Having problems with your 2006 Volkswagen Jetta ?

Best way to access AC compressor on 2006 Jetta to replace it?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

e61f732.jpg\015\012
\015\0121. Make sure the vehicle is off with key removed.
\015\0122. You need to evacuate the refrigerant with a refrigerant recovery system.
\015\0123. Remove the ribbed belt.
\015\0124. Remove the noise insulation beneath the engine.
\015\0125. Remove the bolts (1) from A/C compressor and disconnect refrigerant lines.
\015\0126. Remove hex screws (2) and remove the compressor.
\015\012
\015\012Reinstall in reverse order making sure the bushings (3) are seated. Make sure your new compressor is filled with regrigerant oil prior to install and you do not start the car prior to filling it back up with regrigerant. Turn the ribbed belt pulley of A/C compressor 10 rotations by hand before starting the engine.
Repair Help & Product Troubleshooting for 2006 Volkswagen Jetta

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Best way to access AC compressor on 2006 Jetta to replace it?


\015\012\015\0121. Make sure the vehicle is off with key removed.\015\0122. You need to evacuate the refrigerant with a refrigerant recovery system. ... 2006 Volkswagen Jetta

I need too replace an A/C Compressor on a1999 Pontiac Bonneville 3.8L VIN - K which is the best way to go about this.


Remove the right front tire,then the inner fender pannel(its plastic) you should be able to get to the bolts and lines,becareful to make sure there is no pressure in the system first ... Cars & Trucks

I have a 1996 volkswagon jetta gls 2.o litre and need to replace the fuel pump. I have gained access to the pump but cant figure out how the pump it's self is removed from the tank. is it bolted into the tank or is it fastened some other way?


... 1996 Volkswagen Jetta

I need to replace a rear seat belt in a 1997 Ford Tarsus. Does any know the best way to access the assembly? In addition, are there any diagrams available that show the connection points?


Please don't forget to rate, thx.\015\012\015\012Retractor and Tongue—Sedan \015\012\015\012\015\012SPECIAL SERVICE TOOL(S) REQUIRED \015\012\015\012\015\012Description \015\012\015\012Tool Number \015\012\015\012\015\0 ... 1997 Ford Taurus

Honda Accord 2000 lx V6 3.0 engine. Car starts and runs for awhile then at idle it will shut off. Attempts to restart gets cranking of engine but does not start. Seems like fuel starvation. Let engine cool off 10-15 minutes car will restart and run for a while again. Seems like vapor lock of the fuel pump. If this is what you believe to be the situation. How is the best way to replace the fuel pump? Is it located in the gas tank and if so is the access panel under the rear seat or in the t


The relay can be tested using a voltmeter to read volts out, if it does not switch power to the fuel pump , then the relay is faulty.A general test can also be done reading volts at fuel pump connectors.Instead of testing the ... Honda Accord

Please describe the best way for me to replace an A/C compressor bearing on a 2002 chev trailblazer.


Click on this below link to see detailed step by step information (with pictures) showing how to replace the A/C compressor bearing on a 2002 Chevy Trailblazer. This job will take about 2 1/2 hours \015\012\015\012 ... 2002 Chevrolet TrailBlazer

Replacing the evaporator core in my mercedes 420 sel 1991.What is the best way to access it.


You have a W126 S-Class Sedan \015\012Chassis W126.035\015\012Engine M116.965 V8\015\012Model 420SEL\015\012Years 1986-91\015\012Horse Power 201\015\012Weight 3850 \015\012\015\012other problems, is the ... Mercedes-Benz 420-Series

I am replacing the headliner in my 2006 jetta and have everything out except the air bag pillars 6 in total, what is the best way to get them out without any breakage?


... Volkswagen Jetta

I have a 2007 Ford F-150 FX4 Supercrew P/u , I need to replace the driver side power fold mirror. I'm only required to remove three bolts and unplug the electronics. What is the best way to remove the interior door panel to access the bolts and plug.


To remove the drivers side door panel, first remove the two trim screws at the bottom of the door panel. Next, remove the access plate behind the interior door handle (pry it out at slot) and the two screws. Gently pry up the power window switch pane ... Ford F-150

What is the best way to replace ac compressor on an 2003 mits montero sport 3.5 v6 it is in a tight spot any advice would be great thanks


Here is the step by step procedure. But first be sure the system is vacuumed at a shop to save any freon that may still be in the system or else this could cost a couple hundred more if you choose to dump it into the atmosphere. Also its part of t ... Mitsubishi Montero Sport

Blower motor not working. Best way to access for replacement?


The only way,underneath passenger side dach,not to bad just tight spot,let me know if you have questions.\012\012\012\012\012\012\012\012\012\012\012TIM ... 1994 Acura Vigor

Replacing oil pan: what is the best way to access it to remove it?


Audi 1997 A6 oil pan cracked in a fast oil change place is replacement problematic ? ... 2000 Audi A4

Where do i find the part RU867 in a 2001 Buick Century? I am trying to replace this part in my car. What is the best way to locate this part in the car and the best way to replace it?


