Having problems with your 2006 Volkswagen Touareg ?

How to replace the rear tail light bulb

\015 I need advice on how to access the rear tail light bulb on my 2006 Toureg. One bulb is burned out and I cannot figure out how to get to it.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2006 Volkswagen Touareg

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1997 Rav4. The rear brake or stop lights went out on both sides, and tail lights (same bulbs different filament) remains on constantly even when the lights and car are turned off! [strange] I replaced the bulbs on both sides (bulb# 1157). The stop light on the driver's side had been burned out and I replaced it. Also, the fuse [location 15 fuse 10A] appeared to be burned out and I replaced that with a new 10A fuse. The brake lights still do not go on and the tail lights still remain on

You might need a new Brake Light Switch, it is located by the brake pedal. ... 1997 Toyota RAV4

I need a fuse box diagram for a 1992 Dodge Dakota pickup truck. I need to find the fuse for the left rear tail light. The bulb was replaced however when I turn on the lights the left rear tail light will not come on. The brake light works/comes on;I first thought the socket was bad but when I put the car in gear to back up both lights come on. So I think the fuse needs to be replaced. I purchased the car used and the fuse panel cover is missing.

... 1992 Dodge Dakota

1999 Grand Cherokee. Left turn signal does not work at all. All of the 4 ways work except the left rear. I have replaced the left rear bulbs and replaced the entire tail light assembly. Still no good. I checked the voltage at the connector that goes into the tail light assembly-no voltage. I can't find a detailed wiring diagram on the web.

I recomend you look into you signal relay located in your fues box inside the dash left of drivers knee. ... 1999 Jeep Grand Cherokee

Ok, had a trailer wire box attached to rear drivers side-wife left it hanging out and ran over it. Now I have no rear driver tail light or front amber running light. All turn signals and running lights work correctly except for these 2. I have removed damaged box and replaces all light bulbs. Get no reading from wire labeled major at the pig tails. Is there a quick find fusible link or do I get to trace wires?

Check all your fuses. something may have shorted out and blew out a fuse.if you don`t have blown fuse there is a short somewere.you will have to locate it. ... 1994 Jeep Cherokee

Right rear signal light bulb burnt out, replaced bulb, then no signal lights, hazard or brake lights. Replaced flasher can and checked fuse - ok. Tail lights work. 1997 model, 35,400 miles.

I assume you have checked all the fuses in the running lights both under the hood and in the cab, did this maybe happen after having a trailer hooked up? if no to this question then make sure u have the bulb installed correctly, have found this to be ... Chevrolet C2500

The rear cargo light won't turn off. This happened after I replaced a rear turn signal tail light bulb and a fuse for the horn. (These went out at the same time.) When the blinker light and horn were repaired the cargo light remained, on no matter what. I took the bulb out as a temporary fix there. Are these related? How do I fix this?

Hello! The instigator of this problem appears to be the the rear cargo lamp; Official name is rear dome light. You'll need a multimeter set on the X10 ohm scale to shoot this trouble. Leave the rear dome light bulb out. There are two switches invo ... 1991 Chevrolet S-10 Blazer

2004 Tiburon - tail light problem. Left side tail light and rear-side marker lights were out. We replaced the tail light bulb and it still didn't work. I've checked the fuse for the LH Tail light and it is good. Could it be a wiring problem?

Did you check if power was reaching the socket? you will need a test light to check, I would by one, it will come in handy for years. see if power is at the socket, if so there is a bad ground, you need to verify that to not waste a lot of time guess ... 2004 Hyundai Tiburon

Some time my blinkers wont work had a rear tail light go out went to dealer got bulb replaced it then blinker was working fine notisted brak light in left rear bulbs out again and the last time i drove it blinker wasnot working when i first left then as driving it jest started working out the bluewhat would keep couse my taie brak bulb to keep blowing out and my blinkers sometimes not to work

This is how I fixed mine, hope it helps.\015\012Go to:\015\012http://www.2carpros.com/forum/2001-jeep-grand-c ... 2002 Jeep Grand Cherokee

I replaced a cracked rear tail light with an after market new light. Now the brake light won't work but reverse lights and directional signal do. The bulbs are fine as I've moved them around and still no brake light. And coincidentally, the left brake light won't come on and all other lights work. Bulbs were checked. Any suggestions?

