 21B for my 2008 acura MDX. I've never replaced the blades myself and wanted a step by step instructions on how to remove the old blades and install the new blades.


... Acura MDX

Removal of door panel for BMW 5 series for removal of wing mirror


On the inside trim, you can remove screws that are by the door handle,\015\012arm rest, under door and side of door and then gently pull back on the\015\012panel as there will also be retaining clips attached and you don't want\015\012to break them. ... 2000 BMW 3 Series

Bmw 316i removing bmw alarms systems from a 1996 bmw 316


... Cars & Trucks

1990 BMW 535I COOLANT OVER FLOWING WHILE THE ENG IS RUNNING. OVER FLOWING AFTER 15 MINUTE OF RUNNING. IS THE WATER PUMP NOT CIRCULATING THE COOLANT BUT WHEN I REMOVE THE BELT AND SPIN THE PUMP THE WATER GO UP AND DOWN WHILE LOOKING INSIDE OF THE PUMP. HOW DO YOU REMOVE THIS BIG NUT IN FRONT OF THE PUMP SHAFT CONNECTED TO PROPELLER. ITS VERY TIGHT. IVE BEEN TRYING REMOVING IT BUT NOT LOOSING AT ALL.


Change your thermostat since its stuck closed causing this overflow. Also check for a collasped water hose and a faulty radiator cap seal for this will cause the same problem ... BMW 535

Bmw 5 series 2.3L 2000 england how do i remove airbags from drivers side. i was told i would need a torx 30 to remove two bolts from behind steering wheel. my steering is a m5 wheel, and also how would i remove air bag from passengers side dash board thank you


This may not be what you want to 'hear'.I advise you to STOP!The force of one of these airbags deploying, can easily break your neck, or remove parts of your head!I know how that sounds coming from a stranger, but most o ... 1999 BMW 323 Series

How does one remove the fan clutch? Have removed teh fan blades but don't find any bolts to remove teh clutch to get it out of the way. Working on a 7.3 l diesel.


... 1994 Ford F350 Crew Cab

Where is the windshield wiper delay circuit board located and how is it changed. I thought it would be on the wiper motor but I am having trouble removing the wiper blade arms which should alow removal of the plastic shroud covering the wiper motor. Is there a trick to removing the wiper arms?


You are on the right track. If you have removed that little cap, and unbolted the nut what you do is pull and wiggle. There is a special tool, but if you are persistent you can do it without the tool. A little WD-40 never hurts either. ... 2004 Chevrolet Silverado 1500 Crew Cab

How can I remove the starter from my BMW 540I? I removed 4 bolts but it still wont slide out. I am trying to remove it from underneath. Is there a better way/angle to take it out?


... 2009 BMW 5 Series

Hi, i have a 2006 BMW 325xi, last week my rear electric sun screen stop working. I would like to know if someone knows how to remove the sun screen from the rear deck, i have tryed many ways to remove it, but i have no luck in doing so. I would like to remove it so i can repair the electric motor. It does not go up, but i hear the motor turning. Thank you for any help


Kdy? hlava svítilny odstranit pry?, tam je to! Obrázek nr . 7. ... 2006 BMW 3 Series

I'm trying to replace the failed water pump for my 2005 grand caravan. I've removed the pully bolts and housing bolts and moved the pully inward between the pump housing and the hub, but don't seem to have enough clearance to now remove the old pump. There is only about 3/4" clearance between the pump shaft and the car frame and the impeller blades don't allow removal. I'm stuck; any thoughs as to how to proceed?


You can pry the engine over.. there will be just enough clearance to get\015\012it passed the frame... just be carefull when prying it over not to slip cause you'll break the water pump on installation if the engine rocks back. ... 2005 Dodge Grand Caravan

How to get access to replace the alternator on my Discovery 3 TDVS. I have removed the air-intake pipe from the air-box and the top part of the fan cowling. My question however is whether the fan blades must be removed to gain access and if so how to do it. There is a electrical connection to the fan that I believe can be removed and it looks like a special nut that hold the fan in-place to the shaft.


Hi yes you will have to take the fan off to get to the tensionerand the alternator once the fan is off (with a 27or32 spanner i think) everything else is easy-ish. dont be shy to give it ago people, Alternators are easy to do even on big 4x4s ... 2006 Land Rover LR3

Im trying to remove my old stereo from my bmw 316i 1996 model but cant figure out how to remove the front das trim first or exactly how i remove the old stereo so as i can fit a new unti


There are two little "flaps" on each side of the hu, you need tool too stick in the holes they cover.Its a T10 torque driver thats required. Its like a screw driver but with a star shaped point and the size required is size 10.The ... 1996 BMW 318

Broken tab on wiper blade, cannot remove


... Cars & Trucks

Hi ya..... My wipers on my S reg BMW 528i touring (E39) do not work when there is heavy rain.... It's only started happening over the last 2 or 3 months. Any ideas? IS it the wiper motor or the relay? Also do you know the BMW part number for the motor? Unless I get it removed to locate the number I cannot buy the motor....... I need a cheap and quick way of resolving this


It is possible that the rain sensor (if equiped) is the issue. if not equiped, then i would be more apt to replace the relay. it is located under the hood, under the passenger side cabin filter box, beige in color. fairly inexpensive. ... BMW 528

How do I remove a wiper blade from my 1983 Chevrolet half ton pickup. The original metal part is to be removed to be replaced with anew metal part that comes compete with the rubber part attached.


Flip the arm up off the windshield first. Then use a screwdriver or small pry bar and pry up on the edge of the wiper arm. Alternate between sides and make sure you only have the edge of the wiper arm itself. You should be able to feel when you are o ... 1983 Chevrolet Chevy

Remove radio 2003 bmw 325i - 2003 BMW 325


... 2003 BMW 325
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2571 seconds