It looks like it is in the car:\015\012\015\012http://images.photomania. com/20773/1/rad9FF50.jpg\015\012\015\012Should be on the passenger side near the floor.\015\012\015\012This ... 2001 Buick Century

I have a 1998 Mercury Sable LS Dual Cam. My A/C Compressor went out a couple of months ago. The Compressor is seizing up causing my belt not to turn so the car won't start. Mechanic said a/c needs to be replaced. I cannot afford to have it repaired right now (1000.00) estimate. I've found out there are no "pullies" fthat I could install in place of the compressor for this type of vehicle. Can the compressor be rigged some way to turn? Can I replace it with "just a compressor"? Everyone says the


Looking at your accessory placement, I see no good reason why you couldn't just get a shorter belt--perhaps the one that you would buy if you had bought the car without the A/C option.\015\012The routing will be different and you might need ano ... 1998 Mercury Sable

1982 gmc truck 305 engine how to replace timing chain cover gasket also I know that I have to take the waterpump off also to access the timing cover. Is there a way to replace this without taking off the oil pan also? also what is the right way to tighten the bolts when installing these components?


You just loosen the pan you will however have to take the front 2 pan bolts all the way out and then you can remove your cover,your kit will come with new seals and gasket,I hope this helps you and thank you ... 1983 GMC C1500

2001 chev 1500 rear end is making a whinnig noise and getting worse. What is the best way to determine what is wrong and the best way to remove and replace bearings?


Most of the time they stat that its the gears its self must be pretty worn or ran low on grease my 99 did that ... 1999 Chevrolet Silverado 1500

How to replace the Powers Stearing Pump hose. Best way to go about it? The tube comming off the Power Stearing Pump has broken. What is the easyest way to replace it?


With a small hack saw or tubeing cutter cut the tube off as close to the fitting as you can,this will allow you to pu a socket on it because an open ended wrench will slip and you WILL blead or at least curse.If it has to be replaced then you have no ... 1994 Chevrolet Beretta

Replaced water pump and timing belt tensioner and now it runs but dies sometimes and doesnt run right its like its missing but replaced all plugs and boots. and it also has a slight knocking noise coming from inside the timing cover but when u turn the wheel either way and hold pressure on the wheel it goes away. i no its the timing but whats the best way to solve this problem


Hate to have to be the one to tell u but tear it back down is best fix ,,,,,sorry no short cut ...hope it helps ... 1999 Chevrolet Malibu

I believe my ac compressor pump is going out. Is there a way to bypass the ac pulley with a different belt or a way that I wouldn't have to replace the entire compressor. I cant afford that.


... 2000 Hyundai Sonata

What is the best way to remove old gasket from a metal surface? I am replacing my transmission shift solenoid on my 2002 Dodge Neon SE 4cyl. automatic and when I removed the old solenoid, a lot of the old gasket is stuck to the metal surface. What is the easiest and best way to remove the old gasket? Please help.


Hi, one of the best things to use is one of those scrapers that you can put a stanley blade into or you can just use a blade on its own as long as you keep it flush with the surface which is a bit difficult without the scraper attatchment. ... Dodge Neon

Will crank on ether but not without. what is best way to check if fuel pump is working? Has fire to the plugs. Also transmission shifts fine going forward with no slipping but will not go into reverse. its an automatic. motor is 5.7 350 and 2 wheel drive. whats the best way to replace fuel pump, drop tank or remove bed?


Check to see if there is a blown fuse before you try anything.You should be able to hear it run. Turn the ignition key to the on position and remove the fuel line before the lift pump, should have fuel coming through.If you have to replac ... 1998 Chevrolet C1500

1994 Caprice Classic AC compressor clutch is coming apart. One of the metal rings is loose and off-center, causing shaking and looks like it could damage nearby stuff. Is there a way to replace the clutch alone, or does the whole compressor need replacing? How difficult or expensive is this?


... 1994 Chevrolet Caprice Classic

I am trying to replace all the factory speakers in my 2003 mountaineer i think there is a sub i want to run all the aftermarket speakers to an aftermarket amp if there is a sub can i also run it to a amp the speakers i have are 500 watt 3way coaxial if any one understands this please help what is the best way for me to go about this without having to come out of my pocket for labor i can do it myself i just need to know the safe and best way to do it


No problem with replacing all speakers with ones that are compatable wth you new amp .. and that means the the speaker impedance has to be wtihin the range of what the amp can drive (like 4 ohm, 8 ohm, 16 ohm) .... the subwoofer needs inputs from b ... 2003 Mercury Mountaineer

I don't believe the solution to my request is very complicated. But, in any case, I need to replace the starter on my daughter's 1998 Nissan Quest and wanted to know that I'm doing it right. I haven't even looked at it yet. And, though it's been at least 20 years, I have done things like replace alternators, hoses, thermostats, and plugs in cars. I'd like to know the location, best way to remove the old one and how best to install the new one, as well as of any "gotchas"; or, of any spe


If you want the service manual just click this link directly \015\012http://www.tradebit.com/filedetail.p ... 1998 Mercury Villager

2000 VW Passat Problems: 1. How much should it cost me to replace my "timing belt"??? Parts and Labor??? 2. How much should it cost me to replace my "spark plugs"??? Parts & Labor ??? 3. My LED lights on my car only work when its ***CoLd*** if its Hot no way I'm seeing them. What could be the problem there? Parts & Labor Cost??? 4. All of my speakers are blown on my car, where can I find the best speakers for the best price that will fit "ALL" of my speaker small ones and big ones??? Please help


1. you don't have a timing belt. its a timing chain. you are looking at the serpentine belt. still expensive but it will need replacement. do not drive it very far if the belt breaks while driving.\015\0122. Spark plugs are easy, only cha ... 2000 Volkswagen Passat 4Motion
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8528 seconds