\012\012\012If there are no brake lights period the check the stop switch (brake light switch) \012This is attached to the upper part of the brake pedal itself. Should be a little wire off ... 2003 Jeep Grand Cherokee

99 suburban,rear brake lights and turn signals work intermittently. Tail lights are fine on both sides. I have replaced bulbs and the circuit panel on the rear to no avail. I think it may be the turn signal switch itself. I also lose the cruise control whenever i hit a bump, like crossing a bridge, also. Could the ground be the cause of this? Another point of issue that may not be related directly is that my horn fuse blows whenever it is replaced and the driver side door jamb switch works inter

Blinker switch can go bad everything runs through the switch ... 1999 Chevrolet Suburban

How to replace rear turn signal light bulb. how do you remove the rear tail light cover so as to remove the bulb on 2006 Ford Explorer XLT

I just changed my rear turn signal. Really easy. There is two 1/4 inch bolts visible when you open the tailgate. Take both of those out and gently lift the light housing out towards the outside of the vehicle. There is two small clamps on the other s ... 2006 Ford Explorer

During the day my brake lights work, but not my rear signal lights. when i turn on my head lights, the brake and signal lights will not work. my signal lights in front work all the time, but they blink real fast. i checked my fuses on the dash panel box, all are ok. i checked under the hood and those fuses were ok also, but i do not know about the square big multi pronge fuses. i replaced my rear tail light bulbs also even though my old ones were ok. could there be a loose ground wire or a bad b

U have a short loose ground or power wire check all bulb sockets ur head light switch can be bad also ... Ford Ranger

Nedd to replace rear tail light light bulb

... 2000 Land Rover Range Rover

I need to replace the left rear brake light bulb on my 2004 Prius. Unlike other bulbs (turn-signal, back-up, and tail-light) that has access hole to reach the socket, the brake light bulb socket appear to be un-reachable without dropping the bumper. Is it right?

... 2004 Toyota Prius

2002 Nissan Xterra: not working are my running lights, dash lights and the interior buzzer. I did find that the 15a fuse was blown which ties into the tail lights. Also noticed that I had a bad brake bulb. Both were replaced and all was working. Later that night problem reoccurred, but this time the fuse hadn't blown. I did replace it again but the problem still exists. I'm driving with no rear lights (brake lights are working). What should I check now or test?? Any assistance would be greatly a

Dear fellow \015\012 mostly u have a bad wire defect try to check all ur rear light wiring \015\012\015\012regards ... 2002 Nissan Xterra

I have a silverado 1500 my driver's side rear tail, brake and turn signal is not working. This started before the check engine light came on. I went to replace the bulbs, but the bulbs were not bl

These are not related issues. The problem is a really common one. Most likely the circuit board is bad. I sell about 4 a week for these trucks. You can pick them up for around $20 at your local parts store. ... 1998 Chevrolet Chevrolet silverado


... Cars & Trucks

Both my rear tail lights & number plate lights on my Nissan Navara fail to work. I have checked all my fuses, in the cab & in the engine compartment, all found to be serviceable. The rear stop lights function correctly! I have also replaced a stop light bulb & the fault still persists.

Well there is a fuse panel under a large plastic cover by the windshield washing liquid. check that one ... 2005 Nissan King Cab

I have a 2005 Hyundai Santa Fe and the right rear tail light will not work after replacing the bulb, why?

... 2003 Hyundai Santa Fe

My instrument panel, turn signals,tail lights do not work. I've replaced a 15A fuse in fuse box in dash board and a 10A fuse in the fuse box under hood on driver's side. Also checked rear tail light bulbs-all fine. Still no lights. Suggestions? If another fuse or relay or whatever? Where do I locate it?

... Nissan Sentra

My 2002 sporttrac started out with the right side rear blinker and brake light not working, thought bulb or fuse but before I got to working on that the drivers side went out, same problem, I replaced the bulbs, went through all the fuses and still have the problem, the center brake light works, the tail lights work, the front is find but blinks extremely fast. I'm beating my head of the wall trying to figure this one out. I've inspected the wiring and doesn't seem to be anything out of place,

You have a bad/wrong bulb installed somewhere. ... 2002 Ford Explorer Sport Trac

License plate lights do not work, bulbs and fuses, and all other lights are working ok. I had to replace the left rear tail light bulb.

... 2002 Hyundai Santa Fe

My brake light bulb left rear is burned out. How do I remove the tail light assembly in order to facilitate replacement of the brake light bulbs?

The brake light bulb should be accessable through the trunk. Once you remove the grey fuzzy covering, you will see large black\015\012"nuts" that you can remove with your hand. You should need no special\015\012tools.Once all the "nuts" a ... Lincoln Continental

Right and left brake lights will not function however light in rear window will fuction properly I have replace the fuse for the rear tail light and both bulbs an right and left side. what could be the problem.

Check the brake light switch on the pedal, center light is not on the same circuit ... 2004 Toyota Camry

I have a 1990 full size ford Bronco. The rear right turn signal went out and I replaced in and it still did not work but the rest of the turn signals worked. I then took it to a shop and they looked at it for twenty minutes and could not figure it out. When I got home the rear tail lights brake lights , turn signals (all one multifunctial bulb) would not work and also the back up lights. Also the front blinkers will not work now. I have tried the fuze and that is not the problem. I don't think

... 1990 Ford Bronco
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2121 seconds